Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A packaging designer is told a box has 6 faces, 12 edges and 8 vertices, and every face is a rectangle. To fit exactly onto a shelf, the designer needs to know whether the box must be a cube. Based only on this information, which solid must the box be?
- 2.A jug holds 750 ml of water. Work out what fraction of a litre this is.
- 3.A ship's radar shows a lighthouse at the point (12, −4) on a grid measured in nautical miles. The ship is at (2, 5). The ship sails along the vector that takes it directly to the lighthouse, then sails along that same vector again. Work out the ship's final position.
- 4.A tile manufacturer cuts a hexagonal tile so that all six sides measure exactly 4 cm, but a check shows only two pairs of the six interior angles are equal to each other, not all six angles. The customer's order specifies regular hexagonal tiles. Based on the check, is this tile a regular hexagon?
- 5.A circle has a radius of 1 cm. Work out the circumference of the circle. Give your answer in terms of π.
- 6.A circular garden pond has a diameter of 5 m. A gardener is laying gravel around it in a ring-shaped path 1 m wide, measured outward from the edge of the pond. Work out the area of the gravel path. Use π = 3.14.
- 7.The angle between north and a footpath is 35°, measured clockwise from north. What is the three-figure bearing of the footpath?
- 8.In triangle ABC, AB = 11 cm, AC = 9 cm and the area of the triangle is 45 cm². Given that angle BAC is obtuse, work out the size of angle BAC. Give your answer to 1 decimal place.
- 9.Two straight roads cross at a junction. The angle between them, measured with a protractor, is 118°. What is the size of the angle vertically opposite to it?
- 10.A plumber charges a £45 call-out fee, plus £28 for each hour worked. She works on a job for 3 hours 30 minutes, and her hours are billed by rounding up to the next whole hour. Work out the total amount she charges.
- 11.Triangle ABC has AB = 6 cm and BC = 9 cm, with angle A = 40°. Triangle DEF has DE = 6 cm and EF = 9 cm, with angle D = 40°. Meera says these facts prove the triangles are congruent by SAS. Is Meera correct?
- 12.Point P(2, 5) is enlarged with centre (2, 1) to give image point P′(2, −7). Work out the scale factor of the enlargement.
- 13.Work out the y-coordinate of the midpoint of the line segment joining (2, 4) and (8, 10).
- 14.A circular table mat has diameter 20 cm. Yasmin has a 70 cm length of ribbon and sews it around the edge of the mat with no overlap. Using π = 3.14, work out how much ribbon is left over after going around the mat once.
- 15.A warehouse stores identical cube-shaped crates. Its plan view is a 2 by 4 rectangle of crate positions, and every position is filled to a height of 3 crates, except one corner position, which has only 2 crates stacked on it because a delivery was incomplete. How many crates are there in total?
Answer key
- (b) Cuboid — not necessarily a cube — A solid with 6 faces, 12 edges and 8 vertices in which every face is a rectangle is a cuboid, but nothing here confirms that all the edges are the same length, so the box could be a cube or a non-cube cuboid; the most that can be concluded is that it is a cuboid, making 'Cuboid — not necessarily a cube' correct. 'Cube — only a cube fits this' is wrong because a cube is just one particular cuboid; a general cuboid with different length, width and height has exactly the same face, edge and vertex counts and rectangular faces. 'Triangular prism' is wrong because a triangular prism has 5 faces, 9 edges and 6 vertices, and two of its faces are triangles, so it matches neither the counts nor the face shape. 'Not enough information' is wrong because rectangular faces with these counts do pin the solid down to the cuboid family, even though they cannot pin down a cube specifically.
- (a) 3/4 — 1 litre = 1000 ml, so 750 ml is 750/1000 of a litre. Dividing both the numerator and denominator by 250 simplifies this to 3/4. Writing the fraction upside down, as the litre out of the 750 ml, gives 4/3. Finding the fraction of the litre that is NOT filled, 250/1000, gives 1/4. Dividing the numerator by 250 but the denominator by only 100, an inconsistent simplification, gives 3/10.
- (b) (22, −13) — The vector from the ship to the lighthouse is (12, −4) − (2, 5) = (10, −9). Sailing along this vector twice from the start gives (2, 5) + 2 × (10, −9) = (2 + 20, 5 − 18) = (22, −13). '(12, −4)' stops after the ship reaches the lighthouse and ignores the second identical leg. '(−18, 23)' comes from finding the vector the wrong way round, as (2, 5) − (12, −4) = (−10, 9), and then doubling that. '(2, 5)' comes from adding the vector and then subtracting it again, wrongly cancelling the two legs instead of adding them.
- (d) No — angles must be equal too — A regular polygon must have both all sides equal and all angles equal. This tile has all six sides equal, but its interior angles are not all equal, so it fails the angle condition and is not regular — 'No — angles must be equal too' is correct. 'Yes — all sides are equal' is wrong because equal sides alone are not enough; a shape can have equal sides but unequal angles, as here. 'Yes — six equal sides means regular' is wrong for the same reason: equal sides do not automatically guarantee equal angles. 'No — hexagons can't be regular' is wrong because regular hexagons certainly exist (six equal sides and six equal 120° angles); it is this particular tile that fails to be regular, not hexagons in general.
- (c) 2π cm — Method: the circumference of a circle is 2πr, where r is the radius, or equivalently πd, where d is the diameter. Working: r = 1, so the circumference is 2 × π × 1 = 2π cm. Answer: 2π cm. The distractors: π cm comes from using the formula πd but substituting the radius in place of the diameter; 4π cm comes from doubling twice — changing the radius into the diameter of 2 cm and then putting that diameter into 2πr as though it were a radius; π cm² is the area of this circle, π × 1², and comes from reaching for the area formula when a distance round the outside was asked for, which is why it carries a squared unit.
- (b) 18.84 m² — The pond has radius 2.5 m (half of the 5 m diameter), so the outer edge of the path has radius 2.5 + 1 = 3.5 m. Path area = area of outer circle − area of pond = 3.14 × 3.5² − 3.14 × 2.5² = 38.465 − 19.625 = 18.84 m².
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (d) 114.6° — Method: rearrange Area = (1/2)ab sin C to make sin C the subject, then use the obtuse branch since the question states the angle is obtuse. Working: sin C = 2 × 45 ÷ (11 × 9) = 0.909, so the acute angle is sin⁻¹(0.909) = 65.4°, and the obtuse angle is 180 − 65.4 = 114.6°. Answer: 114.6°. Giving the acute angle straight from the calculator, 65.4°, ignores that the question asks for the obtuse one; forgetting to double the area before dividing gives sin C = 45 ÷ (11 × 9) = 0.4545, whose obtuse angle is 180 − 27.0 = 153.0°; and that same forgotten-doubling error taken on the acute branch instead gives 27.0°. Always double the area first, and then take 180° minus the calculator's answer whenever the question specifically asks for the obtuse angle.
- (a) 118° — When two straight lines cross, the angles that are vertically opposite each other are always equal. So the angle vertically opposite 118° is also 118°. A candidate who instead finds the angle next to it on the straight line, using 180° − 118° = 62°, has found the adjacent angle, not the vertically opposite one. A candidate who answers 180° has confused the rule with angles on a straight line. A candidate who doubles the angle, giving 236°, has applied no valid angle rule at all. The vertically opposite angle is 118°.
- (b) £157 — Method: round the hours worked up to the next whole hour, multiply by the hourly rate, then add the call-out fee. Working: 3 hours 30 minutes rounds up to 4 hours; 28 × 4 = 112; 112 + 45 = 157. Answer: £157. A candidate who uses the unrounded time of 3.5 hours, working out 28 × 3.5 = 98 and adding 45, gets £143. A candidate who forgets the call-out fee, giving only 28 × 4, gets £112. A candidate who rounds down to 3 hours instead of up, working out 28 × 3 = 84 and adding 45, gets £129.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
- (d) −2 — Method: the scale factor is the ratio of the image vector to the object vector, both measured FROM THE CENTRE of enlargement, keeping every sign. Working: the vector from the centre (2, 1) to P(2, 5) is (0, 4); the vector from the centre to P′(2, −7) is (0, −8). The scale factor is −8 ÷ 4 = −2. Answer: −2. Measure both vectors from the CENTRE, not from the origin, divide the IMAGE vector by the OBJECT vector and not the other way round, and keep the negative sign: a negative scale factor is not the same size as its positive counterpart with the sign dropped.
- (b) 7 — Method: each coordinate of a midpoint is the mean of the matching pair of coordinates, so the y-coordinate of the midpoint depends on the two y-coordinates alone. Working: the y-coordinates are 4 and 10, so the mean is (4 + 10) ÷ 2 = 14 ÷ 2 = 7. Answer: 7. The distractors: 5 comes from working out the x-coordinate of the midpoint, (2 + 8) ÷ 2 = 5, and writing that down in place of the y-coordinate the question asked for; 3 comes from halving the difference of the y-coordinates, (10 − 4) ÷ 2 = 3, which is half the vertical gap rather than a position; 14 comes from adding the two y-coordinates and forgetting to halve the total.
- (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
- (b) 23 — If every position were filled to the full height of 3, the total would be 2 × 4 × 3 = 24 crates. One corner position has only 2 crates instead of 3, one crate short of full height there, so the actual total is 24 − 1 = 23. "24" comes from using the full height everywhere and forgetting the one incomplete corner. "22" comes from removing 2 crates for the incomplete corner instead of the 1 that is actually missing (3 − 2 = 1, not 2). "21" comes from removing all 3 crates at that corner, as though the position were completely empty rather than 2 crates short.
Build your own mix at the worksheet builder.