Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.An enlargement with scale factor 5 maps the point (4, 1) to the point (12, 9). Which of these points is invariant (does not move) under this enlargement?
- 2.Triangle JKL and triangle MNP are similar, with JK ÷ MN = JL ÷ MP = 2. A student says triangle JKL must be congruent to triangle MNP. Write down why the student is wrong.
- 3.Triangle DEF is isosceles, with DE = DF. Angle E = 58°. Work out angle F.
- 4.Lines AB and CD are parallel. A straight line EF crosses AB at point P and crosses CD at point Q. At P, angle APE = 65°. Angle APE and angle BPQ are vertically opposite. Angle BPQ and angle PQD are co-interior (allied) angles. Work out angle PQD.
- 5.A jug holds 750 ml of water. Work out what fraction of a litre this is.
- 6.In triangle ABC the angle at A is 90° and BC = 10 cm. For the angle at B, sin B = 3/5. Work out the length of AC.
- 7.In triangle ABC, AB = 6 cm, AC = 8 cm and angle BAC = 60°. Work out the exact area of triangle ABC, giving your answer in the form .
- 8.A textbook contains the instruction 'Draw AB' and, on the next line, the statement 'AB = 5 cm'. Which statement about the notation AB is correct?
- 9.A cuboid has length 3 cm, width 4 cm and height 12 cm. Work out the length of the diagonal that runs from one corner of the cuboid to the opposite corner.
- 10.Postcard P is similar to postcard Q. The 6 cm side of P corresponds to the 15 cm side of Q, and the 8 cm side of P corresponds to a matching side of Q. Work out the length of that matching side of Q.
- 11.A roof truss has two horizontal parallel rafters, one above the other. A straight strut crosses both rafters. Where the strut crosses the lower rafter, the angle above the rafter and to the left of the strut is 65°. Work out the size of the angle above the upper rafter and to the right of the strut, where the strut crosses it.
- 12.In kite WXYZ, WX = WZ and XY = ZY (so at each of X and Z, one side from each of the two unequal pairs meets). Angle X = 100°. Work out angle Z.
- 13.Two triangles are proved congruent using the ASA condition. What can be concluded about the two remaining pairs of corresponding sides that were not part of the original ASA facts?
- 14.A circular table mat has diameter 20 cm. Yasmin has a 70 cm length of ribbon and sews it around the edge of the mat with no overlap. Using π = 3.14, work out how much ribbon is left over after going around the mat once.
- 15.Shape S is enlarged by a scale factor of −3 about a fixed centre. Which statement correctly describes the image compared to the original shape?
Answer key
- (d) (2, −1) — Method: for an enlargement, image = centre + k × (point − centre), so the centre satisfies centre = (image − k × point) ÷ (1 − k). Working: with k = 5, point (4, 1) and image (12, 9): 5 × (4, 1) = (20, 5); (12, 9) − (20, 5) = (−8, 4); dividing by 1 − 5 = −4 gives (2, −1). Answer: (2, −1), the centre of the enlargement, is the only invariant point since the scale factor is not 1. Subtracting the point itself instead of k times the point, (12, 9) − (4, 1) = (8, 8), then dividing by −4 gives (−2, −2); dividing by k − 1 = 4 instead of 1 − k = −4 gives (−2, 1); and simply taking the midpoint of the point and its image ignores the scale factor altogether and gives (8, 5). The centre of an enlargement is never just the midpoint between a point and its image unless the scale factor happens to be −1 — always use the full centre formula and keep the scale factor k in it.
- (c) The scale factor is 2, not 1, so the sides are not equal — Congruent shapes must be exactly the same size as well as the same shape, which means a scale factor of 1. Here the scale factor between the triangles is 2, so the sides are different lengths and the triangles cannot be congruent, even though they are similar. 'Similar triangles are never congruent' is too strong — a scale factor of exactly 1 would make them both similar and congruent. 'The angles are not necessarily equal' is wrong, since similar triangles always have equal matching angles. 'Congruent triangles must have a right angle' is an unrelated, false fact about congruence.
- (c) 58° — In an isosceles triangle, the base angles opposite the equal sides are equal. Since DE = DF, angle F is the base angle equal to angle E, so angle F = 58°.
- (b) 115° — Angle APE and angle BPQ are vertically opposite, so angle BPQ = 65°, equal to angle APE. Angle BPQ and angle PQD are co-interior (allied) angles between the parallel lines, and co-interior angles always add up to 180°, so angle PQD = 180 − 65 = 115°. "65°" comes from treating co-interior angles as equal to each other, the way alternate angles are, instead of adding to 180°. "295°" comes from applying the angles-round-a-point fact (360° − 65°) directly to the original 65°, skipping the correct co-interior step. "25°" comes from misremembering co-interior angles as adding to 90° instead of 180° (90 − 65 = 25).
- (a) 3/4 — 1 litre = 1000 ml, so 750 ml is 750/1000 of a litre. Dividing both the numerator and denominator by 250 simplifies this to 3/4. Writing the fraction upside down, as the litre out of the 750 ml, gives 4/3. Finding the fraction of the litre that is NOT filled, 250/1000, gives 1/4. Dividing the numerator by 250 but the denominator by only 100, an inconsistent simplification, gives 3/10.
- (b) 6 cm — Method: the right angle is at A, so BC is the hypotenuse and AC is the side opposite the angle at B; sin B = opposite ÷ hypotenuse therefore gives AC ÷ BC = 3/5. Working: AC ÷ 10 = 3/5, so AC = 10 × 3 ÷ 5 = 6. Answer: 6 cm. The distractors: 8 cm is AB, the side next to the angle at B, which is what cos B = 4/5 produces — the right method used on the wrong side; 3 cm comes from reading the 3 in the ratio as a length and never scaling it up to the 10 cm hypotenuse; 30 cm comes from multiplying by 3 and forgetting to divide by 5.
- (c) $12\sqrt{3}$ cm² — Use Area = 1/2 × AB × AC × sin(angle BAC) = 1/2 × 6 × 8 × sin 60°. Since sin 60° = √3⁄2, this is 1/2 × 6 × 8 × √3⁄2 = 24 × √3⁄2 = 12√3 cm². Using AB × AB instead of AB × AC (taking 6 × 6 rather than 6 × 8) gives 1/2 × 6 × 6 × sin 60° = 18 × √3⁄2 = 9√3 cm². Using AC × AC instead of AB × AC (taking 8 × 8 rather than 6 × 8) gives 1/2 × 8 × 8 × sin 60° = 32 × √3⁄2 = 16√3 cm². Leaving out the 1/2 from the area formula gives 6 × 8 × sin 60° = 48 × √3⁄2 = 24√3 cm².
- (c) AB means the segment or its length, shown by context — Method: recall the standard convention for a two-letter label such as AB. Working: AB names the segment AND its length; the sentence around it shows which is meant — 'draw AB' means the segment, 'AB = 5 cm' means the length. Options: 'a different symbol is needed' and 'must be written as |AB|' both describe stricter rules than the convention GCSE actually uses; 'AB can only mean the segment' ignores that the same label is also used for the length. Answer: AB means the segment or its length, shown by context.
- (d) 13 cm — Use Pythagoras' theorem in three dimensions: for a cuboid with edges a, b and c the space diagonal d satisfies d² = a² + b² + c². Substitute a = 3, b = 4, c = 12: d² = 3² + 4² + 12² = 9 + 16 + 144 = 169. Take the square root: d = √169 = 13 cm. Adding the three edges directly, 3 + 4 + 12 = 19 cm, ignores that Pythagoras' theorem is about squares, not lengths, and gives 19 cm. Stopping after squaring and adding, without taking the square root, leaves 169 cm — the squared length, not the length itself. Using only the 4 cm and 12 cm edges finds the diagonal of one face, √(4² + 12²) = √160 = 12.6 cm (1 d.p.), and leaves out the third dimension entirely.
- (d) 20 cm — The scale factor from P to Q is 15 ÷ 6 = 2.5. Apply the same scale factor to the other side: 8 × 2.5 = 20 cm. A pupil who divides instead of multiplying by the scale factor gets 8 ÷ 2.5 = 3.2 cm. A pupil who adds the difference between the two known sides, 15 − 6 = 9, to 8 instead of scaling gets 8 + 9 = 17 cm. A pupil who rounds the scale factor 2.5 down to 2 gets 8 × 2 = 16 cm. The correct length is 20 cm.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (a) 100° — In a kite, the pair of angles between the unequal sides are equal to each other. Angle X and angle Z are both between one side from the WX/WZ pair and one side from the XY/ZY pair, so angle Z = angle X = 100°.
- (c) They must also be equal — Once two triangles are proved congruent by any condition, including ASA, they are identical in every respect: every pair of corresponding sides and every pair of corresponding angles must be equal, not just the ones originally used to prove the congruence. So the two remaining pairs of corresponding sides must also be equal, making 'they must also be equal' correct. 'They might be equal or not' and 'not enough information to say' both wrongly suggest that congruence only guarantees the specific facts used to prove it, when congruence actually guarantees the triangles are identical overall. 'They must be different' is backwards: the triangles being identical is the entire point of proving congruence, not a reason for a side to differ.
- (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
- (a) 3 times the size, opposite side, rotated 180° — Method: for any enlargement, the MAGNITUDE of the scale factor gives the size ratio between image and object, while the SIGN decides which side of the centre the image falls on; a negative scale factor puts the image on the opposite side, which is equivalent to a 180° rotation about the centre. Working: the scale factor is −3, so the size ratio is the magnitude, which is 3, and the negative sign puts the image on the opposite side of the centre, rotated 180° relative to the original. Answer: 3 times the size, opposite side, rotated 180°. The magnitude of the scale factor controls the SIZE only: do not let the sign leak into it and turn 3 into 1/3. The sign controls the SIDE and orientation, which a positive-only view of enlargement, just 'further away' with the same orientation, misses entirely.
Build your own mix at the worksheet builder.