Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A ship leaves port P and sails 24 km on a bearing of 040° to a buoy Q. It then sails 31 km on a bearing of 115° to a lighthouse R. Work out the direct distance from P to R. Give your answer to 1 decimal place.
- 2.A scale drawing of a bridge uses a scale of 1 : 25. A support beam on the drawing measures 4.4 cm. What is the real length of the beam, in metres?
- 3.The vector describes a translation. A student writes it as by mistake. Write down what error the student has made.
- 4.A rectangular garden bed measures 5 m by 3 m. A semicircular flower border is attached along one of the 3 m-wide ends, on the outside of the rectangle, so that the 3 m side is the diameter of the semicircle. Work out the total perimeter of the combined shape (the two long sides, the one remaining short side, and the curved edge). Use π = 3.14.
- 5.A sector of a circle has an angle of 90° at the centre. Write down what fraction of the whole circle this sector represents.
- 6.A ramp rises at 30° to the horizontal. Its sloping surface is 4.8 m long. Safety rules say the vertical rise of a ramp must be no more than 2.5 m. Work out how far below that limit the rise of this ramp is.
- 7.A parallelogram has an area of 96 cm² and a base of 8 cm. Work out the perpendicular height of the parallelogram.
- 8.A solid has 5 faces: one square face and four triangular faces, which all meet at a single point above the square. What is the name of this solid?
- 9.Triangle E has vertices (1, 2), (4, 2) and (1, 5). It is rotated 90° anticlockwise about the origin, and the image is then reflected in the line y = x. Work out the coordinates of the image of (4, 2).y = x
- 10.An enlargement with scale factor 5 maps the point (4, 1) to the point (12, 9). Which of these points is invariant (does not move) under this enlargement?
- 11.A rectangle has vertices at (2, 1), (9, 1), (9, 5) and (2, 5). Work out the area of the rectangle.
- 12.In triangle ABC, AB = 8.6 cm, AC = 11.4 cm and angle BAC = 47°. Work out the area of triangle ABC. Give your answer to 1 decimal place.
- 13.Four angles meet at a point. Three of them measure 82°, 105° and 96°. Work out the size of the fourth angle.
- 14.A radar station is at the origin of a grid, where each unit represents 1 km. A boat is detected at the point (7, 24). Work out the boat's distance from the station, then work out how many hours it will take the boat to reach the station travelling directly towards it at 5 km per hour.
- 15.A skateboard ramp is designed so that a straight rail RT is tangent to a circular curve at the point T, and TC is a chord of the curve from T to another point C on the curve. A second rail continues straight through T on the other side, so that the two rails together form a straight line, and the angle between that second rail and the chord TC is 109°. A support point D is placed on the curve, on the major arc TC. Work out the size of angle TDC, the angle subtended by the chord TC at D.
Answer key
- (b) 43.8 km — Method: find the angle of the triangle at Q from the two bearings, then use the cosine rule on the two known sides and that included angle. Working: the bearing of P from Q is the back bearing of 040°, which is 040° + 180° = 220°, and the bearing of R from Q is 115°, so angle PQR = 220° − 115° = 105°. Then PR² = 24² + 31² − 2 × 24 × 31 × cos 105° = 576 + 961 − 1488 × (−0.25882) = 1537 + 385.12 = 1922.12, and the square root of 1922.12 is 43.842. Answer: PR = 43.8 km to 1 decimal place. The distractors: 33.9 km comes from subtracting the bearings, 115° − 040° = 75°, and using 75° as the angle at Q, which is the angle the ship turns through, not the angle inside the triangle; 19.9 km comes from using the first bearing itself, 040°, as the angle at Q; 55.0 km comes from adding the two legs, 24 + 31, which would be the distance only if the ship had sailed in a straight line.
- (d) 1.1 — Method: multiply the drawing length by the scale factor to get the real length, then convert to the units asked for. Working: 4.4 cm × 25 = 110 cm = 1.1 m. A student who answers 4.4 has forgotten to use the scale at all. A student who answers 110 has correctly worked out the real length in centimetres but forgotten to convert it to metres. A student who answers 11 has used a scale factor of 2.5 instead of 25 by misreading the scale. Answer: 1.1 m.
- (c) Swapped the x and y components — The student's vector has the same two numbers, 5 and −2, but in swapped positions, so the error is swapping the x and y components rather than an error with signs or size. 'Reversed both signs' is wrong because the numbers 5 and −2 have not changed sign, only position. 'Reversed only the y sign' is wrong for the same reason — no sign has actually changed. 'Doubled the x component' is wrong because neither number has changed in size.
- (c) 17.71 m — The perimeter is the two long sides (5 m + 5 m = 10 m) plus the one remaining short side (3 m) plus the curved semicircular edge. The 3 m side is the diameter of the semicircle, so its radius is 3 ÷ 2 = 1.5 m and the curved length is half the circumference: (1/2) × 2 × 3.14 × 1.5 = 4.71 m. Total: 10 + 3 + 4.71 = 17.71 m.
- (c) 1/4 — A full turn at the centre of a circle is 360°, so a sector's fraction of the circle is its angle divided by 360°: 90 ÷ 360 = 1/4. 1/2 would be the fraction for a sector with an angle of 180°, not 90°. 3/4 is the fraction of the rest of the circle, the major sector left over from the 270° that is not part of this sector. 1/8 would be the fraction for a sector with an angle of 45°, half of 90°.
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (a) 12 cm — Area of a parallelogram = base × perpendicular height, so height = area ÷ base = 96 ÷ 8 = 12 cm. A student who adds the area and base instead of dividing gets 96 + 8 = 104 cm. A student who multiplies the area and base instead of dividing gets 96 × 8 = 768 cm. A student who uses the triangle area formula, area = 1/2 × base × height, instead of the parallelogram formula solves 96 = 1/2 × 8 × h and gets h = 24 cm.
- (a) Square-based pyramid — A solid with one square base and four triangular faces meeting at a single apex above the base is a square-based pyramid. A triangular prism has two triangular faces and three rectangular faces, not a square base with four triangles, so that is a different solid. A cube has six square faces, and a cuboid has six rectangular faces — neither has any triangular faces at all. The solid described is a square-based pyramid.
- (d) (4, −2) — Method: apply the rotation to the point first, then reflect the rotated image, in the order stated. Working: rotating (4, 2) by 90° anticlockwise about the origin sends (x, y) to (−y, x), so (4, 2) becomes (−2, 4). Reflecting (−2, 4) in the line y = x swaps its coordinates, giving (4, −2). Answer: (4, −2). Rotate before you reflect, exactly as the question orders them: these two maps do not commute, so reflecting first, only rotating without swapping the coordinates afterwards, or forgetting to negate the coordinate when rotating anticlockwise all send you to a different point.
- (d) (2, −1) — Method: for an enlargement, image = centre + k × (point − centre), so the centre satisfies centre = (image − k × point) ÷ (1 − k). Working: with k = 5, point (4, 1) and image (12, 9): 5 × (4, 1) = (20, 5); (12, 9) − (20, 5) = (−8, 4); dividing by 1 − 5 = −4 gives (2, −1). Answer: (2, −1), the centre of the enlargement, is the only invariant point since the scale factor is not 1. Subtracting the point itself instead of k times the point, (12, 9) − (4, 1) = (8, 8), then dividing by −4 gives (−2, −2); dividing by k − 1 = 4 instead of 1 − k = −4 gives (−2, 1); and simply taking the midpoint of the point and its image ignores the scale factor altogether and gives (8, 5). The centre of an enlargement is never just the midpoint between a point and its image unless the scale factor happens to be −1 — always use the full centre formula and keep the scale factor k in it.
- (b) 28 — The width of the rectangle is the difference in x-coordinates, 9 − 2 = 7, and the height is the difference in y-coordinates, 5 − 1 = 4. The area is width × height = 7 × 4 = 28. 22 comes from using the perimeter formula, 2 × (7 + 4), instead of the area formula. 35 comes from multiplying 7 by 5 instead of 4, misreading one of the y-coordinates. 63 comes from multiplying 9 by 7, using an x-coordinate instead of the height.
- (a) 35.9 cm² — Method: the area of any triangle is 1/2 × a × b × sin C, where a and b are two sides and C is the angle between them. Working: the 47° angle lies between AB = 8.6 cm and AC = 11.4 cm, so the area is 1/2 × 8.6 × 11.4 × sin 47° = 49.02 × 0.73135 = 35.851. Answer: the area is 35.9 cm² to 1 decimal place. The distractors: 71.7 cm² comes from leaving out the factor 1/2 and working out 8.6 × 11.4 × sin 47°; 33.4 cm² comes from pressing cos instead of sin, 49.02 × cos 47°, which is the same as using the complement 43° in place of 47°; 52.6 cm² comes from pressing tan instead of sin, 49.02 × tan 47°.
- (d) 77 — Method: angles that meet at a point add up to 360°. Working: 82 + 105 + 96 = 283; 360 − 283 = 77. Answer: 77°. A candidate who gives the sum of the three known angles and forgets to subtract it from 360° gets 283. A candidate who leaves out the 105° angle, working out 360 − 82 − 96, gets 182. A candidate who leaves out the 82° angle, working out 360 − 105 − 96, gets 159.
- (c) 5 hours — The distance from the origin to (7, 24) is √(7² + 24²) = √(49 + 576) = √625 = 25 km. Travelling at 5 km per hour, the time taken is 25 ÷ 5 = 5 hours. 25 hours mistakes the distance itself for the time, forgetting to divide by the speed. 125 hours comes from multiplying the distance by the speed, 25 × 5, instead of dividing. 0.2 hours comes from dividing the speed by the distance, 5 ÷ 25, the wrong way round.
- (a) 71° — Method: first use the straight line through T to find the tangent-chord angle RTC, then apply the alternate segment theorem, which states that this angle equals the angle subtended by the chord in the alternate segment. Working: the two rails form a straight line through T, so angle RTC = 180 − 109 = 71 degrees. D lies in the alternate segment of the chord TC, so angle TDC = angle RTC = 71°. Answer: 71°. Find angle RTC FIRST from the straight line before applying the theorem: using the given 109° directly, doubling the tangent-chord angle, or taking its complement from 90° all give the wrong angle at D.
Build your own mix at the worksheet builder.