Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) x > 4 — Subtract 2x from both sides: 3x − 3 > 9. Add 3 to both sides: 3x > 12. Divide both sides by 3: x > 4. A candidate who subtracts 3 from 9 instead of adding gets 3x > 6, so x > 2. A candidate who divides correctly but wrongly flips the inequality (as if dividing by a negative) gets x < 4. A candidate who multiplies by 3 instead of dividing gets x > 36.
- (b) 6 — Reflecting y = f(x) in the x-axis turns the minimum point (2, −3) into a maximum point at (2, 3), since −f(x) negates every y-value: −(−3) = 3. Adding a then gives 3 + a = 9, so a = 9 − 3 = 6. Forgetting the reflection and using the original y-value of −3 gives −3 + a = 9, so a = 12 — this ignores that −f(x) changes the sign of the y-coordinate before a is added. Writing a = −12 comes from subtracting in the wrong order, working out 9 − (−3) as −3 − 9 instead. Writing a = −6 comes from taking the negative of the correct answer, as if the final value of a needed to be reflected too, on top of the turning point.
- (b) £105 — The hourly charge is 25 × 3 = £75. Adding the call-out fee: £75 + £30 = £105. A candidate who forgets the call-out fee gives just the hourly charge, £75. A candidate who adds the call-out fee to the hourly rate before multiplying by the hours, (30 + 25) × 3, gets £165. A candidate who multiplies the call-out fee by the number of hours instead of the hourly rate, 30 × 3, gets £90.
- (d) 44 m — The trapezium rule between t = 2 and t = 5 uses only the speeds at t = 2, 3, 4 and 5 — 12, 15, 16 and 14 — with three strips of width 1: adding the first and last readings and twice the sum of the middle readings gives 12 + 14 + 2 × (15 + 16) = 88, and half of that is 44 m. Writing 68.5 m comes from applying the trapezium rule to the whole table, from t = 0 to t = 6, instead of restricting it to the interval t = 2 to t = 5 that the question asks for. Writing 28.5 m comes from forgetting to double the two middle readings, 15 and 16, in the trapezium rule formula. Writing 39 m comes from averaging only the first and last speeds in the interval, 12 and 14, and multiplying by the 3-second interval, ignoring the readings at t = 3 and t = 4 in between.
- (a) 2(3x + 1) = 6x + 2 — Expanding 2(3x + 1) = 6x + 2 gives an expression that matches the right-hand side exactly for every value of x — it is an identity. 4x − 3 = 3x + 5 is an ordinary equation with one solution, x = 8. 7 − x = x − 7 is also an ordinary equation with one solution, x = 7. 5x + 1 = 5(x + 1) never holds for any value of x at all, since expanding the right-hand side gives 5x + 5, and 5x + 1 = 5x + 5 would require 1 = 5, which is impossible.
- (c) x = 3, y = 1 — Method: the y terms are +y and −y, so adding the two equations removes y and leaves an equation in x alone. Working: adding 2x + y = 7 and x − y = 2 gives 3x = 9, so x = 3; substituting x = 3 into x − y = 2 gives 3 − y = 2, so y = 1. Answer: x = 3, y = 1, which also satisfies 2 × 3 + 1 = 7. The distractors: x = 1, y = 3 comes from finding the two values correctly and then writing them against the wrong letters; x = 3, y = 2 comes from substituting x = 3 into 2x + y = 7 as 2 + 3 + y = 7, adding the coefficient instead of multiplying by it; x = 3, y = −1 comes from substituting into x − y = 2 as though it read x + y = 2.
- (b) 3 — At the limit, L = √(2L + 3). Squaring both sides: L² = 2L + 3, so L² − 2L − 3 = 0, which factorises as (L − 3)(L + 1) = 0, giving L = 3 or L = −1. Since the sequence of iterates stays positive throughout, the limit is L = 3. Taking the other, negative root without rejecting it gives −1. Treating the equation L = 2L + 3 as already linear, forgetting to square both sides first, gives −L = 3, so L = −3. A sign error when factorising, writing (L + 3)(L − 1) = 0 instead of (L − 3)(L + 1) = 0, gives L = 1.
- (d) 66 — 6 and (4x + 3) are correct factors of 24x + 18. — Substituting x=2 into 24x+18: 24×2+18=48+18=66. Checking the factorisation: 6×4x=24x and 6×3=18, so 6(4x+3)=24x+18, matching the original expression — 6 and (4x+3) are correctly identified as factors. A candidate who substitutes x=2 into (4x+3) but forgets to multiply by the factor 6 afterwards would compute just 4×2+3=11. A candidate who adds 24 and 18 together before multiplying by x, instead of multiplying 24 by x first, would compute (24+18)×2=84. A candidate who distributes the 6 over only the first term inside the brackets, forgetting the second, would check the factorisation as 6×4x=24x but leave the 3 unmultiplied, getting 24x+3 instead of 24x+18 — and would wrongly conclude that 6 and (4x+3) are not correct factors.
- (d) L/6 − 4 — Method: find the length of one equal piece first (divide by 6), then apply the later change (subtract 4) to that piece. Working: one piece is L/6 metres; removing 4 metres from it gives L/6 − 4. Answer: L/6 − 4. L/6 + 4 comes from adding the 4 metres instead of removing it. (L − 4)/6 comes from removing the 4 metres from the whole rope before cutting it into pieces, the wrong order. 4 − L/6 comes from subtracting the piece length from 4 instead of the other way round.
- (a) 40 — From 9am to 12 noon is 3 hours, so the population doubles three times: 5 × 2³ = 40. A candidate who counts the elapsed time as 4 hours (an off-by-one counting error) would reach 5 × 2⁴ = 80. A candidate who counts it as only 2 hours would reach 5 × 2² = 20. A candidate who misreads 'doubles' as 'increases by 2' each hour would compute 5 + 3 × 2 = 11.
- (c) n = 4 — Testing n = 4: 4² = 16, and 16 + 4 + 1 = 21, and 21 = 3 × 7 is not a prime number, so this value disproves the claim. Testing n = 1: 1² = 1, and 1 + 1 + 1 = 3, which is prime, so it does not disprove the claim. Testing n = 2: 2² = 4, and 4 + 2 + 1 = 7, which is prime. Testing n = 3: 3² = 9, and 9 + 3 + 1 = 13, which is also prime — a counterexample has to give a result that isn't prime, and only n = 4 does that.
- (c) 59 — Substitute n = 7: 7² + 2 × 7 − 4 = 49 + 14 − 4 = 59. A sign error on the +2n term, treating it as −2n, gives 49 − 14 − 4 = 31. Working out 7² + 2 × 7 but forgetting to subtract the final 4 gives 49 + 14 = 63. Using n = 6 instead of n = 7 gives 36 + 12 − 4 = 44.
- (b) 5 — Method: expand the bracket first, then solve the resulting linear equation. Working: 3(2x − 1) = 6x − 3, so 6x − 3 = 27. Add 3 to both sides: 6x = 30. Divide by 6: x = 5. Answer: 5. 4 2/3 comes from multiplying only the 2x inside the bracket by 3 and forgetting to multiply the −1 as well, giving 6x − 1 = 27. 4 comes from a sign error when expanding, writing 6x + 3 instead of 6x − 3. 4.5 comes from dividing 27 by 3 to get 2x − 1 = 9, then forgetting to add 1 back before dividing by 2, using 2x = 9 instead of 2x = 10.
- (a) (2, 7) — Midpoint = ((x1+x2)/2, (y1+y2)/2) = ((−3+7)/2, (5+9)/2) = (4/2, 14/2) = (2, 7). (4, 14) comes from adding the coordinates correctly but forgetting to divide by 2. (2, 9) comes from correctly averaging the x-coordinates but simply copying the y-coordinate of the second point instead of averaging the y-coordinates. (5, 2) comes from subtracting the coordinates instead of adding them before halving: ((7−(−3))/2, (9−5)/2) = (5, 2).
- (a) x = 2, x = 7; y-intercept cannot be found here — Translating y = f(x) to y = f(x − 3) shifts the graph 3 units to the right, so each root increases by 3: x = −1 becomes x = 2, and x = 4 becomes x = 7. The y-intercept is the value at x = 0, which for this new graph is f(0 − 3) = f(−3) — and f(−3) is not one of the values given, so the new y-intercept cannot be worked out from the information given. Writing 'y-intercept stays at (0, −8)' wrongly assumes a horizontal translation leaves the y-intercept unchanged — it generally does not, since it moves the whole graph sideways, including the point that used to sit on the y-axis. Writing roots at x = −4 and x = 1 comes from translating 3 units to the LEFT instead of to the right — f(x − 3) shifts the graph in the positive x-direction, not the negative direction.
Build your own mix at the worksheet builder.