Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A robot on a grid moves by the vector , then by the vector , then by the vector . Write down the single column vector that has the same overall effect as these three moves.
- 2.A path goes from A(1, 1) to B(1, 5), then from B to C(6, 5). Work out the total length of the path from A to C.
- 3.A solid is built from centimetre cubes standing on a table. Seen from the front, the left-hand column is 2 cubes high, the middle column is 2 cubes high and the right-hand column is 1 cube high. Work out how many squares make up the front elevation.
- 4.In a construction, a point P is marked at the foot of the perpendicular drawn from point X to a straight line. Which statement correctly compares the distance XP with the distance from X to any other point on the line?
- 5.A straight line crosses two parallel lines. One of the angles formed is (2x + 10)°, and the angle alternate to it is 74°. Work out the value of x.
- 6.A crane's hook starts at the point (3.4, 9.5) on a construction site plan measured in metres. It moves along the vector to pick up a beam, then along the vector to place it. Work out the single column vector that describes the hook's overall movement from its start position to where it places the beam.
- 7.A, B and C are points on a circle with centre O. B is on the minor arc AC. Angle ABC = 100°. Work out the size of the non-reflex angle AOC.
- 8.A ramp rises at 30° to the horizontal. Its sloping surface is 4.8 m long. Safety rules say the vertical rise of a ramp must be no more than 2.5 m. Work out how far below that limit the rise of this ramp is.
- 9.A rectangular garden gate is 3 m wide and 4 m high. A straight brace runs from one corner of the gate to the opposite corner. Work out the length of the brace.
- 10.A tile manufacturer cuts a hexagonal tile so that all six sides measure exactly 4 cm, but a check shows only two pairs of the six interior angles are equal to each other, not all six angles. The customer's order specifies regular hexagonal tiles. Based on the check, is this tile a regular hexagon?
- 11.The midpoint of the line segment AB is (3, 5). A is the point (1, 3). Work out the coordinates of B.
- 12.Which of the following is the correct definition of a regular polygon?
- 13.A student draws a net using 5 identical squares arranged in a row of four with one extra square attached to the side of one of them. Can this net be folded to make a closed cube?
- 14.Shape S is enlarged by a scale factor of 3, centre the origin. A vertex of S is at (2, 1). Work out the coordinates of the image of this vertex.
- 15.PT is a tangent to a circle with centre O, touching the circle at T. OT is a radius. Angle OPT = 27°, where P is a point outside the circle. Work out the size of angle POT.
Answer key
- (d) $\binom{0}{4}$ — Add the three vectors component by component: x: 3 + (−7) + 4 = 0; y: −2 + 5 + 1 = 4, giving $\binom{0}{4}$. $\binom{−4}{3}$ comes from adding only the first two vectors and forgetting the third. $\binom{14}{−6}$ comes from reading the second vector as $\binom{7}{−5}$ instead of $\binom{−7}{5}$, flipping its signs. $\binom{4}{0}$ comes from swapping the final x-total and y-total.
- (a) 9 — AB is a vertical segment, since A and B share the x-coordinate 1, and its length is the difference in y-coordinates: 5 − 1 = 4. BC is a horizontal segment, since B and C share the y-coordinate 5, and its length is the difference in x-coordinates: 6 − 1 = 5. The total path length is 4 + 5 = 9. 20 comes from multiplying the two lengths, 4 × 5, instead of adding them. 5 is only the length of BC, forgetting to include AB. 4 is only the length of AB, forgetting to include BC.
- (c) 5 — The front elevation shows one square for every cube visible from the front, column by column: the left-hand column is 2 cubes high, so it contributes 2 squares; the middle column is 2 cubes high, so it contributes 2 more; the right-hand column is 1 cube high, so it contributes 1. The total is 2 + 2 + 1 = 5 squares. "6" comes from drawing a full 3 by 2 rectangle, treating every column as if it reached the greatest height. "4" comes from losing a square from one of the two tall columns, counting 2 + 1 + 1. "3" comes from counting one square per column — the width of the solid — and ignoring the heights altogether.
- (d) XP is the shortest distance from X to the line — The perpendicular from a point to a line always gives the shortest possible distance to that line — joining X to any other point on the line forms the hypotenuse of a right-angled triangle with XP as one of the shorter sides, and a hypotenuse is always longer than either of the other two sides. So XP is shorter than the distance to every other point on the line. "XP is the longest distance from X to the line" reverses this relationship. "XP equals every other distance from X to the line" would only be true if X were equidistant from every point on the line, which is impossible for a point and a straight line. "XP cannot be compared without knowing the line's length" is false — the shortest-distance fact holds whatever the line's length, since only the local right angle matters.
- (c) 32 — Method: alternate angles between parallel lines are equal, so 2x + 10 = 74. Working: subtracting 10 from both sides gives 2x = 64; dividing by 2 gives x = 32. Answer: x = 32. A candidate who forgets to subtract 10 first and divides 74 by 2 directly gets 37. A candidate who treats the angles as co-interior instead of alternate, so that the two expressions add to 180° rather than being equal, gets 48 after solving. A candidate who makes a sign error and treats the equation as 2x equalling 10 minus 74 instead of 74 minus 10 gets −32.
- (b) $\binom{-0.4}{-7}$ — The overall movement is the sum of the two vectors: (−1.2 + 0.8, −4.5 + (−2.5)) = (−0.4, −7). '$\binom{-2}{-2}$' comes from subtracting the second vector from the first instead of adding them. '$\binom{-0.4}{7}$' gets the top number right but drops the negative sign on the bottom number. '$\binom{2}{-7}$' comes from treating −1.2 + 0.8 as if the signs did not matter, giving +2 instead of −0.4.
- (b) 160° — B is on the minor arc AC, so the angle at the centre theorem applies to the reflex angle AOC: reflex angle AOC = 2 × 100° = 200°. The non-reflex angle AOC is the rest of the full turn: 360° − 200° = 160°. Reporting the reflex angle itself, without subtracting it from 360°, gives 200°. Subtracting angle ABC from 180° instead, as if this were a cyclic quadrilateral, gives 80°. Halving angle ABC instead of doubling it gives 50°. Double first, then take the angle away from a full turn, and 160° is what's left.
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (b) 5 m — Method: the brace, the width and the height form a right-angled triangle in which the brace faces the right angle, so it is the hypotenuse and Pythagoras' theorem applies, a² + b² = c². Working: c² = 3² + 4² = 9 + 16 = 25, so c = √25 = 5. Answer: 5 m. The distractors: 7 m comes from adding the two sides, 3 + 4, instead of adding their squares; 25 m comes from stopping at c² = 25 and forgetting to take the square root; 12 m comes from multiplying 3 × 4, which gives the area of the gate in square metres and not a length across it.
- (d) No — angles must be equal too — A regular polygon must have both all sides equal and all angles equal. This tile has all six sides equal, but its interior angles are not all equal, so it fails the angle condition and is not regular — 'No — angles must be equal too' is correct. 'Yes — all sides are equal' is wrong because equal sides alone are not enough; a shape can have equal sides but unequal angles, as here. 'Yes — six equal sides means regular' is wrong for the same reason: equal sides do not automatically guarantee equal angles. 'No — hexagons can't be regular' is wrong because regular hexagons certainly exist (six equal sides and six equal 120° angles); it is this particular tile that fails to be regular, not hexagons in general.
- (a) (5, 7) — Method: a midpoint is the mean of the two end points, so for each coordinate (start + end) ÷ 2 = midpoint; rearranging that gives end = 2 × midpoint less the start. Working: for x, (1 + x) ÷ 2 = 3, so 1 + x = 6 and x = 5. For y, (3 + y) ÷ 2 = 5, so 3 + y = 10 and y = 7. B is therefore (5, 7). Answer: (5, 7). The distractors: (2, 2) comes from subtracting A from the midpoint, (3 − 1, 5 − 3), which gives the step from A to the midpoint and stops there instead of taking that same step a second time; (4, 8) comes from adding A to the midpoint, (3 + 1, 5 + 3), without doubling the midpoint first; (6, 10) comes from doubling the midpoint, (2 × 3, 2 × 5), and then forgetting to take A off.
- (c) Equal sides and equal interior angles — Method: recall the full definition of 'regular' as applied to a polygon. Working: a regular polygon must have both equal side lengths and equal interior angles at the same time. Options: 'all sides equal' alone describes an equilateral but not necessarily equiangular shape, such as a rhombus, which is not regular; 'all angles equal' alone describes an equiangular but not necessarily equilateral shape, such as a rectangle, which is not regular; 'at least one line of symmetry' is a much weaker condition that many irregular shapes also satisfy. Answer: equal sides and equal interior angles.
- (b) No, it needs one more square — A closed cube has exactly 6 faces, so its net must be made of exactly 6 identical squares, arranged so each one unfolds to a separate face with none overlapping. This net has only 5 squares, so it is one square short and cannot be folded into a closed cube. Choosing 'Yes, it folds into a cube' ignores that a cube needs 6 faces, not 5. Choosing 'No, it has one square too many' miscounts in the wrong direction — 5 is one too FEW, not one too many. Choosing 'Yes, but only if two squares overlap' is not a valid net: a net's faces must not overlap when folded.
- (b) (6, 3) — For an enlargement centred on the origin, multiply both coordinates by the scale factor: (2 × 3, 1 × 3) = (6, 3). A pupil who adds the scale factor to each coordinate instead of multiplying gets (2 + 3, 1 + 3) = (5, 4). A pupil who multiplies only the x-coordinate gets (6, 1). A pupil who multiplies only the y-coordinate gets (2, 3). The correct image is (6, 3).
- (b) 63° — Method: a tangent meets the radius drawn to the point of contact at a right angle, so triangle OPT has a 90° angle at T; the three angles of the triangle then sum to 180°. Working: angle OTP = 90°, angle OPT = 27°, so angle POT = 180 − 90 − 27 = 63 degrees. Answer: 63°. The tangent-radius angle is a fixed 90°, not something to assume equal to another angle in the triangle, and the three angles of ANY triangle sum to 180°, never 360°: that total belongs to a quadrilateral, not a triangle.
Build your own mix at the worksheet builder.