Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A rhombus has all four sides equal in length. Which statement about a rhombus is correct?
- 2.Triangle ABC and triangle DEF are similar. The area of triangle ABC is 36 cm² and the area of triangle DEF is 100 cm². Work out the ratio of the lengths of triangle ABC to the lengths of triangle DEF, in its simplest form.
- 3.A patio plan states: 'Side AB of the patio is parallel to side DC, and AB is longer than DC. Sides BC and AD are not parallel to each other and are not equal in length.' The four sides measure AB = 5.1 m, BC = 3.2 m, DC = 2.8 m and AD = 4.5 m. The tiler needs to order edging strip only for the sides that are not parallel to any other side. What total length of edging strip, in metres, should the tiler order?
- 4.Two straight paths cross at a junction in a park. One of the angles between them, measured with a protractor, is 76°. What is the size of the angle immediately next to it on a straight line?
- 5.Points A, B, C and D lie on a circle with centre O, in that order around the circle, and AC is a diameter. Which of the following circle facts does NOT apply to this diagram?
- 6.Two similar triangles have lengths in the ratio 2 : 5. The sides of the smaller triangle are 4 cm, 6 cm and 8 cm. Work out the length of the longest side of the larger triangle.
- 7.Each of these has an exact value. Write down the one whose value is the greatest.
- 8.A solid pyramid has a square base of side 6 cm. Its apex is directly above the centre of the base, at a vertical height of 8 cm. Work out the volume of the pyramid.
- 9.Triangle T has a vertex A at (4, 6). It is enlarged by a scale factor of −1/2, centre (2, 2). Work out the coordinates of the image of point A.
- 10.A cuboid measures 5 cm long (left to right), 3 cm deep (front to back) and 2 cm tall. Its front elevation is 5 cm wide by 2 cm high. Its side elevation is 3 cm wide by 2 cm high. What are the dimensions of its plan view, looking down from above?
- 11.A path goes from A(1, 1) to B(1, 5), then from B to C(6, 5). Work out the total length of the path from A to C.
- 12.Four angles meet at a point. Three of them measure 82°, 105° and 96°. Work out the size of the fourth angle.
- 13.Shape T has a vertex at (5, 3). T is enlarged by scale factor −1, centre (2, 1). Work out the coordinates of the image of the vertex (5, 3).
- 14.A right-angled triangle has a hypotenuse of 14 cm. One of the other angles is 30°. Work out the exact length of the side opposite the 30° angle.
- 15.A straight line touches the edge of a circle at exactly one point and does not cross into the circle at all. Write down the term for this line.
Answer key
- (b) Its diagonals cross at right angles — In a rhombus, the diagonals always bisect each other at right angles, because a rhombus is a parallelogram with all four sides equal. Its diagonals are not always equal in length — that is a property of a rectangle, and only holds for a rhombus in the special case where it is also a square. It does not always have four right angles — again, that is only true when the rhombus is also a square. Its order of rotational symmetry is generally 2, not 4; order 4 only happens when the rhombus is a square.
- (a) 3 : 5 — Method: for similar figures the ratio of the areas is the square of the ratio of the lengths, so the length ratio is found by taking the square root of each part of the area ratio. Working: the areas are in the ratio 36 : 100, and taking square roots gives √36 : √100 = 6 : 10, which cancels to 3 : 5. Answer: 3 : 5. The distractors: 9 : 25 is 36 : 100 in its simplest form, so it is still the ratio of the areas and the square roots were never taken; 5 : 3 takes the roots correctly but writes the parts the wrong way round, giving DEF to ABC when ABC to DEF was asked for; 25 : 9 makes both mistakes at once, leaving the area ratio and reversing it.
- (a) 7.7 m — AB is parallel to DC, so those two sides are each parallel to another side. BC and AD are stated to be not parallel to each other, so neither one is parallel to any other side — these are the two sides that need edging. Adding these: 3.2 + 4.5 = 7.7 m, so 7.7 m is correct. 7.6 m comes from an arithmetic slip when adding 3.2 and 4.5. 15.4 m comes from doubling the correct total, mistakenly assuming edging strip is needed along both faces of each side. 4.5 m comes from using only the longer of the two non-parallel sides and forgetting to add the shorter one.
- (b) 104 — Method: angles on a straight line add up to 180°. Working: 180° − 76° = 104°. A student who answers 76 has mistaken this for the vertically opposite angle, which is equal, rather than the adjacent angle on a straight line. A student who answers 90 has wrongly assumed the two paths must be perpendicular. A student who answers 14 has subtracted 76° from 90° instead of from 180°. Answer: 104°.
- (c) Tangent-chord angle = angle in the alternate segment. — This diagram has a diameter AC, a centre O, and a cyclic quadrilateral ABCD, but no tangent anywhere in it. 'Angle in a semicircle = 90°' applies directly, because AC is a diameter. 'Opposite angles of a cyclic quadrilateral sum to 180°' applies directly, because ABCD is a cyclic quadrilateral. 'Angle at the centre = twice angle at circumference' applies directly, because O is given as the centre of the circle. The tangent-chord fact relates the angle between a tangent and a chord to an angle elsewhere in the circle, and since this diagram has no tangent, there is nothing in it for that fact to describe — so it is the one theorem that does not apply here.
- (b) 20 cm — Method: corresponding sides of similar triangles are in the same ratio, and the longest side of one triangle corresponds to the longest side of the other; a ratio of 2 : 5 means each length is multiplied by 5 ÷ 2 = 2.5 going from the smaller triangle to the larger one. Working: the longest side of the smaller triangle is 8 cm, so the matching side of the larger triangle is 8 × 2.5 = 20. Answer: 20 cm. The distractors: 10 cm comes from scaling the shortest side, 4 cm, instead of the longest; 40 cm comes from multiplying by 5 and forgetting to divide by 2; 3.2 cm comes from multiplying by 2 ÷ 5 instead of 5 ÷ 2, which scales from the larger triangle down to the smaller one.
- (c) tan 45° — Method: replace each ratio by its exact value, then compare. Working: a right-angled triangle with a 45° angle is isosceles, so its opposite and adjacent sides are equal and the tangent of 45° is exactly 1. The others are cos 30° = √3/2, about 0.87; sin 45° = √2/2, about 0.71; and cos 60° = 1/2. Answer: tan 45°, the only one of the four that reaches 1. Reading √3/2 as though it were √3, about 1.73, makes cos 30° look the largest, but the division by 2 is part of the value. Ranking by the size of the angle also fails here, because the cosine of an angle falls as the angle grows.
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (c) (1, 0) — To enlarge about a centre other than the origin, find the vector from the centre to the point, scale that vector, then add it back to the centre. The vector from (2, 2) to A(4, 6) is (2, 4). Scaling by −1/2 gives (−1, −2). Adding this to the centre (2, 2) gives the image point (1, 0). (3, 4) comes from using +1/2 instead of −1/2, so the image lands on the same side as A instead of the opposite side. (−2, −3) comes from scaling A's coordinates directly about the origin, ignoring that the centre is (2, 2). (−2, −6) comes from using a scale factor of −2 instead of −1/2.
- (b) 5 cm by 3 cm — The plan view looks straight down on the cuboid's footprint, so it shows the length (5 cm, left to right) and the depth (3 cm, front to back) — the two dimensions that do not involve height. "5 cm by 2 cm" repeats the front elevation's dimensions, pairing the length with the height instead of the depth. "3 cm by 2 cm" repeats the side elevation's dimensions, again pairing the depth with the height rather than with the length. "5 cm by 5 cm" comes from mistakenly assuming the plan must be a square, pairing the length with itself instead of with the depth.
- (a) 9 — AB is a vertical segment, since A and B share the x-coordinate 1, and its length is the difference in y-coordinates: 5 − 1 = 4. BC is a horizontal segment, since B and C share the y-coordinate 5, and its length is the difference in x-coordinates: 6 − 1 = 5. The total path length is 4 + 5 = 9. 20 comes from multiplying the two lengths, 4 × 5, instead of adding them. 5 is only the length of BC, forgetting to include AB. 4 is only the length of AB, forgetting to include BC.
- (d) 77 — Method: angles that meet at a point add up to 360°. Working: 82 + 105 + 96 = 283; 360 − 283 = 77. Answer: 77°. A candidate who gives the sum of the three known angles and forgets to subtract it from 360° gets 283. A candidate who leaves out the 105° angle, working out 360 − 82 − 96, gets 182. A candidate who leaves out the 82° angle, working out 360 − 105 − 96, gets 159.
- (b) (−1, −1) — An enlargement by scale factor −1, centre (2, 1), sends a point P to the point on the opposite side of the centre, the same distance away: the image is 2 × centre − P. For the vertex (5, 3), this gives (2 × 2 − 5, 2 × 1 − 3) = (4 − 5, 2 − 3) = (−1, −1). Treating the centre as though it were the origin, and simply negating the point's coordinates, gives (−5, −3) — this ignores that the true centre is (2, 1), not (0, 0). Using scale factor +1 instead of −1 leaves the point exactly where it started, at (5, 3). Adding the point's displacement from the centre instead of subtracting it gives (2 × 2 + 5, 2 × 1 + 3) = (9, 5). Double the centre and subtract the point, and the image is (−1, −1).
- (b) 7 cm — The side opposite the 30° angle is found using sin 30° = opposite/hypotenuse, so opposite = 14 × sin 30° = 14 × 1/2 = 7 cm. 7√3 cm comes from using cos 30° = √3/2 instead of sin 30° (mixing up the opposite and adjacent sides). 14/√3 cm comes from using tan 30° = 1/√3 instead of sin 30°. 28 cm comes from dividing 14 by sin 30° instead of multiplying by it.
- (d) tangent — A line that touches a circle at exactly one point, without crossing into the circle, is called a tangent. A chord is a straight line joining two points ON the circle, so it touches at two points, not one. A radius runs from the centre to the circle's edge, not along the outside of it. A diameter is a chord that passes through the centre, also touching the circle at two points.
Build your own mix at the worksheet builder.