Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A tangent touches a circle with centre O at the point P. Q is a point on the tangent. Write down the circle fact that tells you the size of angle OPQ.
- 2.A circular table mat has diameter 20 cm. Yasmin has a 70 cm length of ribbon and sews it around the edge of the mat with no overlap. Using π = 3.14, work out how much ribbon is left over after going around the mat once.
- 3.The angle between north and a cycle path is 40°, but it is measured anticlockwise from north. What is the three-figure bearing of the cycle path?
- 4.A cuboid has three different edge lengths: a length, a width and a height, all different from each other. How many rectangles make up its net in total?
- 5.A cylinder has a volume of 942 cm³ and a height of 12 cm. Using π = 3.14, work out the radius of the cylinder.
- 6.A radar station is at the origin of a grid, where each unit represents 1 km. A boat is detected at the point (7, 24). Work out the boat's distance from the station, then work out how many hours it will take the boat to reach the station travelling directly towards it at 5 km per hour.
- 7.A rotation of 200° clockwise about the origin is applied, and the image is then rotated 250° anticlockwise about the origin. Work out the single angle of rotation, measured clockwise and between 0° and 360°, that has the same overall effect as the two rotations combined.
- 8.Two triangles are proved congruent using the ASA condition. What can be concluded about the two remaining pairs of corresponding sides that were not part of the original ASA facts?
- 9.A hiker walks on a bearing of 065°. She then turns clockwise through 90° and continues walking in a straight line. What bearing is she now walking on?
- 10.A pinhole camera is set up at a pitch-side stand, with its aperture at the point O = (2, 1) on a grid. Light from the corner F of a triangular flag, at the point (4, 2), passes through the aperture and forms an inverted image on the film behind it. The projection is an enlargement of scale factor −1.5 centred at O. Work out the coordinates of the image of corner F.
- 11.In triangle ABC, AB = 8 cm, AC = 5 cm and angle BAC = 60°. Work out the value of BC².
- 12.m is the column vector with top number 3 and bottom number −4. Which of these column vectors is a scalar multiple of m?
- 13.A builder props a straight plank against a vertical wall to reach a window ledge. The foot of the plank is 2.1 m from the base of the wall, and the plank is 3.5 m long. Work out how high up the wall the plank reaches.
- 14.A plan of a car park is drawn to a scale of 1 : 500. A parking bay is drawn as a rectangle measuring 1.2 cm by 0.6 cm. The real width of the bay corresponds to the 0.6 cm side. What is the real width of the bay, in metres?
- 15.In quadrilateral ABCD the two sides AB and BC are each 6 cm long and meet each other at B. The two sides CD and DA are each 9 cm long and meet each other at D. No side of ABCD is parallel to any other side. Write down the mathematical name of this quadrilateral.
Answer key
- (d) The angle between a tangent and a radius is 90° — OP is the radius drawn to the point of contact P, and a circle theorem states that a tangent always meets that radius at a right angle, so angle OPQ = 90°. A tangent is not parallel to the radius it touches — at the point of contact it is perpendicular to that radius, not parallel to it. A tangent does not pass through the centre — a straight line through the centre that also touches the circle at one point would have to be a diameter, which is a different line entirely. The angle-in-a-semicircle theorem needs a triangle drawn inside the circle with a diameter as its longest side; there is no such triangle here, just a tangent and a radius.
- (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (a) 6 — A cuboid has six faces in total: a top, a bottom, a front, a back, and two ends — each one is a rectangle in the net, giving six rectangles altogether. Choosing 3 counts only the three PAIRS of congruent rectangles (top/bottom, front/back, two ends) rather than all six individual faces. Choosing 5 forgets one face, as if the net were missing its lid. Choosing 12 is the number of edges of a cuboid, not the number of rectangles in its net.
- (c) 5 cm — Volume of a cylinder = πr²h, so r² = V ÷ (πh) = 942 ÷ (3.14 × 12) = 942 ÷ 37.68 = 25, and r = √25 = 5 cm. A pupil who finds r² = 25 but forgets to take the square root gives 25 cm. A pupil who forgets to divide by π, using r² = 942 ÷ 12 = 78.5, gets r = √78.5 ≈ 8.9 cm. A pupil who forgets to divide by the height, using r² = 942 ÷ 3.14 = 300, gets r = √300 ≈ 17.3 cm. The correct radius is 5 cm.
- (c) 5 hours — The distance from the origin to (7, 24) is √(7² + 24²) = √(49 + 576) = √625 = 25 km. Travelling at 5 km per hour, the time taken is 25 ÷ 5 = 5 hours. 25 hours mistakes the distance itself for the time, forgetting to divide by the speed. 125 hours comes from multiplying the distance by the speed, 25 × 5, instead of dividing. 0.2 hours comes from dividing the speed by the distance, 5 ÷ 25, the wrong way round.
- (a) 310° — Method: give the two rotations opposite signs since they turn in opposite senses — clockwise positive, anticlockwise negative — combine them into a single signed turn, then convert that turn into an angle measured clockwise between 0° and 360°. Working: the first rotation is 200° clockwise, so +200. The second is 250° anticlockwise, so −250. Combined: 200 − 250 = −50, meaning the net effect is a 50° turn anticlockwise. Measured clockwise instead, that same turn is 360 − 50 = 310°. Answer: 310°. Give the two rotations opposite signs before combining them, and convert a negative (anticlockwise) result into a clockwise angle by subtracting it from 360°, not from 180°: taking 50° away from a half turn gives 130°, which is a different rotation altogether; adding the two sizes as if both were clockwise gives 450°, which reduces to 90°; and reporting the anticlockwise size without converting it gives 50°.
- (c) They must also be equal — Once two triangles are proved congruent by any condition, including ASA, they are identical in every respect: every pair of corresponding sides and every pair of corresponding angles must be equal, not just the ones originally used to prove the congruence. So the two remaining pairs of corresponding sides must also be equal, making 'they must also be equal' correct. 'They might be equal or not' and 'not enough information to say' both wrongly suggest that congruence only guarantees the specific facts used to prove it, when congruence actually guarantees the triangles are identical overall. 'They must be different' is backwards: the triangles being identical is the entire point of proving congruence, not a reason for a side to differ.
- (c) 155° — Turning clockwise adds to the bearing. Starting on a bearing of 065° and turning clockwise through 90° gives 065° + 90° = 155°. A candidate who instead subtracts, working out 90° − 65° = 25°, has performed the wrong operation, giving 025°. A candidate who turns anticlockwise instead of clockwise works out 065° − 90°, which gives a negative number, and adding 360° to fix this gives 335° — the bearing for turning the other way. A candidate who thinks turning does not change the bearing at all keeps the answer as 065°. The new bearing, turning clockwise, is 155°.
- (a) (−1, −0.5) — Method: for an enlargement centred at a point O that is not the origin, first find the point's position relative to O, multiply that by the scale factor, then add O's coordinates back on — image = O + k × (F − O). Working: F relative to O is (4, 2) − (2, 1) = (2, 1). Multiplying by the scale factor, −1.5 × (2, 1) = (−3, −1.5). Adding O back on: (2, 1) + (−3, −1.5) = (−1, −0.5). Answer: (−1, −0.5). Measure F's position from the aperture O, not from the origin, apply the full signed scale factor −1.5 to that displacement, and add O's own coordinates back on afterwards: measuring from the origin instead of O, treating the factor as +1.5, or adding O onto the wrong displacement all place the image mark somewhere else.
- (a) 49 cm² — Method: two sides and the angle between them are given, so use the cosine rule a² = b² + c² − 2bc cos A with BC facing the 60° angle. By hand, cos 60° = 0.5. Working: BC² = 8² + 5² − 2 × 8 × 5 × cos 60° = 64 + 25 − 80 × 0.5 = 89 − 40 = 49. Answer: BC² = 49 cm². The distractors: 129 cm² comes from adding the final term instead of subtracting it, 89 + 40; 89 cm² comes from leaving the cosine term out altogether and treating the 60° as though it were a right angle, so that Pythagoras applies; 69 cm² comes from forgetting the factor 2 in 2bc cos A and subtracting only 8 × 5 × 0.5 = 20.
- (b) (6, −8) — Method: a scalar multiple of m has the same ratio between its top and bottom numbers as m does. Working: m = (3, −4); multiplying both parts by 2 gives 2 × 3 = 6 and 2 × (−4) = −8, so (6, −8) is a scalar multiple of m. Answer: (6, −8). The vector (6, −4) needs a multiplier of 2 for the top number but only 1 for the bottom number, so it is not a multiple. The vector (−6, −8) needs a multiplier of −2 for the top number but 2 for the bottom number, so it is not a multiple. The vector (9, −8) needs a multiplier of 3 for the top number but 2 for the bottom number, so it is not a multiple.
- (b) 2.8 m — Use Pythagoras' Theorem: the plank is the hypotenuse (3.5 m) of a right-angled triangle formed with the wall and the ground (2.1 m). height² = 3.5² − 2.1² = 12.25 − 4.41 = 7.84. height = √7.84 = 2.8 m. A student who subtracts the two given lengths directly instead of using Pythagoras gets 3.5 − 2.1 = 1.4 m. A student who doubles the distance from the wall by mistake gets 2.1 × 2 = 4.2 m.
- (b) 3 — The real width is 0.6 × 500 = 300 cm, which converts to 3 m by dividing by 100. A candidate who uses the wrong side of the rectangle, 1.2 cm, instead of the 0.6 cm width, gets 1.2 × 500 = 600 cm = 6 m. A candidate who multiplies correctly but converts the 300 cm to metres by dividing by 1000 instead of 100 gets 0.3 m. A candidate who converts by dividing by 10 instead of 100 gets 30 m. The real width of the bay is 3 m.
- (b) Kite — Method: name a quadrilateral by matching what is given — which sides are equal, whether those equal sides lie next to each other or opposite each other, and whether any sides are parallel — against the definitions of the special quadrilaterals. Working: the two 6 cm sides meet at B and the two 9 cm sides meet at D, so each pair of equal sides is a pair of neighbours rather than a pair of opposites, and the stem rules out any parallel sides. The quadrilateral with two pairs of equal adjacent sides and no parallel sides is a kite. Answer: kite. The distractors: a rhombus is chosen by candidates who see two pairs of equal sides and read that as all four sides being equal, which the two different lengths of 6 cm and 9 cm rule out; a parallelogram is chosen by candidates who remember that a parallelogram has two pairs of equal sides but not that in a parallelogram the equal sides are the opposite ones, and who pass over the statement that nothing is parallel; an isosceles trapezium is chosen by candidates who notice that the shape is symmetrical about the line BD and treat symmetry on its own as the mark of a trapezium, when a trapezium needs a pair of parallel sides.
Build your own mix at the worksheet builder.