Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A circular table mat has diameter 20 cm. Yasmin has a 70 cm length of ribbon and sews it around the edge of the mat with no overlap. Using π = 3.14, work out how much ribbon is left over after going around the mat once.
- 2.OABC is a parallelogram, with OA = a and OC = c. X is the point on AC such that AX is a third of XC. Express the vector OX in terms of a and c.
- 3.The angle between north and a footpath is 35°, measured clockwise from north. What is the three-figure bearing of the footpath?
- 4.A parallelogram has an area of 84 cm² and a base of 12 cm. Work out the perpendicular height of the parallelogram.
- 5.A game designer places a coin at (5, 3) on a grid. The game rotates the coin 90° clockwise about the point (2, 3) each time the player presses a button, and this is applied twice in a row. Work out the coordinates of the coin after the button is pressed twice.
- 6.Triangle T has a vertex A at (3, 1). It is enlarged by a scale factor of −2, centre (1, 1). Work out the coordinates of the image of point A.
- 7.A ramp's sloped surface crosses two horizontal parallel rails. At the top rail, the angle between the ramp and the rail on the right of the ramp is (3x + 10)°. At the bottom rail, the angle between the ramp and the rail on the left of the ramp is (5x − 30)°. Work out the value of x.
- 8.Two sides of a triangle are 9 cm and 15 cm long. Write down which one of these lengths is possible for the third side.
- 9.Two spheres are similar solids. Their radii are in the ratio 3 : 4. Write down the ratio of their surface areas.
- 10.Point P has coordinates (6, 4). P is rotated 90° clockwise about the point (1, 2), and the image is then translated by the vector (−3, 5). Work out the coordinates of the final image of P.
- 11.Triangle JKL has a right angle at K, hypotenuse JL = 13 cm, and side JK = 5 cm. Triangle MNO has a right angle at N, hypotenuse MO = 13 cm, and side MN = 5 cm. Using only the facts given, and without working out any further lengths, write down the congruence condition that proves triangle JKL is congruent to triangle MNO.
- 12.Triangle ABC and triangle DEF are similar. The area of triangle ABC is 36 cm² and the area of triangle DEF is 100 cm². Work out the ratio of the lengths of triangle ABC to the lengths of triangle DEF, in its simplest form.
- 13.A square-based pyramid has a square base and four identical triangular sloping faces, with its apex directly above the centre of the base. How many planes of symmetry does it have?
- 14.m is the column vector with top number 4 and bottom number 6. n is the column vector with top number −6 and bottom number −9. Given that n = k × m for some number k, work out the value of k.
- 15.ABCD is a cyclic quadrilateral, with its vertices in that order around the circle. Angle DAB = 108°. Work out the size of angle BCD.
Answer key
- (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
- (d) (3/4)a + (1/4)c — Method: OX = OA + AX, and since AX is a third of XC, AX is 1/4 of the whole of AC, with AC = c − a. Working: OX = a + 1/4(c − a) = a − (1/4)a + (1/4)c = (3/4)a + (1/4)c. Answer: OX = (3/4)a + (1/4)c. Measuring 1/4 of AC from C's end instead of A's swaps the fractions round, giving (1/4)a + (3/4)c; adding (1/4)c onto the whole of a without subtracting a inside the bracket first gives a + (1/4)c; and treating the ratio as though AX and XC were equal gives the midpoint, (1/2)a + (1/2)c. Convert the ratio to a fraction of AC measured from A, subtract before you scale, and then add the result to OA.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (d) 7 cm — Area of a parallelogram = base × height, so height = area ÷ base = 84 ÷ 12 = 7 cm. A pupil who multiplies instead of dividing gets 84 × 12 = 1008 cm. A pupil who divides the base by the area instead of the area by the base gets 12 ÷ 84 ≈ 0.14 cm. A pupil who mistakenly halves the area first, as if this were a triangle, gets (84 ÷ 2) ÷ 12 = 3.5 cm. The correct height is 7 cm.
- (d) (−1, 3) — Method: two 90° rotations about the SAME centre, applied one after another, combine into a single 180° rotation about that same centre: use the shortcut (x, y) → (2a − x, 2b − y) for a half-turn about (a, b). Working: with centre (2, 3), doubling each coordinate gives 2 × 2 = 4 and 2 × 3 = 6, so the rule is (x, y) → (4 − x, 6 − y). Applying it to (5, 3) gives 4 − 5 = −1 and 6 − 3 = 3, so the coin ends at (−1, 3). Answer: (−1, 3). Rotate about the centre (2, 3) stated in the game, not about the origin, and remember the button is pressed TWICE: stopping after one press, or rotating about the wrong centre, both leave the coin somewhere else.
- (c) (−3, 1) — Method: for an enlargement about a centre, first find the vector from the centre to the point, multiply it by the scale factor, INCLUDING its sign, then add the result back onto the centre. Working: the vector from the centre (1, 1) to A(3, 1) is (3 − 1, 1 − 1) = (2, 0). Multiplying by the scale factor −2 gives −2 × 2 = −4 and −2 × 0 = 0, so the scaled vector is (−4, 0). Adding this to the centre gives 1 + (−4) = −3 and 1 + 0 = 1, so the image is (−3, 1). Answer: (−3, 1). A NEGATIVE scale factor keeps its sign all the way through the calculation: do not treat −2 as +2, and do not treat it as a fraction like 1/2, which is the rule for a scale factor between 0 and 1, not a negative one. Always measure the vector from the CENTRE of enlargement, never from the origin, unless the two happen to coincide.
- (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
- (d) 10 cm — For a triangle to exist, any two sides must add up to more than the third side. 9 + 10 = 19 > 15, and 15 − 9 = 6 < 10, so 10 cm satisfies the triangle inequality. The other lengths fail: 6 cm gives 9 + 6 = 15, which is not more than 15; 24 cm and 26 cm are each at least as large as 9 + 15 = 24.
- (c) 9 : 16 — Method: in similar solids the ratio of the surface areas is the square of the ratio of corresponding lengths. Working: the radii are in the ratio 3 : 4, so the surface areas are in the ratio 3² : 4² = 9 : 16. Answer: 9 : 16. The distractors: 27 : 64 is 3³ : 4³, the ratio of the volumes, which cubes the length ratio instead of squaring it; 3 : 4 leaves the length ratio untouched, as though surface area scaled in the same way as a length; 81 : 256 comes from squaring a second time, applying the rule to the ratio 9 : 16 rather than to the radii.
- (b) (0, 2) — Method: to rotate about a point that is not the origin, first subtract the centre's coordinates, apply the rotation rule to the shifted point, then add the centre's coordinates back on; only after that do you apply the translation, in the order the question states them. Working: shifting P relative to the centre gives (6 − 1, 4 − 2) = (5, 2); rotating 90° clockwise sends (x, y) to (y, −x), giving (2, −5); adding the centre back on gives (2 + 1, −5 + 2) = (3, −3); applying the translation (−3, 5) gives (3 − 3, −3 + 5) = (0, 2). Answer: (0, 2). Applying the translation BEFORE the rotation, reversing the order the question gives them in, gives (8, 0); stopping after the rotation and forgetting the translation altogether gives (3, −3); and rotating anticlockwise instead of clockwise, using (x, y) → (−y, x), gives (−4, 12). Always carry out the two transformations in the order stated — rotate about the given centre first, then translate — and check each step before moving to the next.
- (c) RHS — Both triangles are right-angled, and have equal hypotenuses (13 cm) and one equal corresponding side (5 cm), so they are congruent by the RHS (right angle, hypotenuse, side) condition — the three facts given are exactly a right angle, a hypotenuse and one other side. The distractor SAS would apply if two sides and the angle between those two sides were matched, but the right angle here lies between the 5 cm side and the third side, not between the 5 cm side and the hypotenuse. The distractor SSS needs all three pairs of sides matched, and only two sides of each triangle are given — the third side would first have to be calculated by Pythagoras, so SSS is not the condition the given facts supply. The distractor AAS would need two angles and a non-included side matched, but only one angle in each triangle is given.
- (a) 3 : 5 — Method: for similar figures the ratio of the areas is the square of the ratio of the lengths, so the length ratio is found by taking the square root of each part of the area ratio. Working: the areas are in the ratio 36 : 100, and taking square roots gives √36 : √100 = 6 : 10, which cancels to 3 : 5. Answer: 3 : 5. The distractors: 9 : 25 is 36 : 100 in its simplest form, so it is still the ratio of the areas and the square roots were never taken; 5 : 3 takes the roots correctly but writes the parts the wrong way round, giving DEF to ABC when ABC to DEF was asked for; 25 : 9 makes both mistakes at once, leaving the area ratio and reversing it.
- (d) 4 — Method: a plane of symmetry must pass through the apex and cut the base along one of the base's own lines of symmetry. Working: a square has 4 lines of symmetry (2 through opposite edge midpoints, 2 through opposite corners), and each of these, combined with the apex, gives one plane of symmetry of the pyramid. A student who answers 2 has only found the planes through the edge midpoints, or only the ones through the corners, and missed the other pair. A student who answers 8 has doubled the correct count, perhaps confusing it with a different solid. A student who answers 1 has only spotted the one obvious front-to-back plane. Answer: 4.
- (c) −1.5 — Since n = k × m, dividing a number in n by the matching number in m gives k: k = −6 ÷ 4 = −1.5 (check with the bottom numbers: −9 ÷ 6 = −1.5, the same value, confirming n is a scalar multiple of m). 1.5 has the correct size but is missing the negative sign. −10 comes from subtracting the top numbers, −6 − 4, instead of dividing them. −24 comes from multiplying the top numbers, −6 × 4, instead of dividing them.
- (c) 72° — Method: opposite angles in a cyclic quadrilateral always sum to 180°. Working: angle DAB and angle BCD are opposite angles of the cyclic quadrilateral ABCD, so angle BCD = 180 − 108 = 72 degrees. Answer: 72°. Opposite angles in a cyclic quadrilateral are SUPPLEMENTARY, not equal, so do not simply copy the given angle; and do not subtract from 360°, which is the rule for angles round a point, or confuse this with the angle-in-a-semicircle theorem, which gives a fixed 90° that has nothing to do with this quadrilateral.
Build your own mix at the worksheet builder.