Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (a) 615.44 cm² — Method: the surface area of a sphere is 4πr². Square the radius, multiply by π, then multiply by 4. Working: r² = 7² = 49, then 3.14 × 49 = 153.86, then 4 × 153.86 = 615.44. Answer: 615.44 cm². The distractors: 153.86 cm² comes from stopping at πr², which is the area of a flat circle of radius 7 cm and leaves out the factor of 4 that a curved surface needs; 87.92 cm² comes from 4 × 3.14 × 7, using the radius itself where the formula asks for its square; 1436.03 cm³ comes from working out the volume of the ball with (4 ÷ 3) × π × r³ instead of its surface area, which is a different measure and carries a cubic unit.
- (a) 2.40m — Method: a cost found from a rate is the rate multiplied by the amount bought. Working: the rate is £2.40 per kilogram and the amount is m kilograms, so the cost is 2.40 × m. Answer: 2.40m. A candidate who divides the amount by the rate instead of multiplying writes m/2.40. A candidate who adds the rate to the amount instead of multiplying writes 2.40 + m. A candidate who subtracts the rate from the amount instead of multiplying writes m − 2.40.
- (c) 64.4 cm² — Method: with two sides and the angle between them, use Area = (1/2)ab sin C. Working: Area = 1/2 × 15.6 × 8.9 × sin 112° = 64.4 cm² (1 d.p.). Answer: 64.4 cm². Leaving out the 1/2 gives 128.7 cm²; using cos 112° instead of sin 112° gives a negative value, which a candidate who drops the minus sign reads as 26.0 cm²; and squaring one side instead of multiplying the two different given sides together gives 112.8 cm². Sin C is never negative for an angle between 0° and 180°, so a negative area is always a sign that cos was used by mistake — check you used sin before you trust your answer.
- (c) RHS — Both triangles are right-angled, and have equal hypotenuses (13 cm) and one equal corresponding side (5 cm), so they are congruent by the RHS (right angle, hypotenuse, side) condition — the three facts given are exactly a right angle, a hypotenuse and one other side. The distractor SAS would apply if two sides and the angle between those two sides were matched, but the right angle here lies between the 5 cm side and the third side, not between the 5 cm side and the hypotenuse. The distractor SSS needs all three pairs of sides matched, and only two sides of each triangle are given — the third side would first have to be calculated by Pythagoras, so SSS is not the condition the given facts supply. The distractor AAS would need two angles and a non-included side matched, but only one angle in each triangle is given.
- (a) £4.20 — 350 g is 3.5 lots of 100 g, since 350 ÷ 100 = 3.5, so the cost is 3.5 × £1.20 = £4.20. Multiplying the mass in grams directly by the price, without dividing by 100 first, gives £420.00. Working out 100 ÷ 350 instead of 350 ÷ 100 inverts the ratio and gives about £0.34. Rounding 350 g down to 300 g gives 3 × £1.20 = £3.60.
- (d) 1535 cm² — The wiper sweeps out a sector of radius 40 cm, the blade length, through an angle of 110°. Sector area is angle ÷ 360 × π × radius²: 110 ÷ 360 × 3.14 × 1600 = 1535.1 cm², which rounds to 1535 cm². Forgetting to square the radius, using radius instead of radius², gives 38 cm². Using 110 ÷ 180 instead of 110 ÷ 360 for the fraction gives 3070 cm². Treating the 40 cm blade length as a diameter, so using a radius of 20 cm, gives 384 cm².
- (b) 32 cm² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the height. Add the parallel sides: 6 + 10 = 16. Multiply by the height: 16 × 4 = 64. Half of 64 is 32 cm². 64 cm² forgets to halve and just gives (6+10)×4. 8 cm² averages the two parallel sides, (6+10)÷2 = 8, but forgets to multiply by the height. 20 cm² treats it as a triangle using only the longer parallel side as the base: half of 10 × 4.
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
- (a) 32 m — The scale factor from the larger pond to the smaller pond is 4 ÷ 11, so the smaller perimeter is 88 × 4 ÷ 11 = 32 m. The distractor 242 m comes from using the ratio the wrong way round, 88 × 11 ÷ 4 = 242. The distractor 84 m comes from subtracting the smaller ratio number, 88 − 4 = 84, instead of scaling. The distractor 121 m comes from multiplying 11 × 11 = 121, ignoring the given perimeter altogether.
- (c) 5 m — The horizontal distance is the side adjacent to the 60° angle, and the sloping side is the hypotenuse, so horizontal distance = hypotenuse × cos 60°. The exact value of cos 60° is 1/2, so horizontal distance = 10 × 1/2 = 5 m. Using the sloping side itself as the horizontal distance, without using any trigonometry at all, gives 10 m. Using sin 60° = √3/2 instead of cos 60° finds the vertical height of the tent rather than the horizontal distance: 10 × √3/2 = 5√3 = 8.7 m (1 d.p.). Dividing the sloping side by cos 60° instead of multiplying by it, 10 ÷ 0.5 = 20 m, treats the sloping side as though it were the adjacent side rather than the hypotenuse.
- (b) 7 cm — The side opposite the 30° angle is found using sin 30° = opposite/hypotenuse, so opposite = 14 × sin 30° = 14 × 1/2 = 7 cm. 7√3 cm comes from using cos 30° = √3/2 instead of sin 30° (mixing up the opposite and adjacent sides). 14/√3 cm comes from using tan 30° = 1/√3 instead of sin 30°. 28 cm comes from dividing 14 by sin 30° instead of multiplying by it.
- (c) AB, AC and angle BAC: Area = 1/2 × AB × AC × sin(BAC) — Method: Area = 1/2ab sin C only works when the angle used is the one included between the two sides being multiplied. Working: AB and AC meet at A, and angle BAC is the angle at A between them, so the statement pairing AB, AC and angle BAC is the correct one. The statement that three sides with no angle can still go into 1/2 AB × AC × sin(BAC) is wrong: with no angle known, sin(BAC) cannot be evaluated, so a different method must find an angle first. The statement pairing AB and BC with sin(BAC) is wrong: AB and BC meet at B, so the angle between them is angle ABC, not angle BAC — it names the wrong angle for the sides it uses. The statement pairing AB and AC with sin(ABC) is wrong for the same reason: AB and AC meet at A, so their included angle is angle BAC, and angle ABC is not between them at all.
- (d) 7.21 units — Method: the diagonal AC is the hypotenuse of the right-angled triangle ABC, whose shorter sides are AB and BC, so Pythagoras' theorem gives its length. Working: AB runs from (0, 0) to (6, 0), so AB = 6; BC runs from (6, 0) to (6, 4), so BC = 4. Then AC² = 6² + 4² = 36 + 16 = 52, so AC = √52 = 7.2111…, which is 7.21 correct to 2 decimal places. Answer: 7.21 units. The distractors: 10.00 units comes from adding the two sides, 6 + 4, instead of adding their squares and taking the root; 4.47 units comes from subtracting the squares, √(36 − 16), which is the form of Pythagoras used to find a shorter side rather than the hypotenuse; 26.00 units comes from halving 52 in place of taking its square root.
- (c) 460 g — Each division is 20 g, so three divisions past the mark is 3 × 20 = 60 g. Adding this to the 400 g mark gives 400 + 60 = 460 g. Treating each division as worth 1 g instead of 20 g gives 400 + 3 = 403 g. Working out the extra amount correctly but forgetting to add the 400 g mark gives just 60 g. Treating each division as worth 10 g instead of 20 g gives 400 + 30 = 430 g.
Build your own mix at the worksheet builder.