Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A shop stacks tins in a display block. The front elevation of the block is 4 tins wide and 3 tins high. The side elevation shows the block is 2 tins deep. Every position in the block is filled. How many tins are used in total?
- 2.A rectangle has vertices A(1, 1), B(4, 1), C(4, 5) and D(1, 5). Work out the perimeter of the rectangle.
- 3.Four angles meet at a point. Three of them measure 82°, 105° and 96°. Work out the size of the fourth angle.
- 4.The angle between north and a footpath is 35°, measured clockwise from north. What is the three-figure bearing of the footpath?
- 5.A parallelogram has an area of 84 cm² and a base of 12 cm. Work out the perpendicular height of the parallelogram.
- 6.A support strut for a shed roof is in the shape of a right-angled triangle. The two shorter sides of the strut are 5 m and 9 m. Work out the length of the sloping strut (the hypotenuse). Give your answer correct to 1 decimal place.
- 7.A ladder rests against a wall, making an angle of 60° with the ground. The ladder is 2 m long. Using the exact value of sin 60°, work out how high up the wall the ladder reaches, giving your answer in centimetres.
- 8.Two similar shapes have lengths in the ratio 1 : 3. A side of the smaller shape is 4 cm long. Work out the length of the corresponding side of the larger shape.
- 9.A circle has a diameter of 24 cm. A sector of this circle has an angle of 90°. Using π = 3.14, work out the area of the sector.
- 10.A ramp rises at 30° to the horizontal. Its sloping surface is 4.8 m long. Safety rules say the vertical rise of a ramp must be no more than 2.5 m. Work out how far below that limit the rise of this ramp is.
- 11.State whether the line segment joining A(−4, 3) and B(2, 6) is horizontal, vertical or neither, and give a reason for your answer.
- 12.A solid pyramid has a square base of side 6 cm. Its apex is directly above the centre of the base, at a vertical height of 8 cm. Work out the volume of the pyramid.
- 13.In triangle ABC, AB = 10 cm, BC = 7 cm and angle ACB = 35°. Given that angle BAC is acute, work out the length of AC. Give your answer to 1 decimal place.
- 14.A cylinder has a volume of 942 cm³ and a height of 12 cm. Using π = 3.14, work out the radius of the cylinder.
- 15.Quadrilateral PQRS has angle P = 92°, angle Q = 84° and angle R = 106°. Work out the size of angle S.
Answer key
- (a) 24 — The display is 4 tins wide, 3 tins high and 2 tins deep, and every position in that block is filled, so the total number of tins is the product of all three measurements: 4 × 3 × 2 = 24. "12" comes from multiplying only the width and height shown in the front elevation (4 × 3), forgetting the depth entirely. "9" comes from adding the three measurements (4 + 3 + 2) instead of multiplying them. "6" comes from multiplying only the height and depth (3 × 2), forgetting the width shown by the front elevation.
- (c) 14 units — Method: the perimeter of a rectangle is the distance all the way round its outside, 2 × (length + width), so the two side lengths must be found first; on a coordinate grid a side's length is the difference between the coordinates that change along it. Working: along AB, from (1, 1) to (4, 1), only x changes, so AB = 4 − 1 = 3. Along BC, from (4, 1) to (4, 5), only y changes, so BC = 5 − 1 = 4. Perimeter = 2 × (3 + 4) = 2 × 7 = 14. Answer: 14 units. The distractors: 18 units comes from reading the vertex numbers 4 and 5 as the side lengths instead of subtracting, giving 2 × (4 + 5); 12 units comes from working out the area, 3 × 4, in place of the perimeter; 7 units comes from adding one length to one width and stopping there, without doubling for the opposite pair of sides.
- (d) 77 — Method: angles that meet at a point add up to 360°. Working: 82 + 105 + 96 = 283; 360 − 283 = 77. Answer: 77°. A candidate who gives the sum of the three known angles and forgets to subtract it from 360° gets 283. A candidate who leaves out the 105° angle, working out 360 − 82 − 96, gets 182. A candidate who leaves out the 82° angle, working out 360 − 105 − 96, gets 159.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (d) 7 cm — Area of a parallelogram = base × height, so height = area ÷ base = 84 ÷ 12 = 7 cm. A pupil who multiplies instead of dividing gets 84 × 12 = 1008 cm. A pupil who divides the base by the area instead of the area by the base gets 12 ÷ 84 ≈ 0.14 cm. A pupil who mistakenly halves the area first, as if this were a triangle, gets (84 ÷ 2) ÷ 12 = 3.5 cm. The correct height is 7 cm.
- (d) 10.3 m — By Pythagoras' theorem, the hypotenuse = √(5² + 9²) = √(25 + 81) = √106 = 10.29...≈ 10.3 m. "106 m" is the value under the square root sign, correct as far as it goes but with the final square root step left out. "14 m" comes from adding the two shorter sides, 5 + 9, instead of using Pythagoras' theorem at all. "10.2 m" comes from rounding 10.29...m down to 10.2 instead of correctly rounding it up to 10.3.
- (c) 100√3 cm — The height is opposite the 60° angle, so height = 2 × sin 60° = 2 × √3/2 = √3 m. Converting to centimetres: √3 m = 100√3 cm. '√3 cm' forgets to convert the answer from metres to centimetres. '200√3 cm' comes from mis-recalling sin 60° as √3 instead of √3/2, dropping the denominator of the exact value: 2 × √3 = 2√3 m = 200√3 cm. '50√3 cm' comes from halving the ladder's length before multiplying by sin 60°, instead of using the full 2 m.
- (b) 12 cm — Method: in similar shapes every length is multiplied by the same scale factor, and a ratio of 1 : 3 means that factor is 3 going from the smaller shape to the larger one. Working: 4 × 3 = 12. Answer: 12 cm. The distractors: 7 cm comes from adding 3 to the side instead of multiplying by it, which is what happens when a ratio is read as a difference; 36 cm comes from multiplying by 3² = 9, the factor that scales areas, and applying it to a length; 4 cm comes from treating the two shapes as congruent, so that corresponding sides stay equal — similar shapes have equal angles, but their sides are in proportion.
- (b) 113.04 cm² — Sector area is (angle ÷ 360) × π × radius², and radius means the RADIUS, not the diameter: here the diameter is 24 cm, so the radius is 12 cm. The fraction is 90 ÷ 360 = 1/4, and 12² = 144, so the area is 0.25 × 3.14 × 144 = 113.04 cm². Using the diameter itself as if it were the radius gives 0.25 × 3.14 × 576 = 452.16 cm². Using the arc-length formula, 2 × π × radius, instead of the area formula gives 0.25 × 2 × 3.14 × 12 = 18.84 cm². Using the radius instead of its square gives 0.25 × 3.14 × 12 = 9.42 cm².
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (d) 14.9 cm — By the sine rule, sin(BAC) ÷ BC = sin(ACB) ÷ AB, so sin(BAC) = 7 × sin35° ÷ 10 = 0.4015. This gives angle BAC = 23.7° or angle BAC = 156.3°; since angle BAC is acute, angle BAC = 23.7°. Angle ABC = 180° − 35° − 23.7° = 121.3°. By the sine rule again, AC ÷ sin(ABC) = AB ÷ sin(ACB), so AC = 10 × sin121.3° ÷ sin35° = 14.9 cm. Using angle BAC in the final step instead of angle ABC gives AC = 10 × sin23.7° ÷ sin35° = 7.0 cm — this just recomputes the given side BC. Using angle ACB again in the final step, instead of the newly found angle ABC, gives AC = 10 × sin35° ÷ sin35° = 10.0 cm — this just returns AB unchanged. Making a sign slip when finding angle ABC, computing 180° − 35° + 23.7° = 168.7° instead of subtracting it, and carrying that through gives AC = 10 × sin168.7° ÷ sin35° = 3.4 cm. Find angle BAC, then angle ABC, then apply the sine rule once more, and AC comes to 14.9 cm.
- (c) 5 cm — Volume of a cylinder = πr²h, so r² = V ÷ (πh) = 942 ÷ (3.14 × 12) = 942 ÷ 37.68 = 25, and r = √25 = 5 cm. A pupil who finds r² = 25 but forgets to take the square root gives 25 cm. A pupil who forgets to divide by π, using r² = 942 ÷ 12 = 78.5, gets r = √78.5 ≈ 8.9 cm. A pupil who forgets to divide by the height, using r² = 942 ÷ 3.14 = 300, gets r = √300 ≈ 17.3 cm. The correct radius is 5 cm.
- (c) 78° — The angles in any quadrilateral add up to 360°. Add the three given angles: 92° + 84° + 106° = 282°. Angle S = 360° − 282° = 78°. A pupil who only adds angle P and angle Q, forgetting angle R, gets 360° − (92° + 84°) = 184°. A pupil who only adds angle Q and angle R, forgetting angle P, gets 360° − (84° + 106°) = 170°. A pupil who makes a carrying slip adding the three angles, getting 292° instead of 282°, gets 360° − 292° = 68°. The correct answer is 78°.
Build your own mix at the worksheet builder.