Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 1.5 — The area scale factor is the length scale factor squared, so if n is the length factor, n² = 2.25. Taking the positive square root gives n = 1.5 (check: 1.5² = 2.25). 2.25 is just the area factor restated, with no root taken. 1.125 comes from halving 2.25 instead of taking its square root. 5.0625 comes from squaring 2.25 instead of rooting it.
- (a) 24 — The display is 4 tins wide, 3 tins high and 2 tins deep, and every position in that block is filled, so the total number of tins is the product of all three measurements: 4 × 3 × 2 = 24. "12" comes from multiplying only the width and height shown in the front elevation (4 × 3), forgetting the depth entirely. "9" comes from adding the three measurements (4 + 3 + 2) instead of multiplying them. "6" comes from multiplying only the height and depth (3 × 2), forgetting the width shown by the front elevation.
- (a) 5.9 — The real length is 9.8 × 60 = 588 cm. Converting to metres, by dividing by 100, gives 5.88 m, which rounds to 5.9 m to 1 decimal place. A candidate who rounds 5.88 down instead of up gets 5.8 m. A candidate who forgets to convert from centimetres to metres gets 58.8. A candidate who divides by 60 instead of multiplying gets 0.16, to 2 decimal places. The real length, to 1 decimal place, is 5.9 m.
- (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
- (a) 33 — Method: total crates = (number of floor positions that actually have crates on them) × (the stack height). Working: there are 4 × 3 = 12 floor positions in the whole arrangement, but one corner position is left empty, leaving 11 filled positions; each filled position is stacked 3 crates high, so 11 × 3 = 33. Answer: 33. The distractors: 36 comes from forgetting to remove the empty corner and using all 12 positions (12 × 3). 35 comes from removing only one crate for the empty corner instead of the full stack of 3 (36 − 1). 11 comes from counting the filled floor positions and stopping there, forgetting that each one carries a stack 3 crates high.
- (c) 152.2 cm² — Method: find the area of one of the 5 isosceles triangles with 1/2ab sin C, then multiply by 5 for the whole pentagon. Working: one triangle has area 1/2 × 8 × 8 × sin 72° = 30.4338 cm², so the pentagon's area = 5 × 30.4338 = 152.2 cm² — keep the unrounded triangle area, since 5 × 30.4 would give 152.0. Reporting the area of a single triangle and forgetting to multiply by 5 gives 30.4 cm²; multiplying by 6 instead of 5, as for a hexagon, gives 182.6 cm²; and leaving out the 1/2 from each triangle before multiplying by 5 gives 304.3 cm². A regular pentagon splits into exactly 5 triangles at its centre, each with a 72° angle, since 360° ÷ 5 = 72°.
- (c) 62.9 cm² — Method: no two sides are given, so first find AC with the sine rule, then find the area using BC, AC and the angle between them, angle ACB. Working: angle BAC = 180° − 58° − 47° = 75°; by the sine rule, AC = 14 × sin 58° / sin 75° = 12.2915 cm; then area = 1/2 × 14 × 12.2915 × sin 47° = 62.9 cm² — keep the unrounded AC, since rounding it to 12.3 cm shifts the area to 63.0 cm². Pairing 14 with sin 75° and dividing by sin 58° instead (the ratio the wrong way round) gives AC = 15.9 cm and an area of 81.6 cm²; using angle BAC = 75° as the included angle instead of angle ACB gives 83.1 cm²; and assuming the triangle is isosceles with AC = BC = 14 cm, skipping the sine rule step entirely, gives 71.7 cm². The angle used in the area formula must be the one between the two sides being multiplied — here that is angle ACB, between BC and AC.
- (d) (2/5)a + (3/5)b — Method: OP = OA + AP, and since AP : PB = 3 : 2 splits AB into 5 equal parts, AP is 3/5 of the whole of AB, with AB = b − a. Working: OP = a + 3/5(b − a) = a − (3/5)a + (3/5)b = (2/5)a + (3/5)b. Answer: OP = (2/5)a + (3/5)b. Using the ratio the wrong way round, as though it read AP : PB = 2 : 3, gives (3/5)a + (2/5)b; adding (3/5)b onto the whole of a without subtracting a inside the bracket first gives a + (3/5)b; and treating the ratio as 1 : 1 gives the midpoint, (1/2)a + (1/2)b. Convert the ratio to a fraction of AB measured from A, matching the ORDER the ratio is stated in, and subtract before you scale.
- (b) 13.3 cm — The apex is directly above the centre of the square base, so the height, half the base diagonal, and a slant edge form a right-angled triangle with the slant edge as the hypotenuse. Half the base diagonal is 14 ÷ 2 = 7 cm. Using Pythagoras' theorem, height = √(15² − 7²) = √(225 − 49) = √176 = 13.3 cm (1 d.p.). Using the slant edge itself as the height, without applying Pythagoras' theorem at all, gives 15 cm. Using the full base diagonal (14 cm) instead of half of it gives √(15² − 14²) = √(225 − 196) = √29 = 5.4 cm (1 d.p.), far too short for a pyramid this size. Adding the two squares instead of subtracting them, √(15² + 7²) = √(225 + 49) = √274 = 16.6 cm (1 d.p.), gives a length longer than the slant edge itself, which cannot be the height.
- (c) 8 cm — Area of a trapezium = (sum of parallel sides) ÷ 2 × height, so 45 = (a + 10) ÷ 2 × 5. Dividing 45 by 5 gives 9, so (a + 10) ÷ 2 = 9, meaning a + 10 = 18, so a = 18 − 10 = 8 cm. A pupil who correctly finds that the two parallel sides add up to 18 but forgets to subtract the known side of 10 cm gives the sum of both parallel sides, 18 cm, as the answer. A pupil who then adds 10 again by mistake instead of subtracting gets 18 + 10 = 28 cm. A pupil who halves the correct answer by mistake gets 8 ÷ 2 = 4 cm. The correct length of the other parallel side is 8 cm.
- (b) 8 cm — Area = base × height, so height = area ÷ base = 136 ÷ 17 = 8 cm. (16 cm comes from using the triangle formula, thinking area = 1/2 × base × height and so height = 2 × area ÷ base; 2312 cm comes from multiplying the area by the base instead of dividing; 119 cm comes from subtracting the base from the area instead of dividing the area by the base.)
- (c) 36.7 m — Method: use the cosine rule to find the missing side BC, then add all three sides for the perimeter. Working: BC² = 13² + 10² − 2 × 13 × 10 × cos 72°, so BC = 13.7 m, and perimeter = 13 + 10 + 13.7 = 36.7 m. Forgetting the negative sign in the cosine rule (using + instead of −) gives BC = 18.7 m and a perimeter of 41.7 m; leaving AC out of the total and only adding AB and BC gives 26.7 m; and adding AB twice instead of AB and AC gives 39.7 m. Always add all three named sides once the missing one has been found.
- (d) £50 — Area = 1/2 × (3.5 + 6.5) × 4 = 1/2 × 10 × 4 = 20 m². Cost = 20 × £2.50 = £50. (£100 comes from forgetting to halve the trapezium area, giving 40 m² instead of 20 m²; £65 comes from using only the longer parallel side, 6.5 × 4 = 26 m², instead of the trapezium formula; £35 comes from adding all three given lengths, 3.5 + 6.5 + 4, and treating that total as the area in square metres.)
- (d) 21.2 m — Method: the cable is the hypotenuse of a right-angled triangle whose vertical side is the drop from the roof to the bracket and whose horizontal side is 15 m, so use Pythagoras' theorem. Working: the drop is 20 − 5 = 15 m, so c² = 15² + 15² = 225 + 225 = 450 and c = √450 = 21.213…, which is 21.2 m to 1 decimal place. Answer: 21.2 m. The distractors: 25.0 m comes from using the whole 20 m height of the roof as the vertical side and forgetting that the bracket is already 5 m up; 30.0 m comes from adding the two sides of the triangle, 15 + 15, instead of using Pythagoras' theorem; 15.0 m is the horizontal distance on its own, which would be the length of the cable only if it ran level.
Build your own mix at the worksheet builder.