Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A courier drone delivers a parcel. It starts at the point (2, 1) on a map grid measured in kilometres. It flies by the vector to a warehouse, then by the vector to the delivery address. Work out the coordinates of the delivery address.
- 2.Point B is at (3, 5). It is reflected in the line y = 2. Work out the coordinates of the image of point B.
- 3.A circular table mat has diameter 20 cm. Yasmin has a 70 cm length of ribbon and sews it around the edge of the mat with no overlap. Using π = 3.14, work out how much ribbon is left over after going around the mat once.
- 4.A designer enlarges a drawing of a model car for a poster. She first enlarges the drawing by a scale factor of 1.5, and then enlarges that result by a further scale factor of 2. On the original drawing, the position of a wheel relative to the front bumper is given by the column vector with top number 4 and bottom number −3, in centimetres. What is the corresponding column vector on the poster, in centimetres?
- 5.A stained-glass window panel is designed as a kite. Two adjacent sides are each 25 cm, and the other two adjacent sides are each 40 cm. A frame is fitted around the whole panel. The frame costs £2.50 per metre, sold only in whole metres. Work out the total cost of the frame.
- 6.A(1, 2), B(5, 2) and C(5, 6) are three of the four vertices of a square ABCD. Work out the coordinates of D.
- 7.The bearing of a harbour B from a ferry's position A is 260°. What is the bearing of A from B?
- 8.Work out the gradient of the line segment joining A(2, 3) and B(6, 11).
- 9.Two bronze statues are geometrically similar and made from the same solid bronze. Their heights are 30 cm and 45 cm. The smaller statue has a mass of 12 kg. Work out the mass of the larger statue, in kg.
- 10.A rotation of 180° about the point (3, 2) can be written as a reflection in the line x = 3, followed by a reflection in a second line, for every point in the plane. Which line is the second line?
- 11.A roof truss has two horizontal parallel rafters, one above the other. A straight strut crosses both rafters. Where the strut crosses the lower rafter, the angle above the rafter and to the left of the strut is 65°. Work out the size of the angle above the upper rafter and to the right of the strut, where the strut crosses it.
- 12.m is the column vector with top number 3 and bottom number −4. Which of these column vectors is a scalar multiple of m?
- 13.A tent's sloping side makes an angle of 45° with the ground. The sloping side is 3√2 m long. Using the exact value of sin 45°, work out the exact height of the tent.
- 14.In triangle OAB, OA = a and OB = b. M is the midpoint of OA, and N is the midpoint of OB. Express the vector MN in terms of a and b.
- 15.Triangle PQR has vertices P(0, 0), Q(6, 0) and R(0, 8). Work out the perimeter of the triangle.
Answer key
- (d) (6, 2) — Applying the first vector: (2, 1) + (5, −3) = (7, −2), which is the warehouse. Applying the second vector: (7, −2) + (−1, 4) = (6, 2), the delivery address. '(7, −2)' stops at the warehouse and forgets the second flight. '(8, −6)' comes from adding (1, −4) instead of (−1, 4) for the second vector, getting both signs wrong. '(11, −3)' comes from swapping the components of the second vector to (4, −1) before adding.
- (b) (3, −1) — Method: find the distance from the point to the mirror line, then place the image the same distance on the other side of the line. Working: B is 5 − 2 = 3 units above the line y = 2, so its image is 3 units below the line, at y = 2 − 3 = −1, giving (3, −1); the x-coordinate does not change, since the mirror line is horizontal. Options: (3, −5) comes from reflecting in the x-axis (y = 0) instead of the line y = 2; (−3, 5) comes from reflecting in the y-axis instead of a horizontal line; (3, −4) comes from doubling the distance from the line instead of reflecting it, giving 2 − 2×3 = −4. Answer: (3, −1).
- (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
- (b) (12, −9) — Two enlargements one after the other combine into a single scale factor: 1.5 × 2 = 3. Multiplying a vector by a scalar means multiplying both the top number and the bottom number by it: top = 4 × 3 = 12, bottom = −3 × 3 = −9, giving (12, −9). A candidate who adds the scale factor to each number instead of multiplying gets (4 + 3, −3 + 3) = (7, 0). A candidate who multiplies the top number but leaves the bottom number unchanged gets (12, −3). A candidate who multiplies the bottom number but leaves the top number unchanged gets (4, −9). The correct column vector for the poster is (12, −9).
- (b) £5.00 — Perimeter of the kite = 25 + 25 + 40 + 40 = 130 cm = 1.3 m. The frame is sold only in whole metres, so 2 m must be bought. Cost = 2 × £2.50 = £5.00. A student who buys the exact 1.3 m instead of rounding up to whole metres gets 1.3 × £2.50 = £3.25. A student who never converts the perimeter from centimetres to metres and costs 130 × £2.50 gets £325.00.9 m, which rounds up to 3 whole metres, costing 3 × £2.50 = £7.50.
- (b) (1, 6) — Method: when a square is set square-on to the grid, so that its sides run parallel to the axes, each vertex shares its x-coordinate with one neighbour and its y-coordinate with the other, and the missing vertex then borrows one coordinate from each of the two vertices it is joined to; so the first job is to check from the given points that the sides really do run parallel to the axes. Working: A(1, 2) and B(5, 2) share y = 2, so AB is a horizontal side; B(5, 2) and C(5, 6) share x = 5, so BC is a vertical side, which confirms that this square lies square-on to the axes and that the rule may be used. In square ABCD the vertex D is joined to C and to A. DC must be horizontal like AB, so D takes the y-coordinate of C, which is 6; DA must be vertical like CB, so D takes the x-coordinate of A, which is 1. D is therefore (1, 6), and checking confirms every side is 4 long. Answer: (1, 6). The distractors: (1, 5) comes from lifting the first number out of each of A and C, pairing the x-coordinate of A with the x-coordinate of C; (6, 1) comes from finding the right two numbers but writing them the wrong way round, height before sideways position; (9, 6) comes from stepping a further 4 to the right from C instead of closing the square back to the column A stands in.
- (a) 080° — The back bearing differs from the given bearing by 180°. Because 260° is greater than 180°, subtract 180°: 260 − 180 = 80°, so the bearing of A from B is 080°. Choosing 440° adds 180° instead of subtracting it, even though the result would be more than a full turn (260 + 180 = 440). Choosing 180° assumes the back bearing is always exactly 180°, ignoring the original bearing altogether. Choosing 100° comes from measuring the reflex angle the other way round the circle (360 − 260 = 100) instead of applying the 180° back-bearing rule.
- (a) 2 — Gradient = (change in y) ÷ (change in x) = (11 − 3) ÷ (6 − 2) = 8 ÷ 4 = 2. "0.5" comes from dividing the change in x by the change in y the wrong way round: 4 ÷ 8. "8" is only the change in y, forgetting to divide by the change in x at all. "−2" comes from a sign error, as if the y-coordinate had decreased rather than increased.
- (c) 40.5 kg — Since the statues are made from the same material, mass is proportional to volume, which scales with the cube of the length scale factor. The length scale factor is 45 ÷ 30 = 1.5, so the volume (and mass) scale factor is 1.5³ = 3.375. The larger statue's mass is 12 × 3.375 = 40.5 kg. 18 kg comes from multiplying by the length factor 1.5 directly. 27 kg comes from using the area scale factor 1.5² = 2.25 instead of the volume scale factor. 54 kg comes from treating 'cubed' as 'multiplied by 3', giving 1.5 × 3 = 4.5 instead of 1.5³.
- (d) y = 2 — Two reflections in perpendicular lines that cross at a point combine to a 180° rotation about that point. The line x = 3 is vertical, so the second line must be horizontal, and it must pass through the centre of rotation (3, 2) — that line is y = 2. Taking the y-coordinate of the centre but writing it against the wrong letter gives y = 3. Assuming the second line must also be vertical, like the first one, and just swapping in the other coordinate gives x = 2. Reaching for the standard mirror line y = x without checking that it actually passes through (3, 2) gives y = x — it does not pass through that point at all. The line that is both perpendicular to x = 3 and through (3, 2) is y = 2.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (b) (6, −8) — Method: a scalar multiple of m has the same ratio between its top and bottom numbers as m does. Working: m = (3, −4); multiplying both parts by 2 gives 2 × 3 = 6 and 2 × (−4) = −8, so (6, −8) is a scalar multiple of m. Answer: (6, −8). The vector (6, −4) needs a multiplier of 2 for the top number but only 1 for the bottom number, so it is not a multiple. The vector (−6, −8) needs a multiplier of −2 for the top number but 2 for the bottom number, so it is not a multiple. The vector (9, −8) needs a multiplier of 3 for the top number but 2 for the bottom number, so it is not a multiple.
- (a) 3 m — Height = sloping length × sin 45° = 3√2 × √2/2 = (3 × 2)/2 = 3 m, since √2 × √2 = 2. 3√2 m comes from forgetting to multiply by sin 45° at all. 3√2/2 m comes from using sin 30° = 1/2 instead of sin 45° = √2/2. 6 m comes from using √2 instead of √2/2 for sin 45°, dropping the denominator of the exact value: 3√2 × √2 = 6.
- (b) (1/2)b − (1/2)a — Method: MN runs from M to N, so MN = ON − OM, with OM = (1/2)a and ON = (1/2)b. Working: MN = (1/2)b − (1/2)a. Answer: MN = (1/2)b − (1/2)a. Subtracting the other way round gives (1/2)a − (1/2)b, the reverse vector from N to M; subtracting the wrong way round AND forgetting to halve gives a − b, which is BA, not MN; and adding the two halved vectors instead of subtracting them gives (1/2)a + (1/2)b, which is the position vector of the midpoint of AB. Always subtract the START point's vector from the END point's vector, and halve OA and OB before you combine them, not after.
- (c) 24 — PQ lies along the x-axis with length 6, and PR lies along the y-axis with length 8, meeting at a right angle at P, so QR = √(6² + 8²) = √100 = 10. The perimeter is 6 + 8 + 10 = 24. "14" adds only the two shorter sides, PQ and PR, and leaves out the hypotenuse QR completely. "28" comes from finding QR incorrectly as 6 + 8 = 14 instead of using Pythagoras' theorem, then adding 6 + 8 + 14. "48" comes from multiplying the two shorter sides, 6 × 8, instead of finding and adding all three sides of the triangle.
Build your own mix at the worksheet builder.