Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 118° — When two straight lines cross, the angles that are vertically opposite each other are always equal. So the angle vertically opposite 118° is also 118°. A candidate who instead finds the angle next to it on the straight line, using 180° − 118° = 62°, has found the adjacent angle, not the vertically opposite one. A candidate who answers 180° has confused the rule with angles on a straight line. A candidate who doubles the angle, giving 236°, has applied no valid angle rule at all. The vertically opposite angle is 118°.
- (d) 63.6 — Method: the three angles inside the triangle formed by the two ladders and the ground add up to 180°. Working: 180 − 58.2 − 58.2 = 63.6. Answer: 63.6°. A candidate who assumes the top angle equals the base angles gives 58.2. A candidate who subtracts only one base angle from 180°, working out 180 − 58.2, gets 121.8. A candidate who doubles the base angle instead of subtracting it twice from 180°, working out 2 × 58.2, gets 116.4.
- (d) 4.6 cm — Method: BC is opposite the 30° angle and AC is next to it, so the ratio that links the two is tan θ = opposite ÷ adjacent. Working: tan 30° = BC ÷ 8, so BC = 8 × tan 30° = 4.6188…, which is 4.6 to 1 decimal place. Answer: 4.6 cm. The distractors: 13.9 cm comes from dividing by tan 30° instead of multiplying by it; 4.0 cm comes from using sin 30°, which treats the 8 cm side as the hypotenuse when it is the side next to the 30° angle; 6.9 cm comes from using cos 30° in place of tan 30°, which gives the wrong pair of sides.
- (b) 6 m — Volume of a cuboid = length × width × height, so height = volume ÷ (length × width) = 360 ÷ (12 × 5) = 360 ÷ 60 = 6 m. A pupil who divides the volume by the length only gets 360 ÷ 12 = 30 m. A pupil who divides the volume by the width only gets 360 ÷ 5 = 72 m. A pupil who subtracts length × width from the volume instead of dividing gets 360 − 60 = 300 m. The correct height is 6 m.
- (b) 9π cm² — Sector area is the fraction θ/360 of the full circle's area, πr². Substitute θ = 40 and r = 9: 40 out of 360 is one ninth, and the full circle's area is π × 9² = 81π. One ninth of 81π is 9π, so the sector area is 9π cm². Choosing 2π cm² is this sector's ARC LENGTH, not its area — a different formula and a different quantity. Choosing 81π cm² is the area of the WHOLE circle, forgetting to scale down by the sector's angle. Choosing 18π cm² is the CIRCUMFERENCE of the whole circle, 2π × 9, mixed up with an area.
- (c) 100.5 m — The curved part of a semicircular bend is half of a full circle's circumference. The full circumference would be 2 × 3.14 × 32 = 200.96 m, and half of that is 200.96 ÷ 2 = 100.48 m, which rounds to 100.5 m. Choosing 201.0 m uses the FULL circumference, forgetting to halve it for a semicircle. Choosing 50.2 m halves the radius as well as taking a semicircle, using 3.14 × 16 = 50.24 m instead of the correct radius of 32 m. Choosing 64.0 m uses the diameter, 2 × 32 = 64, as if it were the curved length, ignoring π and the semicircle shape entirely.
- (a) A rotation of 180° about the origin — Method: composing two reflections in lines that cross is always a single rotation about the point where the lines meet, through twice the angle between them. Working: the x-axis and y-axis meet at the origin at an angle of 90°, so the combined transformation is a rotation about the origin through 2 × 90 = 180 degrees. Answer: a rotation of 180° about the origin. The rotation angle is TWICE the angle between the mirror lines, not the angle itself, and the centre is always where the two lines cross, not some other point, and the result of two reflections in intersecting lines is a rotation, never another reflection.
- (d) 6.7 cm — Volume of the sphere = (4/3)πr³ = (4/3) × 3.14 × 5³ = (4/3) × 3.14 × 125 = 523.33 cm³. Set this equal to the cylinder's volume πr²h: 523.33 = 3.14 × 25 × h = 78.5h. Divide: h = 523.33 ÷ 78.5 = 6.667 cm, which rounds to 6.7 cm. 1.7 cm comes from using the sphere's diameter, 10 cm, as the cylinder's radius: 523.33 ÷ (3.14 × 10²) = 1.7 cm.
- (b) (0, 2) — Method: to rotate about a point that is not the origin, first subtract the centre's coordinates, apply the rotation rule to the shifted point, then add the centre's coordinates back on; only after that do you apply the translation, in the order the question states them. Working: shifting P relative to the centre gives (6 − 1, 4 − 2) = (5, 2); rotating 90° clockwise sends (x, y) to (y, −x), giving (2, −5); adding the centre back on gives (2 + 1, −5 + 2) = (3, −3); applying the translation (−3, 5) gives (3 − 3, −3 + 5) = (0, 2). Answer: (0, 2). Applying the translation BEFORE the rotation, reversing the order the question gives them in, gives (8, 0); stopping after the rotation and forgetting the translation altogether gives (3, −3); and rotating anticlockwise instead of clockwise, using (x, y) → (−y, x), gives (−4, 12). Always carry out the two transformations in the order stated — rotate about the given centre first, then translate — and check each step before moving to the next.
- (a) 2.40m — Method: a cost found from a rate is the rate multiplied by the amount bought. Working: the rate is £2.40 per kilogram and the amount is m kilograms, so the cost is 2.40 × m. Answer: 2.40m. A candidate who divides the amount by the rate instead of multiplying writes m/2.40. A candidate who adds the rate to the amount instead of multiplying writes 2.40 + m. A candidate who subtracts the rate from the amount instead of multiplying writes m − 2.40.
- (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
- (d) 1 kg — First find the total mass in grams: 4 × 250 = 1000 g. Then convert to kilograms by dividing by 1000: 1000 ÷ 1000 = 1 kg. Finding the correct total in grams but forgetting to divide by 1000 gives 1000 kg. Adding the number of packs to the pack mass instead of multiplying, 4 + 250 = 254 g, gives 0.254 kg. Dividing the pack mass by the number of packs instead of multiplying, 250 ÷ 4 = 62.5 g, gives 0.0625 kg.
- (c) 40.5 kg — Since the statues are made from the same material, mass is proportional to volume, which scales with the cube of the length scale factor. The length scale factor is 45 ÷ 30 = 1.5, so the volume (and mass) scale factor is 1.5³ = 3.375. The larger statue's mass is 12 × 3.375 = 40.5 kg. 18 kg comes from multiplying by the length factor 1.5 directly. 27 kg comes from using the area scale factor 1.5² = 2.25 instead of the volume scale factor. 54 kg comes from treating 'cubed' as 'multiplied by 3', giving 1.5 × 3 = 4.5 instead of 1.5³.
- (a) 10.4 cm — The scale factor from the smaller triangle to the larger triangle is 8 ÷ 5 = 1.6, so the larger side is 6.5 × 1.6 = 10.4 cm. The distractor 4.0625 cm comes from using the ratio the wrong way round, 6.5 × 5 ÷ 8 = 4.0625. The distractor 9.5 cm comes from adding the difference between the ratio numbers (8 − 5 = 3) to the given length, 6.5 + 3 = 9.5. The distractor 13 cm comes from doubling the given length, treating the scale factor as 2 instead of 1.6.
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
Build your own mix at the worksheet builder.