Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 3 — 2x² − 12x + 7 rewrites as 2(x² − 6x) + 7, then as 2[(x − 3)² − 9] + 7, which simplifies to 2(x − 3)² − 11, since −2 × 9 + 7 = −11. The bracket (x − 3)² is zero when x = 3, so the minimum occurs at x = 3. Treating the shift as b/a instead of b/(2a) — using 6 instead of 3 — gives x = 6, which is wrong. Reading the bracket's sign directly without negating it gives x = −3, wrong, because (x − 3)² is zero at x = 3, not x = −3. Reading off the coefficient of x itself, −12, and calling that the answer skips the completing-the-square process entirely and gives x = −12, which is wrong because b is not the turning point's x-coordinate under any circumstance. Always check: substituting your value of x should make the bracketed term equal to zero, and nothing else.
- (c) 6x(2x + 3) — The highest common factor of 12x² and 18x is 6x. Dividing each term by 6x gives 12x² ÷ 6x = 2x and 18x ÷ 6x = 3, so 12x² + 18x = 6x(2x + 3). A candidate who only takes out the number 6 (missing the x) gets 6(2x² + 3x), which is not fully factorised. A candidate who only takes out 2x (missing the extra factor of 3 in 6) gets 2x(6x + 9), also not fully factorised — the bracket still shares a common factor. A candidate who takes out 3x instead of the full 6x gets 3x(4x + 6), which again is not fully factorised since 4x + 6 shares a common factor of 2.
- (a) It has a solution between x = 2.6 and x = 2.7 — f(2.6) is negative and f(2.7) is positive, so the graph of f crosses the x-axis between x = 2.6 and x = 2.7, meaning the equation has a solution there. Choosing 'x = 2.6 is a solution' reads an end of the interval as the root itself, but f(2.6) = −1.424, which is not zero — the change of sign locates a root between the two values, it does not land on either of them. Choosing 'between x = −2.6 and x = −2.7' confuses the negative f-VALUE at 2.6 with a negative x-value. Choosing 'no root in this interval' misapplies the rule, which needs a CHANGE of sign — and a change of sign is exactly what these two values show.
- (a) 8 — f(x − 1) means every input to f is reduced by 1 before it is looked up. At x = 2, the input to f becomes 2 − 1 = 1, so f(x − 1) at x = 2 is f(1) = 8. Reading f(2) = 4 directly from the table, without applying the shift, gives 4. Shifting in the wrong direction, using x + 1 = 3 instead of x − 1 = 1, gives f(3) = 1. Confusing f(x − 1) with f(x) − 1 — taking f(2) = 4 and then subtracting 1 — gives 3.
- (b) 1215 — Method: generate the terms one at a time with the term-to-term rule and compare each with 1000 as you go, stopping at the first one that passes it. Working: the terms are 5, then 5 × 3 = 15, then 45, then 135, then 405, and 405 × 3 = 1215; 405 is still below 1000 while 1215 is above it. Answer: 1215. The distractors: 405 comes from stopping at the last term that is still below 1000 instead of giving the first one above it; 3645 comes from carrying on one term too far, past the first term that passes 1000; 2187 comes from using the multiplier 3 as the first term as well, generating 3, 9, 27, 81, 243, 729, 2187 instead of the sequence described.
- (a) x ≈ 6.70 — Since the two roots sum to 7, the other root is 7 − 0.30 = 6.70. The option 7.30 comes from adding the given root to 7 instead of subtracting it. The option 6.30 comes from subtracting 0.70 (one minus the given root) rather than the given root itself. The option 0.70 confuses the required root with the amount by which the given root falls short of 1.
- (c) x = 2, y = 3 — Method: no letter cancels straight away, so make one letter the subject of one equation and substitute that expression into the other. Working: 2x + y = 7 gives y = 7 − 2x, so x + 2y = 8 becomes x + 2(7 − 2x) = 8, that is x + 14 − 4x = 8, so −3x = −6 and x = 2; substituting back gives y = 7 − 4 = 3. Answer: x = 2, y = 3, which checks in 2 + 6 = 8. The distractors: x = 3, y = 2 comes from adding the equations to x + y = 5 and then subtracting them the wrong way round, writing x − y = 1 instead of x − y = −1; x = 2, y = 5 comes from substituting x = 2 into 2x + y = 7 as 2 + y = 7, dropping the coefficient; x = −2, y = 11 comes from dividing −3x = −6 as though two minus signs gave a negative answer.
- (a) x = 4 ± √13 — Method: halve the coefficient of x to form the bracket, subtract the square of that number to keep the expression equal to the original, then rearrange and take the square root of both sides. Working: half of −8 is −4, so x² − 8x + 3 = (x − 4)² − 16 + 3 = (x − 4)² − 13; setting this equal to zero gives (x − 4)² = 13, so x − 4 = ±√13 and x = 4 ± √13. Answer: x = 4 ± √13. The distractors: x = 8 ± √13 comes from putting the whole coefficient 8 inside the bracket instead of half of it; x = 4 ± √19 comes from adding 16 and 3 rather than subtracting 3 from 16; x = −4 ± √13 comes from writing the bracket as (x + 4)², which reverses the sign of the number that comes out of it.
- (d) 6.0 — Subtract 1.8 from both sides: 6.3x ≤ 38.2. Divide both sides by 6.3: x ≤ 6.0634… . The question asks for the greatest value to 1 decimal place that still satisfies the inequality. Testing 6.1: 6.3 × 6.1 + 1.8 = 40.23, which is more than 40, so 6.1 fails. Testing 6.0: 6.3 × 6.0 + 1.8 = 39.6, which is no more than 40, so 6.0 works and is the greatest such value. A candidate who simply rounds 6.0634… to 1 decimal place answers 6.1, without checking that it satisfies the inequality. A candidate who adds 1.8 instead of subtracting works out 41.8 ÷ 6.3 and answers 6.6. A candidate who forgets the 1.8 altogether divides 40 by 6.3 and answers 6.3.
- (b) 4 — Method: form the equation 30 + 25h = 130, where h is the number of hours, then solve for h. Working: subtract the call-out fee from the total bill: 25h = 130 − 30 = 100. Divide by the hourly rate: h = 100 ÷ 25 = 4. Answer: 4 hours. 5.2 comes from dividing the whole bill by the hourly rate without subtracting the fixed fee first, 130 ÷ 25. 3.5 comes from swapping the fee and the rate, subtracting the rate from the bill and dividing by the fee, (130 − 25) ÷ 30. 6.4 comes from adding the call-out fee to the bill instead of subtracting it, before dividing by the rate, (130 + 30) ÷ 25.
- (c) £8,000 — The multiplier for one year is 1 − 0.18 = 0.82, so 0.82 × 0.82 = 0.6724. Original value = 5,379.20 ÷ 0.6724 = £8,000. Treating the total drop as simple depreciation (18% × 2 = 36% lost in total, so dividing by 0.64 instead of 0.6724) gives 5,379.20 ÷ 0.64 = £8,405 (nearest pound) — wrong, because the depreciation compounds year by year rather than adding up. Dividing by 0.82 only once, forgetting the second year entirely, gives 5,379.20 ÷ 0.82 = £6,560 — wrong, because two years of depreciation have passed, not one. Multiplying by 0.6724 instead of dividing by it — repeating the depreciation forward instead of reversing it — gives 5,379.20 × 0.6724 = £3,617 (nearest pound) — wrong, because to find the ORIGINAL value you must undo the depreciation, not apply it again.
- (d) 2n² − n − 2 — First differences: 5, 9, 13, 17. Second differences: 4, 4, 4, so a = 4 ÷ 2 = 2. Subtracting 2n² (2, 8, 18, 32, 50) from the terms (−1, 4, 13, 26, 43) leaves −3, −4, −5, −6, −7, which is the linear expression −n − 2. So the nth term is 2n² − n − 2. Using the second difference itself as a, without halving it, gives 4n² − n − 2. Finding a = 2 correctly but dropping the linear remainder −n − 2 entirely leaves 2n². Treating the first first difference (5) as a common difference and building a + (n − 1)d = −1 + 5(n − 1) gives 5n − 6, which only matches the first two terms.
- (b) 20 — The rate is the gradient: the change in litres divided by the change in time. From 2 to 7 minutes, the tank gains 150 − 50 = 100 litres over 7 − 2 = 5 minutes, so the rate is 100 ÷ 5 = 20 litres per minute. 100 comes from working out the change in litres but forgetting to divide by the change in time. 25 comes from using only the first reading, 50 ÷ 2, and ignoring the second reading entirely. 0.05 comes from dividing the change in time by the change in litres instead of the other way round, 5 ÷ 100.
- (c) The cost, in pounds, for each extra gigabyte of data used — In C = 15 + 2g, the number multiplying g is the gradient, which gives the extra cost for each extra unit of g — here, £2 for each extra gigabyte. 'The fixed monthly fee, in pounds' describes the constant term 15, not the coefficient of g. 'The total number of gigabytes included in the plan' misreads the coefficient as a quantity of data rather than a cost per gigabyte. 'The cost … for each extra 2 gigabytes' doubles the unit the coefficient actually applies to — it is the cost for each single extra gigabyte.
- (b) 3 — Method: rearrange the equation into the form y = mx + c first, then read off the gradient. Working: dividing 4y = 12x + 20 by 4 gives y = 3x + 5, so the gradient is 3. The value 12 comes from reading the coefficient of x before dividing the equation by 4. The value 20 comes from using the constant term of the unsimplified equation instead of the gradient. The value 5 comes from finding the y-intercept, 20 / 4 = 5, and giving that instead of the gradient.
Build your own mix at the worksheet builder.