Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A quadrilateral has two pairs of parallel sides. All four of its interior angles are right angles, but its sides are not all the same length. Which quadrilateral is this?
- 2.A tap fills a tank at a rate of 18 litres per minute. The tank holds 0.45 m³. Work out how long the tap takes to fill the tank.
- 3.Triangle D has vertices (3, 1), (3, 5) and (6, 1). It is reflected in the line x = 3. Write down the number of vertices of the triangle that are invariant under this reflection.
- 4.A is the point (1, 3) and B is the point (7, 3). Work out the coordinates of the midpoint of AB.
- 5.A ferris wheel's circular frame has centre O. A support strut runs from O to a point A on the rim, and a second strut runs from O to point B on the rim, with angle AOB = 76°. A cabin is mounted at point C on the major arc AB, and D is a separate point on the minor arc AB. Work out the difference between angle ACB and angle ADB.
- 6.A cylinder has a radius of 5 cm. Its volume is 471 cm³. Using π = 3.14, work out the height of the cylinder.
- 7.A dog is tied by a lead 4 m long to a fixed ring on a straight garden wall. The wall extends much further than the lead can reach in both directions, and the dog cannot cross through it. Describe the region the dog can reach.
- 8.A ship's radio can be heard up to 30 km from the ship. A lighthouse's light can be seen up to 20 km from the lighthouse. The ship and the lighthouse are 40 km apart along the coast. Describe the region where BOTH the radio can be heard AND the light can be seen.
- 9.A bead starts at position (2, −1) on a grid, in centimetres. It is moved by the column vector u, with top number 3 and bottom number 5, and then moved by the column vector v, with top number −7 and bottom number 2. Work out the coordinates of the bead's final position.
- 10.OABC is a parallelogram, with OA = a and OC = c. M is the midpoint of AB. Express the vector OM in terms of a and c.
- 11.Work out the y-coordinate of the midpoint of the line segment joining (2, 4) and (8, 10).
- 12.From an external point P, two tangents PA and PB touch a circle with centre O at the points A and B. Angle APB = 50°. Work out the size of angle OAB.
- 13.A surveyor is marking out field ABCD for a new crop. The plan states that side AB is parallel to side DC, but AB and DC are not equal in length, and sides BC and AD are not parallel to each other. Which term correctly describes the shape of field ABCD?
- 14.What does the statement AB = CD mean, where A, B, C and D are all points?
- 15.A circle has centre O. Radii OA and OB are drawn, together with the arc AB, enclosing a sector. The straight chord AB is also drawn. Write down the name of the region enclosed between the chord AB and the arc AB.
Answer key
- (c) Rectangle — A rectangle has two pairs of parallel sides and four right angles, but does not require all sides to be equal — this matches exactly, so Rectangle is correct. A square also has four right angles and parallel sides, but additionally requires all four sides to be equal, which contradicts 'not all the same length', so it is wrong. A rhombus has two pairs of parallel sides and all four sides equal, but its angles are not generally 90° unless it is also a square, so it does not match the right-angle condition here. A kite has no pairs of parallel sides at all, so it does not match the first condition given.
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (d) 2 — Method: a point is invariant under a reflection exactly when it lies on the mirror line, so check each vertex's coordinate against the line's equation. Working: the line of reflection is x = 3, so a vertex is invariant only if its x-coordinate equals 3. (3, 1) has x = 3, so it is invariant. (3, 5) has x = 3, so it is also invariant. (6, 1) has x = 6, so it is not invariant, since 6 is not equal to 3. Two of the three vertices are invariant. Answer: 2. Check EVERY vertex against the mirror line's equation rather than assuming a shape either keeps all its vertices fixed or none of them: a vertex is invariant only when it sits exactly on the line, and here two do and one does not.
- (c) (4, 3) — Method: the midpoint of a segment is the mean of its two end points, so its x-coordinate is the mean of the two x-coordinates and its y-coordinate is the mean of the two y-coordinates. Working: for x, (1 + 7) ÷ 2 = 8 ÷ 2 = 4. For y, (3 + 3) ÷ 2 = 6 ÷ 2 = 3. The midpoint is therefore (4, 3). Answer: (4, 3). The distractors: (3, 3) comes from halving the difference of the x-coordinates, (7 − 1) ÷ 2 = 3, which measures half the distance instead of locating the point; (3.5, 3) comes from halving only the larger x-coordinate and leaving the smaller one out of the working; (4, 0) comes from averaging the x-coordinates correctly but then subtracting the y-coordinates, 3 − 3, rather than averaging them.
- (a) 104° — Method: find each inscribed angle separately using the angle-at-the-centre theorem: for a point on the arc NOT cut off by the given central angle, halve that central angle; for a point on the OTHER arc, halve the REFLEX central angle instead; then subtract the smaller from the larger. Working: for C on the major arc, angle ACB = 76 ÷ 2 = 38 degrees. For D on the minor arc, D sees the reflex angle at the centre, 360 − 76 = 284 degrees, so angle ADB = 284 ÷ 2 = 142 degrees. The difference is 142 − 38 = 104 degrees. Answer: 104°. Both inscribed angles need the theorem applied separately, using the correct arc's central angle each time (the reflex angle for D), and the question asks for the DIFFERENCE between the two, not either angle on its own and not their sum, 180°, which is simply the opposite-angle total for the cyclic quadrilateral ACBD.
- (d) 6 cm — Volume = πr²h, so height = volume ÷ (πr²) = 471 ÷ (3.14 × 25) = 471 ÷ 78.5 = 6 cm. (30 cm comes from dividing by πr instead of πr², missing one factor of the radius; 150 cm comes from dividing by π only, without using r² at all; 24 cm comes from treating the given 5 cm as a diameter and using a radius of 2.5 cm instead.)
- (b) A semicircle of radius 4 m, away from the wall. — Every point the dog can reach is at most 4 m from the fixed ring, so without any wall the region would be a full circle of radius 4 m. The wall runs straight through the ring and blocks the dog from crossing it, and since the wall extends further than the lead in both directions, exactly half of that circle is cut off — leaving a semicircle of radius 4 m on the side of the wall the dog is tied on. (A full circle of radius 4 m ignores that the wall blocks half of the region; a quarter circle of radius 4 m would only be correct if the ring were fixed at a corner where two walls met, not along a single straight wall; a rectangle 4 m wide along the wall ignores that the lead lets the dog swing round in a curve, not stay a fixed distance out from the wall.)
- (a) the lens-shaped region where the two circles overlap — The region within 30 km of the ship is a circle of radius 30 km around the ship; the region within 20 km of the lighthouse is a circle of radius 20 km around the lighthouse. Since 30 + 20 = 50 km is more than the 40 km between them, and 30 − 20 = 10 km is less than 40 km, the two circles genuinely overlap, in a lens-shaped region where both conditions hold at once. "the whole smaller circle, since it fits inside the larger one" would only be true if the 40 km distance between the centres were small enough for one circle to swallow the other, which it is not here. "no overlap — 30 km and 20 km don't add to 40 km" wrongly assumes the two radii must add up to exactly the distance between the centres for an overlap to exist; any total greater than that distance is enough. "a straight strip, exactly halfway between the two" confuses this with an equidistant locus, which is a different problem from the one asked here.
- (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
- (c) a + (1/2)c — Method: OABC is a parallelogram, so OB = OA + AB, and since AB is equal and parallel to OC, AB = c; this gives OB = a + c. M is the midpoint of AB, so AM = (1/2)AB = (1/2)c. Working: OM = OA + AM = a + (1/2)c. Answer: OM = a + (1/2)c. Adding the whole of AB instead of half of it gives a + c, which is OB, not OM; halving the whole diagonal OB instead of just AB gives (1/2)a + (1/2)c, the midpoint of OB rather than of AB; and flipping the sign on the c-term gives a − (1/2)c, which points back the wrong way along AB. Halve only the side you are told to halve, and check the sign before you commit to an answer.
- (b) 7 — Method: each coordinate of a midpoint is the mean of the matching pair of coordinates, so the y-coordinate of the midpoint depends on the two y-coordinates alone. Working: the y-coordinates are 4 and 10, so the mean is (4 + 10) ÷ 2 = 14 ÷ 2 = 7. Answer: 7. The distractors: 5 comes from working out the x-coordinate of the midpoint, (2 + 8) ÷ 2 = 5, and writing that down in place of the y-coordinate the question asked for; 3 comes from halving the difference of the y-coordinates, (10 − 4) ÷ 2 = 3, which is half the vertical gap rather than a position; 14 comes from adding the two y-coordinates and forgetting to halve the total.
- (a) 25° — PA and PB are tangents from the same external point, so PA = PB and OAPB is a kite with right angles at A and B, by the tangent–radius theorem: angle OAP = angle OBP = 90°. The four angles of the kite sum to 360°, so angle AOB = 360° − 90° − 90° − 50° = 130°. Triangle OAB is isosceles because OA = OB, both radii, so its base angles are equal: angle OAB = (180° − 130°) ÷ 2 = 25°. Using angle APB itself as the apex angle of triangle OAB instead of angle AOB gives (180° − 50°) ÷ 2 = 65°. Using a triangle's angle sum on the four-sided kite, and so counting only one of its two right angles, treats angle AOB as 180° − 90° − 50° = 40°, and halving what is then left of triangle OAB gives (180° − 40°) ÷ 2 = 70°. Finding angle AOB = 130° correctly but forgetting to halve for the isosceles base angle gives 180° − 130° = 50°. Halve that remaining angle, and 25° is what's left for angle OAB.
- (b) trapezium — A quadrilateral with exactly one pair of parallel sides is a trapezium; field ABCD has AB parallel to DC and no other pair of parallel sides, so trapezium is correct. Parallelogram requires BOTH pairs of opposite sides to be parallel, but the plan says only AB and DC are parallel. Rhombus requires all four sides to be equal in length, which is not stated here. A kite is defined by two pairs of adjacent equal sides, not by having a pair of parallel sides, so it does not match this description either.
- (c) AB and CD are equal in length — AB = CD states that the line segments AB and CD are equal in length; it says nothing about their direction or position. 'AB is parallel to CD' would be written AB ∥ CD, not AB = CD. 'A, B, C and D all lie on one line' is not what an equals sign between two segment names states at all. 'AB is perpendicular to CD' would be written AB ⊥ CD, not AB = CD.
- (b) segment — The region enclosed between a chord and the arc it cuts off is called a segment. A sector is the different region already named in the question, enclosed by the two radii and the arc, not by the chord. A tangent is a straight line that touches the circle at one point, not an enclosed region at all. The circumference is the total distance around the whole circle, a length, not a region.
Build your own mix at the worksheet builder.