Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A garden water trough is a prism whose cross-section is a right-angled triangle with base 40 cm and height 30 cm. The trough is 120 cm long. Work out the volume of water needed to fill the trough completely.
- 2.Two points on a circle divide its circumference into two arcs of different lengths. Write down the name given to the shorter of the two arcs.
- 3.A surveyor marks two fixed points A and B, with position vectors OA = a and OB = b (in km) from a base station O. A relay mast P is to be placed on the line AB such that AP : PB = 3 : 2. Express the vector OP in terms of a and b.
- 4.Triangle J is mapped onto triangle K by a single transformation with centre O. Triangle K is half the size of triangle J and is inverted (turned through 180°). Which of these transformations maps J onto K?
- 5.Shape S has an area of 5 cm². Shape S is enlarged by a scale factor of −3 to give shape T. Work out the area of shape T.
- 6.Two traffic cones are geometrically similar. The smaller cone has height 6 m and the larger cone has height 9 m. Work out the ratio of the volume of the smaller cone to the volume of the larger cone, giving your answer in the form a : b in its simplest form.
- 7.A pinhole camera is set up at a pitch-side stand, with its aperture at the point O = (2, 1) on a grid. Light from the corner F of a triangular flag, at the point (4, 2), passes through the aperture and forms an inverted image on the film behind it. The projection is an enlargement of scale factor −1.5 centred at O. Work out the coordinates of the image of corner F.
- 8.Triangle PQR and triangle XYZ have angle P = angle X, angle Q = angle Y and angle R = angle Z, with no side lengths given for either triangle. Which of the following correctly describes the relationship between the two triangles?
- 9.A student says the reverse of the translation vector is . Write down the correct reverse translation vector.
- 10.The angle between north and a footpath is 35°, measured clockwise from north. What is the three-figure bearing of the footpath?
- 11.A roof truss has two horizontal parallel rafters, one above the other. A straight strut crosses both rafters. Where the strut crosses the lower rafter, the angle above the rafter and to the left of the strut is 65°. Work out the size of the angle above the upper rafter and to the right of the strut, where the strut crosses it.
- 12.Triangle ABC has AB = 10 cm, BC = 7 cm and angle A = 40°. Triangle DEF has DE = 10 cm, EF = 7 cm and angle D = 40°. Sam says the two triangles are congruent by SAS. Which statement about Sam's claim is correct?
- 13.Point Q has coordinates (3, 5). It is translated by the vector (1, −2), and the image is then enlarged by scale factor 3, centre the origin. Work out the coordinates of the final image of Q.
- 14.A triangle has vertices A(0, 0), B(10, 0) and C(5, 12). Work out the area of the triangle.
- 15.A drinks company sells a novelty giant bottle that is geometrically similar to its standard 500 ml bottle, scaled up by a length factor of 1.5. Work out the capacity of the giant bottle, in ml.
Answer key
- (b) 72 000 cm³ — Cross-sectional area = 1/2 × 40 × 30 = 600 cm². Volume = cross-sectional area × length = 600 × 120 = 72 000 cm³. (144 000 cm³ comes from forgetting the 1/2 in the triangle's area, using 40 × 30 as the cross-section; 36 000 cm³ comes from halving the correct volume again, as if the 1/2 applied a second time; 720 cm³ comes from adding the cross-sectional area and the length, 600 + 120, instead of multiplying them.)
- (d) Minor arc — Method: compare the lengths of the two arcs formed by the two points, and recall the term for the shorter one. Working: the two points split the circumference into two arcs; the shorter one is the minor arc and the longer one is the major arc. A student who answers major arc has picked the longer arc by mistake. A student who answers minor segment has confused the curved boundary with the enclosed two-dimensional region. A student who answers chord has named the straight line joining the two points instead of the curved arc. Answer: minor arc.
- (d) (2/5)a + (3/5)b — Method: OP = OA + AP, and since AP : PB = 3 : 2 splits AB into 5 equal parts, AP is 3/5 of the whole of AB, with AB = b − a. Working: OP = a + 3/5(b − a) = a − (3/5)a + (3/5)b = (2/5)a + (3/5)b. Answer: OP = (2/5)a + (3/5)b. Using the ratio the wrong way round, as though it read AP : PB = 2 : 3, gives (3/5)a + (2/5)b; adding (3/5)b onto the whole of a without subtracting a inside the bracket first gives a + (3/5)b; and treating the ratio as 1 : 1 gives the midpoint, (1/2)a + (1/2)b. Convert the ratio to a fraction of AB measured from A, matching the ORDER the ratio is stated in, and subtract before you scale.
- (b) An enlargement, centre O, scale factor −1/2. — A single enlargement with a negative scale factor both changes the size (by the magnitude of the factor) and rotates the image 180° about the centre (giving the inverted orientation) in one transformation. Halving the size needs a magnitude of 1/2, and inverting needs a negative sign, so the scale factor is −1/2, centre O. 'Scale factor 1/2' gives the correct size but no inversion, since a positive scale factor keeps the same orientation. 'A 180° rotation with no change in size' gives the inversion but not the halving — K is described as smaller than J, so size must change too. 'Scale factor −2' inverts correctly but doubles the size instead of halving it.
- (b) 45 cm² — Area scales with the square of the linear scale factor, and squaring a negative number gives a positive result: (−3)² = 9. The area of T is 5 × 9 = 45 cm². 15 cm² comes from multiplying the original area by the scale factor directly (5 × 3), without squaring. 9 cm² is the area scale factor itself, (−3)², with the multiplication by the original area 5 cm² left out. −15 cm² comes from multiplying 5 × (−3) and carrying the negative sign through, without squaring at all.
- (b) 8 : 27 — The heights are in the ratio 6 : 9, which simplifies to 2 : 3. For similar solids, volume scales with the cube of the length ratio, so the volume ratio is 2³ : 3³ = 8 : 27. 2 : 3 is only the simplified length ratio, without cubing. 4 : 9 comes from squaring instead of cubing — that's the rule for areas, not volumes. 27 : 8 has the correct cubed values but in the wrong order, giving the larger cone's volume first instead of the smaller.
- (a) (−1, −0.5) — Method: for an enlargement centred at a point O that is not the origin, first find the point's position relative to O, multiply that by the scale factor, then add O's coordinates back on — image = O + k × (F − O). Working: F relative to O is (4, 2) − (2, 1) = (2, 1). Multiplying by the scale factor, −1.5 × (2, 1) = (−3, −1.5). Adding O back on: (2, 1) + (−3, −1.5) = (−1, −0.5). Answer: (−1, −0.5). Measure F's position from the aperture O, not from the origin, apply the full signed scale factor −1.5 to that displacement, and add O's own coordinates back on afterwards: measuring from the origin instead of O, treating the factor as +1.5, or adding O onto the wrong displacement all place the image mark somewhere else.
- (a) Similar, but AAA alone does not prove congruence — Three equal corresponding angles (AAA) show that the two triangles are similar — the same shape — but says nothing about their size, so it does not prove congruence. They could be congruent, or one could simply be an enlargement of the other; without matching side lengths, congruence is not established, so 'congruent because AAA proves congruence' is wrong. Equal angles do not force equal sides — a triangle can be enlarged to any size while keeping the same angles, so that option is also wrong. Something CAN be said here — that the triangles are similar — so 'no relationship can be determined' is wrong too.
- (c) $\binom{-4}{9}$ — The reverse of a translation negates both components, so the reverse of $\binom{4}{-9}$ is $\binom{-4}{9}$. $\binom{4}{9}$ is the student's mistake — only the bottom number has been negated, and the top number was left unchanged. $\binom{-4}{-9}$ makes the opposite error, negating only the top number. $\binom{4}{-9}$ is simply the original vector, unchanged.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (d) Wrong - the given angle is not the included angle — Sides AB and BC meet at vertex B, so the included angle needed for SAS is angle B, not angle A — the information given is SSA. SSA does not prove congruence: with AB = 10 cm, BC = 7 cm and angle A = 40° there are two different triangles that fit, one with angle C ≈ 74.6° and one with angle C ≈ 105.4°, so Sam's triangles need not be the same shape and size at all. Sam is not correct just because two sides and an angle are equal, since the angle must be the one INCLUDED between those two sides. The condition is not ASA either, because ASA needs two angles, and only one angle is given here. It is also not true that nothing matches — the stated lengths and angle DO match between the two triangles; the problem is which angle was given, not whether the values agree.
- (b) (12, 9) — Apply the transformations in the order given: first translate, then enlarge. Translating (3, 5) by the vector (1, −2) gives (3 + 1, 5 − 2) = (4, 3). Enlarging this by scale factor 3 about the origin multiplies both coordinates by 3: (4 × 3, 3 × 3) = (12, 9). Enlarging first and translating afterwards reverses the order and gives (3 × 3 + 1, 5 × 3 − 2) = (10, 13), a different point because the two transformations do not commute. Enlarging the original point by scale factor 3 while forgetting to translate it at all gives (3 × 3, 5 × 3) = (9, 15). Reversing the signs of the translation vector before applying it gives (3 − 1, 5 + 2) = (2, 7), which then enlarges to (2 × 3, 7 × 3) = (6, 21).
- (b) 60 units² — Method: the area of a triangle is half the base times the perpendicular height, so choose a side to act as the base and measure the perpendicular distance from the opposite vertex to it. Working: A(0, 0) and B(10, 0) both lie on the x-axis, so AB is horizontal and AB = 10 − 0 = 10. The perpendicular height is the distance of C from the x-axis, which is its y-coordinate, 12. Area = (10 × 12) ÷ 2 = 120 ÷ 2 = 60. Answer: 60 units². The distractors: 120 units² comes from multiplying base by height and forgetting to halve; 65 units² comes from using the slanting side AC, which is 13 long, as the height in place of the perpendicular distance 12; 30 units² comes from halving the base to 5 before multiplying and then halving the product as well, so the halving is done twice.
- (d) 1687.5 ml — The length scale factor from the standard bottle to the giant bottle is 1.5, so the volume scale factor is 1.5³ = 3.375. The capacity of the giant bottle is 500 × 3.375 = 1687.5 ml. 750 ml comes from multiplying by the length factor 1.5 directly, without cubing it. 1125 ml comes from using the area scale factor 1.5² = 2.25 instead of the volume scale factor. 2250 ml comes from treating 'cubed' as 'multiplied by 3', giving 1.5 × 3 = 4.5 as the scale factor instead of 1.5³.
Build your own mix at the worksheet builder.