Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A courier drone delivers a parcel. It starts at the point (2, 1) on a map grid measured in kilometres. It flies by the vector to a warehouse, then by the vector to the delivery address. Work out the coordinates of the delivery address.
- 2.Quadrilateral PQRS has angle P = 92°, angle Q = 84° and angle R = 106°. Work out the size of angle S.
- 3.A solid is built from centimetre cubes standing on a table. Seen from the front, the left-hand column is 2 cubes high, the middle column is 2 cubes high and the right-hand column is 1 cube high. Work out how many squares make up the front elevation.
- 4.A raised garden bed is a prism whose cross-section is a triangle with a base of 1.2 m and a perpendicular height of 0.8 m. The bed is 3 m long. Work out the volume of soil needed to fill it, in m³.
- 5.The bearing of a campsite B from a walker's position A is 070°. What is the bearing of A from B?
- 6.Lines GH and JK are parallel. A straight line crosses GH at point M and crosses JK at point N. Angle HMN = 71°. Angle HMN and angle MNK are alternate angles. Work out angle MNK.
- 7.A garden flower bed is in the shape of a trapezium. Its two parallel edges are 3.5 m and 6.5 m long, and the perpendicular distance between them is 4 m. Bedding plants cost £2.50 per square metre to cover the bed. Work out the total cost of the bedding plants.
- 8.A locus consists of all the points that are the same perpendicular distance from two parallel lines 6 cm apart. Describe this locus.
- 9.A zip-wire is fixed at an angle of 60° to the horizontal ground. The zip-wire is 12 m long. Using the exact value of cos 60°, work out the exact horizontal distance it covers.
- 10.A ramp rises at 30° to the horizontal. Its sloping surface is 4.8 m long. Safety rules say the vertical rise of a ramp must be no more than 2.5 m. Work out how far below that limit the rise of this ramp is.
- 11.Triangle PQR and triangle XYZ have angle P = angle X, angle Q = angle Y and angle R = angle Z, with no side lengths given for either triangle. Which of the following correctly describes the relationship between the two triangles?
- 12.A triangular flower bed ABC has AB = 14 m, BC = 9 m and AC = 11 m. Work out the area of the flower bed. Give your answer to 1 decimal place.
- 13.OABC is a parallelogram, with OA = a and OC = c. M is the midpoint of OC, and N is the point on AC such that AN is twice NC. By finding the vectors MN and MB, show that M, N and B are collinear, and give the scalar k such that MN = k × MB.
- 14.A shopkeeper builds a display from two cuboid boxes, shown in the diagram. She wants to cover the front of the display with coloured paper. Work out the total area of the front elevation, in square centimetres.
- 15.A cuboid-shaped shipping crate has a length of 12 m, a width of 5 m, and a volume of 360 m³. Work out the height of the crate, in metres.
Answer key
- (d) (6, 2) — Applying the first vector: (2, 1) + (5, −3) = (7, −2), which is the warehouse. Applying the second vector: (7, −2) + (−1, 4) = (6, 2), the delivery address. '(7, −2)' stops at the warehouse and forgets the second flight. '(8, −6)' comes from adding (1, −4) instead of (−1, 4) for the second vector, getting both signs wrong. '(11, −3)' comes from swapping the components of the second vector to (4, −1) before adding.
- (c) 78° — The angles in any quadrilateral add up to 360°. Add the three given angles: 92° + 84° + 106° = 282°. Angle S = 360° − 282° = 78°. A pupil who only adds angle P and angle Q, forgetting angle R, gets 360° − (92° + 84°) = 184°. A pupil who only adds angle Q and angle R, forgetting angle P, gets 360° − (84° + 106°) = 170°. A pupil who makes a carrying slip adding the three angles, getting 292° instead of 282°, gets 360° − 292° = 68°. The correct answer is 78°.
- (c) 5 — The front elevation shows one square for every cube visible from the front, column by column: the left-hand column is 2 cubes high, so it contributes 2 squares; the middle column is 2 cubes high, so it contributes 2 more; the right-hand column is 1 cube high, so it contributes 1. The total is 2 + 2 + 1 = 5 squares. "6" comes from drawing a full 3 by 2 rectangle, treating every column as if it reached the greatest height. "4" comes from losing a square from one of the two tall columns, counting 2 + 1 + 1. "3" comes from counting one square per column — the width of the solid — and ignoring the heights altogether.
- (c) 1.44 m³ — The cross-section is a triangle, so its area = base × height ÷ 2. Base × height = 1.2 × 0.8 = 0.96 m², and half of that is 0.96 ÷ 2 = 0.48 m². The volume of the prism = cross-sectional area × length = 0.48 × 3 = 1.44 m³. A pupil who forgets to halve when finding the triangle's area gets 1.2 × 0.8 × 3 = 2.88 m³. A pupil who ignores the height altogether, treating the cross-section as base × length, gets 1.2 × 3 = 3.6 m³. A pupil who correctly finds the cross-sectional area but forgets to multiply by the length of the bed stops at 0.48 m³. The correct volume of soil is 1.44 m³.
- (a) 250° — The back bearing (the bearing of A from B) differs from the bearing of B from A by exactly 180°. Because the given bearing, 070°, is less than 180°, add 180°: 070 + 180 = 250°, so the bearing of A from B is 250°. Choosing 180° assumes the back bearing is always exactly 180°, ignoring the original bearing altogether. Choosing 110° comes from subtracting 180° from 070° and dropping the negative sign (070 − 180 = −110) instead of adding 180°. Choosing 160° comes from adding only 90° instead of 180° (070 + 90 = 160).
- (d) 71° — Alternate angles between parallel lines are equal. Since angle HMN and angle MNK are alternate angles, angle MNK = angle HMN = 71°.
- (d) £50 — Area = 1/2 × (3.5 + 6.5) × 4 = 1/2 × 10 × 4 = 20 m². Cost = 20 × £2.50 = £50. (£100 comes from forgetting to halve the trapezium area, giving 40 m² instead of 20 m²; £65 comes from using only the longer parallel side, 6.5 × 4 = 26 m², instead of the trapezium formula; £35 comes from adding all three given lengths, 3.5 + 6.5 + 4, and treating that total as the area in square metres.)
- (a) a line parallel to both, 3 cm from each — Being equidistant from two parallel lines 6 cm apart means being exactly halfway between them all along their length, tracing out a third line, parallel to both, at 3 cm from each — half of the 6 cm gap. "a line parallel to both, 6 cm from each" repeats the full gap instead of halving it, which puts those points past one of the lines entirely. "a circle of radius 3 cm, centred midway" applies to a locus equidistant from a single fixed POINT, not from two parallel lines running the full length. "the perpendicular bisector of the gap" crosses the gap at right angles and meets each line at only one point — it is not the whole locus, which runs parallel to the lines, not across them.
- (d) 6 m — The horizontal distance is adjacent to the 60° angle and the zip-wire is the hypotenuse, so horizontal distance = 12 × cos 60° = 12 × 1/2 = 6 m. 6√3 m comes from using sin 60° = √3/2 instead of cos 60°, which would give the vertical drop, not the horizontal distance. 4√3 m comes from treating 12 as the side adjacent to a tangent ratio and dividing by tan 60° = √3. 24 m comes from dividing 12 by cos 60° instead of multiplying by it.
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (a) Similar, but AAA alone does not prove congruence — Three equal corresponding angles (AAA) show that the two triangles are similar — the same shape — but says nothing about their size, so it does not prove congruence. They could be congruent, or one could simply be an enlargement of the other; without matching side lengths, congruence is not established, so 'congruent because AAA proves congruence' is wrong. Equal angles do not force equal sides — a triangle can be enlarged to any size while keeping the same angles, so that option is also wrong. Something CAN be said here — that the triangles are similar — so 'no relationship can be determined' is wrong too.
- (c) 49.5 m² — Method: the area formula needs two sides and the angle between them, and only sides are given, so find one angle with the cosine rule first and then use the two sides that enclose it. Working: angle ABC lies between AB = 14 m and BC = 9 m, so cos ABC = (14² + 9² − 11²) ÷ (2 × 14 × 9) = (196 + 81 − 121) ÷ 252 = 156 ÷ 252 = 0.61905, giving angle ABC = 51.753° and sin ABC = 0.78535. The area is then 1/2 × 14 × 9 × 0.78535 = 63 × 0.78535 = 49.477. Answer: the area is 49.5 m² to 1 decimal place. The distractors: 60.5 m² comes from using the correct angle at B with the sides 14 m and 11 m, which do not both meet at B, so the angle is no longer the one they enclose; 63.0 m² comes from leaving the sine out and treating the two sides as a base and a perpendicular height; 40.5 m² comes from working out angle BAC = 39.98° instead and using its sine with the sides that meet at B, so that the angle used is not the angle between them.
- (a) 1/3 — Method: since OABC is a parallelogram, B = OA + OC = a + c. M = (1/2)c, since M is the midpoint of OC. Since AN is twice NC, N is 2/3 of the way along AC from A, so N = a + 2/3(c − a) = (1/3)a + (2/3)c. Working: MN = N − M = (1/3)a + (1/6)c, and MB = B − M = a + (1/2)c. Comparing term by term, 1/3 × (a + (1/2)c) = (1/3)a + (1/6)c, which matches MN exactly. Answer: k = 1/3, so M, N and B lie on a straight line. Giving 2/3 instead is the scalar linking N to B (NB = (2/3)MB), not M to N; giving 1/6 is just MN's c-coefficient read off on its own, without comparing it to MB's c-coefficient at all; and giving 3 is the scalar the wrong way up — it is MB that equals 3 × MN, not the other way round, since MN = k × MB was what was asked for. Always match the direction of the scalar to the vectors exactly as the question states them.
- (a) 4700 cm² — Method: split the T-shaped outline into the two rectangles it is made from, find the area of each, then add them together. Working: the wide base gives a rectangle 90 cm × 30 cm = 2700 cm²; the narrower block on top gives a rectangle 40 cm × 50 cm = 2000 cm²; adding these, 2700 + 2000 = 4700 cm². Answer: 4700 cm². The distractors: 2700 cm² comes from finding only the area of the base rectangle and forgetting to add the block on top. 2000 cm² comes from finding only the area of the top block and forgetting the base. 7200 cm² comes from treating the whole outline as one large rectangle, 90 cm wide by (30 + 50) = 80 cm tall, instead of splitting it into the two separate rectangles that actually make up the shape.
- (b) 6 m — Volume of a cuboid = length × width × height, so height = volume ÷ (length × width) = 360 ÷ (12 × 5) = 360 ÷ 60 = 6 m. A pupil who divides the volume by the length only gets 360 ÷ 12 = 30 m. A pupil who divides the volume by the width only gets 360 ÷ 5 = 72 m. A pupil who subtracts length × width from the volume instead of dividing gets 360 − 60 = 300 m. The correct height is 6 m.
Build your own mix at the worksheet builder.