Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 7.7 m — The horizontal distance is adjacent to the 50° angle and the zip wire is the hypotenuse, so horizontal distance = 12 × cos 50° = 12 × 0.6428... = 7.71...≈ 7.7 m. "9.2 m" uses the sine ratio instead of cosine, 12 × sin 50° = 9.19...≈ 9.2 m, which actually finds the vertical drop of the zip wire, not the horizontal distance. "15.7 m" comes from dividing by the sine ratio instead of multiplying by the cosine ratio, 12 ÷ sin 50° = 15.66...≈ 15.7 m, both the wrong operation and the wrong ratio. "12.0 m" simply uses the length of the zip wire itself as the horizontal distance, ignoring the angle of 50° altogether.
- (a) Translation by the vector (0, 6) — Method: reflecting twice in two parallel horizontal lines is always equivalent to a single translation, at right angles to the lines, of twice the distance between them. Working: the two lines are 4 − 1 = 3 units apart, so the translation is 2 × 3 = 6 units in the positive y-direction. Answer: translation by the vector (0, 6). Using just the gap itself, without doubling it, gives (0, 3); translating in the negative y-direction, from the second line back towards the first, gives (0, −6); and describing the combination as a single reflection in the line halfway between them, y = 2.5, confuses this combination with the effect of a single reflection — two reflections in parallel lines are always equivalent to a translation, never to another reflection. Always double the gap between the lines, and translate in the direction from the first line towards the second.
- (d) 7 cm — Area of a parallelogram = base × height, so height = area ÷ base = 84 ÷ 12 = 7 cm. A pupil who multiplies instead of dividing gets 84 × 12 = 1008 cm. A pupil who divides the base by the area instead of the area by the base gets 12 ÷ 84 ≈ 0.14 cm. A pupil who mistakenly halves the area first, as if this were a triangle, gets (84 ÷ 2) ÷ 12 = 3.5 cm. The correct height is 7 cm.
- (d) No transformation — every point stays exactly where it was — The two vectors (5, −3) and (−5, 3) are opposites, so adding them gives (0, 0): every point ends up exactly where it started, and there is no transformation at all. Misreading the second vector's signs and effectively adding (5, −3) to itself instead of to its opposite gives a translation by the vector (10, −6). Assuming two translations must combine into a reflection gives a reflection in the x-axis — but a reflection reverses orientation, and translations never do. Assuming that two opposite vectors must mean a half turn gives a rotation of 180° about the origin — but a 180° rotation moves every point except its own centre, whereas this pair of translations leaves every single point exactly where it was. Two translations by opposite vectors always cancel exactly, leaving every point unmoved.
- (b) £26.25 — First multiply the base and height: 2.4 × 1.75 = 4.2. The area of the triangular sail is half of that: half of 4.2 is 2.1 m². Then multiply by the cost per m²: 2.1 × £12.50 = £26.25. £52.50 forgets to halve in the area formula, giving an area of 4.2 m² and doubling the true cost. £30.00 multiplies the base length by the cost per m² (2.4 × £12.50) without ever finding the area. £25.00 rounds the area to 2 m² before multiplying by the cost, losing accuracy.
- (b) 10.5 m² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the width. Add the parallel sides: 2.5 + 4.5 = 7. Multiply by the width: 7 × 3 = 21. Half of 21 is 10.5 m². 21 m² forgets to halve, using the full (2.5+4.5)×3. 3.5 m² averages the two parallel sides, (2.5+4.5)÷2 = 3.5, but forgets to multiply by the width. 6.75 m² treats the bed as a triangle, using only the longer parallel side: half of 4.5 × 3.
- (b) (0, 2) — Method: to rotate about a point that is not the origin, first subtract the centre's coordinates, apply the rotation rule to the shifted point, then add the centre's coordinates back on; only after that do you apply the translation, in the order the question states them. Working: shifting P relative to the centre gives (6 − 1, 4 − 2) = (5, 2); rotating 90° clockwise sends (x, y) to (y, −x), giving (2, −5); adding the centre back on gives (2 + 1, −5 + 2) = (3, −3); applying the translation (−3, 5) gives (3 − 3, −3 + 5) = (0, 2). Answer: (0, 2). Applying the translation BEFORE the rotation, reversing the order the question gives them in, gives (8, 0); stopping after the rotation and forgetting the translation altogether gives (3, −3); and rotating anticlockwise instead of clockwise, using (x, y) → (−y, x), gives (−4, 12). Always carry out the two transformations in the order stated — rotate about the given centre first, then translate — and check each step before moving to the next.
- (b) 13.3 cm — The apex is directly above the centre of the square base, so the height, half the base diagonal, and a slant edge form a right-angled triangle with the slant edge as the hypotenuse. Half the base diagonal is 14 ÷ 2 = 7 cm. Using Pythagoras' theorem, height = √(15² − 7²) = √(225 − 49) = √176 = 13.3 cm (1 d.p.). Using the slant edge itself as the height, without applying Pythagoras' theorem at all, gives 15 cm. Using the full base diagonal (14 cm) instead of half of it gives √(15² − 14²) = √(225 − 196) = √29 = 5.4 cm (1 d.p.), far too short for a pyramid this size. Adding the two squares instead of subtracting them, √(15² + 7²) = √(225 + 49) = √274 = 16.6 cm (1 d.p.), gives a length longer than the slant edge itself, which cannot be the height.
- (d) £982.20 — Method: find the missing side BC with the cosine rule, add it to AB and AC for the perimeter, then multiply by the cost per metre. Working: BC² = 45² + 38² − 2 × 45 × 38 × cos 110° = 4638.71, so BC = 68.108 m, perimeter = 45 + 38 + 68.108 = 151.108 m, and cost = 151.108 × £6.50 = £982.20 — keep the unrounded perimeter, because the rounded 151.1 m would give £982.15. Forgetting the negative sign in the cosine rule gives BC = 48.0 m and a cost of £851.18; costing only the missing side BC and forgetting to include AB and AC gives £442.70; and stopping after finding the perimeter, without multiplying by the cost per metre, gives £151.11. The perimeter is only the halfway point of this question — the cost still has to be worked out.
- (d) 310 — Method: since both turns are clockwise, add both angles to the starting bearing. Working: 245° + 50° = 295°; 295° + 15° = 310°. A student who answers 295 has only added the first turn and forgotten the second one. A student who answers 180 has subtracted both turns instead of adding them. A student who answers 320 has added the two turns as 75° instead of 65° by misreading the second turn. Answer: 310°.
- (c) 5√3 cm — The space diagonal of a cube with edge a satisfies d² = a² + a² + a² = 3a², using Pythagoras' theorem in three dimensions. With a = 5, d² = 3 × 5² = 3 × 25 = 75, so d = √75 = √(25 × 3) = 5√3 cm. Finding the diagonal of one face instead, using only two of the three edges, gives d = √(5² + 5²) = √50 = 5√2 cm, which leaves out the third dimension. Adding the three edges directly, 5 + 5 + 5 = 15 cm, ignores that Pythagoras' theorem works with squares of lengths, not the lengths themselves. Squaring the edge and multiplying by 3 correctly, 3 × 5² = 75, but then forgetting to take the square root, leaves 75 cm — the squared length, not the diagonal itself.
- (d) 15° — Sector area = (angle ÷ 360) × π × r², so 4.71 = (angle ÷ 360) × 3.14 × 36 = (angle ÷ 360) × 113.04. Dividing gives angle ÷ 360 = 4.71 ÷ 113.04 = 1/24, so angle = 360 ÷ 24 = 15°. (90° comes from forgetting to square the radius, using (angle ÷ 360) × 3.14 × 6 = 18.84 in place of 113.04; 3.75° comes from using the diameter, 12 cm, in place of the radius, giving (angle ÷ 360) × 3.14 × 144 = 452.16; 45° comes from using the arc length formula, (angle ÷ 360) × 2 × 3.14 × 6 = 37.68, instead of the sector area formula.)
- (a) 10.4 cm — The scale factor from the smaller triangle to the larger triangle is 8 ÷ 5 = 1.6, so the larger side is 6.5 × 1.6 = 10.4 cm. The distractor 4.0625 cm comes from using the ratio the wrong way round, 6.5 × 5 ÷ 8 = 4.0625. The distractor 9.5 cm comes from adding the difference between the ratio numbers (8 − 5 = 3) to the given length, 6.5 + 3 = 9.5. The distractor 13 cm comes from doubling the given length, treating the scale factor as 2 instead of 1.6.
- (d) 1 kg — First find the total mass in grams: 4 × 250 = 1000 g. Then convert to kilograms by dividing by 1000: 1000 ÷ 1000 = 1 kg. Finding the correct total in grams but forgetting to divide by 1000 gives 1000 kg. Adding the number of packs to the pack mass instead of multiplying, 4 + 250 = 254 g, gives 0.254 kg. Dividing the pack mass by the number of packs instead of multiplying, 250 ÷ 4 = 62.5 g, gives 0.0625 kg.
- (b) Wrong: 1 litre = 1000 ml, so 3.2 l = 3200 ml. — 1 litre = 1000 ml, so 3.2 litres = 3.2 × 1000 = 3200 ml — Sam is wrong because he multiplied by 100 instead of 1000. Saying Sam is correct accepts the wrong multiplier. Saying Sam is wrong only because 3.2 should be rounded first misses the real error, which is the multiplier, not the starting number. Saying '1 litre is 100 ml' misstates the basic fact and blames the wrong part of Sam's working.
Build your own mix at the worksheet builder.