Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 0.25 — Method: gradient = vertical rise ÷ horizontal distance. Working: gradient = 3 ÷ 12 = 0.25. Answer: the gradient of the ramp is 0.25. 4 comes from inverting the gradient, dividing the horizontal distance by the vertical rise instead of the other way round. 9 comes from subtracting the rise from the horizontal distance instead of dividing. 36 comes from multiplying the rise and the horizontal distance instead of dividing.
- (a) x ≈ 6.70 — Since the two roots sum to 7, the other root is 7 − 0.30 = 6.70. The option 7.30 comes from adding the given root to 7 instead of subtracting it. The option 6.30 comes from subtracting 0.70 (one minus the given root) rather than the given root itself. The option 0.70 confuses the required root with the amount by which the given root falls short of 1.
- (d) Wrong — the correct solution is x < −3 or x > 3. — Squaring or unsquaring an inequality is not a safe one-step move: the solution must be split into two branches, since a number less than −3 also squares to more than 9. So x > 3 finds only half the solution set. The full answer is x < −3 or x > 3. Distractor routes: "Right — square rooting both sides gives x > 3" treats the square root of an inequality the same as the square root of an equation and misses the negative branch entirely. "Wrong — the correct solution is −3 < x < 3" applies the between-the-roots pattern that belongs to the opposite inequality, x² < 9. "Right, but x = −3 and x = 3 should also work" treats the inequality as if it also allowed equality, when x² > 9 is strict and excludes both x = 3 and x = −3.
- (a) 7.9 m — Method: the iteration converges on the width of the plot, so run the formula three times from the starting value and then add 4 m, because the length is 4 m greater than the width. Working: x₁ = √(30 − 4 × 3) = √18 = 4.24264…; x₂ = √(30 − 4 × 4.24264…) = √13.02943… = 3.60963…; x₃ = √(30 − 4 × 3.60963…) = √15.56147… = 3.94480…. The estimate for the length is 3.94480… + 4 = 7.94480…, which is 7.9 m correct to 1 decimal place. Answer: 7.9 m. The iteration is still oscillating at x₃, so this is the estimate that three uses of the formula give, not a settled value. The distractors: 3.9 m is x₃ itself, the width, given by a candidate who runs the iteration correctly and then stops before the step the question actually asks for; 7.6 m uses x₂ in place of x₃, one use of the formula short, and then adds the 4 m correctly; 15.8 m multiplies the width by 4 instead of adding 4 m to it, reading greater than as a multiplier.
- (c) x + 18 — Expand −3(2x − 6) by multiplying both terms by −3: −3 × 2x = −6x and −3 × (−6) = 18, giving 7x − 6x + 18 = x + 18. Writing x − 18 comes from not flipping the sign of the −6 inside the bracket, so −3 × (−6) is treated as −18 instead of +18. Writing x + 6 comes from forgetting to multiply the −6 by 3, only carrying its sign. Writing 13x − 18 comes from treating the whole bracket as being added rather than subtracted, so 3(2x − 6) = 6x − 18 is added to 7x.
- (a) x = 2, x = 7; y-intercept cannot be found here — Translating y = f(x) to y = f(x − 3) shifts the graph 3 units to the right, so each root increases by 3: x = −1 becomes x = 2, and x = 4 becomes x = 7. The y-intercept is the value at x = 0, which for this new graph is f(0 − 3) = f(−3) — and f(−3) is not one of the values given, so the new y-intercept cannot be worked out from the information given. Writing 'y-intercept stays at (0, −8)' wrongly assumes a horizontal translation leaves the y-intercept unchanged — it generally does not, since it moves the whole graph sideways, including the point that used to sit on the y-axis. Writing roots at x = −4 and x = 1 comes from translating 3 units to the LEFT instead of to the right — f(x − 3) shifts the graph in the positive x-direction, not the negative direction.
- (b) Translate +5 in x, then reflect in the x-axis. — Translating y = x² by 5 units in the positive x-direction gives y = (x − 5)². Reflecting this in the x-axis, which replaces y with −y, gives y = −(x − 5)², matching the target. Using a translation of −5 in x instead gives y = (x + 5)², and reflecting that in the x-axis gives y = −(x + 5)² — the sign inside the bracket is wrong. Reflecting in the y-axis first does nothing to y = x², since (−x)² = x², so translating afterwards only reaches y = (x − 5)² with no negative sign at all. Translating by 5 units in y instead of x gives y = x² + 5, and reflecting that in the x-axis gives y = −x² − 5, a different curve altogether — a vertical shift does not create the (x − 5)² term the target equation needs.
- (c) 6 — Method: rate = amount of fuel used ÷ time taken. Working: fuel used = 50 − 38 = 12 litres, time taken = 2 hours, so rate = 12 ÷ 2 = 6 litres per hour. Answer: the rate is 6 litres per hour. 44 comes from finding the average of the two fuel amounts, (50 + 38) ÷ 2, instead of the fuel used. 12 comes from working out the fuel used but forgetting to divide by the time taken. 19 comes from dividing the remaining fuel, 38, by the time taken instead of the fuel used.
- (a) 2x − 1 — Swap x and y: x = (y + 1)/2. Multiply both sides by 2: 2x = y + 1. Subtract 1 from both sides: y = 2x − 1, so f⁻¹(x) = 2x − 1. Writing 2x + 1 comes from not flipping the sign on the 1 when it is moved across the equals sign. Writing (x − 1)/2 comes from reversing the sign of the 1 but leaving the ÷2 from the original rule in place, instead of turning it into ×2. Writing x/2 − 1 comes from dividing only the x by 2 and treating the 1 as already outside the fraction.
- (d) 2 — The gradient between two points on a line is the change in y divided by the change in x. Using (5, 2) and (0, −8): (2 − (−8)) ÷ (5 − 0) = 10 ÷ 5 = 2. Inverting the fraction, dividing the change in x by the change in y instead, gives 5 ÷ 10 = 0.5. Reversing the order of the x-values in the denominator, giving (2 − (−8)) ÷ (0 − 5) = 10 ÷ (−5), gives −2. Misreading the y-intercept as 8 instead of −8, giving (2 − 8) ÷ 5 = −6 ÷ 5, gives −1.2.
- (d) 10 — The right angle is at (1, 1). The vertical side has length 5 − 1 = 4 and the horizontal side has length 6 − 1 = 5, so the area is (4 × 5) ÷ 2 = 20 ÷ 2 = 10. A candidate who forgets to halve the product of the two sides gets 4 × 5 = 20. A candidate who forgets to subtract the shared vertex's coordinate and uses the raw coordinates 6 and 5 as the side lengths gets (6 × 5) ÷ 2 = 30 ÷ 2 = 15. A candidate who uses only one side length as the area gets 5.
- (b) Translate −90° in x, then translate −2 in y. — cos(x + 90°) translates the graph 90° in the NEGATIVE x-direction, since a positive shift inside the bracket moves a graph left, not right, and subtracting 2 afterwards translates it 2 units in the negative y-direction (down). So the sequence is: translate −90° in x, then translate −2 in y. Using +90° in x reverses the direction of the horizontal shift — the sign inside the bracket moves the graph the opposite way to what it looks like. Using +2 in y reverses the direction of the vertical shift; subtracting 2 outside the function moves the graph down, not up. Describing the −2 as a reflection in the x-axis is wrong because a reflection turns positive y-values negative and vice versa, whereas here every y-value is simply reduced by the fixed amount 2, which is what a translation does, not a reflection.
- (d) 110 — Method: form the equation 15 + 0.08m = 23.80, where m is the number of minutes, then solve for m. Working: subtract the fixed fee: 0.08m = 23.80 − 15 = 8.80. Divide by the cost per minute: m = 8.80 ÷ 0.08 = 110. Answer: 110 minutes. 1.1 comes from using 8 instead of 0.08 as the cost per minute, forgetting to convert pence to pounds. 297.5 comes from dividing the whole bill by the cost per minute without subtracting the fixed fee first, 23.80 ÷ 0.08. 485 comes from adding the fixed fee to the bill instead of subtracting it, before dividing by the cost per minute, (23.80 + 15) ÷ 0.08.
- (b) 3 and 4 — Method: the graph of f(x) is continuous, so where it crosses the x-axis the value of f(x) changes sign; substitute consecutive integers until one value is negative and the next is positive. Working: f(2) = 8 − 6 − 20 = −18, f(3) = 27 − 9 − 20 = −2 and f(4) = 64 − 12 − 20 = 32. The sign changes from negative to positive between x = 3 and x = 4, so the solution lies there. Answer: 3 and 4. The distractors: 2 and 3 comes from ignoring the −3x term and solving x³ = 20, whose root is 2.71, one interval to the left; 6 and 7 comes from reading x³ as x² and solving x² − 3x − 20 = 0, whose positive root is 6.22; 4 and 5 is the interval immediately after the change of sign, named by a candidate who finds f(4) positive and quotes the interval beginning there instead of the one across which the sign actually turned.
- (d) (x − 8)(x + 8) — x² − 64 = x² − 8², a difference of two squares, which factorises as (x − 8)(x + 8). A candidate who treats it as a perfect square with a repeated negative factor gets (x − 8)(x − 8), which expands to x² − 16x + 64 — wrong on both the middle and constant terms. A candidate who uses a repeated positive factor gets (x + 8)(x + 8), which expands to x² + 16x + 64. A candidate who picks a different factor pair of 64, such as 4 and 16, without checking that the middle term cancels, gets (x − 4)(x + 16), which expands to x² + 12x − 64 — the wrong middle term.
Build your own mix at the worksheet builder.