Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A builder lays a low wall made from identical bricks. The diagram shows the plan of the wall's footprint on a grid, where each square is one brick. The wall is built up to a height of 4 bricks everywhere. Work out the total number of bricks used.
- 2.A trapezium has vertices (2, 1), (6, 1), (5, 4) and (3, 4). It is rotated 180° about the vertex (2, 1). Work out the number of points on the trapezium — including its vertices, edges and interior — that are invariant under this rotation.
- 3.Triangle E has vertices (1, 2), (4, 2) and (1, 5). It is rotated 90° anticlockwise about the origin, and the image is then reflected in the line y = x. Work out the coordinates of the image of (4, 2).y = x
- 4.Triangle S has vertices (2, 2), (5, 2) and (2, 5). It is mapped onto triangle S′ with vertices (2, 5), (5, 5) and (2, 2). Which single composition of two transformations maps S onto S′?
- 5.Two vertical masts stand on level ground, 40 m apart. One mast is 30 m tall and the other is 50 m tall. Work out the straight-line distance between the tops of the two masts. Give your answer to 1 decimal place.
- 6.A roof has two triangular sections, P and Q. Section P has a sloping edge of 3.6 m and a base edge of 2.4 m, with an angle of 70° between them. Section Q has a sloping edge of 3.6 m and a base edge of 2.4 m, with an angle of 70° between them, arranged the same way round. A roofer wants to cut identical triangular felt panels for both sections without measuring Section Q separately. Which condition confirms that the two sections are congruent?
- 7.A circle has circumference 31.4 cm. Using π = 3.14, work out the radius of the circle.
- 8.Two triangles are proved congruent using the ASA condition. What can be concluded about the two remaining pairs of corresponding sides that were not part of the original ASA facts?
- 9.A robotic arm's tip starts at the point (12.5, −4.25) on a grid measured in centimetres. It moves by the vector to pick up a component, then by the vector to place it. Work out the coordinates of the tip after both moves.
- 10.Shape S has a vertex at (9, 6). It is enlarged by a scale factor of 1/3, centre the origin. Work out the coordinates of the image of this vertex.
- 11.A shop sells rice in packs of 250 g. Aisha buys 4 packs. Work out the total mass of rice she buys, in kilograms.
- 12.A rectangular garden bed measures 5 m by 3 m. A semicircular flower border is attached along one of the 3 m-wide ends, on the outside of the rectangle, so that the 3 m side is the diameter of the semicircle. Work out the total perimeter of the combined shape (the two long sides, the one remaining short side, and the curved edge). Use π = 3.14.
- 13.A footpath sign shows a distance of 0.45 km to the next village. Work out this distance in metres.
- 14.A shape is reflected in the line x = 1, and the image is then reflected in the line x = 5. Which single transformation is equivalent to this combination, for every point?
- 15.A regular polygon has 12 sides. Work out the size of one exterior angle of the polygon.
Answer key
- (b) 28 — Method: total bricks = (number of squares in the footprint) × (the height of the wall in bricks). Working: the footprint has the row of 5 squares plus the 2 squares in the arm that stands out from the middle of that row, and they do not overlap, giving 5 + 2 = 7 squares; multiplying by the height of 4 bricks gives 7 × 4 = 28. Answer: 28. The distractors: 20 comes from using only the row of 5 and ignoring the arm (5 × 4). 24 comes from treating the bottom square of the arm as if it were one of the row's own squares, so the arm is counted as adding only 1 new square instead of 2 (5 + 1 = 6, then 6 × 4). 32 comes from counting the square of the row directly below the arm a second time as part of the arm (5 + 3 = 8, then 8 × 4).
- (b) 1 point — A rotation about a point P always leaves P itself unchanged, and — unless the shape has rotational symmetry about that exact point — no other point of the shape maps onto itself. The centre of rotation here is the vertex (2, 1), so exactly one point of the trapezium, that vertex, is invariant. Thinking that a rotation always has no invariant points ignores the centre of rotation itself, which is always fixed, and gives 0 points. Assuming every vertex of the shape is invariant confuses a rotation with the identity transformation and gives 4 points, the total number of vertices. Believing that the point diametrically opposite the centre is also fixed applies point symmetry of the whole coordinate grid rather than checking whether that point actually lies on this particular trapezium, and gives 2 points.
- (d) (4, −2) — Method: apply the rotation to the point first, then reflect the rotated image, in the order stated. Working: rotating (4, 2) by 90° anticlockwise about the origin sends (x, y) to (−y, x), so (4, 2) becomes (−2, 4). Reflecting (−2, 4) in the line y = x swaps its coordinates, giving (4, −2). Answer: (4, −2). Rotate before you reflect, exactly as the question orders them: these two maps do not commute, so reflecting first, only rotating without swapping the coordinates afterwards, or forgetting to negate the coordinate when rotating anticlockwise all send you to a different point.
- (a) Reflect in the x-axis, then translate by (0, 7). — Reflecting in the x-axis sends (x, y) to (x, −y); applied to S's vertices (2, 2), (5, 2) and (2, 5) this gives (2, −2), (5, −2) and (2, −5). Translating this image by the vector (0, 7) adds 7 to every y-coordinate, giving (2, 5), (5, 5) and (2, 2), which matches S′ exactly. Using the correct reflection but translating by (7, 0) instead moves the image sideways rather than upwards, giving (9, −2), (12, −2) and (9, −5) — nowhere near S′. Reflecting in the y-axis instead of the x-axis changes the sign of the x-coordinate rather than the y-coordinate, so translating that image by (0, 7) gives (−2, 9), (−5, 9) and (−2, 12), the wrong shape entirely. Rotating 180° about the origin instead of reflecting sends every coordinate to its negative, so translating by (0, 7) gives (−2, 5), (−5, 5) and (−2, 2) — the y-coordinates match S′ but the x-coordinates do not.
- (a) 44.7 m — Method: the line joining the two tops is the hypotenuse of a right-angled triangle whose horizontal side is the gap between the masts and whose vertical side is the difference in their heights, so Pythagoras' theorem applies. Working: the difference in heights is 50 − 30 = 20 m, so d² = 40² + 20² = 1600 + 400 = 2000 and d = √2000 = 44.721…, which is 44.7 m to 1 decimal place. Answer: 44.7 m. The distractors: 34.6 m comes from subtracting the squares, √(40² − 20²), instead of adding them; 60.0 m comes from adding the two sides of the triangle, 40 + 20, rather than using Pythagoras' theorem; 50.0 m is the height of the taller mast, copied from the question in place of the distance asked for.
- (d) SAS — two sides, included angle — Each section has two known sides, 3.6 m and 2.4 m, with the 70° angle between them, matching in both sections; this is exactly the SAS condition, so 'SAS — two sides, included angle' is correct. 'SSS — but only two sides given' is wrong because SSS requires three pairs of equal sides, but only two sides are given for each triangle here. 'ASA — angle between two sides' is wrong because ASA requires two angles with a side between them, but only one angle, 70°, is given, not two. 'Cannot prove — only one angle' is wrong because SAS is specifically designed to prove congruence from exactly two sides and the one angle between them, so no further angle is needed.
- (c) 5 cm — Diameter = circumference ÷ π, so 31.4 ÷ 3.14 = 10 cm, and the radius is half the diameter, so 10 ÷ 2 = 5 cm. 10 cm is the diameter itself, given as the radius by forgetting the final halving step. 15.7 cm comes from halving the circumference, 31.4 ÷ 2 = 15.7, and stopping there, treating half the circumference as the radius without ever dividing by π. 2.5 cm comes from halving the correct radius again, effectively dividing by 2 twice instead of once.
- (c) They must also be equal — Once two triangles are proved congruent by any condition, including ASA, they are identical in every respect: every pair of corresponding sides and every pair of corresponding angles must be equal, not just the ones originally used to prove the congruence. So the two remaining pairs of corresponding sides must also be equal, making 'they must also be equal' correct. 'They might be equal or not' and 'not enough information to say' both wrongly suggest that congruence only guarantees the specific facts used to prove it, when congruence actually guarantees the triangles are identical overall. 'They must be different' is backwards: the triangles being identical is the entire point of proving congruence, not a reason for a side to differ.
- (d) (11, 0.75) — Add the moves to the starting point one component at a time. x: 12.5 + (−3.75) + 2.25 = 11; y: −4.25 + 6.5 + (−1.5) = 0.75, giving (11, 0.75). (8.75, 2.25) stops after the first move only and never applies the second vector. (6.5, 3.75) comes from subtracting the second vector instead of adding it. (0.75, 11) comes from swapping the final x-coordinate and y-coordinate.
- (c) (3, 2) — For an enlargement centred on the origin, multiply every coordinate by the scale factor: (9 × 1/3, 6 × 1/3) = (3, 2). A pupil who multiplies by 3 instead of by 1/3 gets (27, 18). A pupil who subtracts a third of each coordinate instead of scaling by a third gets (9 − 3, 6 − 2) = (6, 4). A pupil who applies the scale factor to the x-coordinate only gets (3, 6). The correct image is (3, 2).
- (d) 1 kg — First find the total mass in grams: 4 × 250 = 1000 g. Then convert to kilograms by dividing by 1000: 1000 ÷ 1000 = 1 kg. Finding the correct total in grams but forgetting to divide by 1000 gives 1000 kg. Adding the number of packs to the pack mass instead of multiplying, 4 + 250 = 254 g, gives 0.254 kg. Dividing the pack mass by the number of packs instead of multiplying, 250 ÷ 4 = 62.5 g, gives 0.0625 kg.
- (c) 17.71 m — The perimeter is the two long sides (5 m + 5 m = 10 m) plus the one remaining short side (3 m) plus the curved semicircular edge. The 3 m side is the diameter of the semicircle, so its radius is 3 ÷ 2 = 1.5 m and the curved length is half the circumference: (1/2) × 2 × 3.14 × 1.5 = 4.71 m. Total: 10 + 3 + 4.71 = 17.71 m.
- (c) 450 m — To convert km to m, multiply by 1000: 0.45 × 1000 = 450 m. Multiplying by 100 instead of 1000 gives 45 m. Multiplying by 10 000 instead of 1000 gives 4500 m. Not converting at all, just relabelling the number, gives 0.45 m.
- (c) Translation by the vector (8, 0) — Method: reflecting twice in two parallel vertical lines is always equivalent to a single translation, at right angles to the lines, of twice the distance between them. Working: the two lines are 5 − 1 = 4 units apart, so the translation is 2 × 4 = 8 units in the positive x-direction. Answer: translation by the vector (8, 0). Using just the gap itself, without doubling it, gives (4, 0); translating in the negative x-direction, from the second line back towards the first, gives (−8, 0); and describing the combination as a single reflection in the line halfway between them, x = 3, confuses this combination with the effect of a single reflection — two reflections in parallel lines are always equivalent to a translation, never to another reflection. Always double the gap between the lines, and translate in the direction from the first line towards the second.
- (a) 30° — Method: the exterior angles of any convex polygon add up to 360°, and in a regular polygon they are all equal, so divide 360° by the number of sides. Working: 360 ÷ 12 = 30. Answer: 30°. The distractors: 150° is the interior angle, 180 − 30, which answers for the wrong angle at the vertex; 15° comes from dividing 180 by 12, using the angles on a straight line instead of the full turn; 36° comes from dividing 360 by 12 − 2 = 10, carrying the subtraction of 2 out of the interior angle sum formula into a calculation that does not need it.
Build your own mix at the worksheet builder.