Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) x = 3 and x = −5 — To factorise x² + 2x − 15, find two numbers that multiply to −15 and add to 2: these are 5 and −3, since 5 × (−3) = −15 and 5 + (−3) = 2. So x² + 2x − 15 = (x + 5)(x − 3). Setting each factor to zero gives x = −5 and x = 3. Choosing x = −3 and x = 5 comes from swapping the signs of the correct roots. Choosing x = 5 and x = 3 uses the right pair of numbers, 5 and 3, but forgets that one of them must be negative for the product to equal −15. Choosing x = −15 and x = 1 mistakes the constant term, −15, for one of the roots, and pairs it oddly with x = 1.
- (d) 2x/(x − 2) — Factorise x² − 4 as (x − 2)(x + 2) first — it's a difference of two squares. The (x + 2) in the numerator then cancels with the (x + 2) in the factorised denominator, and 6x² ÷ 3x simplifies to 2x, leaving 2x/(x − 2). Writing 2/(x − 2) comes from over-cancelling 6x² ÷ 3x as 2 instead of 2x, dropping the x that should remain. Writing 2x/(x + 2) comes from factorising x² − 4 as (x + 2)² instead of (x − 2)(x + 2), a difference of two squares always has one plus and one minus bracket. Writing 2x²/(x − 2) comes from simplifying 6x² ÷ 3x as 2x² instead of 2x, dividing the coefficients but not reducing the power of x.
- (a) (15, 0) — Method: the tangent is perpendicular to the radius at the point of contact, so find the gradient of the radius, take its negative reciprocal, write the equation of the tangent, then substitute y = 0 because every point on the x-axis has y-coordinate 0. Working: the radius from (0, 0) to (3, 6) has gradient 6 ÷ 3 = 2, so the tangent has gradient −1/2. Substituting into y − 6 = −1/2(x − 3) gives y = −0.5x + 7.5. Setting y = 0 gives 0.5x = 7.5, so x = 15 and P is (15, 0). Answer: (15, 0). The distractors: (0, 7.5) is where the same tangent crosses the y-axis, reached by setting x = 0 instead of y = 0; (0, 0) comes from using the gradient of the radius, 2, for the tangent, which gives the line y = 2x through the centre and so crosses the x-axis at the origin; (6, 0) comes from changing the sign of the radius gradient without turning it upside down, which gives y = −2x + 12.
- (d) 5 — Each term is found by multiplying the previous term by the common ratio, 0.5: 80, 40, 20, 10, and the next term is 10 × 0.5 = 5. A candidate who instead subtracts the same amount each time (repeating the last difference of 10) would reach 10 − 10 = 0. A candidate who divides by 4 instead of by 2 would reach 10 ÷ 4 = 2.5. A candidate who multiplies by 2 instead of dividing (reversing the direction of the sequence) would reach 10 × 2 = 20.
- (c) 59 — Substitute n = 7: 7² + 2 × 7 − 4 = 49 + 14 − 4 = 59. A sign error on the +2n term, treating it as −2n, gives 49 − 14 − 4 = 31. Working out 7² + 2 × 7 but forgetting to subtract the final 4 gives 49 + 14 = 63. Using n = 6 instead of n = 7 gives 36 + 12 − 4 = 44.
- (d) (0, 4) — Method: in the form y = mx + c the constant c is the y-coordinate of the point where the line crosses the y-axis, and every point on that axis has x-coordinate 0. Working: comparing y = 2x + 4 with y = mx + c gives c = 4, and substituting x = 0 confirms y = 2 × 0 + 4 = 4, so the crossing point is (0, 4). Answer: (0, 4). The distractors: (4, 0) is the same pair of numbers written in the wrong order and is a point on the x-axis; (0, 2) comes from reading the gradient 2 as the intercept, confusing m with c; (−2, 0) is where the line crosses the x-axis, found by solving 0 = 2x + 4 instead.
- (a) (2, 7) — Midpoint = ((x1+x2)/2, (y1+y2)/2) = ((−3+7)/2, (5+9)/2) = (4/2, 14/2) = (2, 7). (4, 14) comes from adding the coordinates correctly but forgetting to divide by 2. (2, 9) comes from correctly averaging the x-coordinates but simply copying the y-coordinate of the second point instead of averaging the y-coordinates. (5, 2) comes from subtracting the coordinates instead of adding them before halving: ((7−(−3))/2, (9−5)/2) = (5, 2).
- (d) x = 5 — Method: expand the bracket by multiplying both terms inside it by 5, then undo the addition and the multiplication in turn. Working: expanding gives 5x + 15 = 40; subtracting 15 from both sides gives 5x = 25; dividing both sides by 5 gives x = 5. Answer: x = 5. The distractors: x = 8 comes from dividing both sides by 5 first, reaching x + 3 = 8 and writing 8 as the value of x without taking the 3 away; x = 11 comes from adding 15 to both sides instead of subtracting it, giving 5x = 55; x = 7.4 comes from expanding 5(x + 3) as 5x + 3, multiplying only the x by the 5, which leads to 5x = 37.
- (a) 7 — Multiply the input by 2: 6 × 2 = 12. Then subtract 5: 12 − 5 = 7. A candidate who does the operations in the wrong order, subtracting 5 first and then multiplying by 2, gets (6 − 5) × 2 = 2. A candidate who only carries out the multiplication and forgets to subtract gets 12. A candidate who adds 5 instead of subtracting gets 6 × 2 + 5 = 17.
- (a) 271 m — The reading at t = 12 isn't in the table, so it must be interpolated between t = 10 (35 m/s) and t = 14 (27 m/s): the velocity falls by 8 m/s over the 4-second gap, so over 2 seconds it falls by 4 m/s, giving 35 − 4 = 31 m/s. The trapezium rule then uses three strips of unequal width, 4, 6 and 2 seconds, with areas of 40, 165 and 66: 40 + 165 + 66 = 271 m. Writing 267 m comes from skipping the interpolation and using the table's t = 14 reading, 27, directly as the height at t = 12. Writing 282 m comes from treating all three strips as though they were 4 seconds wide, instead of using the true gaps of 4, 6 and 2 seconds between the readings. Writing 275 m comes from using the t = 10 reading, 35, at both ends of the final strip, instead of interpolating a new value at t = 12.
- (d) y = −f(x + 2) has a maximum turning point at (1, 5). — y = f(x + 2) translates the graph 2 units in the negative x-direction, so the turning point's x-coordinate moves from 3 to 1; reflecting in the x-axis then negates the y-coordinate, turning −5 into 5, and also turns a minimum into a maximum — giving a true maximum turning point at (1, 5). Translating the root at x = 1 in the wrong direction, adding 2 instead of subtracting it, gives x = 3, but the true image root is at 1 − 2 = −1, so that statement is false. Keeping the coordinates (1, 5) correct but forgetting that reflecting in the x-axis turns a minimum into a maximum gives a false "minimum turning point" statement. Getting the reflection's effect on the turning-point type right (a maximum) but translating the x-coordinate in the wrong direction, using 3 + 2 = 5 instead of 3 − 2 = 1, gives a false statement at (5, 5).
- (c) 50 — Method: the edge of the track is a circle centred on the origin, so it has equation x² + y² = r²; use the floodlight whose coordinates are given to find r², then substitute x = 0 to find where that circle meets the positive y-axis. Working: 30² + 40² = 900 + 1600 = 2500, so the edge of the track is x² + y² = 2500. Substituting x = 0 gives k² = 2500, so k = √2500 = 50, taking the positive root because k is positive. Answer: k = 50. The distractors: 2500 is r² used as though it were the radius, which would place the second floodlight fifty times too far from the centre; 70 adds the two coordinates, 30 + 40, instead of adding their squares; 40 takes the y-coordinate of the first floodlight to be the radius, which would only be true if that floodlight stood on the y-axis itself.
- (b) 158 minutes — Rearranging C = 15 + 0.2m for m: subtract 15 from both sides to get C − 15 = 0.2m, then divide by 0.2: m = (C − 15)/0.2. Substituting C = 46.60: m = (46.60 − 15)/0.2 = 31.60/0.2 = 158. Answering 233 minutes comes from dividing the whole £46.60 by 0.2 without first taking off the £15 fixed charge. Answering 308 minutes comes from adding the £15 instead of subtracting it: (46.60 + 15)/0.2. Answering 218 minutes divides first and subtracts 15 afterwards, in the wrong order: 46.60/0.2 − 15 = 233 − 15 = 218. Ali made 158 minutes of calls.
- (b) Translate −90° in x, then translate −2 in y. — cos(x + 90°) translates the graph 90° in the NEGATIVE x-direction, since a positive shift inside the bracket moves a graph left, not right, and subtracting 2 afterwards translates it 2 units in the negative y-direction (down). So the sequence is: translate −90° in x, then translate −2 in y. Using +90° in x reverses the direction of the horizontal shift — the sign inside the bracket moves the graph the opposite way to what it looks like. Using +2 in y reverses the direction of the vertical shift; subtracting 2 outside the function moves the graph down, not up. Describing the −2 as a reflection in the x-axis is wrong because a reflection turns positive y-values negative and vice versa, whereas here every y-value is simply reduced by the fixed amount 2, which is what a translation does, not a reflection.
- (b) (−5, −2) — Both points have the same y-coordinate, so the midpoint lies on the same horizontal line: y = −2. The x-coordinate is the average of −9 and −1: (−9 + (−1)) ÷ 2 = −10 ÷ 2 = −5, giving (−5, −2). (−10, −2) comes from adding the x-coordinates but forgetting to divide by 2. (−4, −2) comes from a sign error on the second x-coordinate, treating −1 as +1: (−9 + 1) ÷ 2 = −4. (5, −2) comes from dropping the negative sign on the x-coordinate.
Build your own mix at the worksheet builder.