Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) Subtracting 4x gives 3 = 10, which is never true. — Method: try to solve the equation as normal and see what happens. Working: subtract 4x from both sides: 4x + 3 − 4x = 4x + 10 − 4x, giving 3 = 10. This statement is false for every value of x, so the equation has no solution. Answer: subtracting 4x gives 3 = 10, which is never true. "x would have to be negative" invents a constraint on x that the equation never states. "It's true for every x" confuses this equation with an identity, where both sides would simplify to the same expression. "x = 7" misreads the false statement 3 = 10 as something to solve for x, rather than recognising it means no solution exists.
- (a) −1 — Reflecting y = sin x in the x-axis gives y = −sin x, so g(x) = −sin x. Since sin 90° = 1, g(90) = −1. Reading sin 90° = 1 and forgetting to apply the reflection gives 1. Misreading the angle as 0° instead of 90° gives sin 0° = 0, so 0. Confusing sin 90° with sin 30° = 0.5, then reflecting it, gives −0.5.
- (d) (x − 8)(x + 8) — x² − 64 = x² − 8², a difference of two squares, which factorises as (x − 8)(x + 8). A candidate who treats it as a perfect square with a repeated negative factor gets (x − 8)(x − 8), which expands to x² − 16x + 64 — wrong on both the middle and constant terms. A candidate who uses a repeated positive factor gets (x + 8)(x + 8), which expands to x² + 16x + 64. A candidate who picks a different factor pair of 64, such as 4 and 16, without checking that the middle term cancels, gets (x − 4)(x + 16), which expands to x² + 12x − 64 — the wrong middle term.
- (c) Yes; x = (y + 5)/2 is right — Sam's method is correct throughout: adding 5 to both sides gives y + 5 = 2x, and dividing both sides by 2 gives x = (y + 5)/2, so Sam is right. The option giving x = (y − 5)/2 assumes 5 should be subtracted again, but 2x − 5 = y means 5 has already been subtracted, so it must be added back, not taken away a second time. The option giving x = y/2 + 5 divides only the y term by 2 and leaves the 5 unhalved, which is not a valid rearrangement. The option agreeing Sam is correct but changing step 2 to x = 2(y + 5) confuses '2x' with 'x divided by 2' — since x is multiplied by 2, the inverse is division, not multiplication. Sam's working, and his final formula x = (y + 5)/2, are both correct.
- (d) 4 — Subtracting the second equation from the first: the y-terms cancel, and the x-terms combine as 3x − x = 2x; the right-hand sides give 14 − 6 = 8. This gives 2x = 8, so x = 4. A candidate who subtracts in the wrong order would get 2x = 6 − 14 = −8, so x = −4. A candidate who uses only the first equation, dividing 14 by 3 as if y were 0, would get x ≈ 4.67. A candidate who reports the value of y instead of x would get y = 6 − 4 = 2.
- (c) 37.5 — The tangent at (18, 24) is 18x + 24y = 900 (using ax + by = r² with a = 18, b = 24, r² = 900). Setting x = 0 to find the y-intercept: 24y = 900, so y = 37.5. Choosing 900 skips the division by 24 and just repeats the constant. Choosing 50 divides the constant by the x-coefficient 18 instead of the y-coefficient 24. Choosing 1.25 uses the radius 30 instead of r² = 900 as the constant before dividing.
- (b) It is not even an ordinary equation with a solution: expanding the left-hand side gives 3x − 12, and 3x − 12 = 3x − 4 would require −12 = −4, which is never true. — Expanding the left-hand side, 3(x − 4) = 3x − 12. Setting this equal to the right-hand side, 3x − 12 = 3x − 4, gives −12 = −4 once the 3x terms are removed from both sides — a statement that is never true, so no value of x satisfies the equation at all, and it is certainly not an identity. The option about substituting a specific value misunderstands algebraic expansion, which holds for every x, not one chosen value. The option matching the first term wrongly assumes that is enough to prove equivalence. The option about multiplying the 4 by 3 on both sides is nonsensical, since there is only one bracket to expand, on the left-hand side.
- (b) (2x + 1)/(x − 3) — Factorise both the numerator and the denominator before you cancel anything. The numerator 2x² + 7x + 3 factorises to (2x + 1)(x + 3), and the denominator x² − 9 is a difference of two squares, factorising to (x − 3)(x + 3). The (x + 3) factor is common to both, so it cancels, leaving (2x + 1)/(x − 3). Writing (2x + 1)/(x + 3) comes from factorising x² − 9 as (x + 3)² instead of (x − 3)(x + 3) — a difference of two squares always has one plus and one minus bracket. Writing (2x + 3)/(x − 3) comes from mis-factorising the numerator as (2x + 3)(x + 1) and then wrongly cancelling the (x + 1) against the denominator's (x + 3) as though they were the same bracket. Writing 2x + 1 comes from cancelling the (x + 3) factor correctly but then dropping the remaining (x − 3) on the denominator altogether.
- (a) Litres — The area under a graph is found by multiplying a y-value by an x-value, so its units are the y-axis units multiplied by the x-axis units: litres per minute × minutes = litres, since the 'per minute' cancels with the 'minutes'. Answering 'litres per minute' keeps the y-axis units unchanged, as if multiplying by time did nothing to the units at all. Answering 'litres per minute squared' treats the x-axis as also being measured 'per minute', squaring a unit that should instead cancel. Answering 'minutes' keeps only the x-axis units and drops the rate altogether.
- (b) (n + 1)² − n² = 2n + 1 — (n + 1)² = n² + 2n + 1, so (n + 1)² − n² = n² + 2n + 1 − n² = 2n + 1, which is odd because it is one more than the even number 2n. Expanding (n + 1)² as n² + 1 uses the false rule (a + b)² = a² + b², and subtracting n² from that leaves just 1 — always expand (a + b)² as a² + 2ab + b². Writing n² + 2n + 1 expands correctly but never carries out the subtraction of n². Writing 2n forgets the constant term left after subtracting.
- (d) −2 — y = f(x) − 6 is f(x) shifted down by 6, so every y-value on the graph decreases by 6. At x = 0, f(0) = 4, so the new y-value is 4 − 6 = −2. Adding 6 instead of subtracting gives 10; writing down the shift itself, −6, or leaving the original value 4 unchanged both skip the translation altogether.
- (a) t = 0 or t = 4 — The ball is at ground level exactly when h = 0. From the table, h = 0 at t = 0 and at t = 4, so those are the two times. Distractor origins: t = 1 or t = 3 picks the times with equal (but non-zero) height instead of ground level; t = 2 picks the time of maximum height instead of ground level; t = 0 finds only the starting time and misses the second one.
- (c) Line D — Method: the steeper of two lines is the one whose gradient is greater, and the gradient of a line through two points is the change in y divided by the change in x. Working: line C rises 2 for a run of 4, so its gradient is 2 ÷ 4 = 1/2; the other line rises 2 for a run of 2, so its gradient is 2 ÷ 2 = 1; since 1 is greater than 1/2, it is line D that is the steeper. Answer: Line D. The distractors: Line C is chosen by comparing the x-coordinates and calling the line that reaches further along the x-axis the steeper one; They are equally steep comes from comparing only the y-coordinates, which are both 2, without dividing by the two different runs; There is not enough information comes from believing that a gradient can only be measured off a drawn graph, when two points on a line are enough to work it out.
- (d) y = (1/4)x + 3 — The given line has gradient −4, so the perpendicular gradient is the negative reciprocal, 1/4. Since (0, 3) is the y-intercept, the perpendicular line is y = (1/4)x + 3. Distractor routes: y = −4x + 3 uses the original line's own gradient instead of the perpendicular gradient, only changing the intercept for the new point. y = (−1/4)x + 3 takes the reciprocal of −4 but forgets to change its sign, so it is not the true negative reciprocal. y = 4x + 3 negates the gradient −4 but does not take its reciprocal, giving 4 instead of 1/4.
- (a) (2, 7) — Midpoint = ((x1+x2)/2, (y1+y2)/2) = ((−3+7)/2, (5+9)/2) = (4/2, 14/2) = (2, 7). (4, 14) comes from adding the coordinates correctly but forgetting to divide by 2. (2, 9) comes from correctly averaging the x-coordinates but simply copying the y-coordinate of the second point instead of averaging the y-coordinates. (5, 2) comes from subtracting the coordinates instead of adding them before halving: ((7−(−3))/2, (9−5)/2) = (5, 2).
Build your own mix at the worksheet builder.