Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A hexagon has interior angles of 130°, 142°, 125°, 150°, 135° and x°. Work out the value of x.
- 2.A landscaper marks out two triangular flower beds using stakes and a tape measure. Bed 1 has two edges of 5 m and 7 m, meeting at a corner with a marked angle of 60° between them. Bed 2 has edges of 5 m and 7 m, meeting at a corner also marked at 60° between them. The landscaper wants to check the two beds will be exactly the same size and shape using only these three measurements. Which condition proves the two beds are congruent?
- 3.A water tank is a cube with edges of length 2 m. Work out how many cubic centimetres the tank holds when it is full.
- 4.A dog is tied by a lead 4 m long to a fixed ring on a straight garden wall. The wall extends much further than the lead can reach in both directions, and the dog cannot cross through it. Describe the region the dog can reach.
- 5.A straight line touches the edge of a circle at exactly one point and does not cross into the circle at all. Write down the term for this line.
- 6.Points A, B, C and D lie on a circle with centre O, in that order around the circle, and AC is a diameter. Which of the following circle facts does NOT apply to this diagram?
- 7.A right-angled triangle has a hypotenuse of 29 cm and one shorter side of 20 cm. Work out the length of the other shorter side.
- 8.Two similar triangles have lengths in the ratio 5 : 8. A side of the smaller triangle is 6.5 cm. Work out the length of the corresponding side of the larger triangle.
- 9.A locus consists of all the points that are the same perpendicular distance from two parallel lines 6 cm apart. Describe this locus.
- 10.e is the column vector with top number 5 and bottom number k. f is the column vector with top number 15 and bottom number 6. Given that f is 3 times e, work out the value of k.
- 11.A sector of a circle has radius 9 cm and angle 120°. Using π = 3.14, work out the arc length of the sector, to 1 decimal place.
- 12.In triangle ABC, angle ABC = 72° and angle ACB = 48°. Side AB = (2x + 1) cm and side AC = (3x − 2) cm. Work out the value of x. Give your answer to 1 decimal place.
- 13.Work out the exact value of tan 30° + tan 30°.
- 14.m is the column vector with top number 3 and bottom number −4. Which of these column vectors is a scalar multiple of m?
- 15.A circular plate has a diameter of 20 cm. Work out the area of the plate. Use π = 3.14.
Answer key
- (c) 38° — The interior angles of a hexagon sum to (6 − 2) × 180° = 720°. 130° + 142° + 125° + 150° + 135° = 682°. x = 720° − 682° = 38°. A student who uses 6 × 180° instead of (6 − 2) × 180°, forgetting to subtract the 2, gets 1080° − 682° = 398°. A student who mis-adds the five given angles as 680° instead of 682° gets x = 720° − 680° = 40°. A student who answers with one of the given angles instead of solving for x might write 142°.
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
- (b) A semicircle of radius 4 m, away from the wall. — Every point the dog can reach is at most 4 m from the fixed ring, so without any wall the region would be a full circle of radius 4 m. The wall runs straight through the ring and blocks the dog from crossing it, and since the wall extends further than the lead in both directions, exactly half of that circle is cut off — leaving a semicircle of radius 4 m on the side of the wall the dog is tied on. (A full circle of radius 4 m ignores that the wall blocks half of the region; a quarter circle of radius 4 m would only be correct if the ring were fixed at a corner where two walls met, not along a single straight wall; a rectangle 4 m wide along the wall ignores that the lead lets the dog swing round in a curve, not stay a fixed distance out from the wall.)
- (d) tangent — A line that touches a circle at exactly one point, without crossing into the circle, is called a tangent. A chord is a straight line joining two points ON the circle, so it touches at two points, not one. A radius runs from the centre to the circle's edge, not along the outside of it. A diameter is a chord that passes through the centre, also touching the circle at two points.
- (c) Tangent-chord angle = angle in the alternate segment. — This diagram has a diameter AC, a centre O, and a cyclic quadrilateral ABCD, but no tangent anywhere in it. 'Angle in a semicircle = 90°' applies directly, because AC is a diameter. 'Opposite angles of a cyclic quadrilateral sum to 180°' applies directly, because ABCD is a cyclic quadrilateral. 'Angle at the centre = twice angle at circumference' applies directly, because O is given as the centre of the circle. The tangent-chord fact relates the angle between a tangent and a chord to an angle elsewhere in the circle, and since this diagram has no tangent, there is nothing in it for that fact to describe — so it is the one theorem that does not apply here.
- (b) 21 cm — By Pythagoras' theorem, the other side = √(29² − 20²) = √(841 − 400) = √441 = 21 cm. "9 cm" comes from subtracting the two given lengths directly, 29 − 20 = 9, instead of subtracting their squares. "441 cm" is the value under the square root sign, correct as far as it goes but with the final square root step left out. "35 cm" comes from adding the squares of the two given lengths instead of subtracting them, √(29² + 20²) = √1241 ≈ 35, treating both given lengths as if they were the two shorter sides rather than a shorter side and the hypotenuse.
- (a) 10.4 cm — The scale factor from the smaller triangle to the larger triangle is 8 ÷ 5 = 1.6, so the larger side is 6.5 × 1.6 = 10.4 cm. The distractor 4.0625 cm comes from using the ratio the wrong way round, 6.5 × 5 ÷ 8 = 4.0625. The distractor 9.5 cm comes from adding the difference between the ratio numbers (8 − 5 = 3) to the given length, 6.5 + 3 = 9.5. The distractor 13 cm comes from doubling the given length, treating the scale factor as 2 instead of 1.6.
- (a) a line parallel to both, 3 cm from each — Being equidistant from two parallel lines 6 cm apart means being exactly halfway between them all along their length, tracing out a third line, parallel to both, at 3 cm from each — half of the 6 cm gap. "a line parallel to both, 6 cm from each" repeats the full gap instead of halving it, which puts those points past one of the lines entirely. "a circle of radius 3 cm, centred midway" applies to a locus equidistant from a single fixed POINT, not from two parallel lines running the full length. "the perpendicular bisector of the gap" crosses the gap at right angles and meets each line at only one point — it is not the whole locus, which runs parallel to the lines, not across them.
- (d) 2 — Method: if f is 3 times e, then each part of f equals 3 times the matching part of e. Working: using the bottom numbers, 6 = 3 × k, so k = 2. Answer: k = 2. A candidate who multiplies instead of dividing, working out 6 × 3, gets 18. A candidate who uses the top numbers' ratio instead, 15 ÷ 5, and gives that ratio as k gets 3. A candidate who adds instead of using the multiple relationship, working out 6 + 3, gets 9.
- (d) 18.8 cm — Arc length is a fraction of the full circumference. Here 120 ÷ 360 = 1/3, and the full circumference is 2 × 3.14 × 9 = 56.52 cm, so the arc is 56.52 ÷ 3 = 18.84 cm, which rounds to 18.8 cm. Forgetting the fraction and giving the full circumference rounds to 56.5 cm. Using 9 cm as a diameter instead of a radius gives an arc of 9.4 cm. Using 120 ÷ 180 instead of 120 ÷ 360 for the fraction gives an arc of 37.7 cm.
- (b) 7.4 — Method: AB is opposite angle ACB and AC is opposite angle ABC, so the sine rule gives AB/sin(ACB) = AC/sin(ABC). Working: (2x + 1)/sin 48° = (3x − 2)/sin 72°; cross-multiplying and collecting the x terms gives x = 7.4. Using angle BAC = 180° − 72° − 48° = 60° in place of angle ABC in the ratio gives x = 4.7; ignoring the sine rule altogether and solving 2x + 1 = 3x − 2 as if the two sides were simply equal gives x = 3.0; and pairing each side with the wrong angle — AB with sin 72° and AC with sin 48° — gives x = 1.9. Each side in the sine rule must be paired with the sine of the angle directly opposite it.
- (a) 2√3/3 — tan 30° = √3/3, so tan 30° + tan 30° = 2 × √3/3 = 2√3/3. √3 comes from wrongly treating tan 30° + tan 30° as tan(30° + 30°) = tan 60° = √3 — adding angles is not the same as adding ratios. √3/3 comes from forgetting to double the value and just writing down tan 30° on its own. 2√3 comes from doubling the numerator of √3/3 but forgetting to keep the denominator of 3.
- (b) (6, −8) — Method: a scalar multiple of m has the same ratio between its top and bottom numbers as m does. Working: m = (3, −4); multiplying both parts by 2 gives 2 × 3 = 6 and 2 × (−4) = −8, so (6, −8) is a scalar multiple of m. Answer: (6, −8). The vector (6, −4) needs a multiplier of 2 for the top number but only 1 for the bottom number, so it is not a multiple. The vector (−6, −8) needs a multiplier of −2 for the top number but 2 for the bottom number, so it is not a multiple. The vector (9, −8) needs a multiplier of 3 for the top number but 2 for the bottom number, so it is not a multiple.
- (a) 314 cm² — Method: the area of a circle is πr², and the radius is half the diameter, so halve the 20 cm before squaring. Working: r = 20 ÷ 2 = 10 cm, so the area is 3.14 × 10² = 3.14 × 100 = 314. Answer: 314 cm². The distractors: 1256 cm² comes from putting the diameter straight into πr² without halving it, 3.14 × 20²; 628 cm² comes from halving correctly but then using 2πr², a mixture of the circumference and area formulae; 62.8 cm² comes from working out πd = 3.14 × 20, which is the circumference of the plate rather than its area.
Build your own mix at the worksheet builder.