Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A shop stacks tins in a display block. The front elevation of the block is 4 tins wide and 3 tins high. The side elevation shows the block is 2 tins deep. Every position in the block is filled. How many tins are used in total?
- 2.A quadrilateral has both pairs of opposite sides parallel and equal in length, but none of its angles are right angles. Which statement about this quadrilateral is correct?
- 3.A parallelogram has an area of 136 cm² and a base of 17 cm. Work out the perpendicular height of the parallelogram.
- 4.A parallelogram-shaped tile has two sides of 6 cm and 9 cm, with an angle of 60° between them. Work out the area of the tile. Give your answer to 1 decimal place.
- 5.A drone starts at the point (3.5, −2) on a grid measured in metres. It flies by the vector to check a first sensor. The drone then needs to fly in a straight line to reach the point (−1.7, 9) to check a second sensor. Work out the column vector of this second flight.
- 6.A cylinder has a radius of 3 cm and a height of 10 cm. Using π = 3.14, work out the volume of the cylinder.
- 7.A right-angled triangle has a hypotenuse of 10 cm. One of its other angles is 45°. Work out the exact length of one of the two shorter sides.
- 8.A photograph is 10 cm wide and 15 cm tall. It is enlarged to make a similar poster that is 40 cm wide. The poster costs £0.80 per centimetre of its height to print, based on its full height. Work out the cost of printing the poster.
- 9.A zip wire is fixed at an angle of 50° to the horizontal, running from a high platform down to the ground. The zip wire itself, from the platform to the ground, is 12 m long. Work out the horizontal distance covered by the zip wire. Give your answer correct to 1 decimal place.
- 10.Points P and Q have coordinates P(0, 0, 0) and Q(5, 7, 9) in a three-dimensional coordinate system, with all lengths in centimetres. Work out the distance PQ. Give your answer correct to 1 decimal place.
- 11.A scale drawing shows a room that is 5 cm wide. The real room is 15 m wide. Write the scale of the drawing in the form 1 : n.
- 12.A photocopier enlarges a document so that every length is multiplied by the same scale factor. A line on the original document is 3.2 cm long, and the same line measures 11.2 cm on the enlarged copy. A second line on the original document is 2.5 cm long. Work out the length of the second line on the enlarged copy, giving your answer to 2 decimal places.
- 13.A window is made from a rectangle with a semicircle on top. The rectangle is 40 cm wide and 60 cm tall. The semicircle has the same width as the rectangle. Work out the total area of the window. Use π = 3.14. Give your answer to the nearest whole number.
- 14.A footpath sign shows a distance of 0.45 km to the next village. Work out this distance in metres.
- 15.A ferris wheel's circular frame has centre O. A support strut runs from O to a point A on the rim, and a second strut runs from O to point B on the rim, with angle AOB = 76°. A cabin is mounted at point C on the major arc AB, and D is a separate point on the minor arc AB. Work out the difference between angle ACB and angle ADB.
Answer key
- (a) 24 — The display is 4 tins wide, 3 tins high and 2 tins deep, and every position in that block is filled, so the total number of tins is the product of all three measurements: 4 × 3 × 2 = 24. "12" comes from multiplying only the width and height shown in the front elevation (4 × 3), forgetting the depth entirely. "9" comes from adding the three measurements (4 + 3 + 2) instead of multiplying them. "6" comes from multiplying only the height and depth (3 × 2), forgetting the width shown by the front elevation.
- (c) It is a parallelogram but not a rectangle — Method: match the given properties to the definition of each named quadrilateral. Working: having both pairs of opposite sides parallel and equal in length is exactly the definition of a parallelogram; since none of the angles are right angles, it cannot also be a rectangle, which needs four right angles. Options: 'must be a rectangle' wrongly assumes every parallelogram has right angles; 'must be a rhombus' wrongly assumes equal opposite sides means all four sides are equal, but only the opposite pairs are stated as equal here; 'trapezium' is wrong because a trapezium has exactly one pair of parallel sides, while this shape has two pairs, so it is a parallelogram and not a trapezium. Answer: it is a parallelogram but not a rectangle.
- (b) 8 cm — Area = base × height, so height = area ÷ base = 136 ÷ 17 = 8 cm. (16 cm comes from using the triangle formula, thinking area = 1/2 × base × height and so height = 2 × area ÷ base; 2312 cm comes from multiplying the area by the base instead of dividing; 119 cm comes from subtracting the base from the area instead of dividing the area by the base.)
- (b) 46.8 cm² — Method: for a parallelogram, not a triangle, the two sides and the angle between them give Area = ab sin C — there is no 1/2. Working: Area = 6 × 9 × sin 60° = 46.8 cm² (1 d.p.). Answer: 46.8 cm². Using the triangle formula, (1/2)ab sin C, on a parallelogram by mistake gives half the true area, 23.4 cm²; using cos 60° instead of sin 60° gives 27.0 cm²; and adding the two sides before multiplying by sin 60° gives 13.0 cm². A parallelogram is exactly two of the triangles this formula was built for, so never carry the 1/2 across from the triangle version.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
- (c) 282.6 cm³ — Volume of a cylinder = πr²h = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6 cm³. (94.2 cm³ comes from using πrh and forgetting to square the radius; 90 cm³ comes from using r²h and leaving π out altogether; 1130.4 cm³ comes from using the diameter, 6 cm, in place of the radius.)
- (a) 5√2 cm — Method: the angles of a triangle add to 180°, so the third angle is 45° as well and the two shorter sides are equal. Take one of them as the side opposite a 45° angle and use sin 45° = opposite ÷ hypotenuse. Working: the exact value of sin 45° is √2/2, so the shorter side = 10 × √2 ÷ 2, and half of 10 is 5. Answer: 5√2 cm, which is about 7.07 cm. Remembering sin 45° as √2 rather than as √2 halved gives 10√2 cm, which is longer than the hypotenuse. Halving the hypotenuse because 45° is half of 90° gives 5 cm. Taking the value from the other special triangle, sin 60° = √3/2, gives 5√3 cm.
- (d) £48 — Scale factor = new width ÷ original width = 40 ÷ 10 = 4. Poster height = 15 × 4 = 60 cm. Cost = 60 × £0.80 = £48. (£12 comes from forgetting to scale the height at all, and pricing the original 15 cm height; £15.20 comes from adding the scale factor 4 to the height instead of multiplying by it; £3 comes from dividing the height by the scale factor instead of multiplying by it.)
- (d) 7.7 m — The horizontal distance is adjacent to the 50° angle and the zip wire is the hypotenuse, so horizontal distance = 12 × cos 50° = 12 × 0.6428... = 7.71...≈ 7.7 m. "9.2 m" uses the sine ratio instead of cosine, 12 × sin 50° = 9.19...≈ 9.2 m, which actually finds the vertical drop of the zip wire, not the horizontal distance. "15.7 m" comes from dividing by the sine ratio instead of multiplying by the cosine ratio, 12 ÷ sin 50° = 15.66...≈ 15.7 m, both the wrong operation and the wrong ratio. "12.0 m" simply uses the length of the zip wire itself as the horizontal distance, ignoring the angle of 50° altogether.
- (c) 12.4 cm — In three dimensions, the distance between two points extends Pythagoras' theorem to three squared terms: PQ² = 5² + 7² + 9² = 25 + 49 + 81 = 155. Taking the square root, PQ = √155 = 12.4 cm (1 d.p.). Using only the x- and y-coordinates, and ignoring the third dimension entirely, gives PQ = √(5² + 7²) = √74 = 8.6 cm (1 d.p.), which is not the distance in 3D space. Adding the three coordinates directly, 5 + 7 + 9 = 21 cm, treats the coordinates as if they were lengths along a single straight path rather than the sides of a right-angled arrangement. Squaring and adding all three coordinates but forgetting to take the square root leaves 155 cm, the squared distance rather than the distance itself.
- (c) 1 : 300 — First convert both lengths to the same unit: 15 m = 1500 cm. The scale compares 5 cm on the drawing to 1500 cm in real life, so dividing both parts by 5 gives a scale of 1 : 300. A candidate who compares 5 to 15 without converting units gets 1 : 3. A candidate who converts 15 m to 150 cm, using the wrong conversion factor, gets 1 : 30. A candidate who converts 15 m to 15000 cm, again using the wrong conversion factor, gets 1 : 3000. The scale of the drawing is 1 : 300.
- (d) 8.75 cm — The scale factor of the enlargement is 11.2 ÷ 3.2 = 3.5. Applying this to the second line, 2.5 × 3.5 = 8.75 cm. The distractor 10.50 cm comes from adding the difference between the first line's two lengths (11.2 − 3.2 = 8) to the second line's original length, 2.5 + 8 = 10.5. The distractor 0.71 cm comes from using the scale factor the wrong way round, 2.5 × (3.2 ÷ 11.2) = 0.71 (to 2 d.p.). The distractor 8.70 cm comes from directly subtracting 11.2 − 2.5 = 8.7, muddling the two different lines instead of scaling the second one.
- (c) 3028 cm² — Split the window into a rectangle and a semicircle. Rectangle area = 40 × 60 = 2400 cm². The semicircle has radius 40 ÷ 2 = 20 cm, so its area = 0.5 × 3.14 × 20² = 628 cm². Total area = 2400 + 628 = 3028 cm². A student who uses a full circle instead of a semicircle on top of the rectangle gets 3.14 × 20² = 1256 cm² for the circle, plus 2400 cm² for the rectangle, totalling 3656 cm². A student who uses the rectangle's full width (40 cm) as the radius instead of halving it gets 0.5 × 3.14 × 40² = 2512 cm² for the semicircle, plus 2400 cm² for the rectangle, totalling 4912 cm².
- (c) 450 m — To convert km to m, multiply by 1000: 0.45 × 1000 = 450 m. Multiplying by 100 instead of 1000 gives 45 m. Multiplying by 10 000 instead of 1000 gives 4500 m. Not converting at all, just relabelling the number, gives 0.45 m.
- (a) 104° — Method: find each inscribed angle separately using the angle-at-the-centre theorem: for a point on the arc NOT cut off by the given central angle, halve that central angle; for a point on the OTHER arc, halve the REFLEX central angle instead; then subtract the smaller from the larger. Working: for C on the major arc, angle ACB = 76 ÷ 2 = 38 degrees. For D on the minor arc, D sees the reflex angle at the centre, 360 − 76 = 284 degrees, so angle ADB = 284 ÷ 2 = 142 degrees. The difference is 142 − 38 = 104 degrees. Answer: 104°. Both inscribed angles need the theorem applied separately, using the correct arc's central angle each time (the reflex angle for D), and the question asks for the DIFFERENCE between the two, not either angle on its own and not their sum, 180°, which is simply the opposite-angle total for the cyclic quadrilateral ACBD.
Build your own mix at the worksheet builder.