Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A composite solid is made from a cylinder of radius 3 cm and height 10 cm, with a cone of the same radius and vertical height 4 cm fixed on top, apex upward. Work out the total volume of the solid. Use π = 3.14 and give your answer correct to 1 decimal place.
- 2.A cheese counter sells cheddar at £8.40 per kilogram. Work out the cost of a 350 g piece of cheddar.
- 3.A garden plan is drawn to a scale of 1 cm : 1.8 m. A path on the plan measures 4.5 cm. What is the real length of the path, in metres, to 1 decimal place?
- 4.Shape S is enlarged by a scale factor of −3 about a fixed centre. Which statement correctly describes the image compared to the original shape?
- 5.A cube has edges of length 5 cm. Work out the length of the diagonal that runs from one corner of the cube to the opposite corner. Give your answer as a surd in its simplest form.
- 6.In triangle ABC, AB = 7.4 cm, AC = 5.9 cm and angle BAC = 68°. Work out the length of BC. Give your answer to 1 decimal place.
- 7.A party hat is in the shape of a cone with a base radius of 6 cm and a slant height of 10 cm. Work out the curved surface area of the party hat. Use π = 3.14 and the formula curved surface area = πrl.
- 8.A student is asked to rearrange the cosine rule a² = b² + c² − 2bc cos A to make cos A the subject. They write: cos A = (a² − b² − c²) / (2bc). Is the student's rearrangement correct?
- 9.A kitchen scale is marked in equal divisions of 20 g. The pointer rests three divisions past the 400 g mark. Work out the reading on the scale.
- 10.The angle between north and a cycle path is 40°, but it is measured anticlockwise from north. What is the three-figure bearing of the cycle path?
- 11.A circle has centre O and radius 10 cm. Points A and B lie on the circle such that angle AOB = 130°. Work out the area of the minor segment cut off by the chord AB. Give your answer to 1 decimal place.
- 12.A hiker starts by walking on a bearing of 245°. She turns clockwise through 50°, then turns clockwise through a further 15°, and continues walking in a straight line. What bearing is she now walking on?
- 13.A circular garden pond has a diameter of 5 m. A gardener is laying gravel around it in a ring-shaped path 1 m wide, measured outward from the edge of the pond. Work out the area of the gravel path. Use π = 3.14.
- 14.A stage designer is building a triangular platform ABC for a school play. AB = 11.5 m, AC = 8.2 m and angle BAC = 72°, the angle between them. The flooring for the platform costs £15.80 per square metre. Work out the total cost of the flooring, to the nearest pound.
- 15.A car's windscreen wiper blade is 40 cm long and sweeps through an angle of 110° as it wipes the glass. Using π = 3.14, work out the area of glass it wipes, to the nearest cm².
Answer key
- (b) 320.3 cm³ — Cylinder volume = πr²h = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6 cm³. Cone volume = (1/3)πr²h = (1/3) × 3.14 × 9 × 4 = (1/3) × 113.04 = 37.68 cm³. Total = 282.6 + 37.68 = 320.28 cm³, which rounds to 320.3 cm³.
- (b) £2.94 — Method: the price is quoted for each kilogram, so the mass has to be written in kilograms before it is multiplied by the price. Working: 1 kg = 1000 g, so 350 ÷ 1000 = 0.35 and the piece weighs 0.35 kg. The cost is then 8.40 × 0.35 = 2.94. Answer: £2.94. Treating 350 g as 3.5 kg, a division by 100 rather than by 1000, gives 8.40 × 3.5 = 29.40. Multiplying the price by the number of grams gives 8.40 × 350 = 2940. Dividing the price by the mass instead of multiplying gives 8.40 ÷ 0.35 = 24.
- (a) 8.1 m — Multiply the length on the plan by the scale factor: 4.5 × 1.8 = 8.1, so the real length is 8.1 m. Choosing 6.3 m adds the two numbers instead of multiplying them (4.5 + 1.8 = 6.3). Choosing 2.5 m divides the plan length by the scale factor the wrong way round (4.5 ÷ 1.8 = 2.5) instead of multiplying. Choosing 9.0 m rounds the scale factor up to 2 before multiplying (4.5 × 2 = 9.0), losing the accuracy the 1.8 was giving.
- (a) 3 times the size, opposite side, rotated 180° — Method: for any enlargement, the MAGNITUDE of the scale factor gives the size ratio between image and object, while the SIGN decides which side of the centre the image falls on; a negative scale factor puts the image on the opposite side, which is equivalent to a 180° rotation about the centre. Working: the scale factor is −3, so the size ratio is the magnitude, which is 3, and the negative sign puts the image on the opposite side of the centre, rotated 180° relative to the original. Answer: 3 times the size, opposite side, rotated 180°. The magnitude of the scale factor controls the SIZE only: do not let the sign leak into it and turn 3 into 1/3. The sign controls the SIDE and orientation, which a positive-only view of enlargement, just 'further away' with the same orientation, misses entirely.
- (c) 5√3 cm — The space diagonal of a cube with edge a satisfies d² = a² + a² + a² = 3a², using Pythagoras' theorem in three dimensions. With a = 5, d² = 3 × 5² = 3 × 25 = 75, so d = √75 = √(25 × 3) = 5√3 cm. Finding the diagonal of one face instead, using only two of the three edges, gives d = √(5² + 5²) = √50 = 5√2 cm, which leaves out the third dimension. Adding the three edges directly, 5 + 5 + 5 = 15 cm, ignores that Pythagoras' theorem works with squares of lengths, not the lengths themselves. Squaring the edge and multiplying by 3 correctly, 3 × 5² = 75, but then forgetting to take the square root, leaves 75 cm — the squared length, not the diagonal itself.
- (a) 7.5 cm — Method: two sides and the angle between them are given, so use the cosine rule a² = b² + c² − 2bc cos A, with BC as the side facing the 68° angle. Working: BC² = 7.4² + 5.9² − 2 × 7.4 × 5.9 × cos 68° = 54.76 + 34.81 − 87.32 × 0.3746 = 89.57 − 32.71 = 56.86, and the square root of 56.86 is 7.5405. Answer: BC = 7.5 cm to 1 decimal place. The distractors: 11.1 cm comes from adding the last term instead of subtracting it, 89.57 + 32.71 = 122.28, the commonest sign slip on the cosine rule; 56.9 cm is the value of BC² written down as though it were BC, stopping one step before the square root; 2.9 cm comes from pressing sin instead of cos, using 87.32 × sin 68° = 80.96 as the term to subtract.
- (a) 188.4 cm² — Curved surface area of a cone = πrl. With r = 6 cm, l = 10 cm and π = 3.14, curved surface area = 3.14 × 6 × 10 = 188.4 cm². A student who uses the cylinder's curved surface area formula, 2πrl, instead of the cone's gets 2 × 3.14 × 6 × 10 = 376.8 cm². A student who uses the circle-area formula πr² instead of πrl gets 3.14 × 36 = 113.04 cm². A student who multiplies r × l but leaves out π entirely gets 6 × 10 = 60 cm².
- (b) No — should divide by −2bc, not +2bc; sign is wrong. — Method: rearrange a² = b² + c² − 2bc cos A step by step and compare with the student's version. Working: subtracting b² + c² from both sides gives a² − b² − c² = −2bc cos A, then dividing both sides by −2bc gives cos A = (a² − b² − c²) / (−2bc), which is the same as cos A = (b² + c² − a²) / (2bc). The student divided by +2bc instead of −2bc, so their expression is the negative of the correct one — the verdict is No. Saying the algebra is fine because 'either sign order gives a valid result' ignores that only one of the two signed expressions matches the original equation. Saying the denominator should be bc rather than 2bc is a different, unrelated error — the coefficient 2bc in the original formula is correct and must stay.
- (c) 460 g — Each division is 20 g, so three divisions past the mark is 3 × 20 = 60 g. Adding this to the 400 g mark gives 400 + 60 = 460 g. Treating each division as worth 1 g instead of 20 g gives 400 + 3 = 403 g. Working out the extra amount correctly but forgetting to add the 400 g mark gives just 60 g. Treating each division as worth 10 g instead of 20 g gives 400 + 30 = 430 g.
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (b) 75.1 cm² — Method: a segment is a sector with its triangle cut away, so find the sector area and the triangle area (using Area = (1/2)r² sin C on the two radii) and subtract. Working: sector area = (130 ÷ 360) × π × 10² = 113.4 cm² (1 d.p.); triangle area = 1/2 × 10 × 10 × sin 130° = 38.3 cm² (1 d.p.); segment area = 113.4 − 38.3 = 75.1 cm². Answer: 75.1 cm². Reporting the sector area on its own, without subtracting the triangle, gives 113.4 cm²; reporting the triangle area on its own gives 38.3 cm²; and using the reflex angle, 360° − 130° = 230°, in the sector but still subtracting the triangle gives 162.4 cm², which is neither segment — the major segment would be the 230° sector PLUS the triangle, 239.0 cm². The minor segment is the smaller piece, cut off by the shorter arc, so use the angle actually given, 130°, and subtract the triangle from that sector.
- (d) 310 — Method: since both turns are clockwise, add both angles to the starting bearing. Working: 245° + 50° = 295°; 295° + 15° = 310°. A student who answers 295 has only added the first turn and forgotten the second one. A student who answers 180 has subtracted both turns instead of adding them. A student who answers 320 has added the two turns as 75° instead of 65° by misreading the second turn. Answer: 310°.
- (b) 18.84 m² — The pond has radius 2.5 m (half of the 5 m diameter), so the outer edge of the path has radius 2.5 + 1 = 3.5 m. Path area = area of outer circle − area of pond = 3.14 × 3.5² − 3.14 × 2.5² = 38.465 − 19.625 = 18.84 m².
- (b) £709 — Method: first find the area of the triangular platform with Area = (1/2)ab sin C, then multiply by the cost per square metre. Working: Area = 1/2 × 11.5 × 8.2 × sin 72° = 44.8 m² (1 d.p.); cost = area × £15.80, which rounds to £709 to the nearest pound. Answer: £709. Leaving out the 1/2 in the area formula doubles the area, giving a cost of £1417; using cos 72° instead of sin 72° gives a much smaller area and a cost of £230; and squaring the 11.5 m side instead of multiplying the two different given sides together gives a cost of £994. Find the exact area first — don't round it early — then multiply by the cost per square metre and round only the final answer.
- (d) 1535 cm² — The wiper sweeps out a sector of radius 40 cm, the blade length, through an angle of 110°. Sector area is angle ÷ 360 × π × radius²: 110 ÷ 360 × 3.14 × 1600 = 1535.1 cm², which rounds to 1535 cm². Forgetting to square the radius, using radius instead of radius², gives 38 cm². Using 110 ÷ 180 instead of 110 ÷ 360 for the fraction gives 3070 cm². Treating the 40 cm blade length as a diameter, so using a radius of 20 cm, gives 384 cm².
Build your own mix at the worksheet builder.