Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) (2/5)a + (3/5)b — Method: OP = OA + AP, and since AP : PB = 3 : 2 splits AB into 5 equal parts, AP is 3/5 of the whole of AB, with AB = b − a. Working: OP = a + 3/5(b − a) = a − (3/5)a + (3/5)b = (2/5)a + (3/5)b. Answer: OP = (2/5)a + (3/5)b. Using the ratio the wrong way round, as though it read AP : PB = 2 : 3, gives (3/5)a + (2/5)b; adding (3/5)b onto the whole of a without subtracting a inside the bracket first gives a + (3/5)b; and treating the ratio as 1 : 1 gives the midpoint, (1/2)a + (1/2)b. Convert the ratio to a fraction of AB measured from A, matching the ORDER the ratio is stated in, and subtract before you scale.
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (b) 21.5 km — Method: find angle ABC from the two bearings, then use the cosine rule. Working: the bearing of A from B is 038° + 180° = 218°, so angle ABC = 218° − 142° = 76°. Then AC² = 14² + 20² − 2 × 14 × 20 × cos 76°, so AC = 21.5 km. Leaving out the factor of 2 in the cosine rule gives AC = 23.0 km; using 142° − 38° = 104° as the angle instead of the correct 76° gives AC = 27.0 km; and simply adding the two distances as if the path were a straight line gives 34.0 km. The angle between the two legs must come from the bearings, not from subtracting them directly.
- (c) 25 m — The gardener needs the circumference, since the trim goes around the flower bed. Circumference = πd = 3.14 × 8 = 25.12 m, which rounds to 25 m. A student who mistakes the diameter (8 m) for the radius, then doubles it before multiplying by π, gets 3.14 × 16 = 50.24 m, rounding to 50 m. A student who makes the same mistake but uses the area formula instead of the circumference gets 3.14 × 8² = 200.96 m², rounding to 201. A student who correctly halves the diameter to find the radius (4 m) but then uses πr instead of πd gets 3.14 × 4 = 12.56 m, rounding to 13 m.
- (c) 460 g — Each division is 20 g, so three divisions past the mark is 3 × 20 = 60 g. Adding this to the 400 g mark gives 400 + 60 = 460 g. Treating each division as worth 1 g instead of 20 g gives 400 + 3 = 403 g. Working out the extra amount correctly but forgetting to add the 400 g mark gives just 60 g. Treating each division as worth 10 g instead of 20 g gives 400 + 30 = 430 g.
- (d) 6 cm — Volume = πr²h, so height = volume ÷ (πr²) = 471 ÷ (3.14 × 25) = 471 ÷ 78.5 = 6 cm. (30 cm comes from dividing by πr instead of πr², missing one factor of the radius; 150 cm comes from dividing by π only, without using r² at all; 24 cm comes from treating the given 5 cm as a diameter and using a radius of 2.5 cm instead.)
- (b) 8 cm — Area = base × height, so height = area ÷ base = 136 ÷ 17 = 8 cm. (16 cm comes from using the triangle formula, thinking area = 1/2 × base × height and so height = 2 × area ÷ base; 2312 cm comes from multiplying the area by the base instead of dividing; 119 cm comes from subtracting the base from the area instead of dividing the area by the base.)
- (b) 8.4 cm — Two sides and the angle between them are known, so use the cosine rule: BC² = AB² + AC² − 2 × AB × AC × cos(BAC). Substituting, BC² = 81 + 36 − 45.64 = 71.36. Taking the square root: BC = √71.36 = 8.4 cm (1 d.p.). Leaving out the factor of 2 in the formula gives BC² = 81 + 36 − 22.82 = 94.18, so BC = 9.7 cm. Adding the cosine term instead of subtracting it gives BC² = 81 + 36 + 45.64 = 162.64, so BC = 12.8 cm. Using sin65° in place of cos65° gives BC² = 81 + 36 − 97.88 = 19.12, so BC = 4.4 cm. Keep the factor of 2, subtract the cosine term, and the correct length is 8.4 cm.
- (b) 7 cm — The side opposite the 30° angle is found using sin 30° = opposite/hypotenuse, so opposite = 14 × sin 30° = 14 × 1/2 = 7 cm. 7√3 cm comes from using cos 30° = √3/2 instead of sin 30° (mixing up the opposite and adjacent sides). 14/√3 cm comes from using tan 30° = 1/√3 instead of sin 30°. 28 cm comes from dividing 14 by sin 30° instead of multiplying by it.
- (d) Two angles and a side: sine rule finds other sides. — Method: match the data you are given to the rule that needs it. Working: the sine rule a/sin A = b/sin B = c/sin C needs a complete angle-side pair to set up its ratio, so the statement that two angles and a side (AAS or ASA) let the sine rule find the other sides is the correct one — the third angle comes from the angle sum, and each unknown side is then opposite a known angle. The statement that two sides and the angle between them (SAS) call for the sine rule is wrong: no angle-side pair is complete, so the cosine rule is what works there. The statement that the sine rule finds any angle from three sides (SSS) is wrong for the same reason in reverse — no angle is known at all, so the cosine rule must find the first one. The statement that the cosine rule finds a missing angle directly from two sides and a non-included angle (SSA) is wrong: the cosine rule reports the angle enclosed by the two sides it uses, so with SSA it is the sine rule that reaches the missing angle, and the ambiguous case is then settled from the wording of the question.
- (c) It is a parallelogram but not a rectangle — Method: match the given properties to the definition of each named quadrilateral. Working: having both pairs of opposite sides parallel and equal in length is exactly the definition of a parallelogram; since none of the angles are right angles, it cannot also be a rectangle, which needs four right angles. Options: 'must be a rectangle' wrongly assumes every parallelogram has right angles; 'must be a rhombus' wrongly assumes equal opposite sides means all four sides are equal, but only the opposite pairs are stated as equal here; 'trapezium' is wrong because a trapezium has exactly one pair of parallel sides, while this shape has two pairs, so it is a parallelogram and not a trapezium. Answer: it is a parallelogram but not a rectangle.
- (b) 8.5 m — First apply the scale to convert the plan length to a real length in centimetres: 3.4 × 250 = 850 cm. Then convert centimetres to metres by dividing by 100: 850 ÷ 100 = 8.5, so the wall is 8.5 m long. Choosing 850 m applies the scale correctly but forgets to convert the answer from centimetres into metres. Choosing 0.85 m divides by 1000 instead of 100, confusing the centimetre-to-metre conversion with a metre-to-kilometre one. Choosing 3.4 m ignores the scale factor completely and just restates the plan length as if it were already the real length.
- (d) 183.1 m² — Method: the diagonal AC splits the field into two triangles; find each triangle's area with 1/2ab sin C using AC as a side in both, then add the two areas. Working: area of triangle ABC = 1/2 × 14 × 20 × sin 35° = 80.3 m²; area of triangle ACD = 1/2 × 16 × 20 × sin 40° = 102.8 m²; total area = 80.3 + 102.8 = 183.1 m². Ignoring the diagonal AC completely and using AB, AD and the combined angle 35° + 40° = 75° as if it were one triangle gives 108.2 m²; averaging the two triangle areas instead of adding them gives 91.6 m²; and reporting only the area of triangle ABC, forgetting triangle ACD entirely, gives 80.3 m². A diagonal that splits a quadrilateral into two triangles means both areas must be added, using the diagonal as a side of each.
- (d) 46.2 cm — The perimeter of a sector is the arc length plus its two straight radii. The circumference is 2 × 3.14 × 10 = 62.8 cm, and the arc is 150 ÷ 360 of that: 62.8 × 150 ÷ 360 = 26.2 cm (1 d.p.). Adding the two radii, 26.2 + 10 + 10 = 46.2 cm. Giving just the arc length, without adding the straight edges, gives 26.2 cm. Adding only ONE radius instead of two gives 36.2 cm. Using 150 ÷ 180 instead of 150 ÷ 360 for the fraction gives an arc of 52.3 cm and a perimeter of 72.3 cm.
- (a) 3 — Method: find the sail's area with Area = (1/2)ab sin C, then divide by how much one litre covers, and round up to a whole number of tins since paint can only be bought by the tin. Working: Area = 1/2 × 4.2 × 3.6 × sin 115° = 6.85 m² (2 d.p.); 6.85 ÷ 3 = 2.28 tins, which rounds up to 3 tins. Answer: 3. Rounding 2.28 to the nearest whole number instead of rounding up gives 2, which is not enough paint to finish the sail; forgetting the 1/2 in the area formula gives an area of 13.7 m², needing 5 tins; and assuming one litre covers exactly 1 m² of sail, ignoring the coverage rate given, rounds the area itself up to 7 tins. Whenever a quantity can only be bought in whole units, round up even when the decimal part is small — 2.28 tins means you need a third tin.
Build your own mix at the worksheet builder.