Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Triangle ABC has AB = 8 cm, BC = 10 cm and CA = 6 cm. Triangle LMN has LM = 10 cm, MN = 6 cm and NL = 8 cm. The two triangles are congruent by SSS. Which of the following correctly matches the corresponding vertices?
- 2.Vector A is and vector B is . Write down how vector B compares to vector A.
- 3.A path goes from A(1, 1) to B(1, 5), then from B to C(6, 5). Work out the total length of the path from A to C.
- 4.Two triangular offcuts of wood, PQR and STU, are cut for a construction project. PQ = 8 cm, QR = 6 cm and angle PQR = 90°. ST = 8 cm, TU = 6 cm and angle STU = 90°. A carpenter wants to check the two pieces are identical in shape and size before using them as a matching pair. Using only the measurements given, and without working out any further lengths, which condition proves that triangle PQR is congruent to triangle STU?
- 5.A triangle has one unknown side or angle, marked x. In which one of these situations should the sine rule, rather than the cosine rule, be used to find x?
- 6.Triangle XYZ has angle X = 90°. Angle Y = 34°. Work out angle Z.
- 7.A square-based pyramid has a square base and four identical triangular sloping faces, with its apex directly above the centre of the base. How many planes of symmetry does it have?
- 8.Work out the exact value of sin 30° + cos 60°.
- 9.A pop-up canopy has two sloping supports that meet at the top. Each support makes an angle of 30° with the ground and is 6 m long. Using the exact value of cos 30°, work out the total width of the canopy's base.
- 10.A quadrilateral has two pairs of parallel sides. All four of its interior angles are right angles, but its sides are not all the same length. Which quadrilateral is this?
- 11.A(1, 2), B(5, 2) and C(5, 6) are three of the four vertices of a square ABCD. Work out the coordinates of D.
- 12.A surveyor marks two fixed points A and B, with position vectors OA = a and OB = b (in km) from a base station O. A relay mast P is to be placed on the line AB such that AP : PB = 3 : 2. Express the vector OP in terms of a and b.
- 13.e is the column vector with top number 5 and bottom number k. f is the column vector with top number 15 and bottom number 6. Given that f is 3 times e, work out the value of k.
- 14.A circle has centre O. PQ, RS and TU are three chords of the circle, and only one of them passes through O. Write down what this tells you about that chord.
- 15.A shape is reflected in the line y = −x. Which of these points is invariant under this reflection?y = −x
Answer key
- (c) A↔N, B↔L, C↔M (ABC≅NLM) — Matching equal side lengths: AB (8 cm) equals NL (8 cm), BC (10 cm) equals LM (10 cm), and CA (6 cm) equals MN (6 cm). This gives the correspondence A with N, B with L, and C with M, so triangle ABC is congruent to triangle NLM, making 'A↔N, B↔L, C↔M (ABC≅NLM)' correct. 'A↔L, B↔M, C↔N (ABC≅LMN)' simply matches the vertices in the order they are written without checking the side lengths: AB (8 cm) would need to equal LM (10 cm), which is false. 'A↔M, B↔N, C↔L (ABC≅MNL)' also fails this check, since AB (8 cm) would need to equal MN (6 cm), which is false. 'A↔N, B↔M, C↔L (ABC≅NML)' gets A correct but swaps B and C, so AB (8 cm) would need to equal NM (6 cm), which is also false.
- (d) B is the reverse of A — Every component of vector B is the negative of the matching component of vector A (−2 is the negative of 2, and 5 is the negative of −5), so B undoes the translation that A performs — B is the reverse of A. 'B is the same as A' ignores that both signs have flipped. 'B is twice A' confuses a sign change with a scale-factor change; the sizes of the components have not changed, only their signs. 'B is unrelated to A in direction' misses that the two vectors are directly linked, just in opposite directions.
- (a) 9 — AB is a vertical segment, since A and B share the x-coordinate 1, and its length is the difference in y-coordinates: 5 − 1 = 4. BC is a horizontal segment, since B and C share the y-coordinate 5, and its length is the difference in x-coordinates: 6 − 1 = 5. The total path length is 4 + 5 = 9. 20 comes from multiplying the two lengths, 4 × 5, instead of adding them. 5 is only the length of BC, forgetting to include AB. 4 is only the length of AB, forgetting to include BC.
- (b) SAS (two sides and the included angle) — PQ = ST and QR = TU are two pairs of matching sides, and the angle between them (angle Q and angle T) is 90° in both triangles — two sides and the angle between them are equal, so the triangles are congruent by SAS, using only the measurements given. RHS needs the hypotenuses to be known equal; here only the two legs are given, so you would first have to work out each hypotenuse by Pythagoras' theorem — extra working the question rules out. SSS has the same problem: the third side of each triangle is not given, only calculable. ASA needs two angles and the side between them, but here it is two sides and the angle between them that are given, not two angles.
- (c) Two angles and one side are known; x is another side — The sine rule needs a matching pair, a side and the angle opposite it, that you already know, so you can set up a ratio with the unknown. When two angles and one side are known, you can find the third angle from the angle sum, giving you an angle opposite the known side and an angle opposite x: the sine rule applies directly. When all three sides are known and x is an angle, there is no side-angle pair available at all, so the cosine rule, rearranged for an angle, is what's needed instead. When two sides and the included angle are known and x is the third side, again there is no matching side-angle pair yet, so the cosine rule finds the third side directly. When two sides and the included angle are known and x is one of the other angles, you still have no side-angle pair to start from — the cosine rule has to be used first, to find the third side, before any angle can be found. Only the two-angles-and-a-side case hands you a ready-made pair, which is exactly what the sine rule needs.
- (a) 56° — The angles of a triangle add up to 180°. Add the two known angles: 90° + 34° = 124°. Subtract from 180°: 180° − 124° = 56°.
- (d) 4 — Method: a plane of symmetry must pass through the apex and cut the base along one of the base's own lines of symmetry. Working: a square has 4 lines of symmetry (2 through opposite edge midpoints, 2 through opposite corners), and each of these, combined with the apex, gives one plane of symmetry of the pyramid. A student who answers 2 has only found the planes through the edge midpoints, or only the ones through the corners, and missed the other pair. A student who answers 8 has doubled the correct count, perhaps confusing it with a different solid. A student who answers 1 has only spotted the one obvious front-to-back plane. Answer: 4.
- (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
- (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
- (c) Rectangle — A rectangle has two pairs of parallel sides and four right angles, but does not require all sides to be equal — this matches exactly, so Rectangle is correct. A square also has four right angles and parallel sides, but additionally requires all four sides to be equal, which contradicts 'not all the same length', so it is wrong. A rhombus has two pairs of parallel sides and all four sides equal, but its angles are not generally 90° unless it is also a square, so it does not match the right-angle condition here. A kite has no pairs of parallel sides at all, so it does not match the first condition given.
- (b) (1, 6) — Method: when a square is set square-on to the grid, so that its sides run parallel to the axes, each vertex shares its x-coordinate with one neighbour and its y-coordinate with the other, and the missing vertex then borrows one coordinate from each of the two vertices it is joined to; so the first job is to check from the given points that the sides really do run parallel to the axes. Working: A(1, 2) and B(5, 2) share y = 2, so AB is a horizontal side; B(5, 2) and C(5, 6) share x = 5, so BC is a vertical side, which confirms that this square lies square-on to the axes and that the rule may be used. In square ABCD the vertex D is joined to C and to A. DC must be horizontal like AB, so D takes the y-coordinate of C, which is 6; DA must be vertical like CB, so D takes the x-coordinate of A, which is 1. D is therefore (1, 6), and checking confirms every side is 4 long. Answer: (1, 6). The distractors: (1, 5) comes from lifting the first number out of each of A and C, pairing the x-coordinate of A with the x-coordinate of C; (6, 1) comes from finding the right two numbers but writing them the wrong way round, height before sideways position; (9, 6) comes from stepping a further 4 to the right from C instead of closing the square back to the column A stands in.
- (d) (2/5)a + (3/5)b — Method: OP = OA + AP, and since AP : PB = 3 : 2 splits AB into 5 equal parts, AP is 3/5 of the whole of AB, with AB = b − a. Working: OP = a + 3/5(b − a) = a − (3/5)a + (3/5)b = (2/5)a + (3/5)b. Answer: OP = (2/5)a + (3/5)b. Using the ratio the wrong way round, as though it read AP : PB = 2 : 3, gives (3/5)a + (2/5)b; adding (3/5)b onto the whole of a without subtracting a inside the bracket first gives a + (3/5)b; and treating the ratio as 1 : 1 gives the midpoint, (1/2)a + (1/2)b. Convert the ratio to a fraction of AB measured from A, matching the ORDER the ratio is stated in, and subtract before you scale.
- (d) 2 — Method: if f is 3 times e, then each part of f equals 3 times the matching part of e. Working: using the bottom numbers, 6 = 3 × k, so k = 2. Answer: k = 2. A candidate who multiplies instead of dividing, working out 6 × 3, gets 18. A candidate who uses the top numbers' ratio instead, 15 ÷ 5, and gives that ratio as k gets 3. A candidate who adds instead of using the multiple relationship, working out 6 + 3, gets 9.
- (b) It is the longest of the three chords — Method: in any circle the length of a chord is decided by how far the chord lies from the centre, because a chord passing nearer the centre cuts further across the circle. Working: the chord through O lies at a distance of zero from the centre, and no chord can lie closer than that, so no chord of the circle can be longer than it; a chord through the centre is a diameter. The other two chords lie at some distance greater than zero, so each of them falls short of that maximum. Answer: It is the longest of the three chords. The distractors: It is the shortest of the three chords comes from reversing the rule and picturing a chord near the centre as a short line tucked inside; It is the same length as the other two chords comes from carrying the fact that all radii of a circle are equal across to chords, which are not all equal; It is half the length of each of the other two chords comes from confusing a chord through the centre with a radius, which really is half a diameter.
- (a) (4, −4) — A point is invariant under a reflection only if it lies exactly on the mirror line. The line y = −x consists of every point where the y-coordinate is the negative of the x-coordinate: (4, −4) satisfies this, since −4 = −(4), so it is invariant. (5, 5) lies on the line y = x, a different line altogether, not y = −x. (4, 4) has equal coordinates, but that alone does not put it on y = −x; it would need y = −4, not 4. (−4, −4) also has equal coordinates and lies on y = x, not y = −x — its coordinates would need opposite signs to sit on the given mirror line. Only a point whose coordinates are negatives of each other stays fixed under this reflection.
Build your own mix at the worksheet builder.