Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A circular table mat has diameter 20 cm. Yasmin has a 70 cm length of ribbon and sews it around the edge of the mat with no overlap. Using π = 3.14, work out how much ribbon is left over after going around the mat once.
- 2.A cylinder has a radius of 3 cm and a height of 10 cm. Using π = 3.14, work out the volume of the cylinder.
- 3.Two similar model cars have a length scale factor of 2 from the small model to the large model. Priya works out that the area scale factor is 2² = 4, and then says the volume scale factor must also be 4, since that is the number she just calculated. Is Priya correct?
- 4.e is the column vector with top number 5 and bottom number k. f is the column vector with top number 15 and bottom number 6. Given that f is 3 times e, work out the value of k.
- 5.ABCD is a convex quadrilateral field with diagonal AC = 20 m. In triangle ABC, AB = 14 m and angle BAC = 35°. In triangle ACD, AD = 16 m and angle DAC = 40°. Work out the total area of the field. Give your answer to 1 decimal place.
- 6.Triangle ABC is drawn. The interior angle bisectors from vertices A and B are constructed and meet at point I inside the triangle. Which statement about point I must be true?
- 7.A ramp's sloped surface crosses two horizontal parallel rails. At the top rail, the angle between the ramp and the rail on the right of the ramp is (3x + 10)°. At the bottom rail, the angle between the ramp and the rail on the left of the ramp is (5x − 30)°. Work out the value of x.
- 8.A plan of a car park is drawn to a scale of 1 : 500. A parking bay is drawn as a rectangle measuring 1.2 cm by 0.6 cm. The real width of the bay corresponds to the 0.6 cm side. What is the real width of the bay, in metres?
- 9.A quadrilateral has exactly two lines of symmetry, its two pairs of opposite angles are equal, and its diagonals are not equal in length. Write down the name of this quadrilateral.
- 10.A boat sails from a harbour on a bearing of 090° for 24 km to a buoy, then changes course and sails on a bearing of 000° for 16 km to reach an island. Work out the direct distance from the harbour to the island. Give your answer correct to 1 decimal place.
- 11.A photograph is 10 cm wide and 15 cm tall. It is enlarged to make a similar poster that is 40 cm wide. The poster costs £0.80 per centimetre of its height to print, based on its full height. Work out the cost of printing the poster.
- 12.A garden designer describes a flower bed as a shape with four straight sides: exactly one pair of sides is parallel, those two parallel sides are different lengths, and the other two sides are equal in length to each other but not parallel to each other. Which shape should the designer draw?
- 13.A sailmaker cuts two triangular sail panels from a pattern. Panel X has a 10 m side, with angles of 50° and 75° at its two ends. Panel Y also has a 10 m side, with angles of 50° and 75° at its two ends, in the same arrangement. The sailmaker wants to check the panels will match exactly, without cutting a third measurement. Which condition proves the two panels are congruent?
- 14.A line joins the points A(0, 0, 0) and B(9, 12, 8) in a three-dimensional coordinate system in which the z-axis is vertical. Work out the angle this line makes with the horizontal (the xy-plane). Give your answer correct to 1 decimal place.
- 15.A solid pyramid has a square base of side 6 cm. Its apex is directly above the centre of the base, at a vertical height of 8 cm. Work out the volume of the pyramid.
Answer key
- (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
- (c) 282.6 cm³ — Volume of a cylinder = πr²h = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6 cm³. (94.2 cm³ comes from using πrh and forgetting to square the radius; 90 cm³ comes from using r²h and leaving π out altogether; 1130.4 cm³ comes from using the diameter, 6 cm, in place of the radius.)
- (d) No — the volume factor is 2³ = 8, not the area factor 4. — For similar solids, area scales with the square of the length scale factor and volume scales with its cube — different powers of the same number, so they are not usually equal. The length scale factor here is 2, so the area scale factor is 2² = 4 (Priya's figure) but the volume scale factor is 2³ = 8. Priya is wrong: the correct volume scale factor is 8, not 4. The option claiming area and volume always scale by the same factor treats the two as interchangeable, which is only true for the length factor itself. The option giving 6 comes from multiplying the length factor by the number of dimensions (2 × 3) rather than cubing it. The option repeating '4' for volume simply reuses Priya's own area calculation.
- (d) 2 — Method: if f is 3 times e, then each part of f equals 3 times the matching part of e. Working: using the bottom numbers, 6 = 3 × k, so k = 2. Answer: k = 2. A candidate who multiplies instead of dividing, working out 6 × 3, gets 18. A candidate who uses the top numbers' ratio instead, 15 ÷ 5, and gives that ratio as k gets 3. A candidate who adds instead of using the multiple relationship, working out 6 + 3, gets 9.
- (d) 183.1 m² — Method: the diagonal AC splits the field into two triangles; find each triangle's area with 1/2ab sin C using AC as a side in both, then add the two areas. Working: area of triangle ABC = 1/2 × 14 × 20 × sin 35° = 80.3 m²; area of triangle ACD = 1/2 × 16 × 20 × sin 40° = 102.8 m²; total area = 80.3 + 102.8 = 183.1 m². Ignoring the diagonal AC completely and using AB, AD and the combined angle 35° + 40° = 75° as if it were one triangle gives 108.2 m²; averaging the two triangle areas instead of adding them gives 91.6 m²; and reporting only the area of triangle ABC, forgetting triangle ACD entirely, gives 80.3 m². A diagonal that splits a quadrilateral into two triangles means both areas must be added, using the diagonal as a side of each.
- (c) I is the same distance from all three sides. — The angle bisector from A is the locus of points equidistant from sides AB and AC, and the angle bisector from B is the locus of points equidistant from sides AB and BC. Point I lies on both bisectors, so I is equidistant from AB and AC, and also equidistant from AB and BC — meaning I is the same distance from all three sides. (Being the same distance from all three vertices instead describes the circumcentre, found from the perpendicular bisectors of the sides, not the angle bisectors; I being the midpoint of AB confuses the angle bisector construction with the perpendicular bisector of a side; I lying on side AC is wrong because the angle bisectors meet inside the triangle, not on one of its sides.)
- (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
- (b) 3 — The real width is 0.6 × 500 = 300 cm, which converts to 3 m by dividing by 100. A candidate who uses the wrong side of the rectangle, 1.2 cm, instead of the 0.6 cm width, gets 1.2 × 500 = 600 cm = 6 m. A candidate who multiplies correctly but converts the 300 cm to metres by dividing by 1000 instead of 100 gets 0.3 m. A candidate who converts by dividing by 10 instead of 100 gets 30 m. The real width of the bay is 3 m.
- (b) Rhombus — A rhombus has exactly two lines of symmetry, formed by its two diagonals, and both pairs of opposite angles are equal, but its diagonals are unequal in length. A square also has opposite angles equal, but it has four lines of symmetry and its diagonals ARE equal, so it does not fit. A kite normally has only one line of symmetry and only one pair of opposite angles equal, so it does not fit. A general parallelogram has no lines of symmetry at all, so it does not fit. The correct answer is rhombus.
- (b) 28.8 km — A bearing of 090° is due east and a bearing of 000° is due north, so the two legs of the journey are at right angles to each other, meeting at the buoy. Pythagoras' theorem therefore applies directly, with the direct distance from the harbour to the island as the hypotenuse: distance² = 24² + 16² = 576 + 256 = 832. Taking the square root, distance = √832 = 28.8 km (1 d.p.). Adding the two legs of the journey directly, 24 + 16 = 40 km, treats the route as if it were a straight line, ignoring that the boat actually turns through a right angle partway. Using only the first leg of the journey, 24 km, ignores the second leg entirely. Subtracting the two legs instead of combining them with Pythagoras' theorem, √(24² − 16²) = √(576 − 256) = √320 = 17.9 km (1 d.p.), also gives the wrong distance.
- (d) £48 — Scale factor = new width ÷ original width = 40 ÷ 10 = 4. Poster height = 15 × 4 = 60 cm. Cost = 60 × £0.80 = £48. (£12 comes from forgetting to scale the height at all, and pricing the original 15 cm height; £15.20 comes from adding the scale factor 4 to the height instead of multiplying by it; £3 comes from dividing the height by the scale factor instead of multiplying by it.)
- (a) isosceles trapezium — One pair of parallel sides, plus a separate pair of equal non-parallel sides, is exactly the definition of an isosceles trapezium — the shape the designer should draw. Parallelogram is wrong because a parallelogram needs BOTH pairs of opposite sides parallel, but only one pair is parallel here. Kite is wrong because a kite has two separate pairs of adjacent equal sides and no requirement for any sides to be parallel, a different combination of properties. Rhombus is wrong because a rhombus needs all four sides equal, but the description only makes two of the four sides equal to each other.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (a) 28.1° — The angle a line makes with the horizontal plane lies in the right-angled triangle formed by the vertical rise, the horizontal distance travelled, and the line itself. The horizontal distance from A to B is √(9² + 12²) = √(81 + 144) = √225 = 15, using only the x- and y-coordinates. The vertical rise is the z-coordinate, 8, so tan(angle) = 8 ÷ 15, giving angle = 28.1° (1 d.p.). Inverting the ratio, tan(angle) = 15 ÷ 8, gives 61.9° instead — the complement of the angle, not the angle with the horizontal. Using only the x-coordinate as if it were the whole horizontal distance, tan(angle) = 8 ÷ 9, gives 41.6°. Using the y-coordinate alone in the same way, tan(angle) = 8 ÷ 12, gives 33.7°.
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
Build your own mix at the worksheet builder.