Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A circular pizza base has a radius of 12 cm. Work out the area of the pizza base. Use π = 3.14.
- 2.A ship's radar can detect other ships up to 20 km away, over a sector-shaped area with angle 90°. A monitoring company charges £0.50 per square kilometre covered by one radar sweep. Using π = 3.14, work out the total charge for one sweep.
- 3.Triangle ABC has AB = 10 cm, BC = 7 cm and angle A = 40°. Triangle DEF has DE = 10 cm, EF = 7 cm and angle D = 40°. Sam says the two triangles are congruent by SAS. Which statement about Sam's claim is correct?
- 4.A kitchen scale is marked in equal divisions of 20 g. The pointer rests three divisions past the 400 g mark. Work out the reading on the scale.
- 5.Triangle S has vertices (2, 2), (5, 2) and (2, 5). It is mapped onto triangle S′ with vertices (2, 5), (5, 5) and (2, 2). Which single composition of two transformations maps S onto S′?
- 6.A sailmaker cuts two triangular sail panels from a pattern. Panel X has a 10 m side, with angles of 50° and 75° at its two ends. Panel Y also has a 10 m side, with angles of 50° and 75° at its two ends, in the same arrangement. The sailmaker wants to check the panels will match exactly, without cutting a third measurement. Which condition proves the two panels are congruent?
- 7.A roof truss has two horizontal parallel rafters, one above the other. A straight strut crosses both rafters. Where the strut crosses the lower rafter, the angle above the rafter and to the left of the strut is 65°. Work out the size of the angle above the upper rafter and to the right of the strut, where the strut crosses it.
- 8.Work out the y-coordinate of the midpoint of the line segment joining (2, 4) and (8, 10).
- 9.A roof truss is shaped like an isosceles triangle resting on a horizontal ceiling joist. The truss's sloping edges are equal in length, and the angle at its apex is 40°. The ceiling joist continues in a straight line beyond the foot of the truss. Work out the angle between the truss's sloping edge and the extended joist, on the outside of the truss.
- 10.A solid has 6 faces: one pentagon and five triangles that all meet at a single point above the pentagon. What is the name of this solid?
- 11.Two similar hexagonal tiles have lengths in the ratio 4 : 7. A side of the smaller tile is 8.4 cm long. Work out the length of the corresponding side of the larger tile.
- 12.Triangle ABC has AB = (2x + 3) cm, BC = 11 cm and angle B = 90°. Triangle DEF has DE = 13 cm, EF = 11 cm and angle E = 90°. Given that the two triangles are congruent by SAS, work out the value of x.
- 13.A sector of a circle has radius 9 cm and angle 40°. Work out the area of the sector, in terms of π.
- 14.Triangle DEF has a right angle at E. Angle DFE = 60° and EF = 9 cm. Work out the exact length of DE.
- 15.Quadrilateral WXYZ has WX parallel to ZY, and WZ = XY (the two non-parallel sides are equal in length). Give a reason why angle W = angle X.
Answer key
- (d) 452.16 cm² — Area = πr². Substitute r = 12: area = 3.14 × 12² = 3.14 × 144 = 452.16 cm².
- (a) £157.00 — Area covered = (angle ÷ 360) × π × r² = (90 ÷ 360) × 3.14 × 400 = 0.25 × 1256 = 314 km². Charge = 314 × £0.50 = £157.00. (£7.85 comes from forgetting to square the radius, using 0.25 × 3.14 × 20 = 15.7 km² and then charging that; £628.00 comes from finding the area of a full circle, 3.14 × 400 = 1256 km², and forgetting the angle fraction before charging; £15.70 comes from using the arc length formula, 0.25 × 2 × 3.14 × 20 = 31.4, in place of the area, and charging that.)
- (d) Wrong - the given angle is not the included angle — Sides AB and BC meet at vertex B, so the included angle needed for SAS is angle B, not angle A — the information given is SSA. SSA does not prove congruence: with AB = 10 cm, BC = 7 cm and angle A = 40° there are two different triangles that fit, one with angle C ≈ 74.6° and one with angle C ≈ 105.4°, so Sam's triangles need not be the same shape and size at all. Sam is not correct just because two sides and an angle are equal, since the angle must be the one INCLUDED between those two sides. The condition is not ASA either, because ASA needs two angles, and only one angle is given here. It is also not true that nothing matches — the stated lengths and angle DO match between the two triangles; the problem is which angle was given, not whether the values agree.
- (c) 460 g — Each division is 20 g, so three divisions past the mark is 3 × 20 = 60 g. Adding this to the 400 g mark gives 400 + 60 = 460 g. Treating each division as worth 1 g instead of 20 g gives 400 + 3 = 403 g. Working out the extra amount correctly but forgetting to add the 400 g mark gives just 60 g. Treating each division as worth 10 g instead of 20 g gives 400 + 30 = 430 g.
- (a) Reflect in the x-axis, then translate by (0, 7). — Reflecting in the x-axis sends (x, y) to (x, −y); applied to S's vertices (2, 2), (5, 2) and (2, 5) this gives (2, −2), (5, −2) and (2, −5). Translating this image by the vector (0, 7) adds 7 to every y-coordinate, giving (2, 5), (5, 5) and (2, 2), which matches S′ exactly. Using the correct reflection but translating by (7, 0) instead moves the image sideways rather than upwards, giving (9, −2), (12, −2) and (9, −5) — nowhere near S′. Reflecting in the y-axis instead of the x-axis changes the sign of the x-coordinate rather than the y-coordinate, so translating that image by (0, 7) gives (−2, 9), (−5, 9) and (−2, 12), the wrong shape entirely. Rotating 180° about the origin instead of reflecting sends every coordinate to its negative, so translating by (0, 7) gives (−2, 5), (−5, 5) and (−2, 2) — the y-coordinates match S′ but the x-coordinates do not.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (b) 7 — Method: each coordinate of a midpoint is the mean of the matching pair of coordinates, so the y-coordinate of the midpoint depends on the two y-coordinates alone. Working: the y-coordinates are 4 and 10, so the mean is (4 + 10) ÷ 2 = 14 ÷ 2 = 7. Answer: 7. The distractors: 5 comes from working out the x-coordinate of the midpoint, (2 + 8) ÷ 2 = 5, and writing that down in place of the y-coordinate the question asked for; 3 comes from halving the difference of the y-coordinates, (10 − 4) ÷ 2 = 3, which is half the vertical gap rather than a position; 14 comes from adding the two y-coordinates and forgetting to halve the total.
- (a) 110° — The truss is isosceles, so its two base angles are equal; since the three angles of the triangle add up to 180° and the apex is 40°, each base angle is (180 − 40) ÷ 2 = 70°. The angle between the sloping edge and the joist, extended beyond the base of the truss, sits on a straight line with that 70° base angle, and angles on a straight line add up to 180°, so the required angle is 180 − 70 = 110°. "70°" comes from stopping after finding the base angle and giving it directly, without also using the straight-line fact to find the angle on the OUTSIDE of the truss. "140°" comes from doubling the base angle instead of using the straight-line fact. "20°" comes from taking half of the apex angle (40° ÷ 2), mistaking it for the required angle instead of properly using the triangle's angle sum.
- (c) Pentagonal pyramid — Method: a pyramid has one base and triangular faces that all meet at a single apex; the base shape gives the pyramid its name. Working: the base is a pentagon and the other five faces are triangles meeting at one point, so this is a pyramid with a pentagon base. A student who answers pentagonal prism has confused a pyramid, whose sloping faces meet at an apex, with a prism, which has two identical parallel faces. A student who answers hexagonal pyramid has miscounted the base as having 6 sides instead of 5. A student who answers triangular pyramid has misread the five triangular side faces as meaning the base itself is a triangle. Answer: pentagonal pyramid.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (d) 5 — Method: since the triangles are congruent by SAS, the corresponding sides AB and DE must be equal, because both are the side next to the given right angle that is not BC or EF. Working: AB = DE gives 2x + 3 = 13, so 2x = 10, so x = 5. Options: 10 comes from dropping the coefficient of x and solving x + 3 = 13 instead of 2x + 3 = 13; 4 comes from matching AB to the wrong side, EF, giving 2x + 3 = 11, so 2x = 8, so x = 4; 8 comes from a sign error, solving 2x − 3 = 13 instead of 2x + 3 = 13, giving 2x = 16, so x = 8. Answer: 5.
- (b) 9π cm² — Sector area is the fraction θ/360 of the full circle's area, πr². Substitute θ = 40 and r = 9: 40 out of 360 is one ninth, and the full circle's area is π × 9² = 81π. One ninth of 81π is 9π, so the sector area is 9π cm². Choosing 2π cm² is this sector's ARC LENGTH, not its area — a different formula and a different quantity. Choosing 81π cm² is the area of the WHOLE circle, forgetting to scale down by the sector's angle. Choosing 18π cm² is the CIRCUMFERENCE of the whole circle, 2π × 9, mixed up with an area.
- (d) 9√3 cm — DE is opposite the 60° angle at F, and EF is adjacent to it, so DE = EF × tan 60° = 9 × √3 = 9√3 cm. 9√3/2 cm comes from using sin 60° = √3/2 instead of tan 60°. 3√3 cm comes from using tan 30° = 1/√3 instead of tan 60° (9 × 1/√3 = 9/√3 = 3√3). 18 cm is the hypotenuse DF, not DE: it comes from using cos 60° = 1/2 and working out 9 ÷ 1/2 = 18, which finds the wrong side of the triangle.
- (a) Isosceles trapezium: base angles are equal — WX is parallel to ZY and the two non-parallel sides WZ and XY are equal in length, so WXYZ is an isosceles trapezium. In an isosceles trapezium the two angles at each of the parallel sides are equal, so angle W = angle X (and angle Z = angle Y). A student who answers with the parallelogram property has quoted a fact that is true of a parallelogram, but WZ and XY are given as non-parallel so WXYZ is not a parallelogram — and in a parallelogram "opposite angles" pairs W with Y, not W with X. A student who answers with the kite property has again taken a true fact about the wrong shape: a kite's equal sides are two pairs of adjacent sides, not the two non-parallel sides of a trapezium. A student who answers with the rhombus property has used something no rhombus has — a rhombus has two pairs of parallel sides and only two pairs of equal angles; all four angles are equal only in a square.
Build your own mix at the worksheet builder.