Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A chord divides a circle into two regions, one larger than the other. Write down the term used for the smaller of these two regions.
- 2.A trapezium has vertices (2, 1), (6, 1), (5, 4) and (3, 4). It is rotated 180° about the vertex (2, 1). Work out the number of points on the trapezium — including its vertices, edges and interior — that are invariant under this rotation.
- 3.A cylinder has a volume of 942 cm³ and a height of 12 cm. Using π = 3.14, work out the radius of the cylinder.
- 4.A sector of a circle has radius 9 cm and angle 40°. Work out the area of the sector, in terms of π.
- 5.In triangle OAB, OA = a and OB = b. P lies on AB such that AP is twice PB. Express the vector OP in terms of a and b.
- 6.State whether the line segment joining A(−4, 3) and B(2, 6) is horizontal, vertical or neither, and give a reason for your answer.
- 7.A television cable runs in a straight line from the edge of a flat roof 20 m above the ground to a bracket on a wall 5 m above the ground. The horizontal distance between the roof edge and the bracket is 15 m. Work out the length of the cable. Give your answer to 1 decimal place.
- 8.Three of these are rational numbers and one is irrational. Write down the one that is irrational.
- 9.To construct the perpendicular from a point P to a line l, where P is a point above l, an arc centred at P is drawn to cross l at two points, X and Y. What is the correct next step?
- 10.A trapezium has vertices (0, 2), (4, 2), (3, 5) and (1, 5). It is rotated 180° about the point (2, 2), and the image is then translated by the vector (1, −5). Work out the coordinates of the image of (0, 2).
- 11.Four angles meet at a point. Three of them measure 82°, 105° and 96°. Work out the size of the fourth angle.
- 12.Triangle J is mapped onto triangle K by a single transformation with centre O. Triangle K is half the size of triangle J and is inverted (turned through 180°). Which of these transformations maps J onto K?
- 13.A rectangular garden bed measures 5 m by 3 m. A semicircular flower border is attached along one of the 3 m-wide ends, on the outside of the rectangle, so that the 3 m side is the diameter of the semicircle. Work out the total perimeter of the combined shape (the two long sides, the one remaining short side, and the curved edge). Use π = 3.14.
- 14.The sum of the interior angles of a polygon is 1980°. Work out the number of sides of the polygon.
- 15.A flagpole is 12 m tall. Freya stands 9 m from the base of the flagpole on level ground. Work out the angle of elevation of the top of the flagpole from where Freya stands. Give your answer correct to 1 decimal place.
Answer key
- (c) minor segment — A chord splits a circle into two segments; the smaller of the two is called the minor segment and the larger one the major segment. "major segment" names the larger region, the opposite of what is asked for. "sector" is a different region altogether, enclosed by two radii and an arc, not by a chord. "arc" is a curved length along the circumference, not an enclosed region at all.
- (b) 1 point — A rotation about a point P always leaves P itself unchanged, and — unless the shape has rotational symmetry about that exact point — no other point of the shape maps onto itself. The centre of rotation here is the vertex (2, 1), so exactly one point of the trapezium, that vertex, is invariant. Thinking that a rotation always has no invariant points ignores the centre of rotation itself, which is always fixed, and gives 0 points. Assuming every vertex of the shape is invariant confuses a rotation with the identity transformation and gives 4 points, the total number of vertices. Believing that the point diametrically opposite the centre is also fixed applies point symmetry of the whole coordinate grid rather than checking whether that point actually lies on this particular trapezium, and gives 2 points.
- (c) 5 cm — Volume of a cylinder = πr²h, so r² = V ÷ (πh) = 942 ÷ (3.14 × 12) = 942 ÷ 37.68 = 25, and r = √25 = 5 cm. A pupil who finds r² = 25 but forgets to take the square root gives 25 cm. A pupil who forgets to divide by π, using r² = 942 ÷ 12 = 78.5, gets r = √78.5 ≈ 8.9 cm. A pupil who forgets to divide by the height, using r² = 942 ÷ 3.14 = 300, gets r = √300 ≈ 17.3 cm. The correct radius is 5 cm.
- (b) 9π cm² — Sector area is the fraction θ/360 of the full circle's area, πr². Substitute θ = 40 and r = 9: 40 out of 360 is one ninth, and the full circle's area is π × 9² = 81π. One ninth of 81π is 9π, so the sector area is 9π cm². Choosing 2π cm² is this sector's ARC LENGTH, not its area — a different formula and a different quantity. Choosing 81π cm² is the area of the WHOLE circle, forgetting to scale down by the sector's angle. Choosing 18π cm² is the CIRCUMFERENCE of the whole circle, 2π × 9, mixed up with an area.
- (c) (1/3)a + (2/3)b — Method: OP = OA + AP, and since AP is twice PB, AP is 2/3 of the whole of AB, with AB = b − a. Working: OP = a + 2/3(b − a) = a − (2/3)a + (2/3)b = (1/3)a + (2/3)b. Answer: OP = (1/3)a + (2/3)b. Measuring 2/3 of AB from B's end instead of A's swaps the fractions round, giving (2/3)a + (1/3)b; adding (2/3)b onto the whole of a without first subtracting a inside the bracket gives a + (2/3)b; and treating the ratio as though AP and PB were equal gives the midpoint, (1/2)a + (1/2)b. Convert the ratio to a fraction of AB measured from the point named first in the ratio, subtract before you scale, and then add the result to OA.
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (d) 21.2 m — Method: the cable is the hypotenuse of a right-angled triangle whose vertical side is the drop from the roof to the bracket and whose horizontal side is 15 m, so use Pythagoras' theorem. Working: the drop is 20 − 5 = 15 m, so c² = 15² + 15² = 225 + 225 = 450 and c = √450 = 21.213…, which is 21.2 m to 1 decimal place. Answer: 21.2 m. The distractors: 25.0 m comes from using the whole 20 m height of the roof as the vertical side and forgetting that the bracket is already 5 m up; 30.0 m comes from adding the two sides of the triangle, 15 + 15, instead of using Pythagoras' theorem; 15.0 m is the horizontal distance on its own, which would be the length of the cable only if it ran level.
- (c) cos 45° — cos 45° = √2/2, and √2 cannot be written as an exact fraction, so this value is irrational. tan 0° = 0, sin 90° = 1 and sin 30° = 1/2 are all rational, since each can be written as an exact whole number or fraction.
- (a) Draw equal arcs from X and Y, meeting below line l. — After the first arc marks two points X and Y on line l, compasses are opened to a new radius and arcs of equal radius are drawn centred at X and at Y, so that they meet on the opposite side of l from P; joining P to that meeting point gives the perpendicular. (Joining X and Y with a straight line only retraces part of line l itself, since X and Y both already lie on it; drawing an arc centred at P through only one of X or Y repeats part of the first step instead of moving on; drawing a circle through X, Y and P does not locate the new point needed to complete the perpendicular.)
- (b) (5, −3) — Method: rotate the point about the given centre first, then translate the image, in the stated order. Working: rotating (0, 2) by 180° about (2, 2) uses the rule (x, y) → (4 − x, 4 − y), since the centre doubles in each coordinate. This gives 4 − 0 = 4 and 4 − 2 = 2, so (0, 2) maps to (4, 2). Translating (4, 2) by the vector (1, −5) gives 4 + 1 = 5 and 2 − 5 = −3, so the final image is (5, −3). Answer: (5, −3). Rotate about the centre GIVEN in the question, (2, 2), not about the origin, and translate the rotated image afterwards, in that order: rotating about the wrong centre, swapping the order, or stopping after one step all give a different point.
- (d) 77 — Method: angles that meet at a point add up to 360°. Working: 82 + 105 + 96 = 283; 360 − 283 = 77. Answer: 77°. A candidate who gives the sum of the three known angles and forgets to subtract it from 360° gets 283. A candidate who leaves out the 105° angle, working out 360 − 82 − 96, gets 182. A candidate who leaves out the 82° angle, working out 360 − 105 − 96, gets 159.
- (b) An enlargement, centre O, scale factor −1/2. — A single enlargement with a negative scale factor both changes the size (by the magnitude of the factor) and rotates the image 180° about the centre (giving the inverted orientation) in one transformation. Halving the size needs a magnitude of 1/2, and inverting needs a negative sign, so the scale factor is −1/2, centre O. 'Scale factor 1/2' gives the correct size but no inversion, since a positive scale factor keeps the same orientation. 'A 180° rotation with no change in size' gives the inversion but not the halving — K is described as smaller than J, so size must change too. 'Scale factor −2' inverts correctly but doubles the size instead of halving it.
- (c) 17.71 m — The perimeter is the two long sides (5 m + 5 m = 10 m) plus the one remaining short side (3 m) plus the curved semicircular edge. The 3 m side is the diameter of the semicircle, so its radius is 3 ÷ 2 = 1.5 m and the curved length is half the circumference: (1/2) × 2 × 3.14 × 1.5 = 4.71 m. Total: 10 + 3 + 4.71 = 17.71 m.
- (b) 13 — Using the sum of interior angles formula, (n − 2) × 180° = 1980°, so n − 2 = 1980 ÷ 180 = 11, and n = 11 + 2 = 13. 11 stops after the division, forgetting to add 2 back to find n. 15 adds 2 twice by mistake, giving 11 + 2 + 2. 22 divides 1980 by 90 instead of 180.
- (b) 53.1° — The angle of elevation is opposite the height of the flagpole, 12 m, and adjacent to the distance from its base, 9 m, so tan θ = 12/9 = 1.333..., giving θ = tan⁻¹(1.333...) = 53.13...° ≈ 53.1°. "36.9°" finds the OTHER acute angle of the triangle, 90° − 53.1°, the angle at the top of the flagpole rather than the angle of elevation at Freya's position. "48.6°" comes from wrongly treating 9/12 as a sine ratio and finding sin⁻¹(0.75) = 48.6°, when neither side here is the hypotenuse. "41.4°" comes from wrongly treating 9/12 as a cosine ratio and finding cos⁻¹(0.75) = 41.4°, again without a hypotenuse in the ratio at all.
Build your own mix at the worksheet builder.