Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A garden flower bed is in the shape of a trapezium. Its two parallel edges are 3.5 m and 6.5 m long, and the perpendicular distance between them is 4 m. Bedding plants cost £2.50 per square metre to cover the bed. Work out the total cost of the bedding plants.
- 2.Two triangles are proved congruent using the ASA condition. What can be concluded about the two remaining pairs of corresponding sides that were not part of the original ASA facts?
- 3.A circle has a diameter of 24 cm. A sector of this circle has an angle of 90°. Using π = 3.14, work out the area of the sector.
- 4.Lines AB and CD are parallel. A straight line EF crosses AB at point P and crosses CD at point Q. At P, angle APE = 65°. Angle APE and angle BPQ are vertically opposite. Angle BPQ and angle PQD are co-interior (allied) angles. Work out angle PQD.
- 5.A triangular flag has a base of 40 cm and a perpendicular height of 25 cm. Work out its area.
- 6.A packaging designer is told a box has 6 faces, 12 edges and 8 vertices, and every face is a rectangle. To fit exactly onto a shelf, the designer needs to know whether the box must be a cube. Based only on this information, which solid must the box be?
- 7.The angle between north and a footpath is 35°, measured clockwise from north. What is the three-figure bearing of the footpath?
- 8.A triangular solar panel has two edges of length 1.8 m and 1.3 m, with an angle of 72° between them. Manufacturing the panel costs £85 per square metre. Work out the total manufacturing cost. Give your answer to the nearest penny.
- 9.The diagram shows the plan view and the front elevation of a cuboid-shaped box, each drawn as a rectangle. Work out the area of the box's side elevation, in square centimetres.
- 10.Work out the distance between the point (0, 0) and the point (5, 12).
- 11.In a right-angled triangle, the side opposite angle θ is 6 cm and the hypotenuse is 10 cm. Work out the size of angle θ. Give your answer correct to 1 decimal place.
- 12.PT is a tangent to a circle with centre O, touching the circle at T. OT is a radius. Angle OPT = 27°, where P is a point outside the circle. Work out the size of angle POT.
- 13.Point E is at (4, 2). It is rotated 180° about the point (1, 1). Work out the coordinates of the image of point E.
- 14.Points P and Q have coordinates P(0, 0, 0) and Q(5, 7, 9) in a three-dimensional coordinate system, with all lengths in centimetres. Work out the distance PQ. Give your answer correct to 1 decimal place.
- 15.A cuboid has a length, width and height that are all different from each other. How many planes of symmetry does it have?
Answer key
- (d) £50 — Area = 1/2 × (3.5 + 6.5) × 4 = 1/2 × 10 × 4 = 20 m². Cost = 20 × £2.50 = £50. (£100 comes from forgetting to halve the trapezium area, giving 40 m² instead of 20 m²; £65 comes from using only the longer parallel side, 6.5 × 4 = 26 m², instead of the trapezium formula; £35 comes from adding all three given lengths, 3.5 + 6.5 + 4, and treating that total as the area in square metres.)
- (c) They must also be equal — Once two triangles are proved congruent by any condition, including ASA, they are identical in every respect: every pair of corresponding sides and every pair of corresponding angles must be equal, not just the ones originally used to prove the congruence. So the two remaining pairs of corresponding sides must also be equal, making 'they must also be equal' correct. 'They might be equal or not' and 'not enough information to say' both wrongly suggest that congruence only guarantees the specific facts used to prove it, when congruence actually guarantees the triangles are identical overall. 'They must be different' is backwards: the triangles being identical is the entire point of proving congruence, not a reason for a side to differ.
- (b) 113.04 cm² — Sector area is (angle ÷ 360) × π × radius², and radius means the RADIUS, not the diameter: here the diameter is 24 cm, so the radius is 12 cm. The fraction is 90 ÷ 360 = 1/4, and 12² = 144, so the area is 0.25 × 3.14 × 144 = 113.04 cm². Using the diameter itself as if it were the radius gives 0.25 × 3.14 × 576 = 452.16 cm². Using the arc-length formula, 2 × π × radius, instead of the area formula gives 0.25 × 2 × 3.14 × 12 = 18.84 cm². Using the radius instead of its square gives 0.25 × 3.14 × 12 = 9.42 cm².
- (b) 115° — Angle APE and angle BPQ are vertically opposite, so angle BPQ = 65°, equal to angle APE. Angle BPQ and angle PQD are co-interior (allied) angles between the parallel lines, and co-interior angles always add up to 180°, so angle PQD = 180 − 65 = 115°. "65°" comes from treating co-interior angles as equal to each other, the way alternate angles are, instead of adding to 180°. "295°" comes from applying the angles-round-a-point fact (360° − 65°) directly to the original 65°, skipping the correct co-interior step. "25°" comes from misremembering co-interior angles as adding to 90° instead of 180° (90 − 65 = 25).
- (c) 500 cm² — The area of a triangle is half of base × height. First, base × height = 40 × 25 = 1,000. Half of 1,000 is 500 cm². 1,000 cm² forgets to halve and just gives base × height. 65 cm² adds the base and height together instead of multiplying them. 2,000 cm² doubles base × height instead of halving it.
- (b) Cuboid — not necessarily a cube — A solid with 6 faces, 12 edges and 8 vertices in which every face is a rectangle is a cuboid, but nothing here confirms that all the edges are the same length, so the box could be a cube or a non-cube cuboid; the most that can be concluded is that it is a cuboid, making 'Cuboid — not necessarily a cube' correct. 'Cube — only a cube fits this' is wrong because a cube is just one particular cuboid; a general cuboid with different length, width and height has exactly the same face, edge and vertex counts and rectangular faces. 'Triangular prism' is wrong because a triangular prism has 5 faces, 9 edges and 6 vertices, and two of its faces are triangles, so it matches neither the counts nor the face shape. 'Not enough information' is wrong because rectangular faces with these counts do pin the solid down to the cuboid family, even though they cannot pin down a cube specifically.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (a) £94.58 — Method: find the area with 1/2ab sin C, then multiply by the cost per square metre. Working: area = 1/2 × 1.8 × 1.3 × sin 72° = 1.11274 m², so cost = 1.11274 × £85 = £94.58. Leaving out the 1/2 gives an area of 2.22547 m² and a cost of £189.17; using cos 72° instead of sin 72° gives a cost of £30.73; and rounding the area to 1 decimal place (1.1 m²) before multiplying by the cost per square metre gives £93.50, which loses accuracy that the final answer needs. Even rounding to 1.113 m² is enough to shift the cost to £94.61 — keep the unrounded area in your calculator until the very last step.
- (d) 15 cm² — Method: identify the length that is common to both views, since it is the box's length; then read off the width from the plan view and the height from the front elevation, and multiply those two measurements to find the area of the side elevation. Working: both rectangles share a side of 8 cm, which is the box's length; the plan view's other side gives a width of 5 cm, and the front elevation's other side gives a height of 3 cm. The side elevation is bounded by the width and the height: 5 cm × 3 cm = 15 cm². Answer: 15 cm². The distractors: 24 cm² comes from giving the area of the front elevation shown (8 cm × 3 cm) instead of working out a new rectangle for the side elevation. 40 cm² comes from giving the area of the plan view shown (8 cm × 5 cm) instead of working out the side elevation. 120 cm² comes from multiplying all three measurements together (8 cm × 5 cm × 3 cm), finding the volume of the box instead of the area of one face.
- (b) 13 — Method: the straight-line distance between two points on a grid is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal gap and the vertical gap between them, so Pythagoras' theorem applies. Working: one point is the origin, so the horizontal gap is 5 and the vertical gap is 12. Then d² = 5² + 12² = 25 + 144 = 169, so d = √169 = 13. Answer: 13. The distractors: 17 comes from adding the two gaps, 5 + 12, instead of adding their squares and taking the root; 12 comes from reading off the vertical gap alone and offering that as the whole distance; 7 comes from subtracting the gaps, 12 − 5, as though a distance were a difference.
- (d) 36.9° — sin θ = opposite/hypotenuse = 6/10 = 0.6, so θ = sin⁻¹(0.6) = 36.86...° ≈ 36.9°. "53.1°" finds the OTHER acute angle in the triangle, 90° − 36.9°, instead of θ itself, as if the two acute angles had been swapped. "31.0°" comes from using the tangent ratio instead of sine, working out tan⁻¹(6/10) = 31.0° with the wrong ratio for the two sides given. "36.8°" rounds sin⁻¹(0.6) = 36.86...° down to 36.8° instead of correctly rounding it up to 36.9°.
- (b) 63° — Method: a tangent meets the radius drawn to the point of contact at a right angle, so triangle OPT has a 90° angle at T; the three angles of the triangle then sum to 180°. Working: angle OTP = 90°, angle OPT = 27°, so angle POT = 180 − 90 − 27 = 63 degrees. Answer: 63°. The tangent-radius angle is a fixed 90°, not something to assume equal to another angle in the triangle, and the three angles of ANY triangle sum to 180°, never 360°: that total belongs to a quadrilateral, not a triangle.
- (d) (−2, 0) — A 180° rotation about a centre (a, b) maps (x, y) to (2a − x, 2b − y). Here that gives (2 × 1 − 4, 2 × 1 − 2) = (−2, 0). A pupil who rotates about the origin instead of (1, 1) gets (−4, −2). A pupil who adds the centre's coordinates instead of applying the rotation formula gets (4 + 1, 2 + 1) = (5, 3). A pupil who just subtracts the centre's coordinates from E's, without doubling and reversing, gets (4 − 1, 2 − 1) = (3, 1). The correct image is (−2, 0).
- (c) 12.4 cm — In three dimensions, the distance between two points extends Pythagoras' theorem to three squared terms: PQ² = 5² + 7² + 9² = 25 + 49 + 81 = 155. Taking the square root, PQ = √155 = 12.4 cm (1 d.p.). Using only the x- and y-coordinates, and ignoring the third dimension entirely, gives PQ = √(5² + 7²) = √74 = 8.6 cm (1 d.p.), which is not the distance in 3D space. Adding the three coordinates directly, 5 + 7 + 9 = 21 cm, treats the coordinates as if they were lengths along a single straight path rather than the sides of a right-angled arrangement. Squaring and adding all three coordinates but forgetting to take the square root leaves 155 cm, the squared distance rather than the distance itself.
- (b) 3 — A cuboid with all different edge lengths has three planes of symmetry: one parallel to each pair of opposite faces, cutting the solid exactly in half. Choosing 9 is the number of planes of symmetry a CUBE has (where all edges are equal) — this cuboid's edges are all different, so it has fewer. Choosing 1 counts only one of the three planes and forgets the other two, each parallel to a different pair of faces. Choosing 6 double-counts each of the three planes, as if counting each one from both sides.
Build your own mix at the worksheet builder.