Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 080° — The back bearing differs from the given bearing by 180°. Because 260° is greater than 180°, subtract 180°: 260 − 180 = 80°, so the bearing of A from B is 080°. Choosing 440° adds 180° instead of subtracting it, even though the result would be more than a full turn (260 + 180 = 440). Choosing 180° assumes the back bearing is always exactly 180°, ignoring the original bearing altogether. Choosing 100° comes from measuring the reflex angle the other way round the circle (360 − 260 = 100) instead of applying the 180° back-bearing rule.
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (b) 124.1° — Method: use the sine rule AB/sin(ACB) = AC/sin(ABC), since AB is opposite angle ACB and AC is opposite angle ABC. Working: sin(ACB) = AB × sin(ABC) / AC = 13 × sin 35° / 9 = 0.8285, which gives angle ACB = 55.9° or its supplement 180 − 55.9 = 124.1°; both of these give a valid triangle, and since angle ACB is obtuse the answer is 124.1°. Reporting the acute solution instead, without checking the word 'obtuse' in the question, gives 55.9°; putting the sides the wrong way round in the ratio, sin(ACB) = 9 × sin 35° / 13, gives 23.4°; and subtracting the acute solution and the given 35° from 180° as if angle ACB were the remaining triangle angle gives 89.1°. A given SSA fact always has two possible angle solutions unless the stem states which one is meant.
- (b) 13.3 cm — The apex is directly above the centre of the square base, so the height, half the base diagonal, and a slant edge form a right-angled triangle with the slant edge as the hypotenuse. Half the base diagonal is 14 ÷ 2 = 7 cm. Using Pythagoras' theorem, height = √(15² − 7²) = √(225 − 49) = √176 = 13.3 cm (1 d.p.). Using the slant edge itself as the height, without applying Pythagoras' theorem at all, gives 15 cm. Using the full base diagonal (14 cm) instead of half of it gives √(15² − 14²) = √(225 − 196) = √29 = 5.4 cm (1 d.p.), far too short for a pyramid this size. Adding the two squares instead of subtracting them, √(15² + 7²) = √(225 + 49) = √274 = 16.6 cm (1 d.p.), gives a length longer than the slant edge itself, which cannot be the height.
- (c) 37.6 m² — Triangle ABC has a right angle at B, so use Pythagoras' theorem to find AC: AC² = AB² + BC² = 5² + 12² = 25 + 144 = 169, so AC = 13 m. In triangle ACD, use Area = 1/2 × AC × AD × sin(angle CAD) = 1/2 × 13 × 9 × sin 40° = 58.5 × 0.6428 = 37.6 m² (1 d.p.). Adding AB and BC to get AC = 17 m instead of applying Pythagoras gives 1/2 × 17 × 9 × sin 40° = 49.2 m². Using cos 40° instead of sin 40° gives 1/2 × 13 × 9 × cos 40° = 44.8 m². Substituting AB = 5 m directly instead of finding AC first gives 1/2 × 5 × 9 × sin 40° = 14.5 m².
- (b) 8 : 27 — The heights are in the ratio 6 : 9, which simplifies to 2 : 3. For similar solids, volume scales with the cube of the length ratio, so the volume ratio is 2³ : 3³ = 8 : 27. 2 : 3 is only the simplified length ratio, without cubing. 4 : 9 comes from squaring instead of cubing — that's the rule for areas, not volumes. 27 : 8 has the correct cubed values but in the wrong order, giving the larger cone's volume first instead of the smaller.
- (a) £94.58 — Method: find the area with 1/2ab sin C, then multiply by the cost per square metre. Working: area = 1/2 × 1.8 × 1.3 × sin 72° = 1.11274 m², so cost = 1.11274 × £85 = £94.58. Leaving out the 1/2 gives an area of 2.22547 m² and a cost of £189.17; using cos 72° instead of sin 72° gives a cost of £30.73; and rounding the area to 1 decimal place (1.1 m²) before multiplying by the cost per square metre gives £93.50, which loses accuracy that the final answer needs. Even rounding to 1.113 m² is enough to shift the cost to £94.61 — keep the unrounded area in your calculator until the very last step.
- (c) (1/3)a + (2/3)b — Method: OP = OA + AP, and since AP is twice PB, AP is 2/3 of the whole of AB, with AB = b − a. Working: OP = a + 2/3(b − a) = a − (2/3)a + (2/3)b = (1/3)a + (2/3)b. Answer: OP = (1/3)a + (2/3)b. Measuring 2/3 of AB from B's end instead of A's swaps the fractions round, giving (2/3)a + (1/3)b; adding (2/3)b onto the whole of a without first subtracting a inside the bracket gives a + (2/3)b; and treating the ratio as though AP and PB were equal gives the midpoint, (1/2)a + (1/2)b. Convert the ratio to a fraction of AB measured from the point named first in the ratio, subtract before you scale, and then add the result to OA.
- (a) 21.8° — The base diagonal has length √(6² + 8²) = √(36 + 64) = √100 = 10 cm, using Pythagoras' theorem on the rectangular base. The angle between the space diagonal and the base lies in the right-angled triangle formed by the height (4 cm, opposite), the base diagonal (10 cm, adjacent) and the space diagonal (hypotenuse), so tan(angle) = 4 ÷ 10 = 0.4, giving angle = 21.8° (1 d.p.). Using the height and one base edge instead of the full base diagonal, tan(angle) = 4 ÷ 8 = 0.5, gives 26.6° instead. Inverting the ratio, tan(angle) = 10 ÷ 4 = 2.5, gives 68.2°, the complement of the angle rather than the angle itself. Using the height and the other base edge, tan(angle) = 4 ÷ 6, gives 33.7°.
- (b) 4 : 9 — The heights are in the ratio 4 : 6, which simplifies to 2 : 3. For similar solids, area scales with the square of the length ratio, so the surface area ratio is 2² : 3² = 4 : 9. 2 : 3 is just the simplified length ratio, before squaring has been done. 8 : 27 comes from cubing the ratio (2³ : 3³) instead of squaring it — that's the rule for volumes, not areas. 9 : 4 has the correct squared values but in the wrong order, giving the larger tin's area first instead of the smaller.
- (b) 166.3 cm² — Method: split the regular hexagon into 6 identical triangles meeting at the centre, each with two sides of 8 cm and a 60° angle between them, and use Area = (1/2)ab sin C on just one of them. Working: one triangle's area = 1/2 × 8 × 8 × sin 60° = 27.7 cm² (1 d.p.); the hexagon is 6 of these, so its area is 6 × 27.7 = 166.3 cm² (1 d.p.). Answer: 166.3 cm². Reporting just one triangle's area, without multiplying by 6, gives 27.7 cm²; treating the angle at the centre as a right angle instead of 60°, using 1/2 × 8 × 8 with no sine factor at all, gives 6 × 32 = 192.0 cm²; and multiplying by 5 instead of 6, miscounting the triangles in the hexagon, gives 5 × 27.7 = 138.6 cm². A regular hexagon always splits into exactly 6 triangles at its centre — count them before you multiply.
- (a) 10 cm — Sector area is (angle ÷ 360) × π × radius². Here 90 ÷ 360 = 1/4, and 1/4 × 3.14 = 0.785, so radius² is 78.5 ÷ 0.785 = 100, and the radius is √100 = 10 cm. Stopping after finding radius² and not taking the square root gives 100 cm. Treating 78.5 as the area of the WHOLE circle, ignoring the 90° fraction, gives radius² = 78.5 ÷ 3.14 = 25, so a radius of 5 cm. Correctly finding a radius of 10 cm but then doubling it, mistaking the question for asking the diameter, gives 20 cm.
- (b) £1.57 — Slice area = (90 ÷ 360) × 3.14 × 10² = 0.25 × 314 = 78.5 cm². Cost = 78.5 × £0.02 = £1.57. (£0.16 comes from forgetting to square the radius, using 0.25 × 3.14 × 10 for the area; £6.28 comes from finding the area of the whole cake and forgetting the angle fraction; £0.31 comes from using the arc length formula instead of the sector area formula.)
- (d) 63.6 — Method: the three angles inside the triangle formed by the two ladders and the ground add up to 180°. Working: 180 − 58.2 − 58.2 = 63.6. Answer: 63.6°. A candidate who assumes the top angle equals the base angles gives 58.2. A candidate who subtracts only one base angle from 180°, working out 180 − 58.2, gets 121.8. A candidate who doubles the base angle instead of subtracting it twice from 180°, working out 2 × 58.2, gets 116.4.
- (d) 15° — Sector area = (angle ÷ 360) × π × r², so 4.71 = (angle ÷ 360) × 3.14 × 36 = (angle ÷ 360) × 113.04. Dividing gives angle ÷ 360 = 4.71 ÷ 113.04 = 1/24, so angle = 360 ÷ 24 = 15°. (90° comes from forgetting to square the radius, using (angle ÷ 360) × 3.14 × 6 = 18.84 in place of 113.04; 3.75° comes from using the diameter, 12 cm, in place of the radius, giving (angle ÷ 360) × 3.14 × 144 = 452.16; 45° comes from using the arc length formula, (angle ÷ 360) × 2 × 3.14 × 6 = 37.68, instead of the sector area formula.)
Build your own mix at the worksheet builder.