Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Work out the exact value of sin 45° × cos 45°.
- 2.A circular table mat has diameter 20 cm. Yasmin has a 70 cm length of ribbon and sews it around the edge of the mat with no overlap. Using π = 3.14, work out how much ribbon is left over after going around the mat once.
- 3.A plumber charges a £45 call-out fee, plus £28 for each hour worked. She works on a job for 3 hours 30 minutes, and her hours are billed by rounding up to the next whole hour. Work out the total amount she charges.
- 4.Two similar ponds have perimeters in the ratio 4 : 11. The perimeter of the larger pond is 88 m. Work out the perimeter of the smaller pond.
- 5.A cone is cut by a flat plane parallel to its circular base, partway up between the base and the apex. What shape is the cross-section?
- 6.A landscaper marks out two triangular flower beds using stakes and a tape measure. Bed 1 has two edges of 5 m and 7 m, meeting at a corner with a marked angle of 60° between them. Bed 2 has edges of 5 m and 7 m, meeting at a corner also marked at 60° between them. The landscaper wants to check the two beds will be exactly the same size and shape using only these three measurements. Which condition proves the two beds are congruent?
- 7.A tent has the cross-section of a right-angled triangle. The sloping side of the cross-section is 10 m long, and it makes an angle of 60° with the horizontal ground. Using the exact value of cos 60°, work out the horizontal distance covered by the sloping side.
- 8.A shape is reflected in the line x = 1, and the image is then reflected in the line x = 5. Which single transformation is equivalent to this combination, for every point?
- 9.A regular polygon has an exterior angle of 45°. Work out the number of sides of the polygon.
- 10.Point Q has coordinates (3, 5). It is translated by the vector (1, −2), and the image is then enlarged by scale factor 3, centre the origin. Work out the coordinates of the final image of Q.
- 11.A cylindrical candle and a cone-shaped candle have the same base radius and the same height. State the cone's volume as a fraction of the cylinder's volume.
- 12.A, B, C and D are points on a circle with centre O, in that order around the circle. B lies on the major arc AC, and angle AOC = 152°. In triangle ACD, angle ACD = 30°. Work out the size of angle DAC.
- 13.A triangle has vertices A(0, 0), B(10, 0) and C(5, 12). Work out the area of the triangle.
- 14.OAB is a triangle, with OA = a and OB = b. E lies on OA produced beyond A, such that A is the midpoint of OE. F lies on AB such that FB is twice AF. G is the midpoint of OB. By finding the vectors EF and EG, show that E, F and G are collinear, and give the scalar k such that EF = k × EG.
- 15.A parallelogram has an area of 84 cm² and a base of 12 cm. Work out the perpendicular height of the parallelogram.
Answer key
- (c) 1/2 — sin 45° = √2/2 and cos 45° = √2/2, so sin 45° × cos 45° = √2/2 × √2/2 = 2/4 = 1/2. √2/2 comes from writing down only one of the two factors and forgetting to multiply by the other. √2 comes from adding the two exact values instead of multiplying them: √2/2 + √2/2 = √2. 1 comes from wrongly treating sin 45° × cos 45° as sin(45° + 45°) = sin 90° = 1 — multiplying two ratios is not the same as adding their angles.
- (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
- (b) £157 — Method: round the hours worked up to the next whole hour, multiply by the hourly rate, then add the call-out fee. Working: 3 hours 30 minutes rounds up to 4 hours; 28 × 4 = 112; 112 + 45 = 157. Answer: £157. A candidate who uses the unrounded time of 3.5 hours, working out 28 × 3.5 = 98 and adding 45, gets £143. A candidate who forgets the call-out fee, giving only 28 × 4, gets £112. A candidate who rounds down to 3 hours instead of up, working out 28 × 3 = 84 and adding 45, gets £129.
- (a) 32 m — The scale factor from the larger pond to the smaller pond is 4 ÷ 11, so the smaller perimeter is 88 × 4 ÷ 11 = 32 m. The distractor 242 m comes from using the ratio the wrong way round, 88 × 11 ÷ 4 = 242. The distractor 84 m comes from subtracting the smaller ratio number, 88 − 4 = 84, instead of scaling. The distractor 121 m comes from multiplying 11 × 11 = 121, ignoring the given perimeter altogether.
- (a) A smaller circle — Since the cutting plane is parallel to the circular base, the cross-section is also a circle, but smaller than the base because the cone narrows as it rises towards the apex, so 'a smaller circle' is correct. 'A triangle' wrongly describes the outline seen from the side of the cone, not a horizontal cross-section. 'An ellipse' would only result from a cut made at an angle to the base, not one parallel to it. 'The same size circle as the base' wrongly ignores that the cone tapers, so any parallel cross-section above the base must be smaller.
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (c) 5 m — The horizontal distance is the side adjacent to the 60° angle, and the sloping side is the hypotenuse, so horizontal distance = hypotenuse × cos 60°. The exact value of cos 60° is 1/2, so horizontal distance = 10 × 1/2 = 5 m. Using the sloping side itself as the horizontal distance, without using any trigonometry at all, gives 10 m. Using sin 60° = √3/2 instead of cos 60° finds the vertical height of the tent rather than the horizontal distance: 10 × √3/2 = 5√3 = 8.7 m (1 d.p.). Dividing the sloping side by cos 60° instead of multiplying by it, 10 ÷ 0.5 = 20 m, treats the sloping side as though it were the adjacent side rather than the hypotenuse.
- (c) Translation by the vector (8, 0) — Method: reflecting twice in two parallel vertical lines is always equivalent to a single translation, at right angles to the lines, of twice the distance between them. Working: the two lines are 5 − 1 = 4 units apart, so the translation is 2 × 4 = 8 units in the positive x-direction. Answer: translation by the vector (8, 0). Using just the gap itself, without doubling it, gives (4, 0); translating in the negative x-direction, from the second line back towards the first, gives (−8, 0); and describing the combination as a single reflection in the line halfway between them, x = 3, confuses this combination with the effect of a single reflection — two reflections in parallel lines are always equivalent to a translation, never to another reflection. Always double the gap between the lines, and translate in the direction from the first line towards the second.
- (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
- (b) (12, 9) — Apply the transformations in the order given: first translate, then enlarge. Translating (3, 5) by the vector (1, −2) gives (3 + 1, 5 − 2) = (4, 3). Enlarging this by scale factor 3 about the origin multiplies both coordinates by 3: (4 × 3, 3 × 3) = (12, 9). Enlarging first and translating afterwards reverses the order and gives (3 × 3 + 1, 5 × 3 − 2) = (10, 13), a different point because the two transformations do not commute. Enlarging the original point by scale factor 3 while forgetting to translate it at all gives (3 × 3, 5 × 3) = (9, 15). Reversing the signs of the translation vector before applying it gives (3 − 1, 5 + 2) = (2, 7), which then enlarges to (2 × 3, 7 × 3) = (6, 21).
- (c) One third of the cylinder's volume — Volume of a cylinder = base area × height. Volume of a cone = 1/3 × base area × height. For the same base radius and height, the cone's volume is exactly one third of the cylinder's, so it uses less wax. A student who thinks the cone is half the cylinder's volume has confused it with a different solid's ratio. A student who thinks the two volumes are the same has ignored the 1/3 factor in the cone formula entirely. A student who thinks the cone is two thirds of the cylinder's volume has the right idea that it is a fraction, but the wrong fraction.
- (a) 46° — Method: use the angle at the centre, then the cyclic quadrilateral, then the angle sum of a triangle. Working: angle ABC = 152° ÷ 2 = 76° (angle at the centre is twice the angle at the circumference); angle ADC = 180° − 76° = 104° (opposite angles of a cyclic quadrilateral sum to 180°); angle DAC = 180° − 104° − 30° = 46° (angle sum of triangle ACD). Skipping the halving step and taking angle ABC = 152° gives angle ADC = 180° − 152° = 28° and then angle DAC = 122°; using angle ABC = 76° directly as angle ADC, skipping the cyclic quadrilateral step, gives 74°; and finding angle DAC as 180° − 104° without subtracting the given 30° gives 76°. Each of the three steps must be carried through in order — halve, then subtract from 180°, then subtract from 180° again with the extra angle.
- (b) 60 units² — Method: the area of a triangle is half the base times the perpendicular height, so choose a side to act as the base and measure the perpendicular distance from the opposite vertex to it. Working: A(0, 0) and B(10, 0) both lie on the x-axis, so AB is horizontal and AB = 10 − 0 = 10. The perpendicular height is the distance of C from the x-axis, which is its y-coordinate, 12. Area = (10 × 12) ÷ 2 = 120 ÷ 2 = 60. Answer: 60 units². The distractors: 120 units² comes from multiplying base by height and forgetting to halve; 65 units² comes from using the slanting side AC, which is 13 long, as the height in place of the perpendicular distance 12; 30 units² comes from halving the base to 5 before multiplying and then halving the product as well, so the halving is done twice.
- (d) 2/3 — Method: since A is the midpoint of OE, OE = 2a, so E = 2a. Since FB is twice AF, F is 1/3 of the way along AB from A, so F = a + 1/3(b − a) = (2/3)a + (1/3)b. G is the midpoint of OB, so G = (1/2)b. Working: EF = F − E = (2/3)a + (1/3)b − 2a = −(4/3)a + (1/3)b, and EG = G − E = −2a + (1/2)b. Comparing term by term, 2/3 × (−2a + (1/2)b) = −(4/3)a + (1/3)b, which matches EF exactly — the same scalar works on both the a-term and the b-term, so the two vectors are parallel, and since they share the point E the three points are collinear. Answer: k = 2/3, so E, F and G lie on a straight line. Giving 1/3 instead is the scalar linking F to G (FG = (1/3)EG), not E to F; giving 3/2 is the reciprocal — it is EG that equals 3/2 × EF, not the other way round, since EF = k × EG was what was asked for; and giving 4/3 is EF's a-coefficient read off raw, without ever dividing it by EG's a-coefficient to form the comparison. Always match the direction of the scalar to the vectors exactly as the question states them.
- (d) 7 cm — Area of a parallelogram = base × height, so height = area ÷ base = 84 ÷ 12 = 7 cm. A pupil who multiplies instead of dividing gets 84 × 12 = 1008 cm. A pupil who divides the base by the area instead of the area by the base gets 12 ÷ 84 ≈ 0.14 cm. A pupil who mistakenly halves the area first, as if this were a triangle, gets (84 ÷ 2) ÷ 12 = 3.5 cm. The correct height is 7 cm.
Build your own mix at the worksheet builder.