Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Point D is at (3, 7). It is reflected in the line y = x. Work out the coordinates of the image of point D.y = x
- 2.Shape S has a vertex at (9, 6). It is enlarged by a scale factor of 1/3, centre the origin. Work out the coordinates of the image of this vertex.
- 3.A dog is tied by a lead 4 m long to a fixed ring on a straight garden wall. The wall extends much further than the lead can reach in both directions, and the dog cannot cross through it. Describe the region the dog can reach.
- 4.A solid has two parallel, congruent polygon faces joined by flat rectangles, and its cross-section is the same shape all the way along its length. Which solid is it?
- 5.A triangle has vertices X, Y and Z, with a right angle at Y. Side XY is twice as long as side YZ. Which of the following correctly describes this triangle?
- 6.Work out the distance between the point (0, 0) and the point (5, 12).
- 7.A garden designer describes a flower bed as a shape with four straight sides: exactly one pair of sides is parallel, those two parallel sides are different lengths, and the other two sides are equal in length to each other but not parallel to each other. Which shape should the designer draw?
- 8.A tap fills a tank at a rate of 18 litres per minute. The tank holds 0.45 m³. Work out how long the tap takes to fill the tank.
- 9.In triangle ABC, AB = 6.4 cm, BC = 9.1 cm and AC = 12.8 cm. Work out the size of the largest angle in the triangle. Give your answer to 1 decimal place.
- 10.A solid ball has a radius of 7 cm. Work out the surface area of the ball. Use π = 3.14.
- 11.A landscaper marks out two triangular flower beds using stakes and a tape measure. Bed 1 has two edges of 5 m and 7 m, meeting at a corner with a marked angle of 60° between them. Bed 2 has edges of 5 m and 7 m, meeting at a corner also marked at 60° between them. The landscaper wants to check the two beds will be exactly the same size and shape using only these three measurements. Which condition proves the two beds are congruent?
- 12.A solid rubber ball has a radius of 3 cm. Work out the volume of the ball. Use π = 3.14.
- 13.In triangle ABC the angle at A and the angle at C are equal. The side AB is extended beyond B, and the exterior angle formed at B measures 98°. Work out the size of the angle at A.
- 14.Two similar company logos are printed at different sizes. The area of the larger logo is 2.25 times the area of the smaller logo. Work out the length scale factor from the smaller logo to the larger logo.
- 15.AB is a diameter of a circle with centre O, and C is a point on the circle. A student writes four statements to prove that angle ACB = 90°. Statement 1: OA = OC, since both are radii, so triangle OAC is isosceles with angle OAC = angle OCA. Statement 2: OB = OC, since both are radii, so triangle OBC is isosceles with angle OBC = angle OCB. Statement 3: in triangle ABC, the three angles sum to 360°, so angle OAC + angle OBC + angle ACB = 360°, meaning 2 × angle ACB = 360° and angle ACB = 180°. Statement 4: A, O and B lie on a straight line, since AB is a diameter through the centre O. Which one of these four statements is mathematically incorrect?
Answer key
- (b) (7, 3) — Reflecting in the line y = x swaps the x- and y-coordinates: (3, 7) → (7, 3). A pupil who reflects in the x-axis instead gets (3, −7). A pupil who reflects in the y-axis instead gets (−3, 7). A pupil who confuses y = x with y = −x, swapping the coordinates and changing both signs, gets (−7, −3). The correct image is (7, 3).
- (c) (3, 2) — For an enlargement centred on the origin, multiply every coordinate by the scale factor: (9 × 1/3, 6 × 1/3) = (3, 2). A pupil who multiplies by 3 instead of by 1/3 gets (27, 18). A pupil who subtracts a third of each coordinate instead of scaling by a third gets (9 − 3, 6 − 2) = (6, 4). A pupil who applies the scale factor to the x-coordinate only gets (3, 6). The correct image is (3, 2).
- (b) A semicircle of radius 4 m, away from the wall. — Every point the dog can reach is at most 4 m from the fixed ring, so without any wall the region would be a full circle of radius 4 m. The wall runs straight through the ring and blocks the dog from crossing it, and since the wall extends further than the lead in both directions, exactly half of that circle is cut off — leaving a semicircle of radius 4 m on the side of the wall the dog is tied on. (A full circle of radius 4 m ignores that the wall blocks half of the region; a quarter circle of radius 4 m would only be correct if the ring were fixed at a corner where two walls met, not along a single straight wall; a rectangle 4 m wide along the wall ignores that the lead lets the dog swing round in a curve, not stay a fixed distance out from the wall.)
- (d) A prism — A prism has two identical, parallel polygon faces (its cross-section) joined by flat rectangular side faces, so the same cross-sectional shape runs all the way along its length — this description matches a prism. A pyramid instead narrows from one polygon base up to a single point (the apex), so it does not have two identical parallel faces. A cone has one curved surface and a single circular base narrowing to a point — no flat rectangular sides at all. A cylinder has two identical circular faces, but they are joined by a curved surface, not by flat rectangles.
- (b) A right-angled triangle — The right angle at Y makes this a right-angled triangle, so that description is correct. Since XY is twice YZ, those two sides cannot be equal. The third side XZ is opposite the right angle, so it is the hypotenuse and is longer than either XY or YZ, so it cannot equal either of them. No two sides are equal, which rules out 'an isosceles triangle' and 'a right-angled isosceles triangle', both of which wrongly assume two equal sides. 'An equilateral triangle' would need all three sides equal, which contradicts XY being twice YZ, so it is wrong too.
- (b) 13 — Method: the straight-line distance between two points on a grid is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal gap and the vertical gap between them, so Pythagoras' theorem applies. Working: one point is the origin, so the horizontal gap is 5 and the vertical gap is 12. Then d² = 5² + 12² = 25 + 144 = 169, so d = √169 = 13. Answer: 13. The distractors: 17 comes from adding the two gaps, 5 + 12, instead of adding their squares and taking the root; 12 comes from reading off the vertical gap alone and offering that as the whole distance; 7 comes from subtracting the gaps, 12 − 5, as though a distance were a difference.
- (a) isosceles trapezium — One pair of parallel sides, plus a separate pair of equal non-parallel sides, is exactly the definition of an isosceles trapezium — the shape the designer should draw. Parallelogram is wrong because a parallelogram needs BOTH pairs of opposite sides parallel, but only one pair is parallel here. Kite is wrong because a kite has two separate pairs of adjacent equal sides and no requirement for any sides to be parallel, a different combination of properties. Rhombus is wrong because a rhombus needs all four sides equal, but the description only makes two of the four sides equal to each other.
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (d) 110.1° — Method: the largest angle in any triangle faces the longest side, so identify that angle first and then use the cosine rule rearranged as cos A = (b² + c² − a²) ÷ 2bc. Working: the longest side is AC = 12.8 cm, which is faced by angle ABC, and the two sides meeting at B are 6.4 cm and 9.1 cm, so cos ABC = (6.4² + 9.1² − 12.8²) ÷ (2 × 6.4 × 9.1) = (40.96 + 82.81 − 163.84) ÷ 116.48 = −40.07 ÷ 116.48 = −0.34401. A negative cosine means an obtuse angle, and the inverse cosine of −0.34401 is 110.12°. Answer: the largest angle is 110.1° to 1 decimal place. The distractors: 28.0° is the angle facing the shortest side, chosen by a candidate who thinks the largest angle sits opposite the smallest side; 69.9° comes from dropping the minus sign and using cos = 0.34401, which turns the obtuse angle into its supplement; 81.4° comes from assuming the angles share out 180° in the same ratio as the sides, 180 × 12.8 ÷ 28.3, which is not how a triangle behaves.
- (a) 615.44 cm² — Method: the surface area of a sphere is 4πr². Square the radius, multiply by π, then multiply by 4. Working: r² = 7² = 49, then 3.14 × 49 = 153.86, then 4 × 153.86 = 615.44. Answer: 615.44 cm². The distractors: 153.86 cm² comes from stopping at πr², which is the area of a flat circle of radius 7 cm and leaves out the factor of 4 that a curved surface needs; 87.92 cm² comes from 4 × 3.14 × 7, using the radius itself where the formula asks for its square; 1436.03 cm³ comes from working out the volume of the ball with (4 ÷ 3) × π × r³ instead of its surface area, which is a different measure and carries a cubic unit.
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (a) 113.04 cm³ — Method: the volume of a sphere is (4 ÷ 3) × π × r³. Cube the radius, multiply by π, then multiply by 4 and divide by 3. Working: r³ = 3³ = 27, then 3.14 × 27 = 84.78, then 84.78 × 4 = 339.12 and 339.12 ÷ 3 = 113.04. Answer: 113.04 cm³. The distractors: 84.78 cm³ comes from stopping at πr³ and leaving out the four thirds; 37.68 cm³ comes from squaring the radius instead of cubing it, (4 ÷ 3) × 3.14 × 9; 28.26 cm³ comes from using πr², the area of a circle, and labelling it as a volume.
- (a) 49° — Method: an exterior angle of a triangle equals the sum of the two interior angles that are not next to it, which here are the angles at A and at C; since those two are equal, the exterior angle is twice the angle at A. Working: 2 × angle A = 98, so angle A = 98 ÷ 2 = 49. Answer: 49°. The distractors: 82° is the interior angle at B, 180 − 98, given in place of the angle at A; 41° comes from finding that interior angle of 82° and halving it, 82 ÷ 2, instead of halving the exterior angle; 98° comes from taking the exterior angle to be equal to the angle at A on its own, with no halving at all.
- (c) 1.5 — The area scale factor is the length scale factor squared, so if n is the length factor, n² = 2.25. Taking the positive square root gives n = 1.5 (check: 1.5² = 2.25). 2.25 is just the area factor restated, with no root taken. 1.125 comes from halving 2.25 instead of taking its square root. 5.0625 comes from squaring 2.25 instead of rooting it.
- (b) Statement 3 — a triangle's angles are said to sum to 360° — The angles of any triangle sum to 180°, not 360° — Statement 3 uses the wrong total, and that error is what sends its final line to the impossible claim that angle ACB = 180°. The correct working is angle OAC + angle OBC + angle ACB = 180°, and since angle ACB = angle OCA + angle OCB, this gives 2 × angle ACB = 180°, so angle ACB = 90°, which is the actual theorem. Statement 1 correctly identifies OA and OC as equal radii, making triangle OAC isosceles — nothing wrong there. Statement 2 correctly does the same for triangle OBC. Statement 4 correctly states that A, O and B are collinear, since a diameter passes through the centre — also nothing wrong there. Statement 3 is the one to flag: it is the angle sum it quotes that is wrong, not the diagram or the radii.
Build your own mix at the worksheet builder.