Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Two triangles are proved congruent using the ASA condition. What can be concluded about the two remaining pairs of corresponding sides that were not part of the original ASA facts?
- 2.In triangle XYZ, the side opposite vertex X is labelled using the standard lowercase-letter convention. Which label is correct?
- 3.A ramp's sloped surface crosses two horizontal parallel rails. At the top rail, the angle between the ramp and the rail on the right of the ramp is (3x + 10)°. At the bottom rail, the angle between the ramp and the rail on the left of the ramp is (5x − 30)°. Work out the value of x.
- 4.A tap fills a tank at a rate of 18 litres per minute. The tank holds 0.45 m³. Work out how long the tap takes to fill the tank.
- 5.A trapezium-shaped allotment plot has two parallel sides that face each other, and two sloping sides that are equal in length (an isosceles trapezium). One of the angles next to the shorter parallel side is 118°. Work out the angle next to the other end of the same shorter parallel side.
- 6.A quadrilateral has vertices A(1, 1), B(5, 1), C(6, 4) and D(2, 4). By comparing the y-coordinates of A, B and of D, C, write down whether the sides AB and DC are parallel, and give a reason for your answer.
- 7.In triangle ABC, angle ABC = 90° and angle BAC = 30°. The hypotenuse AC = 12 cm. Work out the exact length of AB.
- 8.Triangle ABC is similar to triangle PQR. AB corresponds to PQ, and BC corresponds to QR. AB = 5 cm, PQ = 15 cm and BC = 7 cm. Work out the length of QR.
- 9.Point Q has coordinates (3, 5). It is translated by the vector (1, −2), and the image is then enlarged by scale factor 3, centre the origin. Work out the coordinates of the final image of Q.
- 10.A game designer places a coin at (5, 3) on a grid. The game rotates the coin 90° clockwise about the point (2, 3) each time the player presses a button, and this is applied twice in a row. Work out the coordinates of the coin after the button is pressed twice.
- 11.A transversal crosses a pair of parallel lines. At one line, the angle is (5x + 4)°. The corresponding angle at the other line is (3x + 24)°. Work out the value of x.
- 12.Triangles ABE and CDE share the vertex E, where lines AC and BD cross at E. AE equals CE, and BE equals DE. Angle AEB and angle CED are formed as vertically opposite angles where the lines cross. Which condition proves that triangle ABE is congruent to triangle CDE?
- 13.A circular plate has a diameter of 20 cm. Work out the area of the plate. Use π = 3.14.
- 14.Two similar triangles have lengths in the ratio 2 : 5. The sides of the smaller triangle are 4 cm, 6 cm and 8 cm. Work out the length of the longest side of the larger triangle.
- 15.Work out the exact value of sin 45° × cos 45°.
Answer key
- (c) They must also be equal — Once two triangles are proved congruent by any condition, including ASA, they are identical in every respect: every pair of corresponding sides and every pair of corresponding angles must be equal, not just the ones originally used to prove the congruence. So the two remaining pairs of corresponding sides must also be equal, making 'they must also be equal' correct. 'They might be equal or not' and 'not enough information to say' both wrongly suggest that congruence only guarantees the specific facts used to prove it, when congruence actually guarantees the triangles are identical overall. 'They must be different' is backwards: the triangles being identical is the entire point of proving congruence, not a reason for a side to differ.
- (c) x — By convention, the side opposite a vertex is labelled with the lowercase version of that vertex's letter, so the side opposite X is labelled x. y is the label for the side opposite Y, not X. z is the label for the side opposite Z, not X. X is the vertex's own uppercase letter — the convention specifically switches to lowercase for the side, so the uppercase letter on its own is not correct.
- (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (d) 118° — In an isosceles trapezium, the two angles next to the same parallel side are equal, because the sloping sides are equal in length. So the angle at the other end of the shorter parallel side also equals 118°.
- (b) Parallel, since AB and DC are both horizontal lines — A and B both have y-coordinate 1, so AB is horizontal; D and C both have y-coordinate 4, so DC is horizontal too. Two horizontal lines are always parallel, so AB and DC are parallel. "Not parallel, since AB and DC have different lengths" is wrong twice over: AB runs from x = 1 to x = 5 and DC from x = 2 to x = 6, so both are in fact 4 units long, and in any case length has no bearing on whether two lines are parallel — only direction does. "Not parallel, since AB is horizontal and DC is vertical" misreads the coordinates of D and C, which share the y-coordinate 4 and so give a horizontal line, not a vertical one. "Parallel, since A and D have the same x-coordinate" rests on a false claim: A has x-coordinate 1 and D has x-coordinate 2, so they do not share an x-coordinate — and even if they did, it would say nothing about whether AB is parallel to DC.
- (d) 6√3 cm — Method: AB lies alongside the 30° angle at A and AC is the hypotenuse, so the ratio needed is cosine: cos 30° = AB ÷ AC. Working: the exact value of cos 30° is √3/2, so AB = 12 × √3 ÷ 2, and half of 12 is 6. Answer: AB = 6√3 cm, which is about 10.4 cm. Using sine by mistake gives 12 × 1/2 = 6 cm, which is the length of BC rather than AB. Using tan 30° = 1/√3 gives 12 ÷ √3, which is 4√3 cm. Remembering cos 30° as √3 rather than as √3 halved gives 12√3 cm, longer than the hypotenuse and so impossible.
- (d) 21 cm — The scale factor from triangle ABC to triangle PQR is PQ ÷ AB = 15 ÷ 5 = 3. QR = BC × scale factor = 7 × 3 = 21 cm. A student who divides BC by the scale factor instead of multiplying gets 7 ÷ 3 = 2.33 cm. A student who multiplies BC by AB instead of by the scale factor gets 7 × 5 = 35 cm.
- (b) (12, 9) — Apply the transformations in the order given: first translate, then enlarge. Translating (3, 5) by the vector (1, −2) gives (3 + 1, 5 − 2) = (4, 3). Enlarging this by scale factor 3 about the origin multiplies both coordinates by 3: (4 × 3, 3 × 3) = (12, 9). Enlarging first and translating afterwards reverses the order and gives (3 × 3 + 1, 5 × 3 − 2) = (10, 13), a different point because the two transformations do not commute. Enlarging the original point by scale factor 3 while forgetting to translate it at all gives (3 × 3, 5 × 3) = (9, 15). Reversing the signs of the translation vector before applying it gives (3 − 1, 5 + 2) = (2, 7), which then enlarges to (2 × 3, 7 × 3) = (6, 21).
- (d) (−1, 3) — Method: two 90° rotations about the SAME centre, applied one after another, combine into a single 180° rotation about that same centre: use the shortcut (x, y) → (2a − x, 2b − y) for a half-turn about (a, b). Working: with centre (2, 3), doubling each coordinate gives 2 × 2 = 4 and 2 × 3 = 6, so the rule is (x, y) → (4 − x, 6 − y). Applying it to (5, 3) gives 4 − 5 = −1 and 6 − 3 = 3, so the coin ends at (−1, 3). Answer: (−1, 3). Rotate about the centre (2, 3) stated in the game, not about the origin, and remember the button is pressed TWICE: stopping after one press, or rotating about the wrong centre, both leave the coin somewhere else.
- (b) 10 — Corresponding angles are equal, so 5x + 4 = 3x + 24. Subtracting 3x from both sides gives 2x + 4 = 24, then subtracting 4 gives 2x = 20, so x = 10. 14 comes from adding the constants, 4 + 24, instead of subtracting them when rearranging. 19 comes from treating the angles as co-interior (summing to 180°): 5x + 4 + 3x + 24 = 180 gives 8x = 152, so x = 19. 20 correctly reaches 2x = 20 but stops without dividing by 2.
- (d) SAS, vertically opposite angle included — AE equals CE and BE equals DE give two pairs of equal sides, and angle AEB equals angle CED because they are vertically opposite angles formed where AC and BD cross; vertically opposite angles are always equal without needing to be measured. This included angle sits between the two known sides in each triangle, giving SAS, so 'SAS, vertically opposite angle included' is correct. 'ASA, vertically opposite angle at E' is wrong because ASA needs two pairs of equal angles with the side between them, but only one angle is known in each triangle here, and the two other known facts are sides, not angles. 'SSS, three equal side pairs' is wrong because only two pairs of sides are given; there is no third pair of equal sides. 'Cannot prove — no angle measured' is wrong because vertically opposite angles are always equal automatically when two straight lines cross, so no separate measurement is needed.
- (a) 314 cm² — Method: the area of a circle is πr², and the radius is half the diameter, so halve the 20 cm before squaring. Working: r = 20 ÷ 2 = 10 cm, so the area is 3.14 × 10² = 3.14 × 100 = 314. Answer: 314 cm². The distractors: 1256 cm² comes from putting the diameter straight into πr² without halving it, 3.14 × 20²; 628 cm² comes from halving correctly but then using 2πr², a mixture of the circumference and area formulae; 62.8 cm² comes from working out πd = 3.14 × 20, which is the circumference of the plate rather than its area.
- (b) 20 cm — Method: corresponding sides of similar triangles are in the same ratio, and the longest side of one triangle corresponds to the longest side of the other; a ratio of 2 : 5 means each length is multiplied by 5 ÷ 2 = 2.5 going from the smaller triangle to the larger one. Working: the longest side of the smaller triangle is 8 cm, so the matching side of the larger triangle is 8 × 2.5 = 20. Answer: 20 cm. The distractors: 10 cm comes from scaling the shortest side, 4 cm, instead of the longest; 40 cm comes from multiplying by 5 and forgetting to divide by 2; 3.2 cm comes from multiplying by 2 ÷ 5 instead of 5 ÷ 2, which scales from the larger triangle down to the smaller one.
- (c) 1/2 — sin 45° = √2/2 and cos 45° = √2/2, so sin 45° × cos 45° = √2/2 × √2/2 = 2/4 = 1/2. √2/2 comes from writing down only one of the two factors and forgetting to multiply by the other. √2 comes from adding the two exact values instead of multiplying them: √2/2 + √2/2 = √2. 1 comes from wrongly treating sin 45° × cos 45° as sin(45° + 45°) = sin 90° = 1 — multiplying two ratios is not the same as adding their angles.
Build your own mix at the worksheet builder.