Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 151,200 cm² — First find the area in m²: 4.2 × 3.6 = 15.12 m². To convert m² to cm², multiply by 10,000, since 1 m² = 100 cm × 100 cm = 10,000 cm²: 15.12 × 10,000 = 151,200 cm². 15.12 cm² gives the area in m² without converting the units at all. 1,512 cm² multiplies by 100 instead of 10,000, treating the conversion as if it were for a single length rather than an area. 15,120 cm² multiplies by 1,000 instead of 10,000.
- (a) £94.58 — Method: find the area with 1/2ab sin C, then multiply by the cost per square metre. Working: area = 1/2 × 1.8 × 1.3 × sin 72° = 1.11274 m², so cost = 1.11274 × £85 = £94.58. Leaving out the 1/2 gives an area of 2.22547 m² and a cost of £189.17; using cos 72° instead of sin 72° gives a cost of £30.73; and rounding the area to 1 decimal place (1.1 m²) before multiplying by the cost per square metre gives £93.50, which loses accuracy that the final answer needs. Even rounding to 1.113 m² is enough to shift the cost to £94.61 — keep the unrounded area in your calculator until the very last step.
- (b) Wrong: 1 litre = 1000 ml, so 3.2 l = 3200 ml. — 1 litre = 1000 ml, so 3.2 litres = 3.2 × 1000 = 3200 ml — Sam is wrong because he multiplied by 100 instead of 1000. Saying Sam is correct accepts the wrong multiplier. Saying Sam is wrong only because 3.2 should be rounded first misses the real error, which is the multiplier, not the starting number. Saying '1 litre is 100 ml' misstates the basic fact and blames the wrong part of Sam's working.
- (a) 24 — The display is 4 tins wide, 3 tins high and 2 tins deep, and every position in that block is filled, so the total number of tins is the product of all three measurements: 4 × 3 × 2 = 24. "12" comes from multiplying only the width and height shown in the front elevation (4 × 3), forgetting the depth entirely. "9" comes from adding the three measurements (4 + 3 + 2) instead of multiplying them. "6" comes from multiplying only the height and depth (3 × 2), forgetting the width shown by the front elevation.
- (b) 21.5 km — Method: find angle ABC from the two bearings, then use the cosine rule. Working: the bearing of A from B is 038° + 180° = 218°, so angle ABC = 218° − 142° = 76°. Then AC² = 14² + 20² − 2 × 14 × 20 × cos 76°, so AC = 21.5 km. Leaving out the factor of 2 in the cosine rule gives AC = 23.0 km; using 142° − 38° = 104° as the angle instead of the correct 76° gives AC = 27.0 km; and simply adding the two distances as if the path were a straight line gives 34.0 km. The angle between the two legs must come from the bearings, not from subtracting them directly.
- (c) 155° — Turning clockwise adds to the bearing. Starting on a bearing of 065° and turning clockwise through 90° gives 065° + 90° = 155°. A candidate who instead subtracts, working out 90° − 65° = 25°, has performed the wrong operation, giving 025°. A candidate who turns anticlockwise instead of clockwise works out 065° − 90°, which gives a negative number, and adding 360° to fix this gives 335° — the bearing for turning the other way. A candidate who thinks turning does not change the bearing at all keeps the answer as 065°. The new bearing, turning clockwise, is 155°.
- (b) 124.1° — Method: use the sine rule AB/sin(ACB) = AC/sin(ABC), since AB is opposite angle ACB and AC is opposite angle ABC. Working: sin(ACB) = AB × sin(ABC) / AC = 13 × sin 35° / 9 = 0.8285, which gives angle ACB = 55.9° or its supplement 180 − 55.9 = 124.1°; both of these give a valid triangle, and since angle ACB is obtuse the answer is 124.1°. Reporting the acute solution instead, without checking the word 'obtuse' in the question, gives 55.9°; putting the sides the wrong way round in the ratio, sin(ACB) = 9 × sin 35° / 13, gives 23.4°; and subtracting the acute solution and the given 35° from 180° as if angle ACB were the remaining triangle angle gives 89.1°. A given SSA fact always has two possible angle solutions unless the stem states which one is meant.
- (b) 8.4 cm — Two sides and the angle between them are known, so use the cosine rule: BC² = AB² + AC² − 2 × AB × AC × cos(BAC). Substituting, BC² = 81 + 36 − 45.64 = 71.36. Taking the square root: BC = √71.36 = 8.4 cm (1 d.p.). Leaving out the factor of 2 in the formula gives BC² = 81 + 36 − 22.82 = 94.18, so BC = 9.7 cm. Adding the cosine term instead of subtracting it gives BC² = 81 + 36 + 45.64 = 162.64, so BC = 12.8 cm. Using sin65° in place of cos65° gives BC² = 81 + 36 − 97.88 = 19.12, so BC = 4.4 cm. Keep the factor of 2, subtract the cosine term, and the correct length is 8.4 cm.
- (c) 1 : 300 — First convert both lengths to the same unit: 15 m = 1500 cm. The scale compares 5 cm on the drawing to 1500 cm in real life, so dividing both parts by 5 gives a scale of 1 : 300. A candidate who compares 5 to 15 without converting units gets 1 : 3. A candidate who converts 15 m to 150 cm, using the wrong conversion factor, gets 1 : 30. A candidate who converts 15 m to 15000 cm, again using the wrong conversion factor, gets 1 : 3000. The scale of the drawing is 1 : 300.
- (a) 188.4 cm² — Curved surface area of a cone = πrl. With r = 6 cm, l = 10 cm and π = 3.14, curved surface area = 3.14 × 6 × 10 = 188.4 cm². A student who uses the cylinder's curved surface area formula, 2πrl, instead of the cone's gets 2 × 3.14 × 6 × 10 = 376.8 cm². A student who uses the circle-area formula πr² instead of πrl gets 3.14 × 36 = 113.04 cm². A student who multiplies r × l but leaves out π entirely gets 6 × 10 = 60 cm².
- (c) 25 m — The gardener needs the circumference, since the trim goes around the flower bed. Circumference = πd = 3.14 × 8 = 25.12 m, which rounds to 25 m. A student who mistakes the diameter (8 m) for the radius, then doubles it before multiplying by π, gets 3.14 × 16 = 50.24 m, rounding to 50 m. A student who makes the same mistake but uses the area formula instead of the circumference gets 3.14 × 8² = 200.96 m², rounding to 201. A student who correctly halves the diameter to find the radius (4 m) but then uses πr instead of πd gets 3.14 × 4 = 12.56 m, rounding to 13 m.
- (c) 500 cm² — The area of a triangle is half of base × height. First, base × height = 40 × 25 = 1,000. Half of 1,000 is 500 cm². 1,000 cm² forgets to halve and just gives base × height. 65 cm² adds the base and height together instead of multiplying them. 2,000 cm² doubles base × height instead of halving it.
- (b) 23 — If every position were filled to the full height of 3, the total would be 2 × 4 × 3 = 24 crates. One corner position has only 2 crates instead of 3, one crate short of full height there, so the actual total is 24 − 1 = 23. "24" comes from using the full height everywhere and forgetting the one incomplete corner. "22" comes from removing 2 crates for the incomplete corner instead of the 1 that is actually missing (3 − 2 = 1, not 2). "21" comes from removing all 3 crates at that corner, as though the position were completely empty rather than 2 crates short.
- (b) 18.84 m² — The pond has radius 2.5 m (half of the 5 m diameter), so the outer edge of the path has radius 2.5 + 1 = 3.5 m. Path area = area of outer circle − area of pond = 3.14 × 3.5² − 3.14 × 2.5² = 38.465 − 19.625 = 18.84 m².
- (c) RHS — Both triangles are right-angled, and have equal hypotenuses (13 cm) and one equal corresponding side (5 cm), so they are congruent by the RHS (right angle, hypotenuse, side) condition — the three facts given are exactly a right angle, a hypotenuse and one other side. The distractor SAS would apply if two sides and the angle between those two sides were matched, but the right angle here lies between the 5 cm side and the third side, not between the 5 cm side and the hypotenuse. The distractor SSS needs all three pairs of sides matched, and only two sides of each triangle are given — the third side would first have to be calculated by Pythagoras, so SSS is not the condition the given facts supply. The distractor AAS would need two angles and a non-included side matched, but only one angle in each triangle is given.
Build your own mix at the worksheet builder.