Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 82.8° — Method: angle ABC is opposite the given side AC, so rearrange the cosine rule to cos B = (AB² + BC² − AC²) / (2 × AB × BC). Working: cos B = (3.5² + 2.8² − 4.2²) / (2 × 3.5 × 2.8), so angle ABC = 82.8°. Forgetting the negative sign in the rearrangement gives the supplementary angle 97.2°; leaving out the factor of 2 in the denominator gives 75.5°; and using AB and AC (the pair either side of angle A, not angle B) gives 41.4°, which is angle BAC, not angle ABC. Always check which angle sits opposite the side you left out of the pair you are dividing by.
- (d) Two angles and a side: sine rule finds other sides. — Method: match the data you are given to the rule that needs it. Working: the sine rule a/sin A = b/sin B = c/sin C needs a complete angle-side pair to set up its ratio, so the statement that two angles and a side (AAS or ASA) let the sine rule find the other sides is the correct one — the third angle comes from the angle sum, and each unknown side is then opposite a known angle. The statement that two sides and the angle between them (SAS) call for the sine rule is wrong: no angle-side pair is complete, so the cosine rule is what works there. The statement that the sine rule finds any angle from three sides (SSS) is wrong for the same reason in reverse — no angle is known at all, so the cosine rule must find the first one. The statement that the cosine rule finds a missing angle directly from two sides and a non-included angle (SSA) is wrong: the cosine rule reports the angle enclosed by the two sides it uses, so with SSA it is the sine rule that reaches the missing angle, and the ambiguous case is then settled from the wording of the question.
- (b) 320.3 cm³ — Cylinder volume = πr²h = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6 cm³. Cone volume = (1/3)πr²h = (1/3) × 3.14 × 9 × 4 = (1/3) × 113.04 = 37.68 cm³. Total = 282.6 + 37.68 = 320.28 cm³, which rounds to 320.3 cm³.
- (d) £48 — Scale factor = new width ÷ original width = 40 ÷ 10 = 4. Poster height = 15 × 4 = 60 cm. Cost = 60 × £0.80 = £48. (£12 comes from forgetting to scale the height at all, and pricing the original 15 cm height; £15.20 comes from adding the scale factor 4 to the height instead of multiplying by it; £3 comes from dividing the height by the scale factor instead of multiplying by it.)
- (a) 104° — Method: find each inscribed angle separately using the angle-at-the-centre theorem: for a point on the arc NOT cut off by the given central angle, halve that central angle; for a point on the OTHER arc, halve the REFLEX central angle instead; then subtract the smaller from the larger. Working: for C on the major arc, angle ACB = 76 ÷ 2 = 38 degrees. For D on the minor arc, D sees the reflex angle at the centre, 360 − 76 = 284 degrees, so angle ADB = 284 ÷ 2 = 142 degrees. The difference is 142 − 38 = 104 degrees. Answer: 104°. Both inscribed angles need the theorem applied separately, using the correct arc's central angle each time (the reflex angle for D), and the question asks for the DIFFERENCE between the two, not either angle on its own and not their sum, 180°, which is simply the opposite-angle total for the cyclic quadrilateral ACBD.
- (b) Wrong: 1 litre = 1000 ml, so 3.2 l = 3200 ml. — 1 litre = 1000 ml, so 3.2 litres = 3.2 × 1000 = 3200 ml — Sam is wrong because he multiplied by 100 instead of 1000. Saying Sam is correct accepts the wrong multiplier. Saying Sam is wrong only because 3.2 should be rounded first misses the real error, which is the multiplier, not the starting number. Saying '1 litre is 100 ml' misstates the basic fact and blames the wrong part of Sam's working.
- (d) No transformation — every point stays exactly where it was — The two vectors (5, −3) and (−5, 3) are opposites, so adding them gives (0, 0): every point ends up exactly where it started, and there is no transformation at all. Misreading the second vector's signs and effectively adding (5, −3) to itself instead of to its opposite gives a translation by the vector (10, −6). Assuming two translations must combine into a reflection gives a reflection in the x-axis — but a reflection reverses orientation, and translations never do. Assuming that two opposite vectors must mean a half turn gives a rotation of 180° about the origin — but a 180° rotation moves every point except its own centre, whereas this pair of translations leaves every single point exactly where it was. Two translations by opposite vectors always cancel exactly, leaving every point unmoved.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (d) Triangle 2, by 3.6 cm² — Method: find both areas with 1/2ab sin C, then compare them. Working: area of triangle 1 = 1/2 × 10 × 13 × sin 64° = 58.4 cm²; area of triangle 2 = 1/2 × 11 × 12 × sin 70° = 62.0 cm²; triangle 2 is larger, by 62.0 − 58.4 = 3.6 cm². Getting the right difference but naming triangle 1 as the larger one, the subtraction done the wrong way round, gives 'Triangle 1, by 3.6 cm²'; leaving out the 1/2 when finding triangle 1's area (giving 116.8 cm² instead of 58.4 cm²) and then subtracting gives 'Triangle 1, by 54.8 cm²'; and using cos 64° instead of sin 64° for triangle 1 (giving 28.5 cm² instead of 58.4 cm²) gives 'Triangle 2, by 33.5 cm²'. Work out both areas fully and correctly before comparing which is bigger.
- (b) 72 000 cm³ — Cross-sectional area = 1/2 × 40 × 30 = 600 cm². Volume = cross-sectional area × length = 600 × 120 = 72 000 cm³. (144 000 cm³ comes from forgetting the 1/2 in the triangle's area, using 40 × 30 as the cross-section; 36 000 cm³ comes from halving the correct volume again, as if the 1/2 applied a second time; 720 cm³ comes from adding the cross-sectional area and the length, 600 + 120, instead of multiplying them.)
- (d) 4.6 cm — Method: BC is opposite the 30° angle and AC is next to it, so the ratio that links the two is tan θ = opposite ÷ adjacent. Working: tan 30° = BC ÷ 8, so BC = 8 × tan 30° = 4.6188…, which is 4.6 to 1 decimal place. Answer: 4.6 cm. The distractors: 13.9 cm comes from dividing by tan 30° instead of multiplying by it; 4.0 cm comes from using sin 30°, which treats the 8 cm side as the hypotenuse when it is the side next to the 30° angle; 6.9 cm comes from using cos 30° in place of tan 30°, which gives the wrong pair of sides.
- (c) 11.2 cm — Method: two angles and a side are given, so use the sine rule, a/sin A = b/sin B = c/sin C, taking care that each side is paired with the angle it faces. Working: BC faces angle BAC = 42°, and AC faces angle ABC = 63°, so AC/sin 63° = 8.4/sin 42°. Multiplying up, AC = 8.4 × sin 63° ÷ sin 42° = 7.4845 ÷ 0.6691 = 11.185. Answer: AC = 11.2 cm to 1 decimal place. The distractors: 6.3 cm comes from writing the ratio upside down, 8.4 × sin 42° ÷ sin 63°, which pairs each side with the angle beside it rather than the angle opposite it; 12.1 cm comes from using the third angle, 180° − 42° − 63° = 75°, in the numerator, which gives the length of AB instead of AC; 12.6 cm comes from assuming the sides are in the same ratio as the angles and working out 8.4 × 63 ÷ 42, which is true for arcs of a circle but never for the sides of a triangle.
- (b) $\binom{-0.4}{-7}$ — The overall movement is the sum of the two vectors: (−1.2 + 0.8, −4.5 + (−2.5)) = (−0.4, −7). '$\binom{-2}{-2}$' comes from subtracting the second vector from the first instead of adding them. '$\binom{-0.4}{7}$' gets the top number right but drops the negative sign on the bottom number. '$\binom{2}{-7}$' comes from treating −1.2 + 0.8 as if the signs did not matter, giving +2 instead of −0.4.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
- (d) 63.6 — Method: the three angles inside the triangle formed by the two ladders and the ground add up to 180°. Working: 180 − 58.2 − 58.2 = 63.6. Answer: 63.6°. A candidate who assumes the top angle equals the base angles gives 58.2. A candidate who subtracts only one base angle from 180°, working out 180 − 58.2, gets 121.8. A candidate who doubles the base angle instead of subtracting it twice from 180°, working out 2 × 58.2, gets 116.4.
Build your own mix at the worksheet builder.