Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Point P(2, 5) is enlarged with centre (2, 1) to give image point P′(2, −7). Work out the scale factor of the enlargement.
- 2.In pentagon PQRST, which of the following correctly names the interior angle at vertex R, using standard three-letter angle notation?
- 3.A scale drawing shows a room that is 5 cm wide. The real room is 15 m wide. Write the scale of the drawing in the form 1 : n.
- 4.A rectangular garden gate is 3 m wide and 4 m high. A straight brace runs from one corner of the gate to the opposite corner. Work out the length of the brace.
- 5.A ramp is built from two straight metal supports that rest on the flat ground and meet each other at the top, forming a triangle with the ground. One support meets the ground at 34°. The angle between the two supports where they meet is 71°. Work out the angle between the second support and the ground.
- 6.A student draws a net using 5 identical squares arranged in a row of four with one extra square attached to the side of one of them. Can this net be folded to make a closed cube?
- 7.A hexagonal prism has 8 faces and 12 vertices. Using F + V − E = 2, work out how many edges it has.
- 8.Quadrilateral PQRS has angle P = 92°, angle Q = 84° and angle R = 106°. Work out the size of angle S.
- 9.OABC is a parallelogram, with OA = a and OC = c. M is the midpoint of OC, and N is the point on AC such that AN is twice NC. By finding the vectors MN and MB, show that M, N and B are collinear, and give the scalar k such that MN = k × MB.
- 10.A builder props a straight plank against a vertical wall to reach a window ledge. The foot of the plank is 2.1 m from the base of the wall, and the plank is 3.5 m long. Work out how high up the wall the plank reaches.
- 11.A circular table mat has diameter 20 cm. Yasmin has a 70 cm length of ribbon and sews it around the edge of the mat with no overlap. Using π = 3.14, work out how much ribbon is left over after going around the mat once.
- 12.Triangle ABC is extended so that side BC is extended beyond C to a point D, forming exterior angle ACD. Angle BAC = 48° and angle ABC = 67°. Which single angle fact gives angle ACD = 115° in one step, without first working out the interior angle at C?
- 13.In parallelogram PQRS, angle P = 65°. Which reason correctly explains why angle R = 65°?
- 14.A carpenter measures two triangular braces. Brace 1 has a 55° angle, a 65° angle, and, opposite the 55° angle, a side of 8 cm. Brace 2 has matching 55° and 65° angles and, opposite its 55° angle, a side of 8 cm. The carpenter says that because the equal 8 cm side is not between the two equal angles in either brace, he cannot be sure the two braces are the same size. Is the carpenter correct?
- 15.A triangle has one unknown side or angle, marked x. In which one of these situations should the sine rule, rather than the cosine rule, be used to find x?
Answer key
- (d) −2 — Method: the scale factor is the ratio of the image vector to the object vector, both measured FROM THE CENTRE of enlargement, keeping every sign. Working: the vector from the centre (2, 1) to P(2, 5) is (0, 4); the vector from the centre to P′(2, −7) is (0, −8). The scale factor is −8 ÷ 4 = −2. Answer: −2. Measure both vectors from the CENTRE, not from the origin, divide the IMAGE vector by the OBJECT vector and not the other way round, and keep the negative sign: a negative scale factor is not the same size as its positive counterpart with the sign dropped.
- (a) ∠QRS — Method: the middle letter in three-letter angle notation is always the vertex of the angle, and the outer two letters are the neighbouring vertices along the shape's sides. Working: at vertex R, the two adjacent vertices along the pentagon are Q and S, so the interior angle is written ∠QRS, with R in the middle. Options: ∠PQR names the angle at Q, not R, since Q is the middle letter there; ∠RST puts R first rather than in the middle, so it actually names the angle at S; ∠TRP does have R in the middle, but T and P are not the vertices adjacent to R along the pentagon's sides, so it does not describe R's interior angle. Answer: ∠QRS.
- (c) 1 : 300 — First convert both lengths to the same unit: 15 m = 1500 cm. The scale compares 5 cm on the drawing to 1500 cm in real life, so dividing both parts by 5 gives a scale of 1 : 300. A candidate who compares 5 to 15 without converting units gets 1 : 3. A candidate who converts 15 m to 150 cm, using the wrong conversion factor, gets 1 : 30. A candidate who converts 15 m to 15000 cm, again using the wrong conversion factor, gets 1 : 3000. The scale of the drawing is 1 : 300.
- (b) 5 m — Method: the brace, the width and the height form a right-angled triangle in which the brace faces the right angle, so it is the hypotenuse and Pythagoras' theorem applies, a² + b² = c². Working: c² = 3² + 4² = 9 + 16 = 25, so c = √25 = 5. Answer: 5 m. The distractors: 7 m comes from adding the two sides, 3 + 4, instead of adding their squares; 25 m comes from stopping at c² = 25 and forgetting to take the square root; 12 m comes from multiplying 3 × 4, which gives the area of the gate in square metres and not a length across it.
- (a) 75° — The three angles in the triangle formed by the two supports and the ground add up to 180°. Two of the angles are 34° and 71°, so the third angle is 180 − 34 − 71 = 75, which is 75°. 105° comes from adding the two given angles together instead of subtracting them from 180° (34 + 71 = 105). 146° comes from computing 180 − 34 = 146 and forgetting to also subtract 71°. 37° comes from subtracting the two given angles from each other instead of using the triangle's angle sum (71 − 34 = 37).
- (b) No, it needs one more square — A closed cube has exactly 6 faces, so its net must be made of exactly 6 identical squares, arranged so each one unfolds to a separate face with none overlapping. This net has only 5 squares, so it is one square short and cannot be folded into a closed cube. Choosing 'Yes, it folds into a cube' ignores that a cube needs 6 faces, not 5. Choosing 'No, it has one square too many' miscounts in the wrong direction — 5 is one too FEW, not one too many. Choosing 'Yes, but only if two squares overlap' is not a valid net: a net's faces must not overlap when folded.
- (c) 18 — Rearranging F + V − E = 2 gives E = F + V − 2. Substitute F = 8 and V = 12: 8 + 12 − 2 = 18 edges. Choosing 20 comes from adding the faces and vertices but forgetting to subtract the 2 (8 + 12 = 20). Choosing 22 comes from adding the 2 instead of subtracting it (8 + 12 + 2 = 22). Choosing 16 comes from subtracting 2 twice by mistake (8 + 12 − 2 − 2 = 16).
- (c) 78° — The angles in any quadrilateral add up to 360°. Add the three given angles: 92° + 84° + 106° = 282°. Angle S = 360° − 282° = 78°. A pupil who only adds angle P and angle Q, forgetting angle R, gets 360° − (92° + 84°) = 184°. A pupil who only adds angle Q and angle R, forgetting angle P, gets 360° − (84° + 106°) = 170°. A pupil who makes a carrying slip adding the three angles, getting 292° instead of 282°, gets 360° − 292° = 68°. The correct answer is 78°.
- (a) 1/3 — Method: since OABC is a parallelogram, B = OA + OC = a + c. M = (1/2)c, since M is the midpoint of OC. Since AN is twice NC, N is 2/3 of the way along AC from A, so N = a + 2/3(c − a) = (1/3)a + (2/3)c. Working: MN = N − M = (1/3)a + (1/6)c, and MB = B − M = a + (1/2)c. Comparing term by term, 1/3 × (a + (1/2)c) = (1/3)a + (1/6)c, which matches MN exactly. Answer: k = 1/3, so M, N and B lie on a straight line. Giving 2/3 instead is the scalar linking N to B (NB = (2/3)MB), not M to N; giving 1/6 is just MN's c-coefficient read off on its own, without comparing it to MB's c-coefficient at all; and giving 3 is the scalar the wrong way up — it is MB that equals 3 × MN, not the other way round, since MN = k × MB was what was asked for. Always match the direction of the scalar to the vectors exactly as the question states them.
- (b) 2.8 m — Use Pythagoras' Theorem: the plank is the hypotenuse (3.5 m) of a right-angled triangle formed with the wall and the ground (2.1 m). height² = 3.5² − 2.1² = 12.25 − 4.41 = 7.84. height = √7.84 = 2.8 m. A student who subtracts the two given lengths directly instead of using Pythagoras gets 3.5 − 2.1 = 1.4 m. A student who doubles the distance from the wall by mistake gets 2.1 × 2 = 4.2 m.
- (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
- (c) exterior angle = sum of the two interior opposite angles — Angle ACD is the exterior angle at C, and the exterior angle of a triangle is always equal to the sum of the two interior angles at the other two vertices — here, angle BAC and angle ABC — so angle ACD = 48° + 67° = 115°. "angles in a triangle add up to 180°" is a true fact, but on its own it only gives the INTERIOR angle at C (180 − 48 − 67 = 65°), not the exterior angle 115° — reaching 115° that way still needs a further step. "angles on a straight line add up to 180°" is the fact that links the interior and exterior angles at C to each other, not the fact that gives 115° directly from the two OTHER angles. "exterior angle is always double the smallest angle" is not a genuine angle fact: double the smallest angle here is 48° × 2 = 96°, not 115°.
- (a) opposite angles of a parallelogram are equal — P and R are opposite vertices of the parallelogram, and opposite angles of a parallelogram are always equal, which is why angle R equals angle P, 65°. Co-interior angles adding up to 180° is the correct fact for angle Q or angle S, the angles adjacent to P along a side, not for the opposite angle R. Alternate angles are equal is a fact about a transversal crossing two parallel lines, which explains other angle relationships in the parallelogram, not the one between opposite angles P and R directly. Angles on a straight line adding up to 180° applies to two angles that sit together on one straight line, which P and R do not.
- (d) No — third angle is also fixed — Since both braces have angles of 55° and 65°, their third angles must both be 60°, because angles in a triangle sum to 180°. All three angles now match, so the braces have the same shape. Both 8 cm sides lie in the same position relative to those angles — opposite the 55° angle in each brace — so one matching pair of corresponding sides fixes the size as well, exactly as ASA or AAS would. The braces are therefore guaranteed to be congruent and the carpenter is incorrect: 'No — third angle is also fixed' is correct. 'Yes — side must be included' is wrong because the side does not have to lie physically between the two named angles; once the third angle is fixed, a corresponding equal side anywhere is enough. 'No — any two angles enough alone' is wrong because two equal angles with no side length at all would only show the triangles are similar, not congruent. 'Yes — third angle may differ' is wrong because the third angle is fixed at 60° by the angle sum and cannot vary.
- (c) Two angles and one side are known; x is another side — The sine rule needs a matching pair, a side and the angle opposite it, that you already know, so you can set up a ratio with the unknown. When two angles and one side are known, you can find the third angle from the angle sum, giving you an angle opposite the known side and an angle opposite x: the sine rule applies directly. When all three sides are known and x is an angle, there is no side-angle pair available at all, so the cosine rule, rearranged for an angle, is what's needed instead. When two sides and the included angle are known and x is the third side, again there is no matching side-angle pair yet, so the cosine rule finds the third side directly. When two sides and the included angle are known and x is one of the other angles, you still have no side-angle pair to start from — the cosine rule has to be used first, to find the third side, before any angle can be found. Only the two-angles-and-a-side case hands you a ready-made pair, which is exactly what the sine rule needs.
Build your own mix at the worksheet builder.