Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 17.71 m — The perimeter is the two long sides (5 m + 5 m = 10 m) plus the one remaining short side (3 m) plus the curved semicircular edge. The 3 m side is the diameter of the semicircle, so its radius is 3 ÷ 2 = 1.5 m and the curved length is half the circumference: (1/2) × 2 × 3.14 × 1.5 = 4.71 m. Total: 10 + 3 + 4.71 = 17.71 m.
- (d) (11, 0.75) — Add the moves to the starting point one component at a time. x: 12.5 + (−3.75) + 2.25 = 11; y: −4.25 + 6.5 + (−1.5) = 0.75, giving (11, 0.75). (8.75, 2.25) stops after the first move only and never applies the second vector. (6.5, 3.75) comes from subtracting the second vector instead of adding it. (0.75, 11) comes from swapping the final x-coordinate and y-coordinate.
- (d) (2/5)a + (3/5)b — Method: OP = OA + AP, and since AP : PB = 3 : 2 splits AB into 5 equal parts, AP is 3/5 of the whole of AB, with AB = b − a. Working: OP = a + 3/5(b − a) = a − (3/5)a + (3/5)b = (2/5)a + (3/5)b. Answer: OP = (2/5)a + (3/5)b. Using the ratio the wrong way round, as though it read AP : PB = 2 : 3, gives (3/5)a + (2/5)b; adding (3/5)b onto the whole of a without subtracting a inside the bracket first gives a + (3/5)b; and treating the ratio as 1 : 1 gives the midpoint, (1/2)a + (1/2)b. Convert the ratio to a fraction of AB measured from A, matching the ORDER the ratio is stated in, and subtract before you scale.
- (a) £4.20 — 350 g is 3.5 lots of 100 g, since 350 ÷ 100 = 3.5, so the cost is 3.5 × £1.20 = £4.20. Multiplying the mass in grams directly by the price, without dividing by 100 first, gives £420.00. Working out 100 ÷ 350 instead of 350 ÷ 100 inverts the ratio and gives about £0.34. Rounding 350 g down to 300 g gives 3 × £1.20 = £3.60.
- (a) 33 — Method: total crates = (number of floor positions that actually have crates on them) × (the stack height). Working: there are 4 × 3 = 12 floor positions in the whole arrangement, but one corner position is left empty, leaving 11 filled positions; each filled position is stacked 3 crates high, so 11 × 3 = 33. Answer: 33. The distractors: 36 comes from forgetting to remove the empty corner and using all 12 positions (12 × 3). 35 comes from removing only one crate for the empty corner instead of the full stack of 3 (36 − 1). 11 comes from counting the filled floor positions and stopping there, forgetting that each one carries a stack 3 crates high.
- (b) 72 000 cm³ — Cross-sectional area = 1/2 × 40 × 30 = 600 cm². Volume = cross-sectional area × length = 600 × 120 = 72 000 cm³. (144 000 cm³ comes from forgetting the 1/2 in the triangle's area, using 40 × 30 as the cross-section; 36 000 cm³ comes from halving the correct volume again, as if the 1/2 applied a second time; 720 cm³ comes from adding the cross-sectional area and the length, 600 + 120, instead of multiplying them.)
- (d) 13 cm — Use Pythagoras' theorem in three dimensions: for a cuboid with edges a, b and c the space diagonal d satisfies d² = a² + b² + c². Substitute a = 3, b = 4, c = 12: d² = 3² + 4² + 12² = 9 + 16 + 144 = 169. Take the square root: d = √169 = 13 cm. Adding the three edges directly, 3 + 4 + 12 = 19 cm, ignores that Pythagoras' theorem is about squares, not lengths, and gives 19 cm. Stopping after squaring and adding, without taking the square root, leaves 169 cm — the squared length, not the length itself. Using only the 4 cm and 12 cm edges finds the diagonal of one face, √(4² + 12²) = √160 = 12.6 cm (1 d.p.), and leaves out the third dimension entirely.
- (c) 100.5 m — The curved part of a semicircular bend is half of a full circle's circumference. The full circumference would be 2 × 3.14 × 32 = 200.96 m, and half of that is 200.96 ÷ 2 = 100.48 m, which rounds to 100.5 m. Choosing 201.0 m uses the FULL circumference, forgetting to halve it for a semicircle. Choosing 50.2 m halves the radius as well as taking a semicircle, using 3.14 × 16 = 50.24 m instead of the correct radius of 32 m. Choosing 64.0 m uses the diameter, 2 × 32 = 64, as if it were the curved length, ignoring π and the semicircle shape entirely.
- (d) 1535 cm² — The wiper sweeps out a sector of radius 40 cm, the blade length, through an angle of 110°. Sector area is angle ÷ 360 × π × radius²: 110 ÷ 360 × 3.14 × 1600 = 1535.1 cm², which rounds to 1535 cm². Forgetting to square the radius, using radius instead of radius², gives 38 cm². Using 110 ÷ 180 instead of 110 ÷ 360 for the fraction gives 3070 cm². Treating the 40 cm blade length as a diameter, so using a radius of 20 cm, gives 384 cm².
- (c) 40.5 kg — Since the statues are made from the same material, mass is proportional to volume, which scales with the cube of the length scale factor. The length scale factor is 45 ÷ 30 = 1.5, so the volume (and mass) scale factor is 1.5³ = 3.375. The larger statue's mass is 12 × 3.375 = 40.5 kg. 18 kg comes from multiplying by the length factor 1.5 directly. 27 kg comes from using the area scale factor 1.5² = 2.25 instead of the volume scale factor. 54 kg comes from treating 'cubed' as 'multiplied by 3', giving 1.5 × 3 = 4.5 instead of 1.5³.
- (a) 75° — The three angles in the triangle formed by the two supports and the ground add up to 180°. Two of the angles are 34° and 71°, so the third angle is 180 − 34 − 71 = 75, which is 75°. 105° comes from adding the two given angles together instead of subtracting them from 180° (34 + 71 = 105). 146° comes from computing 180 − 34 = 146 and forgetting to also subtract 71°. 37° comes from subtracting the two given angles from each other instead of using the triangle's angle sum (71 − 34 = 37).
- (d) 8.8 — Method: substitute into the cosine rule BC² = AB² + AC² − 2 × AB × AC × cos(BAC) and solve the resulting quadratic in x, keeping only the positive root. Working: 15² = x² + (x + 2)² − 2x(x + 2) cos 100°, which expands to a quadratic with two roots, x = 8.8 and x = −10.8; since x is a length, x = 8.8. Expanding (x + 2)² as x² + 4 instead of x² + 4x + 4, missing the middle term, gives x = 9.6; using +2x(x + 2) cos 100° instead of −2x(x + 2) cos 100° (a sign error on the cosine term) gives x = 10.6; and reporting the size of the rejected negative root instead of discarding it gives x = 10.8. Always expand a squared bracket fully before collecting terms.
- (d) 1 kg — First find the total mass in grams: 4 × 250 = 1000 g. Then convert to kilograms by dividing by 1000: 1000 ÷ 1000 = 1 kg. Finding the correct total in grams but forgetting to divide by 1000 gives 1000 kg. Adding the number of packs to the pack mass instead of multiplying, 4 + 250 = 254 g, gives 0.254 kg. Dividing the pack mass by the number of packs instead of multiplying, 250 ÷ 4 = 62.5 g, gives 0.0625 kg.
- (c) 22.3 km — The bearing of E from D is 065°, so the bearing of D from E (the back bearing) is 065° + 180° = 245°. The bearing of F from E is 165°, so the angle at E between ED and EF is 245° − 165° = 80°. Using the cosine rule, DF² = DE² + EF² − 2 × DE × EF × cos(80°) = 14² + 20² − 2 × 14 × 20 × cos(80°) = 196 + 400 − 560 × cos(80°). Since cos(80°) ≈ 0.17365, 560 × cos(80°) ≈ 97.24, so DF² ≈ 596 − 97.24 = 498.76. Taking the square root, DF ≈ 22.333, which rounds to 22.3 km. 26.3 km comes from using 100° as the angle at E — the difference between the two given bearings taken directly (165° − 65°) without converting to the back bearing first. 498.8 km is DF² itself, rounded, with the square root never taken. 23.4 km comes from leaving out the factor of 2 in the cosine rule formula, computing DF² = 196 + 400 − 14 × 20 × cos(80°) ≈ 547.38 instead.
- (d) 4.6 cm — Method: BC is opposite the 30° angle and AC is next to it, so the ratio that links the two is tan θ = opposite ÷ adjacent. Working: tan 30° = BC ÷ 8, so BC = 8 × tan 30° = 4.6188…, which is 4.6 to 1 decimal place. Answer: 4.6 cm. The distractors: 13.9 cm comes from dividing by tan 30° instead of multiplying by it; 4.0 cm comes from using sin 30°, which treats the 8 cm side as the hypotenuse when it is the side next to the 30° angle; 6.9 cm comes from using cos 30° in place of tan 30°, which gives the wrong pair of sides.
Build your own mix at the worksheet builder.