Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A scale model of a bridge is built so that 2 cm on the model represents 5 m of the real bridge. The real bridge is 45 m long. Work out the length of the model bridge, in centimetres.
- 2.The bearing of a harbour B from a ferry's position A is 260°. What is the bearing of A from B?
- 3.Triangle T has a vertex at (8, 4). It is enlarged by a scale factor of 1/2, centre (2, 4). Work out the coordinates of the image of this vertex.
- 4.Two similar triangular tiles have lengths in the ratio 3 : 5. The longest side of the smaller tile is 9 cm. Work out the length of the longest side of the larger tile.
- 5.Lines GH and JK are parallel. A straight line crosses GH at point M and crosses JK at point N. Angle HMN = 71°. Angle HMN and angle MNK are alternate angles. Work out angle MNK.
- 6.Triangle ABC is similar to triangle PQR. AB corresponds to PQ, and BC corresponds to QR. AB = 5 cm, PQ = 15 cm and BC = 7 cm. Work out the length of QR.
- 7.A pop-up canopy has two sloping supports that meet at the top. Each support makes an angle of 30° with the ground and is 6 m long. Using the exact value of cos 30°, work out the total width of the canopy's base.
- 8.A drone starts at the point (3.5, −2) on a grid measured in metres. It flies by the vector to check a first sensor. The drone then needs to fly in a straight line to reach the point (−1.7, 9) to check a second sensor. Work out the column vector of this second flight.
- 9.A chord divides a circle into two regions, one larger than the other. Write down the term used for the smaller of these two regions.
- 10.A ladder rests against a wall, making an angle of 60° with the ground. The ladder is 2 m long. Using the exact value of sin 60°, work out how high up the wall the ladder reaches, giving your answer in centimetres.
- 11.In triangle OAB, OA = a and OB = b. P is the point on OA such that OP = (1/3)a, and Q is the point on OB such that OQ = (1/3)b. Express the vector PQ in terms of a and b.
- 12.Two straight paths cross at a junction in a park. One of the angles between them, measured with a protractor, is 76°. What is the size of the angle immediately next to it on a straight line?
- 13.A scale drawing shows a room that is 5 cm wide. The real room is 15 m wide. Write the scale of the drawing in the form 1 : n.
- 14.A conservatory has a roof panel shaped like a regular octagon. Work out the interior angle of the octagon, then use it to work out the size of the reflex angle at the same vertex, on the outside of the roof panel.
- 15.p is the column vector with top number 2 and bottom number 3. q is the column vector with top number −1 and bottom number 4. Work out 2p + q, giving your answer as a column vector in the form (top, bottom).
Answer key
- (c) 18 — Method: divide the real length by 5 to find how many 'units' of 5 m it contains, then multiply by 2 cm for each unit. Working: 45 ÷ 5 = 9, so the real bridge is 9 lots of 5 m; each lot is represented by 2 cm on the model, so the model length is 9 × 2 = 18 cm. Options: 9 comes from stopping after the division, without multiplying by the 2 cm per unit; 90 comes from multiplying the real length by 2 directly, without dividing by 5 first; 4.5 comes from dividing by 5 and then dividing by 2 again, instead of multiplying by 2. Answer: 18.
- (a) 080° — The back bearing differs from the given bearing by 180°. Because 260° is greater than 180°, subtract 180°: 260 − 180 = 80°, so the bearing of A from B is 080°. Choosing 440° adds 180° instead of subtracting it, even though the result would be more than a full turn (260 + 180 = 440). Choosing 180° assumes the back bearing is always exactly 180°, ignoring the original bearing altogether. Choosing 100° comes from measuring the reflex angle the other way round the circle (360 − 260 = 100) instead of applying the 180° back-bearing rule.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (c) 15 cm — Method: going from the smaller tile to the larger one, every length is multiplied by the scale factor 5 ÷ 3. Working: 9 ÷ 3 = 3, and 3 × 5 = 15. Answer: 15 cm. The distractors: 11 cm comes from adding the difference between the parts of the ratio, 5 − 3 = 2, to the 9 cm side, treating a ratio as a gap rather than a multiplier; 45 cm comes from multiplying by 5 and forgetting to divide by 3; 27 cm comes from multiplying by 3, which is the part of the ratio belonging to the smaller tile.
- (d) 71° — Alternate angles between parallel lines are equal. Since angle HMN and angle MNK are alternate angles, angle MNK = angle HMN = 71°.
- (d) 21 cm — The scale factor from triangle ABC to triangle PQR is PQ ÷ AB = 15 ÷ 5 = 3. QR = BC × scale factor = 7 × 3 = 21 cm. A student who divides BC by the scale factor instead of multiplying gets 7 ÷ 3 = 2.33 cm. A student who multiplies BC by AB instead of by the scale factor gets 7 × 5 = 35 cm.
- (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
- (c) minor segment — A chord splits a circle into two segments; the smaller of the two is called the minor segment and the larger one the major segment. "major segment" names the larger region, the opposite of what is asked for. "sector" is a different region altogether, enclosed by two radii and an arc, not by a chord. "arc" is a curved length along the circumference, not an enclosed region at all.
- (c) 100√3 cm — The height is opposite the 60° angle, so height = 2 × sin 60° = 2 × √3/2 = √3 m. Converting to centimetres: √3 m = 100√3 cm. '√3 cm' forgets to convert the answer from metres to centimetres. '200√3 cm' comes from mis-recalling sin 60° as √3 instead of √3/2, dropping the denominator of the exact value: 2 × √3 = 2√3 m = 200√3 cm. '50√3 cm' comes from halving the ladder's length before multiplying by sin 60°, instead of using the full 2 m.
- (c) (1/3)b − (1/3)a — Method: PQ runs from P to Q, so PQ = OQ − OP. Working: PQ = (1/3)b − (1/3)a. Answer: PQ = (1/3)b − (1/3)a. Subtracting the other way round gives (1/3)a − (1/3)b, the same vector pointing back from Q to P instead of P to Q; using 2/3 instead of the 1/3 that OP and OQ were actually given as gives (2/3)b − (2/3)a; and using the full vectors a and b with no scaling at all gives b − a, which is AB, not PQ. Always subtract START from END, OQ − OP, and carry the fraction given in the question through to your final vector.
- (b) 104 — Method: angles on a straight line add up to 180°. Working: 180° − 76° = 104°. A student who answers 76 has mistaken this for the vertically opposite angle, which is equal, rather than the adjacent angle on a straight line. A student who answers 90 has wrongly assumed the two paths must be perpendicular. A student who answers 14 has subtracted 76° from 90° instead of from 180°. Answer: 104°.
- (c) 1 : 300 — First convert both lengths to the same unit: 15 m = 1500 cm. The scale compares 5 cm on the drawing to 1500 cm in real life, so dividing both parts by 5 gives a scale of 1 : 300. A candidate who compares 5 to 15 without converting units gets 1 : 3. A candidate who converts 15 m to 150 cm, using the wrong conversion factor, gets 1 : 30. A candidate who converts 15 m to 15000 cm, again using the wrong conversion factor, gets 1 : 3000. The scale of the drawing is 1 : 300.
- (a) 225 — Method: find the interior angle of the regular octagon, then subtract it from 360° to find the reflex angle at the same vertex, since the interior angle and the reflex angle together make a full turn. Working: there are 8 − 2 = 6 triangles' worth of angle in the octagon, so the interior angle = 6 × 180 ÷ 8 = 135; reflex angle = 360 − 135 = 225. Answer: 225°. A candidate who stops after finding the interior angle gives 135. A candidate who works out the exterior angle instead, 360 ÷ 8 = 45, gives 45. A candidate who subtracts the exterior angle from 360° instead of the interior angle, working out 360 − 45, gets 315.
- (b) (3, 10) — Method: multiply every part of p by 2, then add the matching parts of q. Working: 2p = (4, 6); adding q gives top 4 + (−1) = 3 and bottom 6 + 4 = 10. Answer: 2p + q = (3, 10). A candidate who forgets to double p first, working out p + q instead, gets (1, 7). A candidate who doubles q instead of p, working out p + 2q, gets (0, 11). A candidate who subtracts q instead of adding it, working out 2p − q, gets (5, 2).
Build your own mix at the worksheet builder.