Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 45° — Method: the tower, the ground and the line of sight form a right-angled triangle in which the 25 m height is opposite the angle of elevation and the 25 m along the ground is adjacent to it, so use tan θ = opposite ÷ adjacent. Working: tan θ = 25 ÷ 25 = 1, so θ = tan⁻¹(1). Answer: 45°. The distractors: 90° comes from using sin θ = 25 ÷ 25 = 1, which treats the 25 m along the ground as the hypotenuse when it is the side next to the angle; 1° comes from writing down the value of tan θ as though it were the angle itself; 50° comes from adding the two given lengths, 25 + 25, instead of comparing them.
- (c) 151,200 cm² — First find the area in m²: 4.2 × 3.6 = 15.12 m². To convert m² to cm², multiply by 10,000, since 1 m² = 100 cm × 100 cm = 10,000 cm²: 15.12 × 10,000 = 151,200 cm². 15.12 cm² gives the area in m² without converting the units at all. 1,512 cm² multiplies by 100 instead of 10,000, treating the conversion as if it were for a single length rather than an area. 15,120 cm² multiplies by 1,000 instead of 10,000.
- (d) 1 kg — First find the total mass in grams: 4 × 250 = 1000 g. Then convert to kilograms by dividing by 1000: 1000 ÷ 1000 = 1 kg. Finding the correct total in grams but forgetting to divide by 1000 gives 1000 kg. Adding the number of packs to the pack mass instead of multiplying, 4 + 250 = 254 g, gives 0.254 kg. Dividing the pack mass by the number of packs instead of multiplying, 250 ÷ 4 = 62.5 g, gives 0.0625 kg.
- (d) 46.2 cm — The perimeter of a sector is the arc length plus its two straight radii. The circumference is 2 × 3.14 × 10 = 62.8 cm, and the arc is 150 ÷ 360 of that: 62.8 × 150 ÷ 360 = 26.2 cm (1 d.p.). Adding the two radii, 26.2 + 10 + 10 = 46.2 cm. Giving just the arc length, without adding the straight edges, gives 26.2 cm. Adding only ONE radius instead of two gives 36.2 cm. Using 150 ÷ 180 instead of 150 ÷ 360 for the fraction gives an arc of 52.3 cm and a perimeter of 72.3 cm.
- (b) £157 — Method: round the hours worked up to the next whole hour, multiply by the hourly rate, then add the call-out fee. Working: 3 hours 30 minutes rounds up to 4 hours; 28 × 4 = 112; 112 + 45 = 157. Answer: £157. A candidate who uses the unrounded time of 3.5 hours, working out 28 × 3.5 = 98 and adding 45, gets £143. A candidate who forgets the call-out fee, giving only 28 × 4, gets £112. A candidate who rounds down to 3 hours instead of up, working out 28 × 3 = 84 and adding 45, gets £129.
- (a) 89.6° — Angle PQR is at vertex Q, so the side opposite it is PR = 13 cm. Using the cosine rule rearranged for an angle: cos(PQR) = (121 + 49 − 169) ÷ (2 × 11 × 7) = 1 ÷ 154 = 0.0065. Taking the inverse cosine, angle PQR = 89.6° (1 d.p.). Using PR as one of the enclosing sides instead of as the opposite side, finding angle P instead of angle Q, gives (121 + 169 − 49) ÷ (2 × 11 × 13) = 241 ÷ 286 = 0.8427, and angle = 32.6°. Swapping the sign inside the bracket, computing 169 − 121 − 49 instead, gives −1 ÷ 154 = −0.0065, and angle = 90.4°. Using PR in the denominator instead of QR gives (121 + 49 − 169) ÷ (2 × 11 × 13) = 1 ÷ 286 = 0.0035, and angle = 89.8°. Keep PR as the opposite side, QR and PQ as the enclosing sides, and angle PQR comes to 89.6°.
- (a) 151 cm³ — Volume of the cone = 1/3 × 3.14 × 3² × 10 = 94.2 cm³. Volume of the hemisphere = 1/2 × (4/3 × 3.14 × 3³) = 1/2 × 113.04 = 56.52 cm³. Total volume = 94.2 + 56.52 = 150.72 cm³, which rounds to 151 cm³. A student who uses a full sphere instead of a hemisphere gets 94.2 + 113.04 = 207.24 cm³, rounding to 207. A student who uses a cylinder instead of a cone for the base, forgetting the 1/3, gets 3.14 × 3² × 10 = 282.6 cm³, plus the hemisphere's 56.52 cm³, totalling 339.12 cm³, rounding to 339.
- (b) 10.5 m² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the width. Add the parallel sides: 2.5 + 4.5 = 7. Multiply by the width: 7 × 3 = 21. Half of 21 is 10.5 m². 21 m² forgets to halve, using the full (2.5+4.5)×3. 3.5 m² averages the two parallel sides, (2.5+4.5)÷2 = 3.5, but forgets to multiply by the width. 6.75 m² treats the bed as a triangle, using only the longer parallel side: half of 4.5 × 3.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (b) No — should divide by −2bc, not +2bc; sign is wrong. — Method: rearrange a² = b² + c² − 2bc cos A step by step and compare with the student's version. Working: subtracting b² + c² from both sides gives a² − b² − c² = −2bc cos A, then dividing both sides by −2bc gives cos A = (a² − b² − c²) / (−2bc), which is the same as cos A = (b² + c² − a²) / (2bc). The student divided by +2bc instead of −2bc, so their expression is the negative of the correct one — the verdict is No. Saying the algebra is fine because 'either sign order gives a valid result' ignores that only one of the two signed expressions matches the original equation. Saying the denominator should be bc rather than 2bc is a different, unrelated error — the coefficient 2bc in the original formula is correct and must stay.
- (b) 32 cm² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the height. Add the parallel sides: 6 + 10 = 16. Multiply by the height: 16 × 4 = 64. Half of 64 is 32 cm². 64 cm² forgets to halve and just gives (6+10)×4. 8 cm² averages the two parallel sides, (6+10)÷2 = 8, but forgets to multiply by the height. 20 cm² treats it as a triangle using only the longer parallel side as the base: half of 10 × 4.
- (d) 310 — Method: since both turns are clockwise, add both angles to the starting bearing. Working: 245° + 50° = 295°; 295° + 15° = 310°. A student who answers 295 has only added the first turn and forgotten the second one. A student who answers 180 has subtracted both turns instead of adding them. A student who answers 320 has added the two turns as 75° instead of 65° by misreading the second turn. Answer: 310°.
- (d) 110.1° — Method: the largest angle in any triangle faces the longest side, so identify that angle first and then use the cosine rule rearranged as cos A = (b² + c² − a²) ÷ 2bc. Working: the longest side is AC = 12.8 cm, which is faced by angle ABC, and the two sides meeting at B are 6.4 cm and 9.1 cm, so cos ABC = (6.4² + 9.1² − 12.8²) ÷ (2 × 6.4 × 9.1) = (40.96 + 82.81 − 163.84) ÷ 116.48 = −40.07 ÷ 116.48 = −0.34401. A negative cosine means an obtuse angle, and the inverse cosine of −0.34401 is 110.12°. Answer: the largest angle is 110.1° to 1 decimal place. The distractors: 28.0° is the angle facing the shortest side, chosen by a candidate who thinks the largest angle sits opposite the smallest side; 69.9° comes from dropping the minus sign and using cos = 0.34401, which turns the obtuse angle into its supplement; 81.4° comes from assuming the angles share out 180° in the same ratio as the sides, 180 × 12.8 ÷ 28.3, which is not how a triangle behaves.
- (d) (11, 0.75) — Add the moves to the starting point one component at a time. x: 12.5 + (−3.75) + 2.25 = 11; y: −4.25 + 6.5 + (−1.5) = 0.75, giving (11, 0.75). (8.75, 2.25) stops after the first move only and never applies the second vector. (6.5, 3.75) comes from subtracting the second vector instead of adding it. (0.75, 11) comes from swapping the final x-coordinate and y-coordinate.
Build your own mix at the worksheet builder.