Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.To construct the perpendicular from a point P to a line l, where P is a point above l, an arc centred at P is drawn to cross l at two points, X and Y. What is the correct next step?
- 2.A trundle wheel has a diameter of 0.5 m. It is rolled along the ground and makes 20 complete turns. Using π = 3.14, work out the total distance rolled, in metres.
- 3.A hiker walks on a bearing of 065°. She then turns clockwise through 90° and continues walking in a straight line. What bearing is she now walking on?
- 4.A cube has edges of length 5 cm. Work out the length of the diagonal that runs from one corner of the cube to the opposite corner. Give your answer as a surd in its simplest form.
- 5.Every diameter of a circle is an example of a more general type of straight line joining two points on the circle. Which term names that more general type of line?
- 6.A point is translated twice by the vector . Write down the single column vector that describes the overall translation.
- 7.The angle between north and a cycle path is 40°, but it is measured anticlockwise from north. What is the three-figure bearing of the cycle path?
- 8.In triangle ABC, angle ABC = 90° and angle BAC = 30°. The hypotenuse AC = 12 cm. Work out the exact length of AB.
- 9.Two circles are drawn with the same centre but different radii. Write down the term used to describe this pair of circles.
- 10.An engineer models a technical drawing on a coordinate grid. A component is reflected in the line x = 2, and the image is then reflected in the line x = 6. Which single transformation has the same overall effect as these two reflections, for every point on the drawing?
- 11.A circle with centre O has radius 17 cm. A chord AB is drawn so that the perpendicular distance from O to AB is 8 cm. Work out the length of the chord AB.
- 12.Two similar bottles have heights in the ratio 1 : 2. Write down the ratio of their volumes.
- 13.A postcard measuring 10 cm by 15 cm is enlarged by a scale factor of 2 to make a poster. Work out the area of the poster, in cm².
- 14.A scale drawing of a bridge uses a scale of 1 : 25. A support beam on the drawing measures 4.4 cm. What is the real length of the beam, in metres?
- 15.Triangle ABC has AB = 6 cm, BC = 8 cm and angle B = 90°. Triangle XYZ has XY = 6 cm, YZ = 8 cm and angle Y = 90°. Which congruence statement correctly shows the matching vertices?
Answer key
- (a) Draw equal arcs from X and Y, meeting below line l. — After the first arc marks two points X and Y on line l, compasses are opened to a new radius and arcs of equal radius are drawn centred at X and at Y, so that they meet on the opposite side of l from P; joining P to that meeting point gives the perpendicular. (Joining X and Y with a straight line only retraces part of line l itself, since X and Y both already lie on it; drawing an arc centred at P through only one of X or Y repeats part of the first step instead of moving on; drawing a circle through X, Y and P does not locate the new point needed to complete the perpendicular.)
- (a) 31.4 — Method: first find the circumference of one turn using π × diameter, then multiply by the number of turns. Working: circumference = 3.14 × 0.5 = 1.57 m; total distance = 1.57 × 20 = 31.4 m. A student who answers 15.7 has mistakenly halved the diameter again before multiplying, using 0.25 m instead of 0.5 m. A student who answers 3.14 has simply written down π itself, without completing the circumference or multiplying by the number of turns. A student who answers 62.8 has mistakenly doubled the diameter to 1 m before multiplying, treating the given length as a radius. Answer: 31.4 m.
- (c) 155° — Turning clockwise adds to the bearing. Starting on a bearing of 065° and turning clockwise through 90° gives 065° + 90° = 155°. A candidate who instead subtracts, working out 90° − 65° = 25°, has performed the wrong operation, giving 025°. A candidate who turns anticlockwise instead of clockwise works out 065° − 90°, which gives a negative number, and adding 360° to fix this gives 335° — the bearing for turning the other way. A candidate who thinks turning does not change the bearing at all keeps the answer as 065°. The new bearing, turning clockwise, is 155°.
- (c) 5√3 cm — The space diagonal of a cube with edge a satisfies d² = a² + a² + a² = 3a², using Pythagoras' theorem in three dimensions. With a = 5, d² = 3 × 5² = 3 × 25 = 75, so d = √75 = √(25 × 3) = 5√3 cm. Finding the diagonal of one face instead, using only two of the three edges, gives d = √(5² + 5²) = √50 = 5√2 cm, which leaves out the third dimension. Adding the three edges directly, 5 + 5 + 5 = 15 cm, ignores that Pythagoras' theorem works with squares of lengths, not the lengths themselves. Squaring the edge and multiplying by 3 correctly, 3 × 5² = 75, but then forgetting to take the square root, leaves 75 cm — the squared length, not the diagonal itself.
- (c) chord — A diameter is a straight line joining two points on the circle that happens to pass through the centre. The general term for any straight line joining two points on a circle is a chord — every diameter is a chord, but not every chord is a diameter. Calling it a radius is wrong because a radius runs from the centre to just ONE point on the circle, not between two points on the circle. A tangent touches the circle at only one point, so it cannot be a diameter at all. An arc is a curved part of the circle's edge, not a straight line.
- (b) $\binom{-6}{10}$ — Translating twice by the same vector doubles both components: 2 × $\binom{-3}{5}$ = $\binom{-6}{10}$. $\binom{-3}{5}$ forgets to double the vector at all, giving only one translation's worth. $\binom{-9}{15}$ trebles the vector instead of doubling it. $\binom{-6}{5}$ doubles only the top number and forgets to double the bottom number.
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
- (d) Concentric circles — Method: focus on what the two circles have in common — their centre, not their size. Working: both circles share exactly the same centre point but have different radii, which is the defining feature of this pair of circles. A student who answers congruent circles has confused 'same centre' with 'same size', but congruent circles simply have equal radii and need not share a centre. A student who answers tangential circles has confused circles that touch each other at one point with ones that share a centre. A student who answers similar circles has used the general term for the same shape at different sizes, missing the specific 'same centre' fact. Answer: concentric circles.
- (d) A translation by the vector (8, 0) — Method: two reflections in PARALLEL lines combine into a single translation, perpendicular to the lines, of size twice the distance between them; two reflections in lines that CROSS combine into a rotation instead, never a translation. Working: the lines x = 2 and x = 6 are parallel, a distance of 6 − 2 = 4 apart. Doubling this distance gives 2 × 4 = 8, and the translation runs in the direction from the first line towards the second, so the vector is (8, 0). Answer: a translation by the vector (8, 0). Double the distance between the lines rather than using it directly, keep the direction running from the FIRST line reflected to the SECOND, and remember that two reflections in lines that never meet can only give a translation, never a rotation.
- (b) 30 cm — The perpendicular from the centre of a circle to a chord bisects the chord, so this line, half the chord and the radius form a right-angled triangle. Using Pythagoras' theorem, half the chord = √(17² − 8²) = √(289 − 64) = √225 = 15 cm. The full chord AB is twice this length: AB = 2 × 15 = 30 cm. Stopping after finding the half-chord, without doubling it for the whole chord, gives 15 cm. Adding the radius and the perpendicular distance directly, 17 + 8 = 25 cm, ignores that these two lengths are the two shorter sides of a right-angled triangle, not parts of a straight line. Subtracting instead, 17 − 8 = 9 cm, makes the same mistake in the other direction.
- (a) 1 : 8 — Method: in similar solids the ratio of the volumes is the cube of the ratio of corresponding lengths. Working: the heights are in the ratio 1 : 2, so the volumes are in the ratio 1³ : 2³ = 1 : 8. Answer: 1 : 8. The distractors: 1 : 2 leaves the height ratio unchanged, as though a volume scaled in the same way as a length; 1 : 4 comes from squaring, 1² : 2², which is the rule for surface areas and not for volumes; 1 : 6 comes from multiplying each part by 3 instead of raising each part to the power 3.
- (d) 600 cm² — Enlarging by scale factor 2 makes the new dimensions 10 × 2 = 20 cm and 15 × 2 = 30 cm, so the poster's area = 20 × 30 = 600 cm². A pupil who scales the original area, 150 cm², by the scale factor itself instead of by its square gets 150 × 2 = 300 cm². A pupil who adds the scale factor to each dimension instead of multiplying gets (10 + 2) × (15 + 2) = 204 cm². A pupil who forgets to enlarge the postcard at all just uses the original area, 150 cm². The correct area of the poster is 600 cm².
- (d) 1.1 — Method: multiply the drawing length by the scale factor to get the real length, then convert to the units asked for. Working: 4.4 cm × 25 = 110 cm = 1.1 m. A student who answers 4.4 has forgotten to use the scale at all. A student who answers 110 has correctly worked out the real length in centimetres but forgotten to convert it to metres. A student who answers 11 has used a scale factor of 2.5 instead of 25 by misreading the scale. Answer: 1.1 m.
- (c) ABC ≅ XYZ — Method: match each vertex in ABC to its corresponding vertex in XYZ, using the equal sides and angles given, then write the letters in that matching order. Working: AB matches XY, BC matches YZ, and angle B matches angle Y, so A corresponds to X, B corresponds to Y, and C corresponds to Z, giving ABC ≅ XYZ. Options: 'ABC ≅ ZYX' puts Z in A's position, but A corresponds to X, not Z; 'ABC ≅ YXZ' puts Y in A's position, but A corresponds to X; 'ABC ≅ ZXY' puts Z in A's position and X in B's position, neither of which is correct. Answer: ABC ≅ XYZ.
Build your own mix at the worksheet builder.