Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Triangle JKL has a right angle at K, hypotenuse JL = 13 cm, and side JK = 5 cm. Triangle MNO has a right angle at N, hypotenuse MO = 13 cm, and side MN = 5 cm. Using only the facts given, and without working out any further lengths, write down the congruence condition that proves triangle JKL is congruent to triangle MNO.
- 2.Two spheres are similar solids. Their radii are in the ratio 3 : 4. Write down the ratio of their surface areas.
- 3.Triangle T has a vertex at (8, 4). It is enlarged by a scale factor of 1/2, centre (2, 4). Work out the coordinates of the image of this vertex.
- 4.A boat sails from a harbour on a bearing of 090° for 24 km to a buoy, then changes course and sails on a bearing of 000° for 16 km to reach an island. Work out the direct distance from the harbour to the island. Give your answer correct to 1 decimal place.
- 5.Two identical ladders lean against the same vertical wall from opposite sides, each making an angle of 58.2° with the ground. The two ladders and the ground form a triangle. Work out the size of the angle between the two ladders at the top, where they meet.
- 6.A cuboid-shaped shipping crate has a length of 12 m, a width of 5 m, and a volume of 360 m³. Work out the height of the crate, in metres.
- 7.Two straight roads cross at a junction. The angle between them, measured with a protractor, is 118°. What is the size of the angle vertically opposite to it?
- 8.Two similar model cars have a length scale factor of 2 from the small model to the large model. Priya works out that the area scale factor is 2² = 4, and then says the volume scale factor must also be 4, since that is the number she just calculated. Is Priya correct?
- 9.A drone starts at the point (2, −3) on a coordinate grid. It flies by the vector and then by the vector . Write down the column vector that would take the drone straight back to its starting point.
- 10.A sector of a circle has radius 6 cm and angle 150°. Using π = 3.14, work out the perimeter of the sector.
- 11.A plan of a school hall uses a scale of 1 : 250. A wall is drawn 3.4 cm long on the plan. Sam wants to know the wall's real length in metres. What is it?
- 12.Shape S is enlarged by a scale factor of 3, centre the origin. A vertex of S is at (2, 1). Work out the coordinates of the image of this vertex.
- 13.A line passes through the points (1, 2) and (3, 6). The line is reflected in the x-axis, and the image is then translated by the vector (2, 0). Work out the gradient of the image line after both transformations.
- 14.A shape is made by joining two rectangles edge to edge, with no overlap. One rectangle measures 12 cm by 4 cm and the other measures 4 cm by 8 cm. Work out the total area of the shape.
- 15.In a right-angled triangle, the side opposite angle θ is 6 cm and the hypotenuse is 10 cm. Work out the size of angle θ. Give your answer correct to 1 decimal place.
Answer key
- (c) RHS — Both triangles are right-angled, and have equal hypotenuses (13 cm) and one equal corresponding side (5 cm), so they are congruent by the RHS (right angle, hypotenuse, side) condition — the three facts given are exactly a right angle, a hypotenuse and one other side. The distractor SAS would apply if two sides and the angle between those two sides were matched, but the right angle here lies between the 5 cm side and the third side, not between the 5 cm side and the hypotenuse. The distractor SSS needs all three pairs of sides matched, and only two sides of each triangle are given — the third side would first have to be calculated by Pythagoras, so SSS is not the condition the given facts supply. The distractor AAS would need two angles and a non-included side matched, but only one angle in each triangle is given.
- (c) 9 : 16 — Method: in similar solids the ratio of the surface areas is the square of the ratio of corresponding lengths. Working: the radii are in the ratio 3 : 4, so the surface areas are in the ratio 3² : 4² = 9 : 16. Answer: 9 : 16. The distractors: 27 : 64 is 3³ : 4³, the ratio of the volumes, which cubes the length ratio instead of squaring it; 3 : 4 leaves the length ratio untouched, as though surface area scaled in the same way as a length; 81 : 256 comes from squaring a second time, applying the rule to the ratio 9 : 16 rather than to the radii.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (b) 28.8 km — A bearing of 090° is due east and a bearing of 000° is due north, so the two legs of the journey are at right angles to each other, meeting at the buoy. Pythagoras' theorem therefore applies directly, with the direct distance from the harbour to the island as the hypotenuse: distance² = 24² + 16² = 576 + 256 = 832. Taking the square root, distance = √832 = 28.8 km (1 d.p.). Adding the two legs of the journey directly, 24 + 16 = 40 km, treats the route as if it were a straight line, ignoring that the boat actually turns through a right angle partway. Using only the first leg of the journey, 24 km, ignores the second leg entirely. Subtracting the two legs instead of combining them with Pythagoras' theorem, √(24² − 16²) = √(576 − 256) = √320 = 17.9 km (1 d.p.), also gives the wrong distance.
- (d) 63.6 — Method: the three angles inside the triangle formed by the two ladders and the ground add up to 180°. Working: 180 − 58.2 − 58.2 = 63.6. Answer: 63.6°. A candidate who assumes the top angle equals the base angles gives 58.2. A candidate who subtracts only one base angle from 180°, working out 180 − 58.2, gets 121.8. A candidate who doubles the base angle instead of subtracting it twice from 180°, working out 2 × 58.2, gets 116.4.
- (b) 6 m — Volume of a cuboid = length × width × height, so height = volume ÷ (length × width) = 360 ÷ (12 × 5) = 360 ÷ 60 = 6 m. A pupil who divides the volume by the length only gets 360 ÷ 12 = 30 m. A pupil who divides the volume by the width only gets 360 ÷ 5 = 72 m. A pupil who subtracts length × width from the volume instead of dividing gets 360 − 60 = 300 m. The correct height is 6 m.
- (a) 118° — When two straight lines cross, the angles that are vertically opposite each other are always equal. So the angle vertically opposite 118° is also 118°. A candidate who instead finds the angle next to it on the straight line, using 180° − 118° = 62°, has found the adjacent angle, not the vertically opposite one. A candidate who answers 180° has confused the rule with angles on a straight line. A candidate who doubles the angle, giving 236°, has applied no valid angle rule at all. The vertically opposite angle is 118°.
- (d) No — the volume factor is 2³ = 8, not the area factor 4. — For similar solids, area scales with the square of the length scale factor and volume scales with its cube — different powers of the same number, so they are not usually equal. The length scale factor here is 2, so the area scale factor is 2² = 4 (Priya's figure) but the volume scale factor is 2³ = 8. Priya is wrong: the correct volume scale factor is 8, not 4. The option claiming area and volume always scale by the same factor treats the two as interchangeable, which is only true for the length factor itself. The option giving 6 comes from multiplying the length factor by the number of dimensions (2 × 3) rather than cubing it. The option repeating '4' for volume simply reuses Priya's own area calculation.
- (b) $\binom{-5}{5}$ — Method: add the two flights to get the single vector of the whole journey out, then reverse that vector to get the journey home. Working: across, 6 − 1 = 5; up, 4 − 9 = −5. So the drone finishes at (7, −8), which is 5 to the right of its start and 5 below it. The way home is therefore 5 to the left and 5 up. Answer: $\binom{-5}{5}$. Giving the combined journey itself, $\binom{5}{-5}$, describes the flight out rather than the flight home. Subtracting the second vector instead of adding it makes the journey out 7 across and 13 up, and reversing that gives $\binom{-7}{-13}$. Reversing the horizontal movement but leaving the vertical one alone gives $\binom{-5}{-5}$.
- (c) 27.7 cm — Arc length = (150 ÷ 360) × 2 × 3.14 × 6 = (5 ÷ 12) × 37.68 = 15.7 cm. The perimeter of a sector also includes the two straight radii, so perimeter = 15.7 + 6 + 6 = 27.7 cm. (15.7 cm comes from stopping after the arc length and forgetting the two straight edges; 21.7 cm comes from adding only one radius instead of two; 31.4 cm comes from doubling the arc length instead of adding the two straight edges.)
- (b) 8.5 m — First apply the scale to convert the plan length to a real length in centimetres: 3.4 × 250 = 850 cm. Then convert centimetres to metres by dividing by 100: 850 ÷ 100 = 8.5, so the wall is 8.5 m long. Choosing 850 m applies the scale correctly but forgets to convert the answer from centimetres into metres. Choosing 0.85 m divides by 1000 instead of 100, confusing the centimetre-to-metre conversion with a metre-to-kilometre one. Choosing 3.4 m ignores the scale factor completely and just restates the plan length as if it were already the real length.
- (b) (6, 3) — For an enlargement centred on the origin, multiply both coordinates by the scale factor: (2 × 3, 1 × 3) = (6, 3). A pupil who adds the scale factor to each coordinate instead of multiplying gets (2 + 3, 1 + 3) = (5, 4). A pupil who multiplies only the x-coordinate gets (6, 1). A pupil who multiplies only the y-coordinate gets (2, 3). The correct image is (6, 3).
- (b) −2 — The gradient of the original line is (6 − 2) ÷ (3 − 1) = 4 ÷ 2 = 2. Reflecting in the x-axis sends every y-coordinate to its negative, which flips the sign of the gradient: the image line has gradient −2. Translating by (2, 0) is a horizontal shift, which does not change the line's steepness or direction at all, so the gradient stays at −2. Assuming the gradient is unaffected by the reflection gives 2, the original gradient carried straight through. Thinking a reflection in the x-axis turns a gradient into its positive reciprocal gives 1/2. Combining that same wrong idea with the sign flip from the reflection gives −1/2. Only the sign flips, from the reflection, and translating never changes a gradient at all, so the answer is −2.
- (c) 80 cm² — Method: a composite shape made of two rectangles that do not overlap has an area equal to the sum of the two rectangle areas, so work out each area and add them. Working: the first rectangle has area 12 × 4 = 48 cm² and the second has area 4 × 8 = 32 cm², so the total is 48 + 32 = 80. Answer: 80 cm². The distractors: 48 cm² comes from working out the larger rectangle only and treating it as the whole shape; 32 cm² comes from working out the smaller rectangle only; 28 cm comes from adding the four given lengths, 12 + 4 + 4 + 8, which is a distance rather than an area and so carries a plain centimetre unit.
- (d) 36.9° — sin θ = opposite/hypotenuse = 6/10 = 0.6, so θ = sin⁻¹(0.6) = 36.86...° ≈ 36.9°. "53.1°" finds the OTHER acute angle in the triangle, 90° − 36.9°, instead of θ itself, as if the two acute angles had been swapped. "31.0°" comes from using the tangent ratio instead of sine, working out tan⁻¹(6/10) = 31.0° with the wrong ratio for the two sides given. "36.8°" rounds sin⁻¹(0.6) = 36.86...° down to 36.8° instead of correctly rounding it up to 36.9°.
Build your own mix at the worksheet builder.