Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A trapezium-shaped allotment plot has two parallel sides that face each other, and two sloping sides that are equal in length (an isosceles trapezium). One of the angles next to the shorter parallel side is 118°. Work out the angle next to the other end of the same shorter parallel side.
- 2.OABC is a parallelogram, with OA = a and OC = c. X is the point on AC such that AX is a third of XC. Express the vector OX in terms of a and c.
- 3.A circular table mat has diameter 20 cm. Yasmin has a 70 cm length of ribbon and sews it around the edge of the mat with no overlap. Using π = 3.14, work out how much ribbon is left over after going around the mat once.
- 4.A parallelogram has an area of 84 cm² and a base of 12 cm. Work out the perpendicular height of the parallelogram.
- 5.A patio plan states: 'Side AB of the patio is parallel to side DC, and AB is longer than DC. Sides BC and AD are not parallel to each other and are not equal in length.' The four sides measure AB = 5.1 m, BC = 3.2 m, DC = 2.8 m and AD = 4.5 m. The tiler needs to order edging strip only for the sides that are not parallel to any other side. What total length of edging strip, in metres, should the tiler order?
- 6.A jug holds 750 ml of water. Work out what fraction of a litre this is.
- 7.A tank holds 3.2 m³ of water. Work out this volume in litres.
- 8.O is the centre of a circle, and PT is a tangent to the circle at the point T. A is a point on the circle, with OA and OT both radii and angle AOT = 122°. At the point T, the chord TA lies between the radius TO and the tangent TP. Work out the size of angle ATP, the angle between the chord and the tangent.
- 9.A parallelogram has an area of 54 cm² and a base of 9 cm. Work out its perpendicular height.
- 10.The diagram shows a cuboid. Work out the area of its front elevation, in square centimetres.
- 11.The angle between north and a footpath is 35°, measured clockwise from north. What is the three-figure bearing of the footpath?
- 12.From an external point P, two tangents PA and PB touch a circle with centre O at the points A and B. Angle APB = 50°. Work out the size of angle OAB.
- 13.A student says the reverse of the translation vector is . Write down the correct reverse translation vector.
- 14.Triangle DEF has a right angle at E. Angle DFE = 60° and EF = 9 cm. Work out the exact length of DE.
- 15.Work out the exact value of (sin 30°)² + (cos 30°)².
Answer key
- (d) 118° — In an isosceles trapezium, the two angles next to the same parallel side are equal, because the sloping sides are equal in length. So the angle at the other end of the shorter parallel side also equals 118°.
- (d) (3/4)a + (1/4)c — Method: OX = OA + AX, and since AX is a third of XC, AX is 1/4 of the whole of AC, with AC = c − a. Working: OX = a + 1/4(c − a) = a − (1/4)a + (1/4)c = (3/4)a + (1/4)c. Answer: OX = (3/4)a + (1/4)c. Measuring 1/4 of AC from C's end instead of A's swaps the fractions round, giving (1/4)a + (3/4)c; adding (1/4)c onto the whole of a without subtracting a inside the bracket first gives a + (1/4)c; and treating the ratio as though AX and XC were equal gives the midpoint, (1/2)a + (1/2)c. Convert the ratio to a fraction of AC measured from A, subtract before you scale, and then add the result to OA.
- (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
- (d) 7 cm — Area of a parallelogram = base × height, so height = area ÷ base = 84 ÷ 12 = 7 cm. A pupil who multiplies instead of dividing gets 84 × 12 = 1008 cm. A pupil who divides the base by the area instead of the area by the base gets 12 ÷ 84 ≈ 0.14 cm. A pupil who mistakenly halves the area first, as if this were a triangle, gets (84 ÷ 2) ÷ 12 = 3.5 cm. The correct height is 7 cm.
- (a) 7.7 m — AB is parallel to DC, so those two sides are each parallel to another side. BC and AD are stated to be not parallel to each other, so neither one is parallel to any other side — these are the two sides that need edging. Adding these: 3.2 + 4.5 = 7.7 m, so 7.7 m is correct. 7.6 m comes from an arithmetic slip when adding 3.2 and 4.5. 15.4 m comes from doubling the correct total, mistakenly assuming edging strip is needed along both faces of each side. 4.5 m comes from using only the longer of the two non-parallel sides and forgetting to add the shorter one.
- (a) 3/4 — 1 litre = 1000 ml, so 750 ml is 750/1000 of a litre. Dividing both the numerator and denominator by 250 simplifies this to 3/4. Writing the fraction upside down, as the litre out of the 750 ml, gives 4/3. Finding the fraction of the litre that is NOT filled, 250/1000, gives 1/4. Dividing the numerator by 250 but the denominator by only 100, an inconsistent simplification, gives 3/10.
- (c) 3200 — Method: to change cubic metres to litres, multiply by 1000. Working: 3.2 × 1000 = 3200. Answer: 3200 litres. A candidate who multiplies by 100 instead of 1000 gets 320. A candidate who multiplies by 10000 instead of 1000 gets 32000. A candidate who does not convert at all gives 3.2.
- (b) 61° — Triangle OAT is isosceles because OA = OT, both radii, so its base angles are equal: angle OTA = angle OAT = (180° − 122°) ÷ 2 = 29°. The tangent PT meets the radius OT at 90°, by the tangent–radius theorem, so angle OTP = 90°. Since TA lies between TO and TP, angle OTP splits into angle OTA and angle ATP: angle ATP = 90° − 29° = 61°. Stopping after the isosceles step and reporting the base angle itself gives 29°. Finding the base angles as 180° − 122° without halving, then subtracting from 90°, gives 90° − 58° = 32°. Adding the base angle to 90° instead of subtracting it gives 90° + 29° = 119°. Subtract the base angle from the right angle, and 61° is what's left.
- (c) 6 cm — For a parallelogram, area = base × height, so height = area ÷ base = 54 ÷ 9 = 6 cm. 12 cm comes from using the triangle's reverse formula, height = 2 × area ÷ base, which does not apply to a parallelogram. 45 cm comes from subtracting the base from the area, 54 − 9, instead of dividing. 486 cm comes from multiplying the area by the base, 54 × 9, instead of dividing.
- (c) 24 cm² — Method: the front elevation of a cuboid is a rectangle formed by the cuboid's length and its height, so its area is length × height. Working: 6 cm × 4 cm = 24 cm². Answer: 24 cm². The distractors: 12 cm² comes from using width × height (3 × 4) instead of length × height, mistaking the side elevation's dimensions for the front's. 18 cm² comes from using length × width (6 × 3), which gives the area of the plan view instead of the front elevation. 20 cm² comes from finding the perimeter of the front face instead of its area: 2 × (6 + 4) = 20.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (a) 25° — PA and PB are tangents from the same external point, so PA = PB and OAPB is a kite with right angles at A and B, by the tangent–radius theorem: angle OAP = angle OBP = 90°. The four angles of the kite sum to 360°, so angle AOB = 360° − 90° − 90° − 50° = 130°. Triangle OAB is isosceles because OA = OB, both radii, so its base angles are equal: angle OAB = (180° − 130°) ÷ 2 = 25°. Using angle APB itself as the apex angle of triangle OAB instead of angle AOB gives (180° − 50°) ÷ 2 = 65°. Using a triangle's angle sum on the four-sided kite, and so counting only one of its two right angles, treats angle AOB as 180° − 90° − 50° = 40°, and halving what is then left of triangle OAB gives (180° − 40°) ÷ 2 = 70°. Finding angle AOB = 130° correctly but forgetting to halve for the isosceles base angle gives 180° − 130° = 50°. Halve that remaining angle, and 25° is what's left for angle OAB.
- (c) $\binom{-4}{9}$ — The reverse of a translation negates both components, so the reverse of $\binom{4}{-9}$ is $\binom{-4}{9}$. $\binom{4}{9}$ is the student's mistake — only the bottom number has been negated, and the top number was left unchanged. $\binom{-4}{-9}$ makes the opposite error, negating only the top number. $\binom{4}{-9}$ is simply the original vector, unchanged.
- (d) 9√3 cm — DE is opposite the 60° angle at F, and EF is adjacent to it, so DE = EF × tan 60° = 9 × √3 = 9√3 cm. 9√3/2 cm comes from using sin 60° = √3/2 instead of tan 60°. 3√3 cm comes from using tan 30° = 1/√3 instead of tan 60° (9 × 1/√3 = 9/√3 = 3√3). 18 cm is the hypotenuse DF, not DE: it comes from using cos 60° = 1/2 and working out 9 ÷ 1/2 = 18, which finds the wrong side of the triangle.
- (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
Build your own mix at the worksheet builder.