Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A path goes from A(1, 1) to B(1, 5), then from B to C(6, 5). Work out the total length of the path from A to C.
- 2.A carpenter cuts two triangular metal brackets for a shelf. Bracket P has sides of 12 cm, 16 cm and 20 cm. Bracket Q has sides of 16 cm, 20 cm and 12 cm, listed in a different order. Before fitting them as a matching pair, the carpenter wants to check they are exactly the same shape and size. Which of the following correctly justifies this?
- 3.m is the column vector with top number 4 and bottom number 6. n is the column vector with top number −6 and bottom number −9. Given that n = k × m for some number k, work out the value of k.
- 4.A pinhole camera is set up at a pitch-side stand, with its aperture at the point O = (2, 1) on a grid. Light from the corner F of a triangular flag, at the point (4, 2), passes through the aperture and forms an inverted image on the film behind it. The projection is an enlargement of scale factor −1.5 centred at O. Work out the coordinates of the image of corner F.
- 5.A cylindrical candle and a cone-shaped candle have the same base radius and the same height. State the cone's volume as a fraction of the cylinder's volume.
- 6.A sector of a circle has radius 8 cm and takes up three-quarters of the full circle. Work out the perimeter of the sector, in terms of π.
- 7.The diagram shows a solid made from two cuboids joined together. Which shape is the front elevation of this solid?
- 8.A rectangular garden gate is 3 m wide and 4 m high. A straight brace runs from one corner of the gate to the opposite corner. Work out the length of the brace.
- 9.Two bronze statues are geometrically similar and made from the same solid bronze. Their heights are 30 cm and 45 cm. The smaller statue has a mass of 12 kg. Work out the mass of the larger statue, in kg.
- 10.A trundle wheel has a diameter of 0.5 m. It is rolled along the ground and makes 20 complete turns. Using π = 3.14, work out the total distance rolled, in metres.
- 11.A carpenter measures two triangular braces. Brace 1 has a 55° angle, a 65° angle, and, opposite the 55° angle, a side of 8 cm. Brace 2 has matching 55° and 65° angles and, opposite its 55° angle, a side of 8 cm. The carpenter says that because the equal 8 cm side is not between the two equal angles in either brace, he cannot be sure the two braces are the same size. Is the carpenter correct?
- 12.Rectangle ABCD has vertices A(−1, 2), B(4, 2), C(4, 5) and D(−1, 5). The rectangle is translated so that C moves to (0, −1). Write down the coordinates of the image of A.
- 13.A straight line crosses two parallel lines. One of the angles formed is (2x + 10)°, and the angle alternate to it is 74°. Work out the value of x.
- 14.A regular polygon has an exterior angle of 45°. Work out the number of sides of the polygon.
- 15.Shape S is enlarged by a scale factor of 3, centre the origin. A vertex of S is at (2, 1). Work out the coordinates of the image of this vertex.
Answer key
- (a) 9 — AB is a vertical segment, since A and B share the x-coordinate 1, and its length is the difference in y-coordinates: 5 − 1 = 4. BC is a horizontal segment, since B and C share the y-coordinate 5, and its length is the difference in x-coordinates: 6 − 1 = 5. The total path length is 4 + 5 = 9. 20 comes from multiplying the two lengths, 4 × 5, instead of adding them. 5 is only the length of BC, forgetting to include AB. 4 is only the length of AB, forgetting to include BC.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (c) −1.5 — Since n = k × m, dividing a number in n by the matching number in m gives k: k = −6 ÷ 4 = −1.5 (check with the bottom numbers: −9 ÷ 6 = −1.5, the same value, confirming n is a scalar multiple of m). 1.5 has the correct size but is missing the negative sign. −10 comes from subtracting the top numbers, −6 − 4, instead of dividing them. −24 comes from multiplying the top numbers, −6 × 4, instead of dividing them.
- (a) (−1, −0.5) — Method: for an enlargement centred at a point O that is not the origin, first find the point's position relative to O, multiply that by the scale factor, then add O's coordinates back on — image = O + k × (F − O). Working: F relative to O is (4, 2) − (2, 1) = (2, 1). Multiplying by the scale factor, −1.5 × (2, 1) = (−3, −1.5). Adding O back on: (2, 1) + (−3, −1.5) = (−1, −0.5). Answer: (−1, −0.5). Measure F's position from the aperture O, not from the origin, apply the full signed scale factor −1.5 to that displacement, and add O's own coordinates back on afterwards: measuring from the origin instead of O, treating the factor as +1.5, or adding O onto the wrong displacement all place the image mark somewhere else.
- (c) One third of the cylinder's volume — Volume of a cylinder = base area × height. Volume of a cone = 1/3 × base area × height. For the same base radius and height, the cone's volume is exactly one third of the cylinder's, so it uses less wax. A student who thinks the cone is half the cylinder's volume has confused it with a different solid's ratio. A student who thinks the two volumes are the same has ignored the 1/3 factor in the cone formula entirely. A student who thinks the cone is two thirds of the cylinder's volume has the right idea that it is a fraction, but the wrong fraction.
- (a) 12π + 16 cm — A three-quarter sector's perimeter is the curved arc plus the two straight radii that close the shape. The full circumference is 2 × π × 8 = 16π cm, and three-quarters of that is 12π cm. Adding the two straight radii, 8 cm each, gives 12π + 16 cm. Leaving out the straight edges gives just 12π cm. Using one-quarter of the circumference, the piece left over rather than the piece asked for, gives 4π + 16 cm. Adding only one radius instead of two gives 12π + 8 cm.
- (c) An L-shape — Method: to find the front elevation, trace the outline of the solid seen from directly in front. Working: the low, wide cuboid gives a wide rectangle across the bottom, and the taller, narrower cuboid sitting on one end adds a narrower rectangle rising above only that end of the base, so the outline steps up on one side only. Answer: an L-shape. The distractors: a rectangle comes from taking the outline of the box the whole solid would just fit inside, ignoring the step created by the taller block. A T-shape comes from placing the taller block in the middle of the base instead of at one end, so that the base would show on both sides of it. A parallelogram comes from copying a face as it is drawn in the sketch — the top of the taller block is drawn as a sloping parallelogram because the solid is drawn at an angle — instead of drawing the true outline seen looking straight at the front.
- (b) 5 m — Method: the brace, the width and the height form a right-angled triangle in which the brace faces the right angle, so it is the hypotenuse and Pythagoras' theorem applies, a² + b² = c². Working: c² = 3² + 4² = 9 + 16 = 25, so c = √25 = 5. Answer: 5 m. The distractors: 7 m comes from adding the two sides, 3 + 4, instead of adding their squares; 25 m comes from stopping at c² = 25 and forgetting to take the square root; 12 m comes from multiplying 3 × 4, which gives the area of the gate in square metres and not a length across it.
- (c) 40.5 kg — Since the statues are made from the same material, mass is proportional to volume, which scales with the cube of the length scale factor. The length scale factor is 45 ÷ 30 = 1.5, so the volume (and mass) scale factor is 1.5³ = 3.375. The larger statue's mass is 12 × 3.375 = 40.5 kg. 18 kg comes from multiplying by the length factor 1.5 directly. 27 kg comes from using the area scale factor 1.5² = 2.25 instead of the volume scale factor. 54 kg comes from treating 'cubed' as 'multiplied by 3', giving 1.5 × 3 = 4.5 instead of 1.5³.
- (a) 31.4 — Method: first find the circumference of one turn using π × diameter, then multiply by the number of turns. Working: circumference = 3.14 × 0.5 = 1.57 m; total distance = 1.57 × 20 = 31.4 m. A student who answers 15.7 has mistakenly halved the diameter again before multiplying, using 0.25 m instead of 0.5 m. A student who answers 3.14 has simply written down π itself, without completing the circumference or multiplying by the number of turns. A student who answers 62.8 has mistakenly doubled the diameter to 1 m before multiplying, treating the given length as a radius. Answer: 31.4 m.
- (d) No — third angle is also fixed — Since both braces have angles of 55° and 65°, their third angles must both be 60°, because angles in a triangle sum to 180°. All three angles now match, so the braces have the same shape. Both 8 cm sides lie in the same position relative to those angles — opposite the 55° angle in each brace — so one matching pair of corresponding sides fixes the size as well, exactly as ASA or AAS would. The braces are therefore guaranteed to be congruent and the carpenter is incorrect: 'No — third angle is also fixed' is correct. 'Yes — side must be included' is wrong because the side does not have to lie physically between the two named angles; once the third angle is fixed, a corresponding equal side anywhere is enough. 'No — any two angles enough alone' is wrong because two equal angles with no side length at all would only show the triangles are similar, not congruent. 'Yes — third angle may differ' is wrong because the third angle is fixed at 60° by the angle sum and cannot vary.
- (d) (−5, −4) — Method: every vertex of a translated shape moves by the same vector, so find that vector from the one vertex whose image is given, then apply it to A. Working: C(4, 5) moves to (0, −1), so across 0 − 4 = −4 and up −1 − 5 = −6, giving the vector $\binom{-4}{-6}$. Applying it to A(−1, 2): −1 − 4 = −5 and 2 − 6 = −4. Answer: the image of A is (−5, −4). Working the vector out as object minus image gives 4 to the right and 6 up, which applied to A gives (3, 8). Getting the horizontal movement right but reversing the vertical one gives (−5, 8). Treating (0, −1) as the image of every vertex ignores that a translation carries each vertex to a different place.
- (c) 32 — Method: alternate angles between parallel lines are equal, so 2x + 10 = 74. Working: subtracting 10 from both sides gives 2x = 64; dividing by 2 gives x = 32. Answer: x = 32. A candidate who forgets to subtract 10 first and divides 74 by 2 directly gets 37. A candidate who treats the angles as co-interior instead of alternate, so that the two expressions add to 180° rather than being equal, gets 48 after solving. A candidate who makes a sign error and treats the equation as 2x equalling 10 minus 74 instead of 74 minus 10 gets −32.
- (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
- (b) (6, 3) — For an enlargement centred on the origin, multiply both coordinates by the scale factor: (2 × 3, 1 × 3) = (6, 3). A pupil who adds the scale factor to each coordinate instead of multiplying gets (2 + 3, 1 + 3) = (5, 4). A pupil who multiplies only the x-coordinate gets (6, 1). A pupil who multiplies only the y-coordinate gets (2, 3). The correct image is (6, 3).
Build your own mix at the worksheet builder.