Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Every diameter of a circle is an example of a more general type of straight line joining two points on the circle. Which term names that more general type of line?
- 2.From an external point P, two tangents PA and PB touch a circle with centre O at A and B. Angle APB = 40°. Work out the size of angle AOB.
- 3.A circle has a radius of 1 cm. Work out the circumference of the circle. Give your answer in terms of π.
- 4.A rotation of 200° clockwise about the origin is applied, and the image is then rotated 250° anticlockwise about the origin. Work out the single angle of rotation, measured clockwise and between 0° and 360°, that has the same overall effect as the two rotations combined.
- 5.A kite string makes an angle of 30° with the ground. The kite is flying at a height of 6 m directly above a point on the ground. Using the exact value of sin 30°, work out the exact length of the kite string.
- 6.Two similar bottles have heights in the ratio 1 : 2. Write down the ratio of their volumes.
- 7.A sector of a circle has radius 8 cm and takes up three-quarters of the full circle. Work out the perimeter of the sector, in terms of π.
- 8.A tap fills a tank at a rate of 18 litres per minute. The tank holds 0.45 m³. Work out how long the tap takes to fill the tank.
- 9.A ramp's sloped surface crosses two horizontal parallel rails. At the top rail, the angle between the ramp and the rail on the right of the ramp is (3x + 10)°. At the bottom rail, the angle between the ramp and the rail on the left of the ramp is (5x − 30)°. Work out the value of x.
- 10.From an external point P, two tangents PA and PB touch a circle with centre O at A and B. Angle AOB = 112°. Work out the size of angle APB.
- 11.A stained-glass window panel is designed as a kite. Two adjacent sides are each 25 cm, and the other two adjacent sides are each 40 cm. A frame is fitted around the whole panel. The frame costs £2.50 per metre, sold only in whole metres. Work out the total cost of the frame.
- 12.Shape S is enlarged by scale factor −1, centre (0, 0). Which single transformation has the same overall effect as this enlargement, for every point?
- 13.A sailmaker cuts two triangular sail panels from a pattern. Panel X has a 10 m side, with angles of 50° and 75° at its two ends. Panel Y also has a 10 m side, with angles of 50° and 75° at its two ends, in the same arrangement. The sailmaker wants to check the panels will match exactly, without cutting a third measurement. Which condition proves the two panels are congruent?
- 14.A roof truss has two horizontal parallel rafters, one above the other. A straight strut crosses both rafters. Where the strut crosses the lower rafter, the angle above the rafter and to the left of the strut is 65°. Work out the size of the angle above the upper rafter and to the right of the strut, where the strut crosses it.
- 15.A solid has 5 faces: one square face and four triangular faces, which all meet at a single point above the square. What is the name of this solid?
Answer key
- (c) chord — A diameter is a straight line joining two points on the circle that happens to pass through the centre. The general term for any straight line joining two points on a circle is a chord — every diameter is a chord, but not every chord is a diameter. Calling it a radius is wrong because a radius runs from the centre to just ONE point on the circle, not between two points on the circle. A tangent touches the circle at only one point, so it cannot be a diameter at all. An arc is a curved part of the circle's edge, not a straight line.
- (c) 140° — Method: OAPB is a quadrilateral whose angles sum to 360°; the tangent-radius angles at A and B are each 90°, and angle APB is given, so angle AOB is whatever is left. Working: angle OAP = angle OBP = 90°, so angle AOB = 360 − 90 − 90 − 40 = 140 degrees. Answer: 140°. Both tangent-radius angles are 90° each and must both be subtracted, not just one, and the quadrilateral's angles sum to 360°, not 180°: do not assume angle AOB simply matches angle APB, which is a different angle in a different part of the figure.
- (c) 2π cm — Method: the circumference of a circle is 2πr, where r is the radius, or equivalently πd, where d is the diameter. Working: r = 1, so the circumference is 2 × π × 1 = 2π cm. Answer: 2π cm. The distractors: π cm comes from using the formula πd but substituting the radius in place of the diameter; 4π cm comes from doubling twice — changing the radius into the diameter of 2 cm and then putting that diameter into 2πr as though it were a radius; π cm² is the area of this circle, π × 1², and comes from reaching for the area formula when a distance round the outside was asked for, which is why it carries a squared unit.
- (a) 310° — Method: give the two rotations opposite signs since they turn in opposite senses — clockwise positive, anticlockwise negative — combine them into a single signed turn, then convert that turn into an angle measured clockwise between 0° and 360°. Working: the first rotation is 200° clockwise, so +200. The second is 250° anticlockwise, so −250. Combined: 200 − 250 = −50, meaning the net effect is a 50° turn anticlockwise. Measured clockwise instead, that same turn is 360 − 50 = 310°. Answer: 310°. Give the two rotations opposite signs before combining them, and convert a negative (anticlockwise) result into a clockwise angle by subtracting it from 360°, not from 180°: taking 50° away from a half turn gives 130°, which is a different rotation altogether; adding the two sizes as if both were clockwise gives 450°, which reduces to 90°; and reporting the anticlockwise size without converting it gives 50°.
- (b) 12 m — sin 30° = opposite ÷ hypotenuse, where the opposite side is the height (6 m) and the hypotenuse is the string. So string = height ÷ sin 30° = 6 ÷ (1/2) = 12 m. The distractor 3 m comes from multiplying by sin 30° instead of dividing (6 × 1/2 = 3). The distractor 6√3 m comes from using tan 30° = 1/√3 instead of sin 30° (6 ÷ (1/√3) = 6√3). The distractor 4√3 m comes from using cos 30° = √3/2 instead of sin 30° (6 ÷ (√3/2) = 12/√3 = 4√3).
- (a) 1 : 8 — Method: in similar solids the ratio of the volumes is the cube of the ratio of corresponding lengths. Working: the heights are in the ratio 1 : 2, so the volumes are in the ratio 1³ : 2³ = 1 : 8. Answer: 1 : 8. The distractors: 1 : 2 leaves the height ratio unchanged, as though a volume scaled in the same way as a length; 1 : 4 comes from squaring, 1² : 2², which is the rule for surface areas and not for volumes; 1 : 6 comes from multiplying each part by 3 instead of raising each part to the power 3.
- (a) 12π + 16 cm — A three-quarter sector's perimeter is the curved arc plus the two straight radii that close the shape. The full circumference is 2 × π × 8 = 16π cm, and three-quarters of that is 12π cm. Adding the two straight radii, 8 cm each, gives 12π + 16 cm. Leaving out the straight edges gives just 12π cm. Using one-quarter of the circumference, the piece left over rather than the piece asked for, gives 4π + 16 cm. Adding only one radius instead of two gives 12π + 8 cm.
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
- (a) 68° — Method: a tangent meets a radius at 90°, so quadrilateral OAPB has two right angles at A and B; its four angles sum to 360°, so angle APB = 360° − 90° − 90° − angle AOB. Working: angle APB = 360° − 90° − 90° − 112° = 68°. Halving angle AOB, confusing this with the angle-at-centre theorem for a chord, gives 56°; assuming the angle between two tangents is always 90° (true only for the angles at A and B, not at P) gives 90°; and assuming angle APB simply equals angle AOB by symmetry gives 112°. The two right angles at A and B, from the tangent-radius property, are what link angle AOB and angle APB.
- (b) £5.00 — Perimeter of the kite = 25 + 25 + 40 + 40 = 130 cm = 1.3 m. The frame is sold only in whole metres, so 2 m must be bought. Cost = 2 × £2.50 = £5.00. A student who buys the exact 1.3 m instead of rounding up to whole metres gets 1.3 × £2.50 = £3.25. A student who never converts the perimeter from centimetres to metres and costs 130 × £2.50 gets £325.00.9 m, which rounds up to 3 whole metres, costing 3 × £2.50 = £7.50.
- (c) A rotation of 180° about the origin — An enlargement by scale factor −1 sends every point (x, y) to (−x, −y) — both coordinates change sign. A rotation of 180° about the origin does exactly the same thing to every point, so the two transformations have identical effect. A reflection in the x-axis only changes the sign of the y-coordinate, sending (x, y) to (x, −y), leaving the x-coordinate untouched. A reflection in the y-axis only changes the sign of the x-coordinate, sending (x, y) to (−x, y), leaving the y-coordinate untouched. Treating a negative scale factor as though it behaves like a positive one gives no transformation at all, but the minus sign is not decorative — it reverses both coordinates. Both signs flip together, which is exactly what a 180° rotation about the origin does.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (a) Square-based pyramid — A solid with one square base and four triangular faces meeting at a single apex above the base is a square-based pyramid. A triangular prism has two triangular faces and three rectangular faces, not a square base with four triangles, so that is a different solid. A cube has six square faces, and a cuboid has six rectangular faces — neither has any triangular faces at all. The solid described is a square-based pyramid.
Build your own mix at the worksheet builder.