Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A tank holds 3.2 m³ of water. Work out this volume in litres.
- 2.A cylinder has a radius of 3 cm and a height of 10 cm. Using π = 3.14, work out the volume of the cylinder.
- 3.Triangle ABC has AB = 9 cm, BC = 6 cm and angle A = 35°. Triangle DEF has DE = 9 cm, EF = 6 cm and angle D = 35°. Which of the following correctly identifies the condition shown here?
- 4.A cylindrical candle and a cone-shaped candle have the same base radius and the same height. State the cone's volume as a fraction of the cylinder's volume.
- 5.A, B, C and D are points on a circle with centre O, placed in that order around the circle so that ABCD is a cyclic quadrilateral. B lies on the major arc AC and D lies on the minor arc AC. Angle AOC = 104°. Work out the size of angle ADC.
- 6.A warehouse stores identical cube-shaped crates. Its plan view is a 2 by 4 rectangle of crate positions, and every position is filled to a height of 3 crates, except one corner position, which has only 2 crates stacked on it because a delivery was incomplete. How many crates are there in total?
- 7.An isosceles trapezium has exactly one pair of parallel sides, and its two non-parallel sides are equal in length. How many lines of symmetry does it have?
- 8.A shop stacks tins in a display block. The front elevation of the block is 4 tins wide and 3 tins high. The side elevation shows the block is 2 tins deep. Every position in the block is filled. How many tins are used in total?
- 9.Two similar shapes have lengths in the ratio 1 : 3. A side of the smaller shape is 4 cm long. Work out the length of the corresponding side of the larger shape.
- 10.A bead starts at position (2, −1) on a grid, in centimetres. It is moved by the column vector u, with top number 3 and bottom number 5, and then moved by the column vector v, with top number −7 and bottom number 2. Work out the coordinates of the bead's final position.
- 11.A builder lays a low wall made from identical bricks. The diagram shows the plan of the wall's footprint on a grid, where each square is one brick. The wall is built up to a height of 4 bricks everywhere. Work out the total number of bricks used.
- 12.A kite string makes an angle of 30° with the ground. The kite is flying at a height of 6 m directly above a point on the ground. Using the exact value of sin 30°, work out the exact length of the kite string.
- 13.Point D is at (3, 7). It is reflected in the line y = x. Work out the coordinates of the image of point D.y = x
- 14.A rhombus has all four sides equal in length. Which statement about a rhombus is correct?
- 15.A sector of a circle has radius 15 cm and angle 216°. Using π = 3.14, work out the arc length of the sector.
Answer key
- (c) 3200 — Method: to change cubic metres to litres, multiply by 1000. Working: 3.2 × 1000 = 3200. Answer: 3200 litres. A candidate who multiplies by 100 instead of 1000 gets 320. A candidate who multiplies by 10000 instead of 1000 gets 32000. A candidate who does not convert at all gives 3.2.
- (c) 282.6 cm³ — Volume of a cylinder = πr²h = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6 cm³. (94.2 cm³ comes from using πrh and forgetting to square the radius; 90 cm³ comes from using r²h and leaving π out altogether; 1130.4 cm³ comes from using the diameter, 6 cm, in place of the radius.)
- (a) SSA - not sufficient to prove congruence — The angle given, angle A, is not the angle between sides AB and BC — it is not the included angle — so this data is SSA (side, side, angle), which is not sufficient to prove congruence on its own; two triangles can share this SSA information without being congruent. SAS is wrong because the given angle is not the one included between the two given sides. ASA is wrong because only one angle (A) is given, not two. AAS is wrong for the same reason — only one angle is given, not two.
- (c) One third of the cylinder's volume — Volume of a cylinder = base area × height. Volume of a cone = 1/3 × base area × height. For the same base radius and height, the cone's volume is exactly one third of the cylinder's, so it uses less wax. A student who thinks the cone is half the cylinder's volume has confused it with a different solid's ratio. A student who thinks the two volumes are the same has ignored the 1/3 factor in the cone formula entirely. A student who thinks the cone is two thirds of the cylinder's volume has the right idea that it is a fraction, but the wrong fraction.
- (b) 128° — Angle AOC and angle ABC stand on the same arc AC (the minor arc, which does not contain B), so by the angle at the centre theorem angle ABC = 104° ÷ 2 = 52°. ABCD is a cyclic quadrilateral, so its opposite angles ABC and ADC sum to 180°: angle ADC = 180° − 52° = 128°. A candidate who finds angle ABC = 52° correctly but then treats opposite angles as equal, as in a parallelogram, instead of supplementary, writes down 52° and stops there. Skipping the halving step and using 104° as angle ABC gives 180° − 104° = 76°. Reading off the given centre angle itself as the final answer, without applying either theorem, gives 104°. Work through both theorems in order and you land on 128°.
- (b) 23 — If every position were filled to the full height of 3, the total would be 2 × 4 × 3 = 24 crates. One corner position has only 2 crates instead of 3, one crate short of full height there, so the actual total is 24 − 1 = 23. "24" comes from using the full height everywhere and forgetting the one incomplete corner. "22" comes from removing 2 crates for the incomplete corner instead of the 1 that is actually missing (3 − 2 = 1, not 2). "21" comes from removing all 3 crates at that corner, as though the position were completely empty rather than 2 crates short.
- (d) 1 — An isosceles trapezium has one line of symmetry, running through the midpoints of the two parallel sides. 0 would be true for a scalene trapezium, whose non-parallel sides are unequal, but this trapezium's non-parallel sides are equal, so it is symmetrical. 2 is the number of lines of symmetry of a rectangle, not a trapezium. 4 comes from wrongly applying the 'number of sides equals number of lines of symmetry' rule, which only holds for REGULAR polygons — a trapezium is not regular.
- (a) 24 — The display is 4 tins wide, 3 tins high and 2 tins deep, and every position in that block is filled, so the total number of tins is the product of all three measurements: 4 × 3 × 2 = 24. "12" comes from multiplying only the width and height shown in the front elevation (4 × 3), forgetting the depth entirely. "9" comes from adding the three measurements (4 + 3 + 2) instead of multiplying them. "6" comes from multiplying only the height and depth (3 × 2), forgetting the width shown by the front elevation.
- (b) 12 cm — Method: in similar shapes every length is multiplied by the same scale factor, and a ratio of 1 : 3 means that factor is 3 going from the smaller shape to the larger one. Working: 4 × 3 = 12. Answer: 12 cm. The distractors: 7 cm comes from adding 3 to the side instead of multiplying by it, which is what happens when a ratio is read as a difference; 36 cm comes from multiplying by 3² = 9, the factor that scales areas, and applying it to a length; 4 cm comes from treating the two shapes as congruent, so that corresponding sides stay equal — similar shapes have equal angles, but their sides are in proportion.
- (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
- (b) 28 — Method: total bricks = (number of squares in the footprint) × (the height of the wall in bricks). Working: the footprint has the row of 5 squares plus the 2 squares in the arm that stands out from the middle of that row, and they do not overlap, giving 5 + 2 = 7 squares; multiplying by the height of 4 bricks gives 7 × 4 = 28. Answer: 28. The distractors: 20 comes from using only the row of 5 and ignoring the arm (5 × 4). 24 comes from treating the bottom square of the arm as if it were one of the row's own squares, so the arm is counted as adding only 1 new square instead of 2 (5 + 1 = 6, then 6 × 4). 32 comes from counting the square of the row directly below the arm a second time as part of the arm (5 + 3 = 8, then 8 × 4).
- (b) 12 m — sin 30° = opposite ÷ hypotenuse, where the opposite side is the height (6 m) and the hypotenuse is the string. So string = height ÷ sin 30° = 6 ÷ (1/2) = 12 m. The distractor 3 m comes from multiplying by sin 30° instead of dividing (6 × 1/2 = 3). The distractor 6√3 m comes from using tan 30° = 1/√3 instead of sin 30° (6 ÷ (1/√3) = 6√3). The distractor 4√3 m comes from using cos 30° = √3/2 instead of sin 30° (6 ÷ (√3/2) = 12/√3 = 4√3).
- (b) (7, 3) — Reflecting in the line y = x swaps the x- and y-coordinates: (3, 7) → (7, 3). A pupil who reflects in the x-axis instead gets (3, −7). A pupil who reflects in the y-axis instead gets (−3, 7). A pupil who confuses y = x with y = −x, swapping the coordinates and changing both signs, gets (−7, −3). The correct image is (7, 3).
- (b) Its diagonals cross at right angles — In a rhombus, the diagonals always bisect each other at right angles, because a rhombus is a parallelogram with all four sides equal. Its diagonals are not always equal in length — that is a property of a rectangle, and only holds for a rhombus in the special case where it is also a square. It does not always have four right angles — again, that is only true when the rhombus is also a square. Its order of rotational symmetry is generally 2, not 4; order 4 only happens when the rhombus is a square.
- (b) 56.52 cm — Arc length = (216 ÷ 360) × 2 × 3.14 × 15 = 0.6 × 94.2 = 56.52 cm. (28.26 cm comes from leaving out the factor of 2, using πr instead of 2πr; 94.2 cm comes from finding the full circumference and forgetting the angle fraction; 113.04 cm comes from using the diameter, 30 cm, instead of the radius.)
Build your own mix at the worksheet builder.