Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 25 — Substitute n = 7: 4 × 7 − 3 = 28 − 3 = 25. Forgetting to subtract 3 gives 4 × 7 = 28. Subtracting 3 from 7 before multiplying by 4, 4 × (7 − 3) = 16, applies the operations in the wrong order. Substituting n = 8 by miscounting the position gives 4 × 8 − 3 = 29.
- (d) 4 — Subtracting the second equation from the first: the y-terms cancel, and the x-terms combine as 3x − x = 2x; the right-hand sides give 14 − 6 = 8. This gives 2x = 8, so x = 4. A candidate who subtracts in the wrong order would get 2x = 6 − 14 = −8, so x = −4. A candidate who uses only the first equation, dividing 14 by 3 as if y were 0, would get x ≈ 4.67. A candidate who reports the value of y instead of x would get y = 6 − 4 = 2.
- (c) r = √(A/π) — A = πr² means r has been squared and then multiplied by π. To make r the subject, first divide both sides by π to get A/π = r², then take the square root of both sides: r = √(A/π). Writing r = A/π stops after dividing by π and forgets that r is still squared — it never undoes the square. Writing r = √A/π takes the square root before dividing by π, which square-roots only the A and not the whole of A/π. Writing r = (A/π)² squares A/π instead of taking its square root — the opposite of what is needed to undo r². The correct rearrangement is r = √(A/π).
- (c) 37 — The first differences are 3, 5, 7, 9 — they increase by 2 each time (the second difference), so the next first difference is 11, giving 26+11=37. A candidate who repeats the last first difference (9) instead of increasing it would reach 26+9=35. A candidate who increases the difference by 4 instead of 2 would reach 26+13=39. A candidate who adds only the second difference (2) to the last term, instead of the next first difference, would reach 26+2=28.
- (a) −2 m/s² — The gradient of a line through two points is the change in the y-value divided by the change in the x-value: (6 − 22)/(16 − 8) = −16/8 = −2 m/s². The negative sign confirms the deceleration mentioned in the question. Writing 2 m/s² comes from subtracting the velocities in the wrong order, using (22 − 6) instead of (6 − 22), which loses the sign that shows the car is slowing down. Writing −0.5 m/s² comes from inverting the fraction, dividing the change in time by the change in velocity instead of the other way round. Writing −16 m/s² comes from finding the change in velocity, −16, but forgetting to divide by the change in time, 8 seconds.
- (b) x = 3, y = 4 — −x² + 6x − 5 = −(x² − 6x) − 5 = −[(x − 3)² − 9] − 5 = −(x − 3)² + 9 − 5 = −(x − 3)² + 4. Because the coefficient of x² is negative, −(x − 3)² is at most zero, so this turning point is a maximum. Substituting x = 3 gives (x − 3)² = 0, so y = 4, confirming the maximum value 4 at x = 3: turning point (3, 4). Using 6 instead of half of 6 inside the bracket — forgetting to halve before completing the square — lands on turning point (6, 31), wrong, because only half the coefficient belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (−3, 4) — wrong, because (x − 3)² is zero at x = 3, not x = −3. Computing 5 − 9 = −4 instead of 9 − 5 = 4 flips the sign of the constant, giving (3, −4) — wrong, since the constant must be evaluated as 9 minus 5, not 5 minus 9. Whenever the leading coefficient is negative, the turning point is a maximum, not a minimum — check by substituting back into the original equation.
- (a) n² + n — n² + n = n(n + 1), the product of two consecutive integers. One of any two consecutive integers is always even, so their product is always even, whatever whole number n is. n² − n + 1 = n(n − 1) + 1 is always ODD, since n(n − 1) is even and adding 1 makes it odd — the opposite of what's asked. 2n + 1 is always odd by definition, not even. n² + 1 is not always even at all: it depends on whether n is odd or even, and testing n = 2 gives 5, which is odd.
- (d) 2 — The gradient between two points on a line is the change in y divided by the change in x. Using (5, 2) and (0, −8): (2 − (−8)) ÷ (5 − 0) = 10 ÷ 5 = 2. Inverting the fraction, dividing the change in x by the change in y instead, gives 5 ÷ 10 = 0.5. Reversing the order of the x-values in the denominator, giving (2 − (−8)) ÷ (0 − 5) = 10 ÷ (−5), gives −2. Misreading the y-intercept as 8 instead of −8, giving (2 − 8) ÷ 5 = −6 ÷ 5, gives −1.2.
- (b) 6 — Reflecting y = f(x) in the x-axis turns the minimum point (2, −3) into a maximum point at (2, 3), since −f(x) negates every y-value: −(−3) = 3. Adding a then gives 3 + a = 9, so a = 9 − 3 = 6. Forgetting the reflection and using the original y-value of −3 gives −3 + a = 9, so a = 12 — this ignores that −f(x) changes the sign of the y-coordinate before a is added. Writing a = −12 comes from subtracting in the wrong order, working out 9 − (−3) as −3 − 9 instead. Writing a = −6 comes from taking the negative of the correct answer, as if the final value of a needed to be reflected too, on top of the turning point.
- (c) 5(x + y − 1) — Method: take out the highest common factor of all three terms and divide every term by it, the number term included. Working: the highest common factor of 5x, 5y and −5 is 5; dividing gives 5x ÷ 5 = x, 5y ÷ 5 = y and −5 ÷ 5 = −1, so the bracket holds x + y − 1. Answer: 5(x + y − 1), which multiplies back out to 5x + 5y − 5. The distractors: 5(x + y + 1) comes from dividing −5 by 5 and losing the minus sign; 5(x + y − 5) comes from dividing only the terms containing a letter by 5 and carrying the −5 into the bracket unchanged; 5(xy − 1) comes from collecting the unlike terms 5x and 5y as 5xy before factorising.
- (d) −3 — Substitute y = 11 into y = 5 − 2x, giving 11 = 5 − 2x. Subtracting 5 from both sides gives 6 = −2x, so x = 6 ÷ (−2) = −3. A candidate who mishandles the negative sign when rearranging, treating the equation as 6 = 2x, gets x = 3. A candidate who correctly finds −2x = 6 but forgets to divide by 2 at all gets x = 6. A candidate who adds 5 and 11 instead of subtracting, getting 2x = 16, gets x = 8.
- (a) x + 14 — Expand each bracket separately: 3(x + 4) = 3x + 12, and −2(x − 1) = −2x + 2 (multiply −2 by both x and −1). Combine: 3x + 12 − 2x + 2 = x + 14. Writing x + 10 comes from taking −2(x − 1) as −2x − 2, not flipping the sign of the −1 inside the bracket. Writing 5x + 10 comes from treating the second bracket as +2(x − 1) instead of subtracting it, so the x-terms are added rather than subtracted. Writing x + 13 comes from only multiplying the 2 by the x, and carrying the −1 across unmultiplied.
- (d) 40 m — Each trapezium has width 2. Its area is width × the average of its two heights. Strip 1: average of 0 and 5 is 2.5, so area = 2 × 2.5 = 5. Strip 2: average of 5 and 9 is 7, so area = 2 × 7 = 14. Strip 3: average of 9 and 12 is 10.5, so area = 2 × 10.5 = 21. Total distance = 5 + 14 + 21 = 40 m. Leaving out the division by 2 in the averaging step doubles every strip, giving 80 m instead of 40 m. Using only the LEFT height of each strip as a rectangle, 0 × 2 + 5 × 2 + 9 × 2 = 28, or only the RIGHT height, 5 × 2 + 9 × 2 + 12 × 2 = 52, both ignore that the graph curves between the two ends of each strip — always average the two heights of a trapezium, never use just one of them.
- (a) 3y² — 'y squared, multiplied by 3' means the square is applied to y only, and the result is then multiplied by 3, written as 3y². Writing y³ mistakes the multiplication by 3 for an extra factor of y, adding to the power instead of using a coefficient. Writing (3y)² squares the whole of 3y, including the 3, which gives 9y² rather than 3y² — the square should apply to y alone. Writing 3 + y² adds the 3 instead of multiplying by it. The expression for 'y squared, multiplied by 3' is 3y².
- (a) 45 — The ratio between the two given points, one power of x apart, gives b: 405 ÷ 135 = 3, so b = 3. Substituting back, at x = 1, y = A × b, so 135 = A × 3, giving A = 45. Giving the common ratio b itself instead of A confuses which unknown was asked for and produces 3 — wrong, because the question asks for A, not b. Giving 135 instead treats the first given point as the y-intercept and reads A off it directly — wrong, because that point is at x = 1, not x = 0, so 135 is A × b, not A. Assuming A equals b⁰ = 1 by itself, rather than substituting a known point to solve for A, gives 1 — wrong, because b⁰ is always 1 regardless of A; A must be found using an actual (x, y) pair from the graph.
Build your own mix at the worksheet builder.