Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Line 1 passes through (0, 1) and (2, 5). Line 2 passes through (3, 2) and (5, 6). Work out the gradient of each line. Then write down whether the two lines are parallel.
- 2.A crane's hook starts at the point (3.4, 9.5) on a construction site plan measured in metres. It moves along the vector to pick up a beam, then along the vector to place it. Work out the single column vector that describes the hook's overall movement from its start position to where it places the beam.
- 3.Triangles PQS and RQS share the common side QS. PQ equals RQ, and PS equals RS. Which condition proves that triangle PQS is congruent to triangle RQS?
- 4.u is the column vector with top number 5 and bottom number 1. v is the column vector with top number 2 and bottom number 4. Work out u − v, giving your answer as a column vector in the form (top, bottom).
- 5.A student is asked to rearrange the cosine rule a² = b² + c² − 2bc cos A to make cos A the subject. They write: cos A = (a² − b² − c²) / (2bc). Is the student's rearrangement correct?
- 6.The vector describes a translation. A student writes it as by mistake. Write down what error the student has made.
- 7.Triangles LMN and XYZ have LM = XY, MN = YZ and LN = XZ. Give a reason why triangle LMN is congruent to triangle XYZ.
- 8.Two similar triangles have lengths in the ratio 2 : 5. The sides of the smaller triangle are 4 cm, 6 cm and 8 cm. Work out the length of the longest side of the larger triangle.
- 9.Two similar hexagonal tiles have lengths in the ratio 4 : 7. A side of the smaller tile is 8.4 cm long. Work out the length of the corresponding side of the larger tile.
- 10.The sum of the interior angles of a polygon is 1980°. Work out the number of sides of the polygon.
- 11.Point B is at (3, 5). It is reflected in the line y = 2. Work out the coordinates of the image of point B.
- 12.The midpoint of the line segment AB is (3, 5). A is the point (1, 3). Work out the coordinates of B.
- 13.A rectangle has vertices A(1, 1), B(4, 1), C(4, 5) and D(1, 5). Work out the perimeter of the rectangle.
- 14.Point P(2, 5) is enlarged with centre (2, 1) to give image point P′(2, −7). Work out the scale factor of the enlargement.
- 15.A tent has the cross-section of a right-angled triangle. The sloping side of the cross-section is 10 m long, and it makes an angle of 60° with the horizontal ground. Using the exact value of cos 60°, work out the horizontal distance covered by the sloping side.
Answer key
- (a) Parallel, since both gradients are 2 — Gradient of line 1 = (5 − 1) ÷ (2 − 0) = 4 ÷ 2 = 2. Gradient of line 2 = (6 − 2) ÷ (5 − 3) = 4 ÷ 2 = 2. The two gradients are equal, so the lines are parallel. "Not parallel, since the gradients are 2 and 4" uses 4 for line 2, which comes from dividing the change in y, 4, by 1 rather than by the change in x, 5 − 3 = 2. "Not parallel, since the two lines cross the y-axis at different points" confuses parallel lines with the same line repeated — parallel lines are distinct lines, and where a line crosses the y-axis has no effect on its gradient. "Parallel, since both lines pass through positive coordinates" reaches the right conclusion for the wrong reason: lines are parallel because their gradients are equal, not because the coordinates given happen to be positive.
- (b) $\binom{-0.4}{-7}$ — The overall movement is the sum of the two vectors: (−1.2 + 0.8, −4.5 + (−2.5)) = (−0.4, −7). '$\binom{-2}{-2}$' comes from subtracting the second vector from the first instead of adding them. '$\binom{-0.4}{7}$' gets the top number right but drops the negative sign on the bottom number. '$\binom{2}{-7}$' comes from treating −1.2 + 0.8 as if the signs did not matter, giving +2 instead of −0.4.
- (d) SSS, using shared side QS — PQ equals RQ and PS equals RS are two given pairs of equal sides, and QS is common to both triangles, so QS equals itself and gives a third pair of equal sides. Three pairs of equal sides is exactly the SSS condition, so 'SSS, using shared side QS' is correct. 'SAS, using the angle at Q' is wrong because no angle is given anywhere in this question; angle PQS and angle RQS are not stated to be equal, and assuming they are would be assuming the very thing being proved. 'Only two pairs of sides — not enough' is wrong because it forgets that the shared side QS is itself a third pair of equal sides. 'Cannot prove — no angle given' is wrong because SSS is one of the four basic congruence conditions and specifically requires no angle at all.
- (b) (3, −3) — Subtracting column vectors means subtracting the top numbers and subtracting the bottom numbers, in the order given: top = 5 − 2 = 3, bottom = 1 − 4 = −3, giving (3, −3). A candidate who works out v − u instead of u − v, reversing the order, gets (−3, 3). A candidate who makes a sign error on the bottom number, treating 1 − 4 as 3 instead of −3, gets (3, 3). A candidate who adds the vectors instead of subtracting gets (7, 5). Because the question asks for u − v, not v − u, the correct answer is (3, −3).
- (b) No — should divide by −2bc, not +2bc; sign is wrong. — Method: rearrange a² = b² + c² − 2bc cos A step by step and compare with the student's version. Working: subtracting b² + c² from both sides gives a² − b² − c² = −2bc cos A, then dividing both sides by −2bc gives cos A = (a² − b² − c²) / (−2bc), which is the same as cos A = (b² + c² − a²) / (2bc). The student divided by +2bc instead of −2bc, so their expression is the negative of the correct one — the verdict is No. Saying the algebra is fine because 'either sign order gives a valid result' ignores that only one of the two signed expressions matches the original equation. Saying the denominator should be bc rather than 2bc is a different, unrelated error — the coefficient 2bc in the original formula is correct and must stay.
- (c) Swapped the x and y components — The student's vector has the same two numbers, 5 and −2, but in swapped positions, so the error is swapping the x and y components rather than an error with signs or size. 'Reversed both signs' is wrong because the numbers 5 and −2 have not changed sign, only position. 'Reversed only the y sign' is wrong for the same reason — no sign has actually changed. 'Doubled the x component' is wrong because neither number has changed in size.
- (a) SSS – all three corresponding sides are equal — All three pairs of corresponding sides are stated as equal — LM = XY, MN = YZ and LN = XZ — with no angle mentioned. This matches the SSS condition, so triangle LMN is congruent to triangle XYZ.
- (b) 20 cm — Method: corresponding sides of similar triangles are in the same ratio, and the longest side of one triangle corresponds to the longest side of the other; a ratio of 2 : 5 means each length is multiplied by 5 ÷ 2 = 2.5 going from the smaller triangle to the larger one. Working: the longest side of the smaller triangle is 8 cm, so the matching side of the larger triangle is 8 × 2.5 = 20. Answer: 20 cm. The distractors: 10 cm comes from scaling the shortest side, 4 cm, instead of the longest; 40 cm comes from multiplying by 5 and forgetting to divide by 2; 3.2 cm comes from multiplying by 2 ÷ 5 instead of 5 ÷ 2, which scales from the larger triangle down to the smaller one.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (b) 13 — Using the sum of interior angles formula, (n − 2) × 180° = 1980°, so n − 2 = 1980 ÷ 180 = 11, and n = 11 + 2 = 13. 11 stops after the division, forgetting to add 2 back to find n. 15 adds 2 twice by mistake, giving 11 + 2 + 2. 22 divides 1980 by 90 instead of 180.
- (b) (3, −1) — Method: find the distance from the point to the mirror line, then place the image the same distance on the other side of the line. Working: B is 5 − 2 = 3 units above the line y = 2, so its image is 3 units below the line, at y = 2 − 3 = −1, giving (3, −1); the x-coordinate does not change, since the mirror line is horizontal. Options: (3, −5) comes from reflecting in the x-axis (y = 0) instead of the line y = 2; (−3, 5) comes from reflecting in the y-axis instead of a horizontal line; (3, −4) comes from doubling the distance from the line instead of reflecting it, giving 2 − 2×3 = −4. Answer: (3, −1).
- (a) (5, 7) — Method: a midpoint is the mean of the two end points, so for each coordinate (start + end) ÷ 2 = midpoint; rearranging that gives end = 2 × midpoint less the start. Working: for x, (1 + x) ÷ 2 = 3, so 1 + x = 6 and x = 5. For y, (3 + y) ÷ 2 = 5, so 3 + y = 10 and y = 7. B is therefore (5, 7). Answer: (5, 7). The distractors: (2, 2) comes from subtracting A from the midpoint, (3 − 1, 5 − 3), which gives the step from A to the midpoint and stops there instead of taking that same step a second time; (4, 8) comes from adding A to the midpoint, (3 + 1, 5 + 3), without doubling the midpoint first; (6, 10) comes from doubling the midpoint, (2 × 3, 2 × 5), and then forgetting to take A off.
- (c) 14 units — Method: the perimeter of a rectangle is the distance all the way round its outside, 2 × (length + width), so the two side lengths must be found first; on a coordinate grid a side's length is the difference between the coordinates that change along it. Working: along AB, from (1, 1) to (4, 1), only x changes, so AB = 4 − 1 = 3. Along BC, from (4, 1) to (4, 5), only y changes, so BC = 5 − 1 = 4. Perimeter = 2 × (3 + 4) = 2 × 7 = 14. Answer: 14 units. The distractors: 18 units comes from reading the vertex numbers 4 and 5 as the side lengths instead of subtracting, giving 2 × (4 + 5); 12 units comes from working out the area, 3 × 4, in place of the perimeter; 7 units comes from adding one length to one width and stopping there, without doubling for the opposite pair of sides.
- (d) −2 — Method: the scale factor is the ratio of the image vector to the object vector, both measured FROM THE CENTRE of enlargement, keeping every sign. Working: the vector from the centre (2, 1) to P(2, 5) is (0, 4); the vector from the centre to P′(2, −7) is (0, −8). The scale factor is −8 ÷ 4 = −2. Answer: −2. Measure both vectors from the CENTRE, not from the origin, divide the IMAGE vector by the OBJECT vector and not the other way round, and keep the negative sign: a negative scale factor is not the same size as its positive counterpart with the sign dropped.
- (c) 5 m — The horizontal distance is the side adjacent to the 60° angle, and the sloping side is the hypotenuse, so horizontal distance = hypotenuse × cos 60°. The exact value of cos 60° is 1/2, so horizontal distance = 10 × 1/2 = 5 m. Using the sloping side itself as the horizontal distance, without using any trigonometry at all, gives 10 m. Using sin 60° = √3/2 instead of cos 60° finds the vertical height of the tent rather than the horizontal distance: 10 × √3/2 = 5√3 = 8.7 m (1 d.p.). Dividing the sloping side by cos 60° instead of multiplying by it, 10 ÷ 0.5 = 20 m, treats the sloping side as though it were the adjacent side rather than the hypotenuse.
Build your own mix at the worksheet builder.