Printable · GCSE Higher · ages 14-16
Geometrical problems on coordinate axes worksheet — GCSE Higher
Fifteen questions on "geometrical problems on coordinate axes" — DfE statement G11. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Geometrical problems on coordinate axes worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A vertical line passes through the point (5, 2). Write down the equation of this line.
- 2.Work out the length of the straight line segment joining the points (2, −4) and (−3, −4).
- 3.A is the point (1, 3) and B is the point (7, 3). Work out the coordinates of the midpoint of AB.
- 4.A rectangle has vertices A(1, 1), B(4, 1), C(4, 5) and D(1, 5). Work out the perimeter of the rectangle.
- 5.The point A(3, 2) is translated by the vector (−5, 4) to give point B. Work out the coordinates of B.
- 6.Triangle PQR has vertices P(0, 0), Q(9, 0) and R(0, 4). Work out the area of triangle PQR.
- 7.State whether the line segment joining A(−4, 3) and B(2, 6) is horizontal, vertical or neither, and give a reason for your answer.
- 8.Work out the distance between the point (0, 0) and the point (5, 12).
- 9.A quadrilateral has vertices A(1, 1), B(5, 1), C(6, 4) and D(2, 4). By comparing the y-coordinates of A, B and of D, C, write down whether the sides AB and DC are parallel, and give a reason for your answer.
- 10.P is the point (3, 4) and Q is the point (6, 0). Work out the distance of each point from the origin, and write down which point is closer to the origin.
- 11.Work out the y-coordinate of the midpoint of the line segment joining (2, 4) and (8, 10).
- 12.Work out the gradient of the line segment joining A(2, 3) and B(6, 11).
- 13.A(1, 2), B(5, 2) and C(5, 6) are three of the four vertices of a square ABCD. Work out the coordinates of D.
- 14.The midpoint of the line segment AB is (3, 5). A is the point (1, 3). Work out the coordinates of B.
- 15.Work out the distance between the points (−3, 4) and (5, −2).
Answer key
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (b) 5 — Method: the two points have the same y-coordinate, so the segment joining them runs horizontally and its length is the gap between the two x-coordinates; a length is a distance, so it is never negative. Working: the x-coordinates are 2 and −3, so the gap is 2 − (−3) = 2 + 3 = 5. Both points have y = −4, so there is no vertical part to add on. Answer: 5. The distractors: 1 comes from dropping the minus sign on −3 and working out 3 − 2 instead; 0 comes from subtracting the y-coordinates, which are equal, in place of the x-coordinates; 6 comes from counting the grid lines from −3 across to 2 inclusive, which counts one more than the number of gaps between them.
- (c) (4, 3) — Method: the midpoint of a segment is the mean of its two end points, so its x-coordinate is the mean of the two x-coordinates and its y-coordinate is the mean of the two y-coordinates. Working: for x, (1 + 7) ÷ 2 = 8 ÷ 2 = 4. For y, (3 + 3) ÷ 2 = 6 ÷ 2 = 3. The midpoint is therefore (4, 3). Answer: (4, 3). The distractors: (3, 3) comes from halving the difference of the x-coordinates, (7 − 1) ÷ 2 = 3, which measures half the distance instead of locating the point; (3.5, 3) comes from halving only the larger x-coordinate and leaving the smaller one out of the working; (4, 0) comes from averaging the x-coordinates correctly but then subtracting the y-coordinates, 3 − 3, rather than averaging them.
- (c) 14 units — Method: the perimeter of a rectangle is the distance all the way round its outside, 2 × (length + width), so the two side lengths must be found first; on a coordinate grid a side's length is the difference between the coordinates that change along it. Working: along AB, from (1, 1) to (4, 1), only x changes, so AB = 4 − 1 = 3. Along BC, from (4, 1) to (4, 5), only y changes, so BC = 5 − 1 = 4. Perimeter = 2 × (3 + 4) = 2 × 7 = 14. Answer: 14 units. The distractors: 18 units comes from reading the vertex numbers 4 and 5 as the side lengths instead of subtracting, giving 2 × (4 + 5); 12 units comes from working out the area, 3 × 4, in place of the perimeter; 7 units comes from adding one length to one width and stopping there, without doubling for the opposite pair of sides.
- (a) (−2, 6) — Translating by the vector (−5, 4) means adding −5 to the x-coordinate and adding 4 to the y-coordinate: (3 + (−5), 2 + 4) = (−2, 6). (8, 6) comes from treating −5 as +5, adding instead of subtracting on the x-coordinate. (−2, −2) keeps the x-coordinate correct but subtracts 4 from the y-coordinate instead of adding it. (7, −3) comes from swapping the two components of the vector, applying 4 to the x-coordinate and −5 to the y-coordinate.
- (a) 18 — PQ lies along the x-axis with length 9, and PR lies along the y-axis with length 4, and these two sides meet at right angles at P, so they can be used as the base and height of the triangle. Area = 1/2 × base × height = 1/2 × 9 × 4 = 18. 36 comes from multiplying the base and height but forgetting to halve the result. 13 comes from adding the two lengths, 9 + 4, instead of multiplying them. 26 comes from the perimeter-style calculation 2 × (9 + 4) instead of the triangle area formula.
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (b) 13 — Method: the straight-line distance between two points on a grid is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal gap and the vertical gap between them, so Pythagoras' theorem applies. Working: one point is the origin, so the horizontal gap is 5 and the vertical gap is 12. Then d² = 5² + 12² = 25 + 144 = 169, so d = √169 = 13. Answer: 13. The distractors: 17 comes from adding the two gaps, 5 + 12, instead of adding their squares and taking the root; 12 comes from reading off the vertical gap alone and offering that as the whole distance; 7 comes from subtracting the gaps, 12 − 5, as though a distance were a difference.
- (b) Parallel, since AB and DC are both horizontal lines — A and B both have y-coordinate 1, so AB is horizontal; D and C both have y-coordinate 4, so DC is horizontal too. Two horizontal lines are always parallel, so AB and DC are parallel. "Not parallel, since AB and DC have different lengths" is wrong twice over: AB runs from x = 1 to x = 5 and DC from x = 2 to x = 6, so both are in fact 4 units long, and in any case length has no bearing on whether two lines are parallel — only direction does. "Not parallel, since AB is horizontal and DC is vertical" misreads the coordinates of D and C, which share the y-coordinate 4 and so give a horizontal line, not a vertical one. "Parallel, since A and D have the same x-coordinate" rests on a false claim: A has x-coordinate 1 and D has x-coordinate 2, so they do not share an x-coordinate — and even if they did, it would say nothing about whether AB is parallel to DC.
- (b) P, since OP = 5 and OQ = 6 — Using the distance formula, OP = √(3² + 4²) = √(9 + 16) = √25 = 5, and OQ = √(6² + 0²) = √36 = 6. Since 5 is less than 6, P is closer to the origin. Naming Q as closer, with OQ = 5 and OP = 6, has the two distances swapped around the wrong point. Naming P as closer but with OP = 6 and OQ = 5 also has the two values swapped, even though it names the right point. The distances are not equal, since 5 is not the same as 6, so P and Q are not equally distant from the origin.
- (b) 7 — Method: each coordinate of a midpoint is the mean of the matching pair of coordinates, so the y-coordinate of the midpoint depends on the two y-coordinates alone. Working: the y-coordinates are 4 and 10, so the mean is (4 + 10) ÷ 2 = 14 ÷ 2 = 7. Answer: 7. The distractors: 5 comes from working out the x-coordinate of the midpoint, (2 + 8) ÷ 2 = 5, and writing that down in place of the y-coordinate the question asked for; 3 comes from halving the difference of the y-coordinates, (10 − 4) ÷ 2 = 3, which is half the vertical gap rather than a position; 14 comes from adding the two y-coordinates and forgetting to halve the total.
- (a) 2 — Gradient = (change in y) ÷ (change in x) = (11 − 3) ÷ (6 − 2) = 8 ÷ 4 = 2. "0.5" comes from dividing the change in x by the change in y the wrong way round: 4 ÷ 8. "8" is only the change in y, forgetting to divide by the change in x at all. "−2" comes from a sign error, as if the y-coordinate had decreased rather than increased.
- (b) (1, 6) — Method: when a square is set square-on to the grid, so that its sides run parallel to the axes, each vertex shares its x-coordinate with one neighbour and its y-coordinate with the other, and the missing vertex then borrows one coordinate from each of the two vertices it is joined to; so the first job is to check from the given points that the sides really do run parallel to the axes. Working: A(1, 2) and B(5, 2) share y = 2, so AB is a horizontal side; B(5, 2) and C(5, 6) share x = 5, so BC is a vertical side, which confirms that this square lies square-on to the axes and that the rule may be used. In square ABCD the vertex D is joined to C and to A. DC must be horizontal like AB, so D takes the y-coordinate of C, which is 6; DA must be vertical like CB, so D takes the x-coordinate of A, which is 1. D is therefore (1, 6), and checking confirms every side is 4 long. Answer: (1, 6). The distractors: (1, 5) comes from lifting the first number out of each of A and C, pairing the x-coordinate of A with the x-coordinate of C; (6, 1) comes from finding the right two numbers but writing them the wrong way round, height before sideways position; (9, 6) comes from stepping a further 4 to the right from C instead of closing the square back to the column A stands in.
- (a) (5, 7) — Method: a midpoint is the mean of the two end points, so for each coordinate (start + end) ÷ 2 = midpoint; rearranging that gives end = 2 × midpoint less the start. Working: for x, (1 + x) ÷ 2 = 3, so 1 + x = 6 and x = 5. For y, (3 + y) ÷ 2 = 5, so 3 + y = 10 and y = 7. B is therefore (5, 7). Answer: (5, 7). The distractors: (2, 2) comes from subtracting A from the midpoint, (3 − 1, 5 − 3), which gives the step from A to the midpoint and stops there instead of taking that same step a second time; (4, 8) comes from adding A to the midpoint, (3 + 1, 5 + 3), without doubling the midpoint first; (6, 10) comes from doubling the midpoint, (2 × 3, 2 × 5), and then forgetting to take A off.
- (d) 10 — Method: the distance between two points is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal and vertical gaps, so work out both gaps first, handling the negative coordinates carefully, and then apply Pythagoras' theorem. Working: the horizontal gap is 5 − (−3) = 5 + 3 = 8 and the vertical gap is 4 − (−2) = 4 + 2 = 6. Then d² = 8² + 6² = 64 + 36 = 100, so d = √100 = 10. Answer: 10. The distractors: 14 comes from adding the two gaps, 8 + 6, instead of adding their squares and taking the root; 100 comes from stopping at the sum of the squares and never taking the square root; 50 comes from reaching 100 correctly and then halving it instead of taking its square root, a candidate who has read the last step as “halve” rather than “root”.
Build your own mix at the worksheet builder.